• Fashion & Textile Research Journal
• /
• v.22 no.5
• /
• pp.686-695
• /
• 2020

The present study evaluated the manual dexterity and usability of conductive gloves when operating touchscreen devices in the cold. Twelve male subjects (23.3±1.5 years in age) participated in three experimental conditions: no gloves, fabric conductive and lambskin conductive gloves. Manual dexterity was tested using both Purdue Pegboard (PP) and ASTM dexterity tests at an air temperature of 5℃ and air humidity of 30%RH. Glove usability was tested through the following touchscreen tests: tap, double tap, long tab, drag, flick, and multi-touch. The results showed that manual dexterity according to the PP (2.5 mm of a pin diameter) and ASTM tests (8 mm of a stick diameter) was worse for the two glove conditions than for the no glove condition (p<.005). PP dexterity was better for the fabric glove condition than for the lambskin glove condition (p<.05); however, there was no difference in ASTM dexterity between the two glove conditions. Hand and finger skin temperatures were higher for the glove conditions than the bare hand condition (p<.05), with no differences between the two glove conditions. The touchscreen usability was the best for the no glove condition, followed by fabric gloves (p<.05). Wearing either fabric or lambskin gloves diminishes hand dexterity while maintaining hand and finger temperatures at higher levels. For improved hand dexterity in dealing with small numbers, letters on a touchscreen in cold environments, we recommend wearing fabric conductive gloves rather than lambskin conductive gloves.

• Korean Journal of Human Ecology
• /
• v.9 no.1
• /
• pp.43-50
• /
• 2006

The main colorant of Chelidonium majus extracts is a berberine which shows relatively good dyeability onto silk fabrics in the appropriate dyeing conditions without mordant, But cotton fabrics are difficult to dye with berberine because of the low substantivity the cationic to cellulosic fibers. we treated cotton fabrics using three types of polycarboxylic acid, DL-malic acid, citric acid, 1,2,3,4-butanetetracarboxylic acid(BTCA) to increase dyeability of Chelidonium majus extracts onto cotton fabrics. As a result the cotton fabrics treated with polycarboxylic acid could be dyed with Chelidonium majus extracts and also showed yellow vividly. The dye uptake were increased with increasing the number of carboxy groups. And so dye uptake resulted the largest in the BTCA solutions which have four carboxylic groups in the molecular unit. The optimal dyeing temperature a of Chelidonium majus extracts onto polycarboxylic acid treated cotton fabrics were $60^{\circ}C$. The dye equilibrium was reached 20 minutes after dyeing. Neutral pH of dye solutions showed in higher K/S value than acidic or alkaline conditions. But the colorfastness to washing and light according to polycarboxylic acid treat was not enhance.

• 보존과학연구
• /
• s.6
• /
• pp.96-110
• /
• 1985

This report is briefly thied to introduce the kinds of clothes for the body of deceased and special features of remains in the era of the middle of Yidynasty found in Changheung IM's tomb, and some remarks related to the conservation treatment for shrouds as well. The contents of this report are summed up as follows:1. Included with the clothes of dead body of IM's clan were 2 pcs. Of woman's jacket, 2 pcs. of underpants, 1pcs. of single layered overcoat twithout cotton, 1pcs.of women's overcoat with a single layered thin cotton inside, women's socks, cushoned mattress, straw shoes and other hemp fabrics etc. By the observation of these remains, it is considered that they dressed the deceased with new cloth taken from the unsuals not prepared specially and stored beforehand for such as occasion as does it nowadays.2. As to the conservation treatment, the materials were comparatively good and so they employed general tank washing method with special neutrality liquid soap(made by Lab, of Household Products, Pacific R & D Center) for cleaning imbrued matrials on the clothes. After cleaning and drying naturally at a shade place, remains put into apaulowania tree box were fumigated by mixed gas (M. B. + E. O.) for prevention of damages from fungi and insects.3. Desirable environment control for scientific conservation of such kinds of cellulose textiles is to be illuminated at below 50Lux, temperature 16-18℃, relative humidity 45-60%($\pm$4%) and removed the dust. For the prevention of the damaging fungi and insects, it is desirable to fumigate by mixed gas (M.B.+E.O.) once a year.

