• Journal of the Korean GEO-environmental Society
• /
• v.8 no.5
• /
• pp.5-14
• /
• 2007

The quantity of noxious wastes generated by the growth in industrialization and population in all over the world and its potential hazards in subsurface environments are becoming increasingly significant. The extraction of the contaminant from the soil and movement of the water are restricted due to the low permeability and adsorption characteristics of the reclaimed soils. Incorporated technique with PVDs have been used for dewatering from fine-grained soils for the purpose of ground improvement by means of soil flushing and soil vapor extraction systems. This paper is to evaluate several key parameters that affected to the performance of the PVDs specifically with regard to: well resistance of PVD, zone of influence, and smear effects. In the feasibility of contaminant remediation was evaluated in pilot-scale laboratory experiments. Well resistance is affected on the vertical discharge capacity of the PVDs under the various vacuum pressures. The discharge capacity increases consistently in areal extents with higher applied vacuum up to a limiting vacuum pressure. The head values for each piezometer at different vacuum pressures show that the largest head loss occurs within 14 cm of the PVD. Air flow rates and head losses were measured for the PVD placed in the model test box and the gas permeability of the silty soils was calculated. Increasing the equivalent diameter results in a decrease in the calculated gas permeability. It is concluded that the gas permeability determined over the 1,500 to 2,000 $cm^3/s$ flow rates are the most accurate values which yields gas permeability of about 3.152 Darcy.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.10 no.5
• /
• pp.76-86
• /
• 2007

For the purpose of ground improvement by means of soil flushing systems. Incorporated technique with prefabricated vertical drains have been used for dewatering from fine-grained soils. The laboratory model tests were performed by using the flushing tracer solutions for silty soils and recorded the tracer concentration changes with the elapsed time and flow rates. A mathematical model for prediction of contaminant transport using the PVD technology has been developed. The clean-up times for the predictions on both soil condition indicate more of a sensitivity to the dispersivity parameter than to the extracted flow rate and vertical velocity parameters. Based on the results of the analyses, numerical analysis indicate that the most important factor to the in-situ soil remediation in prefabricated vertical drain system is the effective diameter of contaminated soil.

• Proceedings of the Korea Air Pollution Research Association Conference
• /
• 2000.11a
• /
• pp.409-410
• /
• 2000

생물여과 (biofiltration)로 알려진 기술은 오염물을 gas stream이나 liquid stream을 사용하여 생물학적으로 처리할 수 있다. 주요 방법으로 생물세정 방법과 생물여과의 두 방법을 사용하고 있다. 오염물질 제거효율에 영향을 미치는 인자로는 오염물질의 종류와 특징, 오염물질의 유입농도, 충진물의 종류와 형상, 오염물질이 충진물에 머무름 시간 등이 있다. 일반적으로 생물 여과에 있어서 반응기의 충진물로 compost, peat, wood chips와 토양을 이용하거나 또는 활성이 없는 합성 매체를 이용하기도 한다(Leson and Winer, 1991). (중략)

• Journal of Soil and Groundwater Environment
• /
• v.16 no.4
• /
• pp.31-37
• /
• 2011

The feasibility study of soil flushing was investigated to remediate lubricant oil and zinc contaminated railway soil. In this study, mixed washing agents of surfactant and inorganic acid/base were used for the simultaneous removal. The mixed washing agent of non-ionic surfactant and HCl removed 15% of the lubricant oil and 40% of zinc, respectively. Alkaline-enhanced soil washing process increased the removal of lubricant oil up to 40%. This is because alkaline solution reduced the interfacial tension between water phase and lubricant oil phase due to the soap formation reaction. To simulate in-situ soil flushing for the remediation of railroad-related contamination, two dimensional soil flushing was carried out based on the results of batch soil washing. In the soil flushing, the removal efficiencies of lubricant oil and zinc were 34% and 16%, respectively. Even though the removal efficiency was low, the mixed washing agent can remove metal and lubricant oil simultaneously.

