• Journal of Korean Society of Forest Science
• /
• v.90 no.3
• /
• pp.306-313
• /
• 2001

The objectives of this study were to understand the physiological responses and resistance of red pine trees to ozone exposure in relation to nitrogen and phosphorus fertilization. Potted one-year-old seedlings of Pinus densiflora S. et Z. were exposed in an open-top chamber(OTC) to ozone at concentration of 0.12ppm for 3 hours daily for eight weeks with or without N and P fertilization alone or in combination. The OTC had dimensions of 2.0m in height and 2.5m in diameter, and the air in a control chamber was filtered with activated charcoal to maintain the ozone concentration below 0.02ppm. After eight weeks of ozone exposure, none of the seedlings showed any symptoms of visible injury on leaves. The seedlings fertilized with N and P in a control chamber showed 22 to 95% increase in total dry weight, and similar fertilizer effect was also noticed in an ozone chamber. Ozone treatment did not decrease the total dry weight, but increased shoot/root ratio by 14.5%. Ozone treatment increased sucrose content in the leaves by 23%, but decreased sucrose content in roots by 20% regardless of N or P application. Starch content in the leaves was not affected by either ozone or fertilizer. However, starch content in the roots was decreased by 41% by ozone treatment. Chlorophyll content in the leaves was increased by 70% by N application, but was not affected by ozone treatment. Nitrogen and P fertilization stimulated net photosynthesis by 80% in a control chamber, but stimulatory effect of N and P on net photosynthesis was 22.3% less in an ozone chamber. Net photosynthesis of the seedlings with no fertilization was not affected by ozone treatment. Based on the observed interactions between N, P, and ozone, it was concluded that the stimulatory effect of fertilization on growth of Pinus densiflora would be decreased by ozone treatment, but fertilization would increase resistance to ozone by re-allocation of increased carbohydrates.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2004.11a
• /
• pp.339-342
• /
• 2004

It is research about special quality of ozone gas concentration and dissolved ozone concentration that show according to change of flow rate when liquefied ozone gas in water. If increase flow rate of ozone gas, ozone concentration increases being proportional and amount to fixed flow rate, dissolved ozone concentration was measured low. When ozone concentration How rate 1000 [ppm], dissolved ozone concentration smelted to flow rate 1.5[Q] for 28 [min] is $0.1740{\sim}0.8020[mg/l]$. Could know that half-life is most short by 3 minutes 8 seconds in flow rate 1.5 [Q]. And ozone smelted 20 minutes later after half-life measurement became disjointing all.

• Journal of Agricultural Extension & Community Development
• /
• v.7 no.1
• /
• pp.181-191
• /
• 2000

This experiment was conducted to find out the effects of mushroom cultivation on ozone susceptibility. The mushroom media in cultivation became softening well without bad Knell when it was soaked for 120 hours. The mushroom media softening on cultivating of oyster mushroom was good and fast when the concentration of gas condition ozone is high. The concentration of gas condition ozone must control at less than 0.02 ppm at the innoculation room, 0.03 ppm at the incubating room, must not use at the sprouting mom, less than 0.02 ppm at the growing room respectively. Also at the growing room, it removes the smell of mushroom, so has a protective effects of coming into mushroom fees and disease. When the concentration of 0.02 ppm liquid condition ozone was sprinkled, it was very useful in disease protection If it was input, the storage period of mushroom fruiting body was prolonged.

• Journal of Life Science
• /
• v.11 no.5
• /
• pp.489-495
• /
• 2001

The effect of ozone-water treatment on the morphological change of endosperm cells and the activity of acid phosphatase during Glycine max germination was investigated with electron microscope. Acid phosphatase showed the activity in the cell organelles of germinating endosperm of seed. it's activity occurrs in 12 hrs cultivation after 0.5 ppm ozone-water treatment. As the differentiation of endosperm, reaction products of the acid phosphatase appear to be accumulated invacuole after treatment of ozone-water. This result confirm that acid phosphatase is inveolved in the decomposition and translation of the intracellular storage materials. The characteristics of grganelle in the endosperm cell during germination were discussed.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.28 no.5
• /
• pp.87-92
• /
• 2000

