• Proceedings of the IEEK Conference
• /
• 2007.07a
• /
• pp.77-78
• /
• 2007

A planar UWB antenna using partial ground and CPW feeding is designed and fabricated. We obtained the return loss of average -8.2 dB in Low Band ($3.1\;GHz{\sim}4.8\;GHz$) and the good band rejection characteristic in the range of $4.9\;GHz{\sim}6.8\;GHz$. The simulation results by HFSS are seen to be in good agreement with the measured results.

• Journal of electromagnetic engineering and science
• /
• v.18 no.2
• /
• pp.141-143
• /
• 2018

Two 110-GHz oscillators have been developed in 65-nm CMOS technology. To study the effect of layout on the circuit performance, both oscillators had the same LC cross-coupled topology but different layout schemes of the circuit. The oscillator with the conventional cross-coupled design (OSC1), showed an output power of -3.9 dBm at 111 GHz with a phase noise of -75 dBc/Hz at 1-MHz offset. On the other hand, OSC2, with a modified cross-coupled line layout, generated an output power of -2.0 dBm at 117 GHz with a phase noise of -77 dBc/Hz at 1-MHz offset. The result indicates that the optimized layout can improve key oscillator performances such as oscillation frequency and output power.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.10
• /
• pp.758-765
• /
• 2018

This paper presents a 24-GHz frequency-modulated continuous wave(FMCW) radar transceiver with two Rx and one Tx channels in 65-nm complementary metal-oxide-semiconductor(CMOS) process and implemented it on a radar system using the developed transceiver chip. The transceiver chip includes a $14{\times}$ frequency multiplier, low-noise amplifier, down-conversion mixer, and power amplifier(PA). The transmitter achieves >10 dBm output power from 23.8 to 24.36 GHz and the phase noise is -97.3 GHz/Hz at a 1-MHz offset. The receiver achieves 25.2 dB conversion gain and output $P_{1dB}$ of -31.7 dBm. The transceiver consumes 295 mW of power and occupies an area of $1.63{\times}1.6mm^2$. The radar system is fabricated on a low-loss Duroid printed circuit board(PCB) stacked on the low-cost FR4 PCBs. The chip and antenna are placed on the Duroid PCB with interconnects and bias, gain blocks and FMCW signal-generating circuitry are mounted on the FR4 PCB. The transmit antenna is a $4{\times}4$ patch array with 14.76 dBi gain and receiving antennas are two $4{\times}2$ patch antennas with a gain of 11.77 dBi. The operation of the radar is evaluated and confirmed by detecting the range and azimuthal angle of the corner reflectors.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.59 no.8
• /
• pp.1429-1435
• /
• 2010

In this paper, a double lorentz composite right left handed(DL-CRLH) transmission line is designed using defected ground structure (DGS) and varactor diodes. Previously, the diode has been adopted only selectively for one of parallel or series resonators, and the balanced frequency as well as triple band frequencies were fixed. However in the proposed DL-CRLH transmission line, the balanced frequency, where the resonant frequencies of the series-connected parallel resonator and shunt-connected series resonator are the same, is adjustable. In addition, the triple band frequencies are controlled, too. The measured balanced frequency varies between 3.42~4.8GHz according to the controlled bias voltage. Under the same bias condition for the balanced frequency, the adjusted frequencies are 2.22~2.77GHz, 3.7~5.2GHz, 7.32~8.23GHz, 3.42~4.8GHz, and 4.44~5.92GHz for the conditions that ${\beta}d=+0.5{\pi}$, $-0.5{\pi}$, 2nd $+0.5{\pi}$, ${\omega}_{\infty}$, and ${\omega}_o$, respectively.

