• Land and Housing Review
• /
• v.15 no.3
• /
• pp.189-198
• /
• 2024

This study analyzes the thermal performance of insulating concrete based on material combinations aimed at carbon reduction. The study compares the thermal and structural properties of insulating concrete enhanced with perlite and EPS (Expanded Polystyrene) beads to conventional concrete, with a focus on the impact of insulation properties on thermal conductivity. The results indicate that the content of EPS beads is critical to the insulating performance, and increased moisture absorption significantly reduces the energy efficiency of the insulating concrete. These findings provide valuable insights for the design and application of insulating concrete to enhance energy efficiency and reduce carbon emissions. This study offers guidance for further developing insulating concrete as a carbon-reducing building material.

• Journal of Animal Environmental Science
• /
• v.9 no.2
• /
• pp.93-102
• /
• 2003

This study designed and constructed an experimental column far adhesion efficiency test and conducted experiment to investigate the offensive odor adhesion efficiency of filter bed materials. The offensive odor adhesion experiment was conducted using mixture of high physical adhesion efficiency material, and the fixity of deodorization microorganism of selected filter bed material was tested using ammonia exclude microorganism A4-­2 and sulfur oxidation microorganism S5­-5.2 those were cultured at the Agricultural Chemical Department of Chungnam National University, and deodorization efficiency of selected filter bed material mixture was tested. Following are summary of these tests results. 1. Amount of elimination of the offensive odor gas of ammonia and hydrogen sulfide per unit volume was 0.054 and 0.016$\ell/\textrm{cm}^3$ in rice hull, 0.01 and 0.004 $\ell/\textrm{cm}^3$ in rice straw 0.158 and 0.01 $\ell/\textrm{cm}^3$ in coconut, 0.014 and 0.02$\ell/\textrm{cm}^3$ perlite, 0.004 and 0.003$\ell/\textrm{cm}^3$ in high road ball, and 0.112 and 0.015 $\ell/\textrm{cm}^3$ in chaff of pine, respectively. 2. Amount of elimination of offensive odor gas of ammonia and hydrogen sulfide per unit volume was 0.045 and 0.014$\ell/\textrm{cm}^3$ in mixture 1, 0.079 and 0.016$\ell/\textrm{cm}^3$ in mixture 2, 0.123 and 0.017 $\ell/\textrm{cm}^3$ in mixture 3, 0.031 and 0.015$\ell/\textrm{cm}^3$ in mixture 4, 0.055 and 0.016$\ell/\textrm{cm}^3$ in mixture 5, and 0.111 and 0.020$\ell/\textrm{cm}^3$ in mixture 6, respectively. 3. The offensive odor elimination microorganism inoculated to mixture of chaff of pine(70%) and perlite(30%) showed the elimination efficiency of 99.06% and 96.61% against the ammonia and hydrogen sulfide, respectively, during 24 hours period.

• Journal of Bio-Environment Control
• /
• v.18 no.4
• /
• pp.348-353
• /
• 2009

Organic materials reveal the remarkable absorption and high buffer capacity for nutrient. Hence, organic materials need some different nutrient management skill from inorganic one. The objective of this study was to evaluate the effect of EC level of nutrient solution on the yield and quality of cut rose grown in the mixed substrate of coir and perlite. 3 EC levels of nutrient solution was treated, which were 0.7, 1.0, 1.3 times of standard solution (Aichiken solution, Japan) for cut rose hydroponics. EC of the standard solution was changed by season following as 1.4 (Apr.~June), 1.0 (July~Aug.), 1.4 (Sep.~Oct.), and $1.6dS{\cdot}m^{-1}$ (Nov.~Mar.) subsequently. The supply of nutrient solution was controlled by the signal of water potential at -5kPa using frequency domain reflectometry (FDR) sensor. As the results, marketable yield was similar for all treatments until 3rd harvest, but was decreased in high EC level from 4th harvest to 7th harvest as final. 0.7 times of standard solution decreased the ratio of unmarketable rose having short stem below 70cm and increased the ratio of high quality rose having long stem above 91cm. The flower weight and stem diameter of cut rose was higher in the low EC treatment than the others.

