• Polymer(Korea)
• /
• v.29 no.6
• /
• pp.588-592
• /
• 2005

For the purpose of obtaining polycarbonate film which blocks ultra-violet ion beam was irradiated onto the surface of PC film. This method has gotten several advantages compared with the techniques, such as the protection of changes in film thickness and UV blocking material deposited onto a base film. In order to investigate UV blocking PC film, the optical and chemical characteristics, surface morphology and lightfastness were confirmed by UV/Vis, FTIR(ATR) spectroscopy, AFM, and Q-UV fasoess analyses. As a result, it was shown that the modified PC film was able to block almost all of UV region and easily control the degree of UV block. The optical changes in the film were attributed to chemical changes in PC surface by ion beam irradiation. Moreover, we expect that the modified PC film can durably block UV due to no changes in colour and UV transmittance after UV fastness test.

• Journal of the Korea Institute of Building Construction
• /
• v.1 no.2
• /
• pp.165-173
• /
• 2001

This study examinated the application in construction field and the development of waterproofing material system by the spray water-soluble rubber asphalt to solve the problems of synthetic polymer sheet and gio membrane(A mat sheet of Bentonite) that had been used domestic waterproofing material in advance. As the result of study, characters of study water-soluble rudder asphalt are the follows: 1) The amount of water absorption was '0.06'g and the seepage quality was '0'g in result. 2) The tensile strength was about 30.7kgf/$\textrm{cm}^2 and the elongation was about 72.4% in result. 3) After reliance of temperature test had been ended, the tensile strength was about 72.4kgf/$\textrm{cm}^2 in low temperature and about 30.7kgf/$\textrm{cm}^2 in normal temperature. 4) After acid and alkaline treatment had been ended, the tensile strength was about 19.7kgf/$\textrm{cm}^2$ and about 21.9kgf/$\textrm{cm}^2 in result. 5) After chlorine ion treatment had been ended, the tensile strength was 28.5kgf/$\textrm{cm}^2$ and the elongation was 250% in result. 6) The impact performance was subsided at 1.5m height. 7) After promotion weathering had been ended, the tensile and elongation was about 26.0kgf/$\textrm{cm}^2, 214% in result. So, this study can propose the spray water-soluble rubber asphalt to satisfy the and durability of waste filled land.

• Journal of the Korean Geotechnical Society
• /
• v.29 no.4
• /
• pp.13-22
• /
• 2013

To simulate the soft ground improved by vertical drain method and to investigate the effect of overlapping smear on subsequent consolidation behavior, a series of consolidation tests with a large consolidation chamber and mandrel insertion device were conducted. Based on the test result, numerical analysis was also performed to analyze the efficiency of the vertical drain method. Laboratory test and numerical analysis results showed that the effect of smear zone increased consolidation settlement but the overlapping smear zone decreased the consolidation settlement. In addition, vertical drain accelerated consolidation rate but narrowing the drain spacing did not affect the consolidation rate because of the effect of smear. The efficiency of consolidation rather decreased substantially when the smear zone was overlapped.

• Journal of the Korean Geosynthetics Society
• /
• v.6 no.4
• /
• pp.15-20
• /
• 2007

Recently, the demand for industrial and residental land are increasing with economic growth, but it is difficult to acquire areas for development with good ground condition. For efficient and balanced development of land, new development projects are being carried out not only the areas with inland but those with the soft ground as well. As soft grounds have complex engineering properties and high variations such as ground subsidence especially when their strength is low and depth is deep, we need to accurately analyze the engineering properties of soft grounds and find general measures for stable and economic design and management. Vertical drain technology is widely used to accelerate the consolidation of soft clay deposits and dredged soil under pre-loading and various types of vertical drain are used with there discharge capacity. Under field conditions, discharge capacity is changed with various reason, such as soil condition, confinement pressure, long-term clogging and folding of vertical drains and so on. Therefore, many researcher and engineer recommend the use of required discharge capacity. In this paper, the experiment study were carried out to obtain the discharge capacity of six different types of vertical drains by utilizing the large-scale model tests and discharge capacity, degree of consolidation with the time elapsed.

• Journal of the Korean Geosynthetics Society
• /
• v.14 no.4
• /
• pp.147-158
• /
• 2015

In this study, sewer backfill material was developed to prevent sewer damage and ground subsidence. Laboratory test was performed in the field of CA replacement ratio, accelerator type and replacement ratio and W/M. The compression strength of backfill material was 0.55~0.64MPa below in W/M 70% and 0.20MPa over W/B 80%. Ice block was used to simulate the ground cavity and subsidence caused by sewer damage in application study. The existing sand compaction and the new backfill material was comparative estimated in field. The ground settlement of cross section was 23.4cm and that of longitudinal section was 27cm in sand compaction section, but the ground had not sunk in backfill material section.

