• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.4 no.6
• /
• pp.1311-1326
• /
• 2010

Peer-to-peer (P2P) networks consume the most bandwidth in the current Internet and file sharing accounts for the majority of the P2P traffic. Thus it is important for a P2P file sharing application to be efficient in bandwidth consumption. Bandwidth consumption as much as downloaded file sizes is inevitable, but those in file search and bad downloads, e.g. wrong, corrupted, or malicious file downloads, are overheads. In this paper, we target to reduce these overheads even in the presence of high volume of malicious users and their bad files. Sybil attacks are the example of such hostile environment. Sybil attacker creates a large number of identities (Sybil nodes) and unfairly influences the system. When a large portion of the system is subverted, either in terms of the number of users or the number of files shared in the system, the overheads due to the bad downloads rapidly increase. We propose ELiSyR, a file search protocol that can tolerate such a hostile environment. ELiSyR uses social networks for P2P file search and finds benign files in 71% of searches even when more than half of the users are malicious. Furthermore, ELiSyR provides similar success with less bandwidth than other general efforts against Sybil attacks. We compare our algorithm to SybilGuard, SybilLimit and EigenTrust in terms of bandwidth consumption and the likelihood of bad downloads. Our algorithm shows lower bandwidth consumption, similar chances of bad downloads and fairer distribution of computation loads than these general efforts. In return, our algorithm takes more rounds of search than them. However the time required for search is usually much less than the time required for downloads, so the delay in search is justifiable compared to the cost of bad downloads and subsequent re-search and downloads.

• The Journal of Korea Robotics Society
• /
• v.11 no.4
• /
• pp.285-292
• /
• 2016

For articulated swimming robots, there have been no researches about controlling the motion or trajectory following. A control method for articulated swimming robot is suggested by extending a previous algorithm, ESPG (Extended Swimming Pattern Generator). The control method focuses on the situation that continuous pre-determined swimming pattern is applied for long range travelling. In previous studies, there has not been a way to control the propulsive force when a swimming pattern created by ESPG was in progress. Hence, no control could be made unless the swimming pattern was completed even though an error occurred while the swimming pattern was in progress. In order to solve this problem, this study analyzes swimming patterns and suggests a method to control the propulsive force even while the swimming pattern was in progress. The angular velocity of each link is influenced and this eventually modifies the propulsive force. However, The angular velocity is changed, a number of problems can occur. In order to resolve this issue, phase compensation method and synchronization method were suggested. A simple controller was designed to confirm whether the suggested methods are able to control and a simulation has affirmed it. Moreover, it was applied to CALEB 10 (a biomimetic underwater articulated robot) and the result was verified.

• Mycobiology
• /
• v.33 no.4
• /
• pp.194-199
• /
• 2005

Application of fertilizers such as urea, diammonium phosphate (DAP) and muriate of potash in soil adversely affected the spore germination of Arthrobotrys dactyloides. Amendment of soil with urea at the concentrations of 1.0%, 0.5% and 0.1 % completely inhibited spore germination and direct trap formation on the conidium, whereas muriate of potash delayed and reduced the spore germination even at the lowest concentration. DAP also inhibited spore germination at 1.0% concentration, while at lower concentration the percentage of spore germination was reduced. Application of neem cake at the concentration of 0.5% also inhibited spore germination after 24 h of amendment. The inhibitory effect of neem cake was reduced after 15 days of amendment, while after 30 days after amendment the inhibitory effect was completely lost and the spore germinated by direct trap as in unamended soil. Nematodes were not attracted to ungerminated spores after 24 h of amendment. After 15 days of amendment nematodes were attracted to agar blocks containing fewer germinated spores after 24 h of incubation but after 48 h of incubation large number of nematodes were attracted and trapped by the germinated spores with direct traps. After 30 days of amendment, larger number of nematodes were attracted and trapped by direct traps.

• International Journal of CAD/CAM
• /
• v.4 no.1
• /
• pp.33-45
• /
• 2004

In this work, a rational procedure has been formulated for the selection of points approximating slice contours cut in LOM (Laminated Object manufacturing) with first order approximation. It is suggested that the number of points representing a slice contour can be 'minimised' or 'optmised' by equating the horizontal chordal deviation (HCD) to the user-defined surface form tolerance. It has been shown that such optimization leads to substantial reduction in slice height calculations and NC codes file size for cutting out the slices. Due to optimization, the number of contour points varies from layer to layer, so that points on successive layer contours have to be matched by four sided ruled surface patches and triangular patches. The technological problems associated with the cutting out of triangular patches have been addressed. A robust algorithm has been developed for the determination of slice height for optimum and arbitrary numbers of contour points with different strategies for error calculations. It has been shown that optimisation may even lead to detection and appropriate representation of elusive surface features. An index of optimisation has been defined and calculations of the same have been tabulated.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.31A no.4
• /
• pp.99-105
• /
• 1994

k-bounded circuits are combinational circuits proposed by Fujiwara whose subcircuits are partitioned in a way that they form a tree and have some restricted k inputs respectively. Fujiwara proposed a O($16^{k}m$) fault detection algorithm for k-bounded circuits where m is the number of signal lines in the circuit. This algorithm is very ineffective to be applied to real circuits, even for small values of k. In this paper, it is shown that a single stuck-at fault in k-bounded circuits can be detected in O($2^{k}m$)time, and multiple stuck-at faults are detected in O($4^{k}m$) time by using thable lookup and imput partitionsing.