• Journal of information and communication convergence engineering
• /
• v.14 no.4
• /
• pp.246-251
• /
• 2016

In this study, we developed a reduced 94 GHz hybrid ring coupler on a GaAs substrate in order to demonstrate the possibility of the integration of various passive components and MMICs in the millimeter-wave range. To reduce the size of the hybrid ring coupler, we used multiple open stubs on the inside of the ring structure. The chip size of the reduced hybrid ring coupler with multiple open stubs was decreased by 62% compared with the area of the hybrid ring coupler without open stubs. Performance in terms of the loss, isolation, and phase difference characteristics exhibited no significant change after the use of the multiple open stubs on the inside of the ring structure. The reduced hybrid ring coupler showed excellent coupling loss of $3.87{\pm}0.33dB$ and transmission loss of $3.77{\pm}0.72dB$ in the measured frequency range of 90-100 GHz. The isolation and reflection were -48 dB and -32 dB at 94 GHz, respectively. The phase differences between two output ports were $180^{\circ}{\pm}1^{\circ}$ at 94 GHz.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.12 no.6
• /
• pp.958-964
• /
• 2001

In this paper, we propose a novel wide band printed monopole antenna called the staircase bow-tie monopole antenna (SBMA). We apply an extraordinary method for an impedance matching to conventional bow-tie monopoles. So we get the SBMA with a very wide band. Our antenna is smaller than a quarter wavelength in size but provides a 2:1 VSWR bandwidth of about 77.1 %. An antenna gain and a radiation pattern are about 1.7 dBi and omni-directional at 1.7 GHz, respectively.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.6
• /
• pp.56-61
• /
• 2013

In this paper, a high gain patch antenna using a single layer metamaterial superstrate with a near-to-zero refractive index (n) is proposed. Simulations for an ordinary patch antenna and our proposed metamaterial patch antenna were conducted. Our proposed metamaterial patch antenna was implemented and measured. The gain of our proposed metamaterial patch antenna is 6.77dB higher than that of an ordinary patch antenna.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.12
• /
• pp.77-84
• /
• 2004

We design and implement the DSP module for automotive radar using FMCW. The designed parameters are based on 77GHz FMCW radar, and show the resolution of 0.4m and 0.67km/h in distance and velocity, respectively. For detecting multiple targets, we discuss the relationship between fb's and targets. In addition, we show that the detection of multiple targets is very simple when the range of $f_r$ is sufficiently larger than that of $f_b$. In the front of ADC, the 2nd order differentiator is applied for reducing the effects of path-loss so that the ADC bits are reduced to 8 bits. The designed block is simulated in Matlab and implemented with DSP and micro-processor.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.14 no.3
• /
• pp.274-283
• /
• 2014

In this paper, the epi layer of npn SOI HBT with n+ buried layer has been studied through Sentaurus process and device simulator. The doping value of the deposited epi layer has been varied for the npn HBT to achieve improved $f_tBV_{CEO}$ product (397 GHzV). As the $BV_{CEO}$ value is higher for low value of epi layer doping, higher supply voltage can be used to increase the $f_t$ value of the HBT. At 1.8 V $V_{CE}$, the $f_tBV_{CEO}$ product of HBT is 465.5 GHzV. Further, the film thickness of the epi layer of the SOI HBT has been scaled for better performance (426.8 GHzV $f_tBV_{CEO}$ product at 1.2 V $V_{CE}$). The addition of this HBT module to fully depleted SOI CMOS technology would provide better solution for realizing wireless circuits and systems for 60 GHz short range communication and 77 GHz automotive radar applications. This SOI HBT together with SOI CMOS has potential for future high performance SOI BiCMOS technology.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2016.05a
• /
• pp.77-78
• /
• 2016

In this paper, small WLAN antenna was designed and investigated. Proposed antenna was configured for meandered type patch antenna ($20mm{\times}20mm$) that was mounted on RF4 dielectric substrate (relative permittivity 4.4, thick 1.6mm, tangent loss 0.025) size of $20mm{\times}60mm$. Antenna parameters was calculated by using the OpenFDTD simulator. As a result, frequency bandwidth satisfying the condition of VSWR(2:1) was 1.82-3.05GHz (1.23GHz, 44.6%) for considering WLAN.