• Horticultural Science & Technology
• /
• v.17 no.3
• /
• pp.355-360
• /
• 1999

This study was carried out to investigate the effect of irrigation frequency, particle size and depth of perlite medium on the growth of Dendranthema grandiflorum (Ramat.) Kitamura 'Shuhouno-chikara' grown on recycling system. In Exp 1, the irrigation frequency (IF) was designed as 3 (IF3), 9 (IF9), and 18 (IF18) times a day. Fine and coarse particle size (PS) of perlite was used as a media, and depth of media (DM) was 15 and 10 cm contained in $34{\times}120{\times}15cm$ styrofoam bed. In Exp 2, the IF was 3 (IF3), 6 (IF6), and 9 (IF9) times a day with the same amount of nutrient solution. Fine and coarse PS were used, and DM was 15 and 7.5 cm. In this study, high IF and fine PS was favorable for plant growth. However, as the IF became frequent, difference of plant growth between fine and coarse PS became smaller. Also, shallow media showed little difference with deep media in plant growth. Thus, decreasing the amount of media was recommended to reduce the production cost.

• Journal of Bio-Environment Control
• /
• v.17 no.3
• /
• pp.215-220
• /
• 2008

This study was carried out to find optimum accumulative solar radiation in 'Carnidal' of Perlite Media. The pH was stable from 6.0 to 6.7 during cultivation. Electric conductivity by drainage was higher water than by supply water and electric conductivity was increased at later. Inorganic compound, such as phosphoric, kalium and magnesium were accumulated in crossed system. Especially, kalium and magnesium were highly accumulated. When solar radiation high, consumption of the amount of nutrient solution were increased. Sap flew was $273g{\cdot}hr^{-1}$ per hour from 10 : 30 to 11 : 00 AM. However there was no relation-ship between solar radiation and the mount of sap flew. When amount of solar radiation was $250W{\cdot}hr^{-1}$, cut rose 'Cardinal' nutrient consumption was 212.8 mL at nutrient supply of 50 mL. The yield of cut rose 'Cardinal' was 154.6 ea/10a in perlite media. In the cut rose 'Cardinal', nutrient solution was 50 mL as supplied at solar radiation of $200W{\cdot}hr^{-1}$ and nutrient solution was 30mL as supplied at solar radiation of $250W{\cdot}hr^{-1}$ at low solar radiation in perlite.

• Journal of the Korea Concrete Institute
• /
• v.20 no.5
• /
• pp.653-660
• /
• 2008

The purpose of this study is to analyze the optimal mix design of the sound absorption material that is made from perlite and various binder systems for noise barrier wall. The polymer cement slurry which is made from two types of polymer dispersions, and silicone type inorganic material are used as binder. The test specimens are prepared with various polymer cement ratios, binder ratios, and tested for strengths, freezing and thawing and sound absorption performance by the tube and the reverberation room methods. From the test results, the difference of sound absorption coefficient by the tube method is a little recognized, however, noise reduction coefficient (NRC) of test specimens bound by the polymer cement slurry is in the ranges of 0.48 to 0.51. They are a little higher than those bound by cement only, and are lower values than recommended value of 0.7 by the Ministry of Environment. However, the sound absorption coefficient of test specimens at low frequency range of 250 to 500 Hz by reverberation room method shows very high values as 0.84 to 1.00, and 0.57 to 0.77 at the high frequency. The test specimens with polymer cement slurry binder have a good balance between performance and cost, and have proper properties in strengths, freezing and thawing resistance as sound absorption material for noise barrier wall. It is apparent that the good sound absorption material can be produced according to the optimum mix design that is recommended from this study.