• Journal of the Korean Applied Science and Technology
• /
• v.21 no.4
• /
• pp.313-319
• /
• 2004

Ethanol washing with distillation as a cleanup process of polycyclic aromatic hydrocarbon(PAH)-contaminated soil was investigated in this study. A multistage ethanol washing with distillation process was applied to three different types of soil, i.e., sandy soil, alluvial soil, and clay with the initial concentration of benzo(a)pyrene 10 mg/kg, benz(a)anthracene 250 mg/kg, and pyrene 100 mg/kg soil. Ethanol was selected as washing solvent because of its high PAH removal efficiency, low cost, and non-toxicity comparing to the other solvent such as isopropyl alcohol and sodium dodecyl sulfate. The satisfactory results (i.e. lower than benzo(a)pyrene 1 mg/kg, pyrene 10 mg/kg, benz(a)anthracene 25 mg/kg, which are the Canada or the Netherlands soil standard) for three types of soils were obtained by at most five-six times washing. It was suggested that organic content in soil decreased the removal efficiency by ethanol washing.

• Journal of Korean Society of Environmental Engineers
• /
• v.34 no.5
• /
• pp.304-311
• /
• 2012

Chlorinated ethylenes such as perchloroethylene (PCE) and trichloroethylene (TCE) are widely used as industrial solvents and degreasing agents. Because of improper handling, these highly toxic chlorinated ethylenes have been often detected from contaminated soils and groundwater. Biological PCE dechlorination activities were tested in bacterial cultures inoculated with 10 different environmental samples from sediments, sludges, soils, and groundwater. Of these, the sediment using culture (SE 2) was selected and used for establishing an efficient PCE dechlorinating enrichment culture since it showed the highest activity of dechlorination. The cathode chamber of bioelectrochemical system (BES) was inoculated with the enrichment culture and the system with a cathode polarized at -500 mV (Vs Ag/AgCl) was operated under fed-batch mode. PCE was dechlorinated to ethylene via TCE, cis-dichloroethylene, and vinyl chloride. Microbial community analysis with polymerase chain reaction-denaturing gradient gel electrophoresis (PCR-DGGE) showed that the microbial community in the enrichment culture was significantly changed during the bio-electrochemical PCE dechlorination in the BES. The communities of suspended-growth bacteria and attached-growth bacteria on the cathode surface are also quite different from each other, indicating that there were some differences in their mechanisms receiving electrons from electrode for PCE dechlorination. Further detailed research to investigate electron transfer mechanism would make the bioelctrochemical dechlorination technique greatly useful for bioremediation of soil and groundwater contaminated with chlorinated ethylenes.

• Journal of the Korean GEO-environmental Society
• /
• v.9 no.2
• /
• pp.39-46
• /
• 2008

Due to the growth in industrialization, potential hazards in subsurface environments are becoming increasingly significant. The extraction of the contaminant from the soil and movement of the water are restricted due to the low permeability and adsorption characteristics of the reclaimed soils. There are a number of approaches to in-situ remediation that are used in contaminated sites for removing contaminants. These include soil flushing, dual phase extraction, and soil vapor extraction. Among these techniques, soil flushing was the focus of the investigation in this paper. Incorporated technique with PVDs has been used for dewatering from fine-grained soils for the purpose of ground improvement by means of prefabricated vertical drain systems. The laboratory model tests were performed by using the flushing tracer solutions for silty soils and recorded the tracer concentration changes with the elapsed time and flow rates. The modeling was intended to predict the effectiveness and time dependence of the remediation process. Modeling has been performed on the extraction, considering tracer concentration and laboratory model test characteristics. The computer model used herein are SEEP/W and CTRAN/W, this 2-D finite element program allows for modeling to determine hydraulic head and pore water pressure distribution, efficiency of remediation for the subsurface environment. It is concluded that the coefficient of permeability of contaminated soil is related with vertical velocity and extracted flow rate. The vertical velocity and extracted flow rate have an effect on dispersivity and finally are played an important role in-situ soil remediation.

