• The Korean Journal of Quaternary Research
• /
• v.17 no.2
• /
• pp.145-148
• /
• 2003

The Kunang cave paleolithic site is located at Tanyang [$N37^{\circ}2'$, $128^{\circ}21'E$], Chungbuk Province, which is in the Central part of the Korean peninsula. The cave is developed at 312 amsl in a karstic mountainous area. The South Han River flows across this region and other caves can also be found near the river. The site was discovered in 1986 and excavated 3 times by the Chungbuk National University Museum until now. The cave was wellpreserved from modem human activities until the first discovery. The full length of the cave is estimated to be ca. 140 m. However, a spacious part up to 11 m from the entrance has been excavated. Eight lithological units are divided over the vertical profile at a depth of 5 m. Each unit is deposited in ascending order as follow: mud layer (Unit 9), lower complex (Unit 8) which is composed of angular blocks and fragments with a muddy matrix, lower travertine layer (Unit 7； flowstone), middle complex (Unit 6; cultural layer) which is composed of fragments with a muddy matrix, middle travertine layer (Unit 5； flowstone), yellowish muddy layer (Unit 4), upper complex (Unit 3； cultural layer) which has a similar composition to Unit 8. the upper travertine layer (Unit 2； flowstone), and finally surface soil layer (Unit 1). The most abundant vestiges in the cultural layers are the animal bones. They are small fractured pieces and mostly less than 3 cm in length. About 3,800 bone pieces from 25 animal species have been collected so far, 90 percent of them belonging to young deers. Previous archaeological study of these bone pieces shows thatprehistoric people occupied the cavenot for permanent dwelling but for temporary shelter during their seasonal hunting activity. More extensive studies of these bones together with pollen analysis are in progress to reconstruct the paleoenvironment of this cave. Only a single date (12,500 BP) obtained from a U-Th measurement of the upper travertine layer was previously available. In spite of the importance of the cave stratigraphy, there was no detail chronological investigation to establish the depositional process of the cultural layers and to understand the periodic structure of the cave strata, alternating travertine floor and complex layers. We have measured five 14C age dating (38900+/-1000, 36400+/-900, 40600+/-1600, more than 51000 and 52000 14C BP) using Seoul National University 14C AMS facility, conducted systematic process of the collagen extraction from bone fragments samples. From the result, we estimate that sedimentation rate of the cave earth is constant, and that the travertine layers, Unit 2 and Unit 3, was formed during MIS 5a(ca. 80 kBP) and MIS 5c (ca. 100 kBP) respectively. The Kunang Cave site is located at Yochonli of the region of Danyang in the mid-eastern part of Korea. This region is compased of limestones in which many caves were found and the Nam-han river flows meanderingly. The excavations were carried out three times in 1986, 1988, and 1998.

• Journal of Digital Convergence
• /
• v.12 no.11
• /
• pp.437-449
• /
• 2014

In this study, we analyzed an effect of area-environmental factor on breast cancer screening rates using multi-level analysis. It was intended for the KNHANES-IV. Total subjects were 14338. Among them, 4143 subjects met the inclusion criteria. When we applied only empty Model, a variance of breast cancer screening rates was 0.061 in each region. When we applied Model with individual level variables, the variance was 0.034. However, when we applied both Model with individual level variables and Model with area level variables, the variance was 0.023. We drew applied only individual level variables parallel applied 3 regional variances which could explain variance of inspection of breast cancer up to 18.04% compared with applied only individual level variables. Area level variables could reduce a variance of region. This means besides individual level variables. The group can share a same thing and can effect to breast cancer screening rates. We need to discover factors which area level variables and suggest that make a standard for inspection of breast cancer.

• The Korean Journal of Quaternary Research
• /
• v.18 no.1 s.22
• /
• pp.1-20
• /
• 2004

A geoscientific research was performed on 12 samples of comb-pattern potteries which were excavated at Daecheonri neolithic site, Korea. The texture and compositions of 12 potteries and surrounding metrix of soil and rocks were compared with the help of petrographic microscope, XRD and REE data. As to the manufacturing techniques thick potteries are caused by the amount and number of coarse grains which are assumed to be added shards when their distributional pattern are considered. DC1, DC3, DC 7 and DC11 samples have clearly oriented textures, and the orientation of vesicles in DC3 and DC11 samples arranged in the same direction with those on the pottery surface. This indicates the use potter's wheel technique in manufacturing potteries. Burning temperature is assumed over $800^{/circ}C$, particularly under reduction environment. As to the source, raw materials of pottery matrix are derived from the bottom of excavation site, or in an extracted outcrop of the northwestern foothill from site, while the shard materials are very similar with those extracted from sandy loams near sites. Finally any use pattern of pottery may control the pottery thickness, shard addition, and matrix selection.

