• Clinical and Experimental Reproductive Medicine
• /
• v.16 no.2
• /
• pp.139-146
• /
• 1989

The purpose of this study was to examine the qualitative variation of human fetal-cord sera (HCS) and to accept the sera in human lVF-ET program. One hundred and sixteenth RCS were tested with 1772 2-cell embryos of F1 (C57BL x CBA) virgin mice, Ten to sixteenth embryos were cultured in m-KRB medium with a aliquot of each serum (10%, v/v) or with bovine serum albumin(O.4%, w/v) as a control medium. Embryonic development were recorded at every 24hr for 4 days by such events as cellular compaction, cavitation, and hatching. In the control groups of eight assays, 98.1%(106/ 108) of 2-ce1l embryos developed above expanded blastocyst and the embryonic development was unified through the tests. But the developmental pattern in medium with each serum was various. Namely, the sera that supported development of 100% 2-cell embryos to above morula, early blastocyst, expanded blastocyst and hatching blastocyst was 45,7%(53/116) , 35.3%(41/116), 15.5%08/116.) and 6.9-%(8/116), respectively. And the sera that supported development of above 80% 2-cell embryos to the each embryonic stage was 92.2% (107/116), 83.6%(97/116), 63.8%(74/116) and 36.2%(42/116), respectively. Meanwhile two kinds of toxic pattern to the embryonic development were observed in some sera. The first pattern is that some sera arrested development of most embryos in pre- or post-stage of morula or blastocyst. The second pattern is that some sera promoted or arrested a part of embryos in the same dish. The ability of serum was depended on the batch of serum. Finally we could accept 69%(80/116) of the tested sera for human IVF-ET program. The base line for acceptance was the ability that supported above 80% 2-ce1l embryos to blastocyst. But some deterious sera were contained in this range. We cut off about 10% of the sera (83.6% , 97/116) that passed the baseline. This final percent of sera was similar to that of grade N of this study.

• The Korean Journal of Malacology
• /
• v.16 no.1_2
• /
• pp.17-20
• /
• 2000

Effect of predation of starfish Asterias amurensis and Asterina pectinifera under different water temperature in the recirculating seawater vessel was conducted at the invertebrate culture laboratory of Yosu National University from February 1 to February 25, 2000. The highest activity of Asterias amurensis and Asterina pectinifera according to water temperature was obtained at 14$\^{C}$ and 22$\^{C}$. The average individual numbers of Anadara broughtonii predated by Asterias amurensis and Asterina pectinifera were 2.20 and 1.60 at 6$\^{C}$ , 3.60 and 2.00 at 10$\^{C}$, 7.20 and 2.50 at 14$\^{C}$, 3.40 and 6.80 at 22$\^{C}$, 0.80 and 3.90 at 26$\^{C}$, respectively.

• Food Science and Preservation
• /
• v.17 no.2
• /
• pp.281-289
• /
• 2010

We determined the optimum ethanolic conditions for extraction of $\gamma$-oryzanol and other functional components from rice bran, using response surface methodology (RSM). A central composite design was used to investigate the effects of the independent variables of solvent ratio ($X_1$), extraction temperature ($X_2$), and extraction time ($X_3$), on dependent variables including yield ($Y_1$), total phenolic content ($Y_2$), electron-donating activity ($Y_3$), ferulic acid level ($Y_4$), and $\gamma$-oryzanol concentration ($Y_5$). Solvent ratio and extraction temperature were the most important factors in extraction. The maximum yield was at 22.56 mL/g ($X_1$), 78.19C ($X_2$), and 522.15 min ($X_3$), at the saddle point. Total phenolic levels were little affected by solvent ratio or extraction temperature. The maximum concentration of extracted total phenolics was 90.78mg GAE/100 g at 21.26 mL/g, $94.65^{\circ}C$, and 567.97 min. A maximum electron-donating ability of 54.72% was obtained with the parameters 20.20 mL/g,$81.89^{\circ}C$, and 701.87 min, at the highest point. The maximum level of ferulic acid components was 210.47 mg/100g at 5.22 mL/g, $79.66^{\circ}C$, and 575.24 min. In addition, the maximum $\gamma$-oryzanol concentration was 660.39 mg/100g at 5.10 mL/g, $81.83^{\circ}C$, and 587.39 min. The optimum extraction conditions were a solvent ratio of 10.45 mL/g, $80^{\circ}C$ extraction temperature, and 535 min extraction time. Predicted extraction levels under optimized conditions were in line with experimental values.

