• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2003.11a
• /
• pp.669-679
• /
• 2003

Through AIS(Automatic Identification System), ITU-R suggested the navigational data communication between ships and between ships and shore stations for the better safety of navigation, and it requires two different the transmitting output power level depending on its operating mode. According to ITU's recommendation, these levels should reach within 20% of its final value in 1ms. In this paper, an adequate feedback control circuit for power amplifier module is designed and implemented.

• Proceedings of the Korean Society of Machine Tool Engineers Conference
• /
• 2000.10a
• /
• pp.140-143
• /
• 2000

Motion control system using motor generally consists of 2 inertio system, motor inertio and load inertio linked with flexible coupling. In the case of direct drive motor control, the effect of coupling inertio decrease the precision performance. The study is about semiclosed control scheme of the system and experimental setup. To compensate the effect of coupling inertio, semiclosed control system by disturbance observer is employed. The simulation result is shown.

• Proceedings of the Optical Society of Korea Conference
• /
• 2005.07a
• /
• pp.80-81
• /
• 2005

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2007.11a
• /
• pp.63-64
• /
• 2007

자기장 제어에 따른 플라즈마 형성 거동 및 코팅 물성간의 상관관계를 알아보기 위해 자기장 시뮬레이션을 수행하여 챔버 내 자력 분포에 따른 CrN 코팅막 물성 변화를 관찰하였다. Cross link type의 자석 배열을 할수록 폐회로(close field)의 자기장 배열을 형성하므로 높은 플라즈마 밀도를 구현할 수 있으며, 우수한 물성을 갖는 CrN이 합성됨을 확인하였다.

• Proceedings of The Korean Society of Agricultural and Forest Meteorology Conference
• /
• 2017.11a
• /
• pp.80-80
• /
• 2017

• Journal of the Korean Vacuum Society
• /
• v.15 no.2
• /
• pp.180-185
• /
• 2006

Microwatt power level at relatively high voltage(order of volt) was produced by $Bi_{0.5}Sb_{1.5}Te_{3}/Bi_{2}Te_{2.4}Se_{0.6}$ thin film thermoelectric generators, and maximum output power varied with temperature difference in the square-law relation. Output voltage and current were possible to control by changing the way of electrical connection as well as the number of stacking plate-modules. Variation of open circuit voltage and short circuit current with temperature difference showed a linear relationship. There were, however, some differences in variations; open circuit voltage were dependent on the number of plate-module when connected in series, but it was not for parallel connection. On the other hand, short circuit current showed the opposite behavior to the case of open circuit current.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.43 no.11
• /
• pp.1008-1015
• /
• 2015

Thermal vacuum test should be performed prior to launch to verify satellites' functionality in extremely cold/hot temperatures and vacuum conditions. A thermal vacuum chamber used to perform the thermal vacuum tests of a satellite system and its components. A cryogenic blower is a core component of the gaseous nitrogen (GN2) closed loop thermal control system for thermal vacuum chambers. A final goal of this research is development of cryogenic blower. Design requirements of a blower are 150 CFM flow rate, 0.5 bara pressure difference, hot and cold temperatures. This paper describes the performance analysis of impeller by 1D, CFD commercial software, the design of the thermal protection interface between the driving part and the fluid part. The performance of the cryogenic blower is confirmed by test at the standard air condition and is verified by on the thermal vacuum chamber at the real operating condition.

• Journal of the Korean Society for Railway
• /
• v.13 no.6
• /
• pp.565-569
• /
• 2010

Sleepers perform bearing rails and are underneath rails. Therefore, the current and voltage of rails are related to the resistance of sleepers. In case that the resistance of sleepers are low, operation problems of relays in tr ack circuits are occur because of flowing leakage current through sleepers. So the condition that the track circuit is always occupied by a train is kept. Currently, the creosote has been used in wood sleepers due to prevention against putrefaction. After a long time, the material is changeable to the chemistry material bases on carbon dioxide or carbon. So, the insulation resistance of wood sleepers is lower than the initial insulation resistance. In case of effecting wood sleepers as conductors, amplitude of the current and voltage on rails is decreased. This phenomenon causes that a train does not receive signals. In this paper, four-network model on the track circuit including the insulation resistance of sleepers is suggested. Also, the standard value of the resistance in straight section is proposed in the wood sleeper.

• Journal of the Mineralogical Society of Korea
• /
• v.23 no.4
• /
• pp.297-303
• /
• 2010

We report the particle-size distribution and comminution charactersitics of dolomite depending upon crushing equipment (hammer crusher and roll crusher) and crushing circuit (open and closed). The quantity of fine particles (< 100 mesh) produced by hammer crusher was 34 wt.% which is about three times that by roll crusher. The quantity of 14~25 mesh size fraction by roll crusher was 20 wt.% higher than that produced by hammer crusher. 80 wt.% of the crushing products by hammer crushing was under 35 mesh in size, while the particles produced by roll crushing were relatively coarse. The particle size of both the hammer and roll crushers decreased by employing closed crusing circuit in comparison to open circuit. Products of required particle-size were obtained effectively depending on appropriate crushing equipment and crushing circuit.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2020.06a
• /
• pp.201-201
• /
• 2020

수문 순환 및 물 수지에 관한 연구는 강수량, 지표유출량, 지하수, 토양수분 및 증발산량에 대한 정량화가 이루어질 때 실제적으로 규명될 수 있다. 그러나, 수문 순환 및 물수지 평가에 중요한 부분을 차지하는 증발산량의 경우 관측값보다 단순한 가정이나 경험식에 의한 추정값을 사용하고 있어 그 자료의 신뢰성에 대해서도 꾸준히 문제가 제기되어 왔다. 따라서, 수문 순환 및 물수지의 정량적인 분석을 위해서는 수문 순환 과정에서 상당부분을 차지하는 증발산량의 측정(실측)이 필요한 실정이다. 본 연구는 환경부의 기초수문자료 구축사업의 일환으로 수행되고 있으며, 에디공분산 기술을 사용하여 증발산량을 직접 관측하고 있다. 에디공분산 방법으로 증발산량을 측정하기 위해서 필요한 장비 중 수증기 농도를 측정하는 장비(개회로 기체분석기, 폐회로 기체분석기<수증기 농도를 측정하는 부분의 개폐여부에 따른 장비 구분>)에 대해 비교 측정을 수행하였으며, 관측 지점은 인위적인 관개가 이루어지고 있는 논경지(청미천 관측소)에서 수행하였다. 측정 자료에 대한 검토는 측정 장비에 따른 자료의 특성을 비교하기 위해 약 13,000개(9개월, 30분 간격) 자료를 활용하여 분석을 수행하였다. 그 결과 두 측정장비 모두 농도 변화에 따른 경향성은 유사하게 나타났으나, 측정 자료의 취득률에서는 차이(약 20%)를 보이는데, 이는 개회로 측정 장비의 경우 강우 및 안개 등의 기상상황에 따라 영향을 받기 때문으로 판단된다. 에디공분산 방법을 이용한 증발산량은 여러 기상자료를 이용하여 보정을 수행하기 때문에 측정 장비의 취득률로 인한 증발산량 산정에는 문제가 되지 않을 것으로 판단된다. 단 높은 관측률 및 측정 자료를 위해서는 폐회로 측정 장비를 이용하는 것이 유리할 것으로 판단된다.