• The Journal of Engineering Geology
• /
• v.31 no.3
• /
• pp.433-445
• /
• 2021

Plasma blasting by high voltage arc discharge were performed in laboratory-scale soil samples to investigate the fluid penetration efficiency. A plasma blasting device with a large-capacity capacitor and columnar soil samples with a diameter of 80 cm and a height of 60 cm were prepared. Columnar soil samples consist of seven A-samples mixed with sand and silt by ratio of 7:3 and three B-samples by ratio of 9:1. When fluid was injected into A-sample by pressure without plasma blasting, fluid penetrated into soil only near around the borehole, and penetration area ratio was less than 5%. Fluid was injected by plasma blasting with three different discharge energies of 1 kJ, 4 kJ and 9 kJ. When plasma blasting was performed once in the A-samples, penetration area ratios of the fluid were 16-25%. Penetration area ratios were 30-48% when blastings were executed five times consecutively. The largest penetration area by plasma blasting was 9.6 times larger than that by fluid injection by pressure. This indicates that the higher discharge energy of plasma blasting and the more numbers of blasting are, the larger are fluid penetration areas. When five consecutive plasma blasting were carried out in B-sample, fluid penetration area ratios were 33-59%. Penetration areas into B-samples were 1.1-1.4 times larger than those in A-samples when test conditions were the same, indicating that the higher permeability of soil is, the larger is fluid penetration area. The fluid penetration radius was calculated to figure out fluid penetration volume. When the fluid was injected by pressure, the penetration radius was 9 cm. Whereas, the penetration radius was 27-30 cm when blasting were performed 5 times with energy of 9 kJ. The radius increased up to 333% by plasma blasting. All these results indicate that cleaning agent penetrates further and remediation efficiency of contaminated soil will be improved if plasma blasting technology is applied to in situ cleaning of contaminated soil with low permeability.

• Korean Journal of Breeding Science
• /
• v.42 no.6
• /
• pp.674-678
• /
• 2010

A new sweetpotato variety, 'Daeyumi', was developed by Bioenergy Crop Research Center, National Institute of Crop Science (NICS), RDA in 2008. This variety was obtained from the cross between 'Jinhongmi' and 'Xusju 18' in 2000. The seedling and line selections were performed from 2001 to 2003, preliminary and advanced yield trials were carried out from 2004 to 2005, and the regional yield trials were conducted at six locations from 2006 to 2008. 'Daeyumi' has cordate leaf, green vine and petiole, elliptic storage root, red skin and yellow flesh color of storage root. This variety is also resistant to Fusarium wilt and nematode. The starch value was 25.9%, ethanol yield was 418 L/Ton, which was 7% higher than that of 'Yulmi' variety, and the total sugar content was 2.47 g/100g, dry weight. 'Daeyumi's initial temperature of starch gelatinization was lower, 76.2$^{\circ}C$, and the retrogradation process was earlier than 'Yulmi'. The average yield of storage root was 27.8 ton/ha in the regional yield trials, which was 36% higher than that of 'Yulmi' variety. Number of storage roots over 50 gram per plant was 3.0, and the average weight of one storage root was 152 gram. This variety can be used for the production of bioethanol and starch processing.

• Korean Journal of Breeding Science
• /
• v.42 no.6
• /
• pp.679-683
• /
• 2010

'Yeonjami' is a new sweetpotato variety developed for table use by Bioenergy Crop Research Center, National Institute of Crop Science (NICS), RDA in 2008. This variety was selected from the cross between 'Ayamurasakki' and 'Poly Cross' in 2000, and seedling and line selections were practiced from 2001 to 2003. Preliminary and advanced yield trials were carried out from 2004 to 2005. The regional yield trials were conducted at six locations from 2006 to 2008. 'Yeonjami' has cordate leaf, green vine and petiole, long elliptic storage root, purple skin and light purple flesh color of storage root. The average yield of storage root was 25.9 ton/ha in the regional yield trials, which was 15% higher than that of 'Sinjami' variety. Number of storage roots over 50 gram per plant was 2.9, and the average weight of one storage root was 153 gram. This variety was partly-resistant to Fusarium wilt and nematode. In addition, steamed 'Yeonjami' has higher polyphenol contents as 139.6 mg/100 g and higher biological activities as, which may improve the bioactivity in human.