• The Korean Journal of Quaternary Research
• /
• v.31 no.2
• /
• pp.23-30
• /
• 2017

There are many uncertainty to understand the ways in which Paleolithic men hunted animals. But in the meantime, We can identify a part of the hunting activities of the old people through artworks left by the paleolithic people at that time. First is the size of the hunt. In the case of painted artwork, the size of the herd does not exceed 10 people. Therefore, a small group of about 10 people would go out for a hunt, and they could see that the size of the herd varied according to the hunting target. In other words, to catch large and wild beasts like bison, you can see that it consists of nine or seven groups. In order to catch the horse, the same large animal, we can see that six people joined together. On the other hand, a group of two or three people hunting a relatively small, mild animal such as a deer would have been enough. Therefore, the size of the hunting herd was less than 10 people, and the size of the hunting herd seemed to be slightly different for each animal. Second, it is confirmed that these groups have a well-divided role. Because all nine of them were hunted out, they were divided into four small groups, which is likely to imply that the role of each group was different. Third, we can see that most of the weapons of the hunting herds were spears. The production and use of stone tools have been progressively developed, making a small stoner, a small stoneware, and connecting it to the spears, making it more efficient to hunt. This kind of composite wool connecting stone tools and wood would have been the most efficient means of hunting.

• KSBB Journal
• /
• v.8 no.5
• /
• pp.446-451
• /
• 1993

In ethanol fermentation, by-products such as glycerol, acetic acid and lactic acid are produced along with ethanol. The effects of culture conditions on cell growth ethanol production and by-products biosynthesis were investigated in ethanol fermentation using S. cerevisiae. With increasing aeration rate or yeast extract concentration, ethanol and by-products biosynthesis decreased while final cell mass increased. With increasing glucose concentration or decreasing temperature, final cell mass, ethanol and by-products concentrations all increased. The optimal pH for the cell growth, ethanol and by-products productions was found to be pH 4.5. By-products biosynthesis was found, in general, to proceed with the ethanol biosynthesis. The results can be applied for the optimization of ethanol fermentation and for the recovery and purification of ethanol from the culture broth.

• Resources Recycling
• /
• v.2 no.4
• /
• pp.27-32
• /
• 1993

A process has been studied to recover gallium from steelmaking dust which had several hundreds ppm of gallium. Aqueous solution containing 38 mg/l gallium was obtained by leaching of dust with 2.25 mol/l sulfuric acid. The leach liquor contained iron and zinc about 1,000 times greater than gallium. Gallium was then concentrated by ion exchanger of chelating resin with functional group of amino carboxylic acid after reduction of ferric ion to ferrous ion and pH adjustment. Gallium was concentrated to be 13 g/l in the resulting eluate by double ion exchanges. The liquor was further treated to remove impurities by solvent extraction technique empolying TOMAC as extractant. The galluim with 99% purity was finally obtainable.

• Journal of Plant Biology
• /
• v.25 no.1
• /
• pp.37-53
• /
• 1982

Pollen analysis from lake districts, Youngnangho, Wolhamji and Bangeojin, revealed vegetational patterns in Korea. The pollen stratigraphy was divided into five zones, zone L, I, II, IIIa and IIIb for the past 15,000 years. During zone L (earlier than 10,500 yr BP), late-glacial period, Youngnangho was vegetated with a coniferous forest dominated by spruce, larch, haploxylon pine and fir with considerable amount of herbs. Zone I(10,500~7500 yr BP) was predominantly herbaceous vegetationj with significant amount of oak and diploxylon pine. It suggests that the overall environment became milder and drier than late-glacial period. Zone II(7,500~4,000 yr BP), hypsithermal period, showed significant warming condition, indicated by high pollen concentrations of oak, diploxylon pine and hornbeam, and by more diverse flora of deciduous broad-leaved trees than before. Herbs were not an important part of vegetation. Zone III$^a$(4,000~1,500 yr BP) had pine and oak as main elements. Birch increased slightly while hornbeam decreased in this time. It indicates cooling condition. Zone III$^b$(1,5000-present) which can be called pine period showed obvious human interference. Following forest clearance, agriculture was intensified. The beginning of logging and agriculture was discernible by a sudden decline of arboreal species and by considerable amount of rice, buckwheat, sorrel and plantain. Numerous charcoal fragments were observed in zone I and zone III$^b$.