• Journal of Bio-Environment Control
• /
• v.20 no.1
• /
• pp.33-39
• /
• 2011

This experiment was carried out to understand the characteristics of inorganic ion uptake of strawberries to establish a labor saving, environmentally sound closed hydroponic system. Nitrate nitrogen is absorbed in the perlite and granule rockwood with the almost same rate and in the cocopeat with a little bit higher concentration. At the early growth stage, phosphate was absorbed in comparatively high rate, but it is gradually declining to $4me{\cdot}L^{-1}$ in the three treatments except for reused medium. Four treatments showed different absorption rates for potassium, respectively, however, it became $3{\sim}5me{\cdot}L^{-1}$ gradually. But there was few sign to absorb potassium in the reused medium. High concentration of calcium was absorbed in the cocopeat medium and the lowest absorption rate in the granule rockwool, and it turned out to be $2{\sim}3me{\cdot}L^{-1}$ absorption concentration rate in the perlite. All three treatments showed $1me{\cdot}L^{-1}$ at the average absorption concentration rate of magnesium. Iron showed high absorption rate but it showed steadily 1~2 ppm absorption rate. Results of this experiment will be utilized for developing the new substrates for strawberry closed hydroponic system.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.38 no.7
• /
• pp.743-749
• /
• 2014

In this study, a noncircular drawing (NCD) sequence for manufacturing high-strength and high-ductility pearlitic steel wires was investigated. Multipass NCD was conducted up to the 12th pass at room temperature with two processing routes (defined as the NCDA and NCDB), and compared with the wire drawing (WD). During the torsion test, delamination fracture in the drawn wire was observed in the 10th pass of the WD whereas it was not observed until the 12th pass of the NCDB. From X-ray diffraction, the circular texture component that increases the likelihood of delamination fracture of the drawn wire was rarely observed in the NCDB. Thus, the improved ability of the multipass NCDB to manufacture high-strength pearlitic steel wires with high torsional ductility compared to the WD (by reducing the likelihood of delamination fracture) was demonstrated.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.32 no.6 s.107
• /
• pp.103-108
• /
• 2005

It was aimed to promote as a material for interior landscape by validating Rumohra aristata, in an indoor environment, especially irrigation interval, medium composition and drainage at indoor. 1. The result of physico-chemical analysis of medium composition showed that porosity, pH and Ex-Ca, Ex-Mg and Ex-K were high with peatmoss: vermiculite: perlite(1:1:1) and water contents, organic matter content, total nitrogen and cation exchange capacity were high with sand: leaf mold(1:1). 2. Growth and indoor adaptability of Rumohra aristata were better with irrigation at 2 interval per week than irrigation at 7 interval per week regardless of drainage. 3. In the case of medium composition, of growth and indoor adaptability were higher with sud: leaf mold (1:1) than peatmoss: vermiculite: perlite(1:1:1). 4. Fronds fresh weight and dry weight decreased when irrigation interval increased and were higher with sand: leaf mold(1:1) than peatmoss: vermiculite: perlite(1:1:1) treatment.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.30 no.4 s.48
• /
• pp.543-548
• /
• 2004

For pearl pigments used for splendor or gloss effect of make-up products, especiallv point make-up products like eye-shadow and blusher, we studied the variation of particle size distribution by the grinding time and by the binder used as a binding agent. In this study. high speed mixer was used and the particle sire distribution was measured by using the light scattering method. In case of pearl pigments, its median diameter of $5{\;}{\mu}m$, the particle size was reduced to 4.6 um when it was ground for 120 s. When it was applied for the pearl pigment of $45{\;}{\mu}m$, the particle size was reduced to $27{\;}{\mu}m$. We confirmed that the latter was reduced more largely and the original gloss was reduced too. For the binder, we studied the correlation between particle size of raw material and grinding time. We also investigated the effects of the binder contents on the variation of particle size distribution of products by aggregation of particles.