• Fashion & Textile Research Journal
• /
• v.13 no.4
• /
• pp.614-623
• /
• 2011

The purpose of this study is to develop a wedding dress basic torso pattern and sleeve pattern considering good fit and aesthetic for figures of Korean brides in their 20s. For the research method, 3 women in their 20s who has the body size of ${\pm}$ S.D range of average figure and dress form suggested by 'the 5th human body measurement' of Size Korea were selected as the test group. The evaluators are 8 clothing construction majors, and the evaluation items included total 22 questions related to torso and total 10 questions related to sleeves. The evaluation was made using 5 Likert point scale. 4 prototypes for basic dress pattern were selected through the literature search. After compare analyzing design methods of prototypes, the real wedding dresses were made in the average size of women in their 20s and the dresses were tried on for the assessment. The data was analyzed using SPSS 18.0 Program to examine average, standard deviation and significant differences between basic patterns. Based on the results of the first and the second try-on assessments, a new wedding dress basic pattern with maximized strengths of compared prototypes was completed. The details of result follows. As for dress torso basic pattern, A pattern, which had the highest overall silhouette satisfaction and scores in basic pattern analysis and try-on assessments, was selected as the prototype, and a research basic pattern reflecting strengths of each basic pattern was developed. As for dress sleeve basic pattern, B pattern, which had the highest overall silhouette satisfaction and scores in basic pattern analysis and try-on assessments, was selected as the prototype, and a research basic pattern reflecting strengths of each basic pattern was developed. In this study, a wedding dress basic pattern considering good fit and aesthetic for figures of Korean brides in their 20s was suggested. It is expected that the basic pattern will be used by continuously developing dress market and ready-made wedding dress manufacturers as well as in educational institutes.

• Fashion & Textile Research Journal
• /
• v.18 no.5
• /
• pp.695-707
• /
• 2016

This study presents quantitative evaluation standards for the shape fitness test, conducted in the process of the slacks fit test. This study aims to quantify appearance sensory test of slacks for the objectification of qualitative evaluation methods in existing shape fitness tests. The subjects were women of standard body type between the ages of 18 and 24. Slacks differing in their ease in waist girth, hip girth, crotch length and knee length were designed to test their shape fitness. The gap volume distribution between the body and slack, angle of the baseline by body part, and ratio of total thickness from the sideline using 3D human body scan data (which reflect the results of the appearance sensory test) were presented as quantitative evaluation standards. There were less wrinkles in the wrinkle/overstretch and ease categories of the appearance sensory test; in addition, ease was adequate and small enough to comfortably perform basic human activities in the standing upright posture. The gap volume distribution analysis between body and slacks showed that curves increased in the slacks surface along with an increase of ease in slacks and suggested that wrinkles also increased. In the baseline's horizontal categories in terms of a $0^{\circ}$ horizontal angle, the range of angles were evaluated as adequate by the clothing expert group. The total thickness ratio of 0.5:0.5 divides into the sideline from the baseline.

• Textile Coloration and Finishing
• /
• v.21 no.1
• /
• pp.1-9
• /
• 2009

A lot of research has been made over the recent decade to develop testing packages with antimicrobial properties to improve food safety. In this study, a new method, experimental device and technology for environmental corresponding packages of polypropylene (PP) film has been developed to provide effective temperature buffering during the transport/long-term storage of grains or foodstuffs from the supplier to the market. This quantitatively optimized mixing system enabled to produce PP films with the 700$\sim$1,400d (width;1.5$\sim$3mm, thickness;0.01$\sim$0.5mm). In the whole mixing systems, the finely-granulated inorganic illite and PP virgin chip for master batch (M/B) chip was calculated by digital measurement methods, and then the M/B chip for PP film was adapted through a air jet and PP grinding method. The prepared PP film was characterized with tensile strength and elongation, far infrared radiation (FIR) emissivity, antimicrobial activity and deodorization properties. The results revealed that the two differently grain-sized illite could be show homogeneously dispersed on PP chip surface, and as the increasing of illite content, the FIR emissivity and the anion emission rate of film was increasingly improved. In both of 325 and 1,500 mesh-sized illite contained PP chip, of course the antimicrobial activity was good. But the ultimate deodorization rate for ammonia gas of PP film were found to be approximately the same.