• Journal of agriculture & life science
• /
• v.50 no.1
• /
• pp.105-115
• /
• 2016

This study was carried out to establish the optimum forest management plan for the Cryptomeria japonica plantations in southern inland and Jeju island in Korea. Sixty seven circular sample plots of 0.04ha were established and we surveyed vegetation structure and growth characteristics from three layers(upper, middle, and lower). As a result of cluster analysis obtained by importance values of each tree species, the community type of C. japonica stands were classified into C. japonica group(C1) and C. japonica-C obtusa group. C. obtusa community were also sbudivided into P. thunbergii-Q. serrata group(C2) and Q. serrata-C obtusa group(C3). In tree layers importance value(IV) of C. japonica were 97.2% in C1, 80.7% in C2, and 47.6% in C3 and in sub-tree layers IV were 8.9% in C1, 15.2% in C2, and 5.7% in C3. Especially in C3 there are bamboo species (Smilacina japonica var. lutecarpa and Pseudosasa japonica) it is necessary for us to control them. In shrub layers C. japonica were found in C1(9.2%) and C2(7.0%), but except for C3. In tree layer species diversity indices of each community ranged from the lowest 0.059 in C1 to the highest 0.548 in C3. Dominance ranged from 0.958 in C1 to 0.393 in C3 which may caused by interspecific competition. Current annual increment of diameter growth ranged from 7.01mm/yr to 8.04mm/yr. As a result of our study we recommend the application of proper thinning and pruning for C1 and C2.

• Journal of Aquaculture
• /
• v.21 no.4
• /
• pp.265-271
• /
• 2008

Upper temperature tolerance of the turbot Scophthalmus maxim us, one of the popular aquaculture species in European community and China, was evaluated in terms of survival and growth at $20^{\circ}C$, $23^{\circ}C$, $26^{\circ}C$, or $29^{\circ}C$. Best growth was achieved at temperature $20^{\circ}C$ in this experiments. The fish exposed to $20^{\circ}C$ or $23^{\circ}C$ were comparable in survival, condition factor and feed conversion efficiency reminiscent of the latter temperature to be agreeable for the fish. The temperature over $23^{\circ}C$ appeared to be the temperatures beyond the fish can tolerate. For instance, the fish exposed to 26 showed mortality of 60.9% by day 60; none of the fish exposed to $29^{\circ}C$ survived beyond day 7. Culture densities between 80 and $200\;fish/m^2$ did not influence the survival, growth, condition factor and specific growth rate of the fish. The final production of the culture density experiment was $10\;kg/m^2$ on average. These results imply that the location where water temperature remains lower than $25^{\circ}C$ during summer can be a candidate site for the turbot aquaculture.

• Advances in environmental research
• /
• v.6 no.1
• /
• pp.1-14
• /
• 2017

New technologies or improvement of the existing technologies are required to enhance the efficiency of removal of pollutants from wastewater. In this study we attempted to produce and test the activated carbon produced from the refused tea waste for the removal of dyes from wastewater. The objectives of this investigation were to produce activated carbon from refused tea waste by chemical activation, evaluate its performance for the removal of color produced from Acid Yellow 36, and the modeling of its dye removal with the kinetic study. The activation was performed in two steps namely carbonization at $375{\pm}25^{\circ}C$ and chemical activation with HCl at $800^{\circ}C$ under the absence of Oxygen. Adsorption isotherms and kinetic studies were performed with a textile dye, Acid Yellow 36, at different concentrations (20-80 mg/L). The maximum dye removal (~90%) observed at 80 mg/L dye concentration and it reduced at low dye concentrations. Maximum adsorption (71.97 mg/g) was recorded at 96 h at $29{\pm}1^{\circ}C$. Low pH increased the dye adsorption (pH=2; 78.27 mg/g) while adsorption reduced at high pH levels indicating that the competition occurs in between OH- ions and AY36 molecules for the adsorption sites in RTAC. The Langmuir isotherm model clearly explained the dye adsorption, favorably, by RTAC. Moreover, kinetic studied performed showed that the pseudo second order kinetic model clearly describes the dye adsorption. Based on the results obtained in this study, it can be concluded that RTAC can be used for the removal of textile dyes.

