• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.9
• /
• pp.208-214
• /
• 2014

Vehicle dynamic states used in various advanced driving safety systems are influenced by road geometry. Among the road geometry information, the vehicle pitch angle influenced by road slope and acceleration-deceleration is essential parameter used in pose estimation including the navigation system, advanced adaptive cruise control and others on sag road. Although the road slope data is essential parameter, the method measuring the parameter is not commercialized. The digital map including the road geometry data and high-precision DGPS system such as DGPS(Differential Global Positioning System) based RTK(Real-Time Kinematics) are used unusually. In this paper, low-cost cascade extended Kalman filter(CEKF) based road slope estimation method is proposed. It use cascade two EKFs. The EKFs use several measured vehicle states such as yaw rate, longitudinal acceleration, lateral acceleration and wheel speed of the rear tires and 3 D.O.F(Degree Of Freedom) vehicle dynamics model. The performance of proposed estimation algorithm is evaluated by simulation based on Carsim dynamics tool and T-car based experiment.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.32 no.2
• /
• pp.163-171
• /
• 2014

Based on the GPS/IMU integration, the car navigation has unstable conditions as well as drastically reduces accuracies in urban region. Nowadays, many cars mounted the camera to record driving states. If the ground coordinates of street furniture are known, the position and attitude of camera can be determined through SPR(Single Photo Resection). Therefore, an estimated position and attitude from SPR can be applied measurements in Kalman filter for updating errors of navigation solutions from GPS/IMU integration. In this study, the GPS/IMU/SPR integration algorithm was developed in loosely coupled modes through extended Kalman filters. Also, in order to analyze performances of GPS/IMU/SPR, simulation tests were conducted in GPS signal reception environments and the GCPs (Ground Control Points) distributions. In fact, the position and attitude gathered from GPS/IMU/SPR integration are more precise than the position and attitude from GPS/IMU integration. When IPs (image points), corresponded to GCPs, were concentrated in the center of image, the position error in the optical axis respectively increased. To understand effects from SPR, we plan to carry additional test on the magnitude of GCP, IP and initial exterior orientation errors.

• Transactions of the Korean Society of Machine Tool Engineers
• /
• v.18 no.1
• /
• pp.50-58
• /
• 2009

For precise tracking control of a servo system with nonlinear friction, a robust friction compensation scheme is presented in this paper. The nonlinear friction is difficult to identify the friction parameters exactly through experiments. Friction parameters can be also varied according to contact conditions such as the variation of temperature and lubrication. Thus, in order to overcome these problems and obtain the desired position tracking performance, a robust adaptive back-stepping control scheme with a dual friction observer is developed. In addition, to estimate lumped friction uncertainty due to modeling errors, a DEKF recurrent neural network and adaptive reconstructed error estimator are also developed. The feasibility of the proposed control scheme is verified through the experiment fur a ball-screw system.

• Journal of the Korean Society for Precision Engineering
• /
• v.16 no.3 s.96
• /
• pp.136-144
• /
• 1999

This paper presents an in-process measurement system for shaft radius measurement during grinding process. This system does not require to stop the grinding process, which can enhance productivity and quality. In order to measure the radius, the system employs an eddy current sensor that can measure without any contact with the shaft. This type of sensor is very appropriate because it is insensitive to interference such as cutting fluid, coolant, contact pressure, and wear. For data analysis, the measurement system is modeled as a linearized discrete form where the states with noise are estimated by an extended Kalman filter. This system has been validated through simulations and experiments.

• Proceedings of the KIPE Conference
• /
• 2019.07a
• /
• pp.198-200
• /
• 2019

배터리의 상태를 추정하기 위해 전압과 전류 데이터는 사용자가 센서를 통해 얻을 수 있는 정보이며, 이때 노이즈 성분이 포함된 전압 및 전류 데이터는 배터리의 상태 추정을 할 때 정확도를 크게 감소시킬 수 있다. 기존의 확장 칼만필터(EKF, Extended Kalman Filter)를 사용하여 노이즈 성분이 포함된 데이터를 통해 배터리의 상태를 추정했을 때는 노이즈의 영향으로 인해 추정 정확도가 떨어진다. 본 논문은 적응형 칼만 필터(AKF, Adaptive Kalman Filter)를 사용하여 노이즈 분산값을 업데이트 해줌으로써 SOC추정 성능을 향상시켰다. 실험 및 배터리의 모델링은 21700 NMC 고용량 배터리를 사용하였으며, 배터리의 전압에 임의의 노이즈 성분을 추가하여 배터리의 SOC를 추정 정확도를 검증 하였다.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.32 no.1
• /
• pp.63-73
• /
• 2014