The purpose of this study is to investigate Ozone which we have to contact in our daily lives. Recently Ozone becomes a serious pollutant in the inside and outside. To select th indicator plants or the purifier plants for air pollution caused by ozone, this stud has been conducted with interior landscape plant of 10 species. The results are as follows; 1) The visible demage by Ozone was firstly observed on Viburnum awabuki among 10 species, and it occurred after the lapse of 10, 8 and 4 hours on 0.5, 1.0 and 2.0 ppm ozone treatment, respectively. The first symptom of visible demage appeared on chlorosis or blotting of leaves, then progressed on necrosis of leaves. 2) On the other hand, Litsea japonica and Ardisia japonica were so resistant against Ozone fumigation that they were not demage independently of Ozone concentration till the lapse of 60 hours. 3) Chlorophyll contents were decreased by the increased Ozone concentration. At this time, grana destruction was observed. The most sensitive plant to ozone was Viburnum awabuki, and we suggest that Viburnum awabuki would be possible one to use for the indicator plant. The most resistance plant to Ozone was Litsea japonic and Ardisia japonica, we suggest that Litsea japonica and Ardisia japonica would be possible to use for the purifier plant for Ozone pollution.

• Journal of Veterinary Clinics
• /
• v.22 no.4
• /
• pp.314-317
• /
• 2005

The potential therapeutic effect of ozone gas on bovine mastitis was investigated. Eighteen quarters from 18 lactating cows with chronic mastitis were included. The 18 quarters were assigned to the control group (treatment with antibiotics for 3 days), experimental group I (0.1 ppm ozone treatment, for 7 days) and experimental group II (1ppm ozone treatment, for 3days). In experimental group I, milk somatic cell counts were lower on day 7 after ozone treatment, compared to the pretreated counts, but were higher than the control counts. In experimental group II, somatic cell counts were significantly decreased (p<0.05) on day 7 compared to the pretreatment counts, and they were lower than the control counts. There were no changes in leukocyte, neutrophil, or lymphocyte numbers, N/L ratios, N/L ratios, or serum total protein in the control and experimental groups. We concluded that ozone gas treatment(1ppm for 3days) might be effective for treatment of bovine mastitis.

• Journal of Environmental Health Sciences
• /
• v.30 no.5 s.81
• /
• pp.417-426
• /
• 2004

We investigate changing characteristics and concentration distribution of ambient air quality using data from which obtained local ambient air monitoring network and local meterological measuring sites in Gwangju area from January to December in 2003. Sulfur dioxide ($SO_2$) showed that increase from 8 AM and decrease in 6 PM but, it was not drastically changed concentration. it also 0.010 ppm in 1995 from at this time it's decrease step by step and than some constant in year 2001 to 2003. Nitrogen dioxide ($NO_2$) concentration was showed highest peak in 10 AM and increase again at 6 PM. And also it showed peak concentration (0.026 ppm) in 2001 and decreased from after that times. Ozone was showed peak concentration in 1 PM and Nitrogen dioxide was ditto in 10 AM from this data, we can conclude that this two article ws showed chemical reaction by 3 to 5 hours. There was no case of Ozone alarm in Gwangju area since 1995, but it showed highest ozone concentration (over 0.070 ppm) in May and June of the year and 2 to 4 PM of the day and sometimes it showed increase at the dawn. Ozone product optimum condition was that air temperature is over $25^{\circ}C$, no rain and increase solar radiation (over $20MJ/m^2$) and no wind or below 2.0 m/s wind speed.

• Korean Journal of Environmental Agriculture
• /
• v.5 no.2
• /
• pp.106-112
• /
• 1986

Biochemical and histological effects of ozone gas (0.3 ppm) on rice plant were discussed. After ozone expoure, damage symptom, percentages of destroyed leaves, activities of peroxidase and polyphenoloxidase, and the contents of flavonoid, protein and sugar were examined on two rice varieties (Seokwangbyeo, Jinjubyeo), on tillering stage, and at different exposure time (0, 1, 3, 5 hr). The result were as followed. 1. The ozone-injured cell adjoining stomata become pigmented red-brown. 2. The percentage of injured leaves in Jinjubyeo was higher than that in Seokwangbyeo. 3. The activities of peroxidase and polyphenoloxidase increased on ozone-injured leaves. 4. The peroxidase activity increased with time in Jinjubyeo compared to Seokwangbyeo. 5. Peroxidase isozyme spectrum was altered after ozone exposure. 6. The content of flavonoid and reducing sugar in the rice leaves was increased, but the contents of protein was reduced.