• Korean Journal of Human Ecology
• /
• v.17 no.5
• /
• pp.963-973
• /
• 2008

Clothing pressure is closely connected with the degree of comfort of an athlete's tight-fitting garments. Therefore, the construction of sports garments is very important to the wearer's athletic performance. In this study, the fundamental relationship between the reduction rates of stretch fabrics and clothing pressure was explored with the aim of improving clothing comfort and obtaining a systematic pattern reduction for women's tight-fitting bodysuits. A women's bodysuit pattern was obtained by the draping method using a dressform. The basic pattern was divided into four parts and changed into reduced pattems according to the amount of fabric stretch determined by ASTM D2594. Clothing pressure was measured using an air-pack-type pressure sensor (model AMI 3037-2) at 20 locations (shoulder, 9 locations; bust, 5; and armhole, 6). Among the 15 garments tested, the mean pressure of the A1 bodysuit was 4.60 $gf/cm^2$, and that of the C5 bodysuit was 22.98 $gf/cm^2$. The mean pressures of the bodysuits with reduction rates of 10% and 20% were below 10 $gf/cm^2$, while those of suits with reduction rates of 30%,40%, and 50% (except C5) were below 20 $gf/cm^2$. The pressure at the shoulder was 9.50$\sim$32.24 $gf/cm^2$, which was higher than that at the bust (3.34$\sim$24.56 $gf/cm^2$) and the armhole (0.95$\sim$12.15 $gf/cm^2$). The mean pressures of the 15 bodysuits were divided into five groups using analysis of variance (ANOVA), and were found to be significantly different (p<0.001). Regression analysis afforded the following expression: mean pressure ($gf/cm^2$) = 1.607 + 0.369[reduction rate (%)].

• Journal of Fashion Business
• /
• v.21 no.6
• /
• pp.66-76
• /
• 2017

This study used a virtual wearing system equipped with body shape data with a 3D scanner, based on a female basic bodice, to develop a modified Hanbok Jeogori with high fitness capabilities to provide basic data for the development of the modified Hanbok Jeogori pattern for the academic and industrial fields. In this study, the representative modified Hanbok design which most frequently appeared in broadcasting ads and on line was selected. The wearing test was conducted by six professionals, and three times wearing tests were implemented based on 17 evaluation items. The data for this study was processed statistically using SAS 9.0. We conducted, the F-test for significance verification, the Duncan-test for a post test, and a correlation analysis of Cronbach's alpha coefficient for a reliability test of dressing test results were implemented for each of the three tests. The pattern of the developed modified Hanbok Jeogori overcame the defects of the short length of the conventional modified hanbok, and could fix the length issue. The developed Hanbok pattern solved the overlapping problem of the shoulder, back neck point-sleeve length(Whajang), and armhole, displayed in a straight line from the Godae point of the previous modified Hanbok; it suggested the position of the Seop and neck line in the basic bodice. Based on this, the Seop width, Git form, Goreum and the width, length, and position of the string whose dimensions can differ in accordance with the trend can be applied in various forms.

• Nano
• /
• v.13 no.10
• /
• pp.1850113.1-1850113.11
• /
• 2018

Environmental and energy issues have always been a hot topic of global research. Oil leakage has caused great damage to the environment, affecting a wide area and it is difficult to clean up. In most cases, carbon-based adsorbents are typically utilized to remove oil spills because of their economic benefits and high adsorbent efficiency. At the same time, its excellent material properties can also be used for the preparation of supercapacitors. In this paper, the carbon aerogels were prepared by the one-step method. The prepared materials endowed a 3D network structure with a huge number of micropores and mesoporous, and the material is light-weight, stable, hydrophobic and has affinity for oil (17.02 g/g) to the KGM carbon aerogel. Through the physicchemical characterization, the KGM carbon aerogel shows specific surface area is $689m^2/g$, high water contact angle ($136.64^{\circ}$) and excellent reusability (more than 15 cycle times). In addition, we also discussed the electrochemical properties of the material and obtained the specific electrical capacity of 139 F/g under the condition of 1 A/g.

• Journal of Fashion Business
• /
• v.25 no.1
• /
• pp.51-64
• /
• 2021

The purpose of this study was to develop smart bags that combining fashion-specific trends and smart information technologies such as light-emitting diodes(LED) and optic fibers by grafting marquage techniques that have recently become popular as part of eco-fashion. We applied e-textiles by designing leather tote bags that could show off LED luminescence. A total of two tote bags, a white-colored peacock design and a black-colored paisley design, divided the LED's light-emitting method into two types, incremental lighting and random light-emission to suit each design, and the locations of the optical fibers were also reversed depending upon the design. The production of circuits for the LEDs and optical fibers was based on the design, and a flexible conductive fabric was laser-cut instead of wire line and attached to the circuit-line location. A separate connector was underwent three-dimensional(3D)-modeling and was connected to high-luminosity LEDs and optic fiber bundles. The optical fiber logo part expressed a subtle image using a white-colored LED, which did not offset the LED's sharp luminous effects, suggesting that using LEDs with fiber optics allowed for the expression of each in harmony without being heterogeneous. Overall, the LEDs and fiber optic fabric were well-harmonized in the fashion bag using marquage techniques, and there was no sense of it being a mechanical device. Also, the circuit part was made of conductive fabric, which is an e-textile product that feels the same as a thin, flexible fabric. The study confirmed that the bag was developed as a smart wearable product that could be used in everyday life.