Recently, researches on DBRN(DataBase Referenced Navigation) system are being carried out to replace GNSS(Global Navigation Satellite System), as weaknesses of GNSS were found that are caused by the intentional interference and the jamming of the satellite signal. This paper describes the gravity gradient modeling and the construction of EKF(Extended Kalman Filter) based GGRN(Gravity Gradient Referenced Navigation). To analyze the performance of GGRN, fourteen flight trajectories were made for simulations over whole South Korea. During the simulations, we considered the errors in both DB(DataBase) and sensor as well as the flight altitudes. Accurate performances were found, when errors in the DB and the sensor are small and they located at lower altitude. For comparative evaluation, the traditional TRN(Terrain Referenced Navigation) was also developed and performances were analyzed relative to those from the GGRN. In fact, most of GGRN performed better in low altitude, but both of precise gravity gradient DB and gradiometer were required to obtain similar level of precisions at the high altitude. In the future, additional tests and evaluations on the GGRN need to be performed to investigate on more factors such as DB resolution, flight speed, and the update rate.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2023.05a
• /
• pp.233-233
• /
• 2023

효율적인 수자원 관리에 필수적인 요소 중 하나는 유역 유출의 정확한 예측이다. 동일한 유역이라 할지라도 과거 기후조건에 대해 매개변수나 모형구조가 최적화된 수문모형은 현재나 미래 기후에 대해 최적이라 할수 없으며, 이에 따라 유역 유출 해석의 불확실성 또한 증가하고 있다. 수문자료동화는 모형의 입력 자료에 따른 불확실성을 줄이고 예측정확도를 향상 시킬 수 있는 방법으로, 수문모형의 상태량이나 매개변수를 업데이트하여 모형 초기 조건의 가능성 높은 추정치를 생성하는 기법이다. 본 연구에서는 국내 댐 상류 유역에 대해 집중형 수문모형과 순차자료동화 기법의 연계 패키지인 airGRdatassim 모형을 적용하여, 앙상블 칼만 필터와 파티클 필터 기법의 수문자료동화 특성을 비교 분석하고, 자료동화와 관련된 하이퍼-매개변수의 불확실성이 수문모의 성능에 미치는 영향을 분석하였다. 자료동화 적용 결과, 두 자료동화 기법 중 파티클 필터에 의한 모의성능이 높았으며 기상강제력 노이즈의 범위, 갱신 대상 상태량 설정, 앙상블 설정 등 수문자료동화의 설정과 관련된 하이퍼 매개변수의 불확실성은 두 기법별 뚜렷한 차이를 보였다. 또한, 본 연구에서는 일단위에서 시단위로 확장한 유량 예측 자료동화의 시험 모의결과 및 앙상블 수문동화기법의 도전과제에 대해서도 논의한다.

• Journal of Advanced Navigation Technology
• /
• v.20 no.6
• /
• pp.528-538
• /
• 2016

In this paper, an extend kalman filter based relative navigation algorithm is proposed for Link-K based relative navigation. Link-K is a tactical data link system for joint operation capability upgrade of ROK forces. Link-K is inter-operable with Link-16 and transmit and received information of operations and target. In Link-K communication channel, PPLI message including transmitter position and TOA measurement can be used for relative navigation. Therefore Link-K based relative navigation system can be operated. In this paper, software based simulations were carried out for operational feasibility test and performance verification as error factors of proposed Link-K based relative navigation system.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.27 no.2
• /
• pp.225-234
• /
• 2009

Real-time Aerial Monitoring System (RAMS) is to perform the rapid mapping in an emergency situation so that the geoinformation such as orthophoto and/or Digital Elevation Model is constructed in near real time. In this system, the GPS/INS plays an very important role in providing the position as well as the attitude information. Therefore, in this study, the performance of an IMU sensor which is supposed to be installed on board the RAMS is evaluated. And the integration algorithm of GPS/INS are tested with simulated dataset to find out which is more appropriate in real time mapping. According to the static and kinematic results, the sensor shows the position error of 3$\sim$4m and 2$\sim$3m, respectively. Also, it was verified that the sensor performs better on the attitude when the magnetic field sensor are used in the Aerospace mode. In the comparison of EKF and UKF, the overall performances shows not much differences in straight as well as in curved trajectory. However, the calculation time in EKF was appeared about 25 times faster than that of UKF, thus EKF seems to be the better selection in RAMS.

• International Journal of Highway Engineering
• /
• v.16 no.5
• /
• pp.59-66
• /
• 2014

PURPOSES : This study is to predict the Sound Pressure Level(SPL) obtained from the Noble Close ProXimity(NCPX) method by using the Extended Kalman Filter Algorithm employing the taylor series and Linear Regression Analysis based on the least square method. The objective of utilizing EKF Algorithm is to consider stochastically the effect of error because the Regression analysis is not the method for the statical approach. METHODS : For measuring the friction noise between the surface and vehicle's tire, NCPX method was used. With NCPX method, SPL can be obtained using the frequency analysis such as Discrete Fourier Transform(DFT), Fast Fourier Transform(FFT) and Constant Percentage Bandwidth(CPB) Analysis. In this research, CPB analysis was only conducted for deriving A-weighted SPL from the sound power level in terms of frequencies. EKF Algorithm and Regression analysis were performed for estimating the SPL regarding the vehicle velocities. RESULTS : The study has shown that the results related to the coefficient of determination and RMSE from EKF Algorithm have been improved by comparing to Regression analysis. CONCLUSIONS : The more the vehicle is fast, the more the SPL must be high. But in the results of EKF Algorithm, SPLs are irregular. The reason of that is the EKF algorithm can be reflected by the error covariance from the measurements.