• Journal of Environmental Science International
• /
• v.13 no.4
• /
• pp.403-412
• /
• 2004

Waste water-soluble cutting oil was treated with WI type #1 and WI type #2. The properties of the original water-soluble cutting oil were pH=l0.4, viscosity=1.4cP, CODcr=44,750 ppm, and TOC=10,569 ppm. However, the properties of the oil used for more than 3 months were changed to pH=7.82, viscosity=2.1cP, CODcr=151,000 ppm, and TOC=74,556 ppm. It might be attributed to the fact that molecular chains were cut due to thermal oxidation and impurities such as metal chips were incorporated in to the oil during the operation processes. To prevent the putrefaction of oil, the sterilization effect of ozone and UV on the microorganism in the oil was investigated. Ozone treatment showed that 99.99% of the microorganism was annihilated with 30 minutes contact time and 60 minutes were necessary for the same effect when UV was used. Ozone treatment could cut molecular chains of the oil due to strong sterilization power, which was evidenced by the increase of TOC from 25,132 ppm at instantaneous contact to 28,888 ppm at 30 minutes contact time. However, UV treatment didn't show severe changes in TOC values and thus, seemed to cause of severe cut of molecular chains. When the activated carbon was used to treat the waste water-soluble cutting oil, TOC decreased to 25,417 ppm with 0.lg carbon and to 15,946 ppm with 5.0g carbon. This results indicated that the waste oil of small molecular chains could be eliminated by adsorption. From the results, it could be concluded that these treatment techniques could be proposed to remove the waste oil of small molecular chains resulting in the degradation of the oil properties. In addition, these experimental results could be used for the correlation with future works such as investigation of the molecular distribution according to the sizes, lengths, and molecular weight of the chains.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.28 no.2
• /
• pp.200-210
• /
• 2018

Objectives: The purpose of this study is to assess the exposure to ozone and total volatile organic compounds(TVOCs) generated during welding work at a shipyard and recommend respiratory protective equipment(RPE) adequate against these hazards. Method: Ozone was collected for about 30 minutes at two-minutes intervals using a direct reading instrument, specifically an ozone analyzer(Serinus 10, Ecotech, Australia). TVOCs were collected for about 30 minutes at three-minute intervals using a portable GC (Alpha 115, Synspec BV, the Netherlands), and were determined simultaneously by area sampling at the welding plume closest to the welder's breathing zone. The total measurements were 162 for ozone($CO_2$ welding 47, TIG 60, stick 55), and 136 for TVOCs($CO_2$ 65, TIG 50, stick 21). Based on these measurements, a literature survey was conducted to assess the adequacy of RPE. Results: Relative to Korean OEL, measurements above STEL 0.2 ppm were 23.4% for $CO_2$, 63.3% for TIG and 14.5% for stick welding. There were significant differences(p=<0.0001) among welding types. Compared with ACGIH peak exposure of 0.4 ppm for ozone, which is not applied in Korea, $CO_2$ welding exceeded it by 10.6%, TIG by 40.0% and stick by 7.3%. Although it was not feasible to compare them directly since there are no Korean OEL, TVOCs had very high levels similar to the concentrations before moving into a new apartment and about 10-20 times the indoor air quality recommendations for some individual measurements. Conclusions: As ozone removal RPE has been recommended in welding environments for a long time(Lunau, 1967), this fact was demonstrated based on the results of the on-site work environment measurements(ozone and TVOCs). In conclusion, for all welding at a shipyard, gas/vapor and particulate combination RPE are recommended. If this is not possible, it should at least be present for TIG welding.