• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2002.10a
• /
• pp.888-891
• /
• 2002

This paper presents the lubrication characteristics of a disk type wavy thrust bearing. The hydrodynamic pressure distributions in the fluid film are numerically solved the Reynolds equation and then the bearing load capacity and friction forces acting on the disk are calculated. Especially the effects of number and amplitude of the circumferential waves are investigated for tilted operating conditions. The results showed that the load capacity increases with wave amplitude and optimum wave number exists for given design conditions. Therefore the results can be applied to enhance the lubrication performance of thrust bearing adopted in the scroll compressor.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2007.04a
• /
• pp.217-221
• /
• 2007

In this study, forced vibrations analysis was performed for main wing of small scale WIG vehicle which is equipped two-stroke pusher type propeller engine, in terms of structural. for the frequency response analysis, excitations were assumed by H-mode(Horizontal mode), X-mode(Twisted mode) which is main vibration mode of engine, and for the transient response analysis, excitations were assumed by L-mode(Longitudinal mode) with propeller thrust which is occurred when it revolution.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.14 no.6
• /
• pp.1067-1072
• /
• 2011

If the flow of booster gas which is exhausted to the rear part of a canister is properly restricted in the canister of a hot-launch system, the resultant pressure built up in the canister provides additional force to accelerate the missile to a required launch velocity. These thrust augmentation performances can be controlled through the configuration design of baseplate orifices. In this paper, the simple technique to analyze the thrust augmentation performances of baseplate orifices is suggested and the thrust augmentation characteristics by its various configurations are compared. According to the initial displacement of a missile, the inner pressure of a canister is measured from scaled cold flow tests, and the discharge coefficient of baseplate orifices is calculated. Then the thrust augmentation in a canister is simulated by applying these discharge characteristics to the AMESIM software for launch dynamics.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2004.10a
• /
• pp.292-295
• /
• 2004

Firing performance test of hydrazine decomposition catalyst which is used in mono-propellant thruster of satellite and launcher was peformed. Equipment for catalyst test was developed and with this equipment reaction delay time, catalyst activity, granule stability of the catalyst firing performance was measured and analyzed.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2009.08a
• /
• pp.384-384
• /
• 2009

• Proceedings of the Korean Vacuum Society Conference
• /
• 2009.08a
• /
• pp.369-369
• /
• 2009

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 1999.10a
• /
• pp.16-16
• /
• 1999

최근 세계적인 관심을 끌고있는 레이저 광원에 의한 공기흡입추진기술의 연구 동향을 소개하고 레이저 추진 램가속기의 응용 방법, 제안된 램가속기 탄체 형상, 작동원리, 사용 레이저 특성을 제시하고, 레이저 추진 기술의 주요기술인 레이저 유도 플라즈마 유동의 해석을 위한 매우 간단한 추력면 형상에 대한 수치계산 결과와 현상의 설명을 제시한다.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.50 no.1
• /
• pp.1-12
• /
• 2022

Wind tunnel test for a small scale electric ducted fan with a 104mm diameter was conducted to analyze the aerodynamic characteristics when it was used as a propulsion system of tilt-propeller UAV. Experimental conditions were derived from flight conditions of a sub-scaled OPPAV. Forces and moments of the ducted fan model were measured by a 6-axis balance and 3-dimensional wake vectors which could induce an aerodynamic influence in the vehicle were measured by 5-hole probes. Thrust and torque on hover and cruise conditions were measured and analyzed to drive out the operating conditions when it was applied in the sub-scaled OPPAV. On transition conditions, thrust keep its value with tilt angle variation below 40° and increase after that. But, sideforce increase constantly until 75°. The maximum axial velocity in the wake on hover and cruise conditions was around 60m/s and tangential velocity was around 12m/s. The position of the maximum axial velocity and vortex center move off the fan rotation center line as the tilt angle increases.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.44 no.2
• /
• pp.116-122
• /
• 2016

The performance characteristics of a TBCC engine considering the transition mode from a turbojet to a ramjet engine has been investigated. The performance of each engine was proposed and a transition mode of the TBCC engine has been evaluated by adjusting the operating rate of the ramjet engine and turbojet engine performance changes continuously. Based on the transition model, it was confirmed that the performance is continuously changed at various flight Mach numbers and altitudes. The performance characteristics including thrust and specific impulse considering various flight conditions and transition mode were analyzed, which testifies characteristics of the engine itself, as well as transition of the combined cycle.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.32 no.4
• /
• pp.111-117
• /
• 2004

An analytical study was carried out to evaluate the regenerative cooling characteristics in the liquid rocket engine of a 10tf-thrust level using kerosene as a fuel. As a supplementary cooling method, a radiative cooling was applied to the nozzle extension. It was found out from this work that the cooling system with the regenerative and radiation cooling only is not adaptable for the liquid rocket engine of a 10tf-thrust level using kerosene as a fuel for the $2^{nd}$ stage of the space launch vehicle, with the viewpoint of the thermal and thermo-structural instability and the excessive pressure drop in the cooling channel.