• 한국정보통신설비학회:학술대회논문집
• /
• 2002.08a
• /
• pp.17-20
• /
• 2002

본 논문에서는 세라믹 칩 안테나를 LTCC로 구현하여 다중 대역 특성을 얻는 방법을 제안하고 있다. 휴대용 단말기에 칩 안테나를 내장함으로 물리적 손상을 피하고 위치추적 시스템(GPS) 대역과 단말기 송수신용 대역, 즉 두 대역 이상 사용 가능하고 ${\varepsilon}_r=7.8$인 세라믹 칩 안테나를 LTCC(Low Temperature Co-fired Ceramic)공정을 이용하여 세라믹 칩 내부에 정합 회로를 구현하여 이중 대역 특성을 갖는 구조에 대해 논의하고 있다. 안테나의 전체 크기는 $16mm{\times}4mm{\times}2mm$ 이며 대역폭은 삽입손실 -10dB 기준 대략 1560MHz에서 2160MHz까지 약 600MHz정도이다. 측정은 접지면의 넓이가50mmx50mm이고 두께=0.7874mm, ${\varepsilon}_r=4.6$인 FR4 기판을 이용하여 측정한다.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.13 no.3
• /
• pp.239-254
• /
• 1988

In this paper an exciter which performs modulation and amplification is composed of high power(30dBm) VCO(Voltage Controlled Oscillator) using push-pull circuit. Modulation is FSK using PLL(Phase Locked Loop). A single loop PLL synthesizer having sequency range of 42.5-100.5MHz, 25KHz channel spacing and switching time of 1msec converts down the exciter VCO frequency to 1.25MHz. This signal mixed with the FSK modulated signal coming in the phase detector of exciter. The acquisition time of exciter for frequency hoppng is less than 200usec, so the total acquisition time for transmission is less that 1.5msec. There is no need of additional power amplification because power amlifiction by high power VCO is high enough to communicate within near distance. The proposed frequency synthesizer is not complex so it is suitable for low cost slow frequency hopping spread spectrum communication.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.18 no.5
• /
• pp.97-102
• /
• 2018

In this paper, W-band Waveform Generator for compact radar has been designed and fabricated. DDS (Direct Digital Synthesizer) is applied to generate CW (Continuous Wave) and FMCW (Frequency Modulation Continuous Wave) waveform at high speed. We designed two LO (Local Oscillator) paths for functions of distance delay and distance tracking tests at the prpposed system without extra test equipment. Two mode selections are provided by switch. It is observed that fabricated waveform generator performs -91 dBc/Hz phase noise at offset 1 kHz and -63.2 dBc spurious. Proposed W-band Waveform Generator is expected to apply for W-band compact radar transceiver module.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.13 no.5
• /
• pp.971-978
• /
• 2018

This paper deals with the design and implementation of a limiter, which is a key component of the Ku-band radar system. The limiter design with the multi-pin diode switch was complemented by wideband signal attenuation, and realized the physical implementation. In the test result of implemented limiter, when the pin diode switch is all off, it is possible to transmit the incoming signal without distortion. Also when the pin diode switch is turned on sequentially, the input signal is attenuated about 20dB or more step by step. Finally when all of them were turned on, attenuation about 50dB or more were measured for a wide bandwidth(1000MHz) in Ku-band.

• Proceedings of the Korean Society of Broadcast Engineers Conference
• /
• 2015.07a
• /
• pp.195-198
• /
• 2015

최근 TV 서비스의 가입자 및 TV 프로그램 콘텐츠의 급격한 증가에 따라 빅데이터 처리에 적합한 추천 시스템의 필요성이 증가하고 있다. 본 논문은 사용자들의 간접 평가 데이터 기반의 추천 시스템 디자인 시, 누적된 사용자의 과거 이용내역 데이터를 저장하지 않고 새로 생성된 사용자 이용내역 데이터를 학습하는 효율적인 알고리즘이면서, 시간 흐름에 따라 사용자들의 선호도 변화 및 TV 프로그램 스케줄 변화의 추적이 가능한 토픽 모델링 기반의 알고리즘을 제안한다. 빅데이터 처리를 위해서는 분산처리 형태의 알고리즘을 피할 수 없는데, 기존의 연구들 중 토픽 모델링 기반의 추론 알고리즘의 병렬분산처리 과정 중에 핵심이 되는 부분은 많은 데이터를 여러 대의 기계에 나누어 병렬분산 학습하면서 전역변수 데이터를 동기화하는 부분이다. 그런데, 이러한 전역데이터 동기화 기술에 있어, 여러 대의 컴퓨터를 병렬분산처리하기위한 하둡 기반의 시스템 및 서버-클라이언트간의 중재, 고장 감내 시스템 등을 모두 고려한 알고리즘들이 제안되어 왔으나, 네트워크 대역폭 한계로 인해 데이터 증가에 따른 동기화 시간 지연은 피할 수 없는 부분이다. 이에, 본 논문에서는 빅데이터 처리를 위해 사용자들을 클러스터링하고, 클러스터별 제안 알고리즘으로 전역데이터 동기화를 수행한 것과 지역 데이터를 활용하여 추론 연산한 결과, 클러스터별 지역별 TV프로그램 시청 토큰 별 은닉토픽 할당 테이블을 유지할 때 추천 성능이 더욱 향상되어 나오는 결과를 확인하여, 제안된 구조의 추천 시스템 디자인의 효율성과 합리성을 확인할 수 있었다.