• Horticultural Science & Technology
• /
• v.31 no.2
• /
• pp.173-178
• /
• 2013

Experiments were conducted to investigate the optimum concentration of nutrient solution for strawberry 'Maehyang' bred domestically for exportation in hydroponics. Nutrient solutions for strawberry, which was made by Yamazaki, were supplied electrical conductivity (EC) 0.6, 0.8, 1.2, and $1.8dS{\cdot}m^{-1}$ after planting on cocopeat medium during the experiment period. Growth of shoot of strawberries did not show any statistical differences among treatments. Fruit length showed the longest in EC 0.8 and $1.2dS{\cdot}m^{-1}$, followed by 0.6 and $1.8dS{\cdot}m^{-1}$ in the first and third cluster. It showed the shortest in EC $1.8dS{\cdot}m^{-1}$ in the second cluster but there were no significant differences among treatments in the fourth cluster. Fruit diameter did not show significant differences among treatments in the first and second cluster but was the longest in the lowest concentration EC $0.6dS{\cdot}m^{-1}$ in the third cluster. The shortest was in EC $1.8dS{\cdot}m^{-1}$ in the fourth cluster. The heaviest mean fruit weight appeared in EC 0.8 and $1.2dS{\cdot}m^{-1}$, and the lightest was in EC $1.8dS{\cdot}m^{-1}$ in the first cluster and also lightest in EC $1.8dS{\cdot}m^{-1}$ but no significant differences was found among other treatments in the second & third cluster. Also the fruit weight was significantly light in plants grown in EC $1.8dS{\cdot}m^{-1}$ than $0.6dS{\cdot}m^{-1}$ in the fourth cluster. Soluble solids content of fruit was the highest in EC $0.6dS{\cdot}m^{-1}$ in all cluster. As a result, we came to the conclusion that the optimum EC for strawberry 'Maehyang' was EC 0.8 - $1.2dS{\cdot}m^{-1}$ during low temperature season. This result will be utilized as an indicator for strawberry hydroponics.

• Polymer(Korea)
• /
• v.29 no.5
• /
• pp.451-456
• /
• 2005

In the field of designing of nano-fillers of polyimide nanocomposites, the two strategic points are the heat-resistance and compatibility with polyimide, a matrix polymer. In this study, we designed oligo(amic acid) having alkyl side chains and terminal amine groups to satisfy previous requirements and studied the modification of surface of layered silicates. Oligo(amic acid)s were prepared by the reaction of diamine monomers and PMDA and their molecular weight was controlled in about 2000g/mol. After that, acidification and ion exchange reaction led to the high-temperature organophilic layered silicate (OLS). XRD pauerns of OLS showed the more increased gallery spacing by $4{\AA}$ than that of the pristine layered silicate and the initial decomposition temperatures of OLS were in above $280^{\circ}C$. The polyimide nanocomposite films based on heat resistant OLS showed that the OLSs were well dispersed through the matrix and their CTEs showed a decrease of $26\%$ compared with pristine polyimide films.

• Clean Technology
• /
• v.23 no.4
• /
• pp.378-387
• /
• 2017

To obtain epoxy resin with permanently attached flame-retardant groups, phosphorus compound containing di-hydroxyl group [10-(2,5-dihydroxyphenyl)-9,10-dihydro-9-oxa-10-phospha phenanthrene-10-oxide, DOPO-HQ] and silicone compound containing di-hydroxyl group (polydimethylsiloxane, hydroxyl terminated, PDMS) were reacted with uncured epoxy prepolymer (diglycidyl ether of bisphenol A, DGEBA) and then cured using 4,4-diaminodiphenylmethane (DDM) as a crosslinking agent. The properties of the resulting epoxy materials were characterized using Fourier transform infrared (FTIR) spectrometer, differential scanning calorimetry (DSC), thermogravimetric analysis (TGA), limiting oxygen index (LOI) test/vertical burning test (UL 94-V test), tensile properties test and impact test. This study examined the effect of phosphorus/silicone compound contents on the thermal/mechanical properties and flame retardancy of cured epoxy resins containing phosphorus and silicone compounds. It was found that the thermal/mechanical properties of epoxy resins containing phosphorus and silicone components were higher than those of simple epoxy resin. The flame-retardancy (LOI: 29.9 ~ 31.8% and UL 94-V: V-0) of all samples containing phosphorus compound and phosphrous compound/silicone compound was found to be passed the flame-retardant requirements (LOI: > 30%, UL 94-V: V-0) of LOI and vertical burning tests. However, the flame-retardancy (LOI: 21.4% and UL 94-V: no rating) of simple epoxy resin was found to be failed the flame-retardant requirements.