• Journal of Biosystems Engineering
• /
• v.34 no.4
• /
• pp.260-268
• /
• 2009

As a basic study to develop a high sensitive biosensor using film bulk acoustic resonator, the mathematical model for analyzing the resonance characteristics of bulk acoustic resonator with acoustic Bragg reflectors was investigated. The simulation results due to the number of acoustic Bragg reflectors with low and high acoustic impedance materials were compared with the experimental results for 1, 2.25 and 5 MHz of PZT based bulk acoustic resonators with various acoustic Bragg reflectors. At the fabricated bulk acoustic resonator with an odd number of acoustic Bragg reflectors, low and high acoustic impedance materials in sequence under the bottom electrode showed better resonance characteristics than even number of acoustic Bragg reflectors. The changes of resonance frequencies due to the increase of number of acoustic Bragg reflectors by simulation and experiment, respectively showed approximately similar tendency but some differences in input impedance between the experiment and simulation were found. The derived mathematical model for describing the resonance characteristics of the bulk acoustic resonator with acoustic Bragg reflector will be available for analyzing the design parameters for development of biosensor using bulk acoustic resonator.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.12 no.4
• /
• pp.651-656
• /
• 2017

In this study, we designed the system that helps drivers check all information about parking space at the entrance and find out whether the places is available or not, because the system has 'Image recognition function' which can even recognize car number plates exactly. Besides, we place the webcam close to the car number plate, so that car number can be identified more quickly. Finally, since we set the webcam high, the system keeps us from parking wrong places by displaying on the screen.

• Journal of Environmental Science International
• /
• v.25 no.7
• /
• pp.937-950
• /
• 2016

Algal blooming in 4 major rivers introduces substantial impacts to water front activity. Concentrations of algae are increasing at major points along the Geum River. Ecosystem food webs can be affected by algal blooming because blue-green algae release toxic materials. Even though there have been many studies on blue-green algae, its causality to environmental factors has not been completely determined yet. This study analyzed the exclusive correlation between various hydrometeorological, water quality, and hydrologic variables and the cell number of cyanobacteria to understand causality of blue-green algae in the Geum River. A prewhitening process was introduced to remove the autocorrelation structure and periodicity, which is useful to evaluate the effective relationship between two time series.

• Journal of Trauma and Injury
• /
• v.30 no.4
• /
• pp.179-185
• /
• 2017

Purpose: Rib fracture is the most common complication of blunt thoracic trauma. We investigated the effect of rib fracture on pulmonary function in the conservatively treated patients. Methods: From January 2000 to February 2017, we reviewed the records of 72 patients with rib fracture and pulmonary function tests were performed. According to the number of rib fractures, patients were classified into two groups: less than six fractured ribs (group A) and more than six fractured ribs (group B). The groups were compared concerning demographics, underlying diseases, associated thoracic injuries, surgery, mechanical ventilator times, days spent in the intensive care unit and pulmonary function test. Results: There were no statistically significant differences in the demographic data between the two groups. Mean hospitalization was 13.5 days in group A and 27.0 days in group B (p<0.001). There was no statistically significant difference between the two groups in the pulmonary function test. Conclusions: We conclude that pulmonary function is restored by conservative treatment in patients with rib fractures even if the number of rib fractures increases. In patients with multiple rib fractures, studies comparing open rib fixation and conservative treatment of long term pulmonary function are required.

• Korea-Australia Rheology Journal
• /
• v.16 no.4
• /
• pp.183-191
• /
• 2004

High Deborah or Weissenberg number problems in viscoelastic flow modeling have been known formidably difficult even in the inertialess limit. There exists almost no result that shows satisfactory accuracy and proper mesh convergence at the same time. However recently, quite a breakthrough seems to have been made in this field of computational rheology. So called matrix-logarithm (here we name it tensor-logarithm) formulation of the viscoelastic constitutive equations originally written in terms of the conformation tensor has been suggested by Fattal and Kupferman (2004) and its finite element implementation has been first presented by Hulsen (2004). Both the works have reported almost unbounded convergence limit in solving two benchmark problems. This new formulation incorporates proper polynomial interpolations of the log­arithm for the variables that exhibit steep exponential dependence near stagnation points, and it also strictly preserves the positive definiteness of the conformation tensor. In this study, we present an alternative pro­cedure for deriving the tensor-logarithmic representation of the differential constitutive equations and pro­vide a numerical example with the Leonov model in 4:1 planar contraction flows. Dramatic improvement of the computational algorithm with stable convergence has been demonstrated and it seems that there exists appropriate mesh convergence even though this conclusion requires further study. It is thought that this new formalism will work only for a few differential constitutive equations proven globally stable. Thus the math­ematical stability criteria perhaps play an important role on the choice and development of the suitable con­stitutive equations. In this respect, the Leonov viscoelastic model is quite feasible and becomes more essential since it has been proven globally stable and it offers the simplest form in the tensor-logarithmic formulation.