• Journal of the Korean Electrochemical Society
• /
• v.3 no.2
• /
• pp.121-126
• /
• 2000

The effect of electroless Ni and Cu plating on $LaNi_5$, $AB_5$ type hydrogen storage alloy was investigated by the various electrochemical techniques such as constant current charge-discharge test, cyclic voltammeoy, and a.c. impedance spectroscopy. Scanning electron microscopy and X-ray diffraction test were conducted for phenomenological logical analyses. Cyclic Voltammetry results show that activation characteristics, cycle life and reaction ,rate were improved through electroless Ni and Cu plating. Compared with bare $LaNi_5$ the charge transfer resistance of electrode was greatly reduced as charge-discharge cycle increases. Therefore, electroless Ni and Cu plating on $LaNi_5$ alloy tends to accelerate the early activation, increasing the cyclic lift of electrode.

• Journal of the Korean GEO-environmental Society
• /
• v.2 no.3
• /
• pp.57-69
• /
• 2001

Sand pile is widely used as a ground improvement method. Although the primary purpose of constructing sand pile is accelerating consolidation, composite ground effect also can be gained by constructing sand pile. This study was accomplished to understand composite ground effect on the ground improved by sand piles which were applied as vertical drainage material when area replacement ratio was small relatively. For determining bearing capacities of origin ground and sand piles and analysing interaction between embankment and origin ground, bearing tests and earth pressure monitoring are performed. From the results, it turned out that the contribution of sand pile as a load bearing mechanism is not substantial. However, the bearing capacity of sand pile was increased to sixty percentages when compared with origin ground. The increasement of bearing capacity could be caused the change of consolidation characteristics during the process of consolidation by overburden load. Therefore, the composite ground effects depending on stiffness increasement of sand pile would be estimated as a factor decreasing consolidation settlement.

• Korean Journal of Food Science and Technology
• /
• v.2 no.1
• /
• pp.113-120
• /
• 1970

For the purpose of disinfection and efficient storage, Korean Paldal variety rice was hulled into the unpolished and polished ones and packed in the kraft paper bags, irradiated with relatively high doses, 500, 800, and 1,000 krad from the $CO^{60}$ source and stored at room temperature, a variety of changes were observed as follows. 1) With 1,000 krad irradiation, mold was almost sterilized. 2) Fat acidity increased during storage and continued to increase more with increased doses. 3) The content of riboflavin eras severely reduced with higher doses. 4) The results of organoleptic test were featured by a yellow color and a keen irradiation odor appearing in the boiled rice. 5) In the irradiated rice starch with 3,000 krad, hydrolysis with ${\alpha}$-amylase was not effective while accelerated with diastase.

• Journal of Veterinary Clinics
• /
• v.21 no.2
• /
• pp.93-96
• /
• 2004

We examined the responses of PBMCs to house dust mite (HDM) allergen in atopic and healthy, non-atopic dogs to identify differences in lymphocyte reactivity that might reflect the immunologic status of atopic dermatitis. Thirteen of 20 (65%) atopic dogs showed a positive lymphocyte proliferative response to HDM allergen. The rate of response was significantly higher in the atopic dogs than that in healthy, non-atopic dogs insensitive to the allergen (P = 0.007). The proliferative responses were positively correlated with the level of HDM-specific IgE in serum (P = 0.035), and were thereby confirmed to reflect the activity of lymphocytes competent to promote IgE production. These results suggest that HDM-specific lymphocytes were present in peripheral blood and played a role in the pathogenesis of canine atopic dermatitis.

• Journal of Bio-Environment Control
• /
• v.6 no.3
• /
• pp.225-234
• /
• 1997

This study was carried out to investigate the native distribution of wax myrtle (Myrica rubra) in Cheju Province and its propagation method. Wax myrtle is heavily distributed at 100 to 400m above sea level of Donhong-chun and Hyodon-chun which is bordered by Youngchon-dong of Seogwipo City and Haryeri of Namcheju county. BA, IBA, Kinetin, IAA, and GA3 were applied to promote rooting of cutting but were ineffective in promoting rooting. Treating cuttings with both AgNO,1 which removes rooting inhibitor, tannin and growth regulators such as BA, IBA and Kinetin were also ineffective in promoting rooting. Incubating seeds at 4$0^{\circ}C$ for 30 days resulted in 39％ germination. There was distinct difference in leaf shape between seedlings and mature trees.