• Parasites, Hosts and Diseases
• /
• v.39 no.1
• /
• pp.49-56
• /
• 2001

Excretory/secretory proteins (ESP) from Toxoplasma gondii were analyzed to define the function in the penetration process into host cells. Whole ESP obtained at 37$^{\circ}C$ were composed of 15 bands with molecular mass of 110, 97, 86, 80, 70, 60, 54, 42, 40, 36. 30, 28, 26, 22, and 19 kDa. Five ESP of 86, 80, 42, 36, and 28 kDa were reacted with monoclonal antibodies (mAb). named as Tg386 (microheme), Tg485 (surface membrane), Tg786 (rhoptry), Tg378, and Tg556 (both dense granules), respectively. The ESP was released by a temperature-dependent/-independent manner and all at once whenever ready to pour out except Tg786. Each ESP was not exhausted within the parasite but the amount was limited. Tg786 was released continuously with increment, whereas Tg378 and Tg556 were ceased to release after 3 and 4 hr, Dense granular Tg378 and Tg556 were released spontaneously and constitutively before the entry into host cells also. The entry of T. gondii was inhibited by all the mAbs differentially. And the parasite deprived of ESP was inhibited to enter exponentially up to 90.1%. It is suggested that ESP play an essential function to provide appropriate environment for the entry of the parasite into host cells.

• Journal of Technologic Dentistry
• /
• v.35 no.2
• /
• pp.97-103
• /
• 2013

Purpose: The purpose of this study was to investigate the effect of addition of fiber glass on the physical properties of silanized fiber mesh and non silanized mesh of denture base resins. Methods: The denture base resins were used in this study heat curing acrylic resins(Vertex Rs, Lucitone 199, $20{\times}80mm$) and fiber glass(SES, Green B&D co., Ltd, $20{\times}80mm$) were used as reinforcement. The specimens were stored in distilled water at $37{\pm}2^{\circ}C$ for 72 hours before test. Bending strength and tensile strength were measured by an universal testing machine(Instron 4301, Instron Corp.). Penetration distribution on fiber was observed by scanning electron microscopy(JSM 840A, Jeol Ltd). Results: The bending strength and modulus were increased by 30% after adding fiber glass on denture base resins. Tensile strength showed significant increasing by adding fiber glass on denture base resins. Conclusion: In this study, Addition of silanized fiber in denture base resins were improved physical properties. we confirmed the fiber glass possibility of the replacement about conventional materials.

• The Bulletin of The Korean Astronomical Society
• /
• v.44 no.1
• /
• pp.33.2-33.2
• /
• 2019

Horizon Run 5 is the most massive cosmological hydrodynamic simulation ever performed until now. Owing to the large spatial volume ($717{\times}80{\times}80[cMpc/h]^3$) and the high resolution down to 1 kpc, we may study the cosmological effects on star and galaxy formations over a wide range of mass scales from the dwarf to the cluster. We have modified the public available Ramses code to harness the power of the OpenMP parallelism, which is necessary for running simulations in such a huge KISTI supercomputer called Nurion. We have reached z=2.3 from z=200 for a given simulation period of 50 days using 2500 computing nodes of Nurion. During the simulation run, we have saved snapshot data at 97 redshifts and two light cone space data, which will be used later for the study of various research fields in galaxy formation and cosmology. We will close this talk by listing possible research topics that will play a crucial role in helping us take lead in those areas.

• Journal of Sensor Science and Technology
• /
• v.16 no.2
• /
• pp.97-103
• /
• 2007

Crystallized carbon nitride film that has many stable physical and/or chemical properties has been expected potentially by a new electrical material. However, one of the most significant problems degrading the quality of carbon nitride films is an existence of N-H and C-H bonds from the deposition environment. The possibility of these reactions with hydroxyl group in carbon nitride films, caused by a hydrogen attack, was suggested and proved in our previous reports that this undesired effect could be applied for fabricating micro-humidity sensors. In this study, MIS capacitor and MIM capacitor with $5{\mu}m{\times}5{\mu}m$ meshes were fabricated. As an insulator, carbon nitride film was deposited on a $Si_{3}N_{4}/SiO_{2}/Si$ substrate using reactive magnetron sputtering system, and its dielectric constant, C-V characteristics and humidity sensing properties were investigated. The fabricated humidity sensors showed a linearity in the humidity range of 0 %RH to 80 %RH. These results reveal that MIS and MIM $CN_{X}$ capacitive humidity sensors can be used for Si based micro-humidity sensors.