• Journal of KIISE:Information Networking
• /
• v.30 no.5
• /
• pp.573-580
• /
• 2003

Increasing user demand for the more bandwidths in wireless communications has motivated a new challenge to utilize the benefits of wireless ATM technology This paper focuses on how to provide IP services to a mobile user over wireless ATM networks. By enhancing the NHRP standard, several shortcomings are improved that are resulted from the naive combinations of Mobile IP over ATM and IP over wireless ATM. This paper presents a mobile location management algorithm that is referred to as the Mobile NHRP scheme. The mobile tracking procedure and the mobile locating procedure are explicitly defined in the proposed scheme. On the locating procedure, the source station may obtain the current location of the destination from NHSs(Next Hop Servers). Therefore the optimized connection can be setup directly. The total costs per move and per setup over ATM/IP overlaid networks are estimated.

• Journal of the Institute of Convergence Signal Processing
• /
• v.14 no.3
• /
• pp.191-204
• /
• 2013

In this paper, we investigated the correlation outputs of Daejeon correlator at the viewpoints of the buffer memory setting related to the fine delay tracking and the under/overflow issue in FFT modules, in order to eliminate DC-like component and phase concentration to 0 degree. As the ring buffer memory is being used for the fine delay tracking, the DC-like component in correlation outputs is generated by improper setting of data read/write address, and then that address setting method is modified to exclude a polluted FFT segment in correlation processing when crossing the port/stream boundary. The phase concentration to 0 degree at beginning of bandpass is caused by inadequate scaling factors, which may be the origins of under/overflow occurred at internal computation of FFT stage. With the revised method of the ring buffer memory setting and the scaling factors in FFT, we could obtain higher signal-to-noise ratio and flux density, compared to the previous method, through the correlation processing of true observational data.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.44 no.5
• /
• pp.45-53
• /
• 2007

To recover transmitted signal perfectly at DTV receiver, we have to acquire carrier frequency synchronization to compensate pilot signal which located in wrong position and rotated phase. Also, we need a symbol timing synchronization to compensate sampling timing error. Conventionally, to synchronize symbol timing, we use Gardner's scheme which used in multi-level signal. Gardner's scheme is well known for its sampling the timing error signal from every symbol and it makes easy to detect and keep timing sync in multi-path channel. In this paper, to discuss the problem when the received power level is out of range and we cannot get synchronization information. With this problem, we use 2 step procedures. First, we put a received signal power compensation block before Garder's timing error detector. Second, adaptive loop filter to get a fast synchronization information and averaging loop filter's output value to reduce the amount of jitter after synchronization in PLL(Phased Locked Loop) circuit which is used to get a carrier frequency synchronization and symbol timing synchronization. Using the averaging value, we can estimate offset. Based on offset changing ratio, we can adapt adaptive loop filter to carrier frequency and symbol timing synchronization circuit.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.9 no.1
• /
• pp.65-75
• /
• 2005

Measurement of network traffic have shown that the self-similarity is a ubiquitous phenomenon spanning across diverse network environments. In previous work, we have explored the feasibility of exploiting the long-range correlation structure in a self-similar traffic for the congestion control. We have advanced the framework of the multiple time scale congestion control and showed its effectiveness at enhancing performance for the rate-based feedback control. Our contribution is threefold. First, we define a modular extension of the TCP-a function called with a simple interface-that applies to various flavours of the TCP-e.g., Tahoe, Reno, Vegas and show that it significantly improves performance. Second, we show that a multiple time scale TCP endows the underlying feedback control with proactivity by bridging the uncertainty gap associated with reactive controls which is exacerbated by the high delay-bandwidth product in broadband wide area networks. Third, we investigate the influence of the three traffic control dimensions-tracking ability, connection duration, and fairness-on performance.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.7
• /
• pp.532-539
• /
• 2018

A position estimation technique is presented for a missile using high-resolution range profiles obtained by three wideband radars. Radar measures a target range using a reflected signal from the surface of a missile. However, it is difficult to obtain the range between the radar and the origin of the missile. For this reason, the interior angle between the moving missile and tracking radar is calculated, and a compensated range between surface of the missile and its origin is added to the tracking range of the radar. Therefore, position estimation of a missile can be achieved by using three total ranges from each radar to the origin of the missile. To verify the position estimation of the missile, electromagnetic numerical analysis software was used to prove the compensated range according to the flight position. Moreover, a wideband radar operating at 500-MHz bandwidth was applied, and its range profile was used for the position estimation of a missile.