• Title/Summary/Keyword: 채널 구성

Search Result 1,553, Processing Time 0.045 seconds

Design of Remote Control Electrical Switch Using Embedded Linux (임베디드 리눅스를 이용한 원격 제어 전기 스위치 개발)

  • 박세현;박세훈;노석호
    • Proceedings of the Korean Institute of Information and Commucation Sciences Conference
    • /
    • 2004.05b
    • /
    • pp.788-791
    • /
    • 2004
  • 임베디드 리눅스를 이용한 원격 제어 전기 스위치를 개발한다. 산업 전반에 널리 보급된 인터넷을 이용하여 실시간으로 원격 전기 스위치 기기의 상태를 파악하고 제어함으로서 시간과 공간 및 비용 절감이라는 측면에서 효과를 볼 수 있다. 본 논문에서 설계된 원격 전기 스위치의 서버는 MPC860으로 구성되어 임베디드 리눅스가 포팅되었다. 클라이언트는 서버의 웹 페이지를 접속함으로서 전자 스위치를 원격 관리를 할 수 있게 HTML과 자바로 설계되어 있다. 하나의 서버는 마스트로서 다수의 슬레이브를 가지고 있으며 슬레이브는 전기스위치들과 아날로그 채널로 구성되어 있다.

  • PDF

Multi-channel Transimpedance Amplifier Arrays in Short-Range LADAR Systems for Unmanned Vehicles (무인차량용 단거리 라이다 시스템을 위한 멀티채널 트랜스임피던스 증폭기 어레이)

  • Jang, Young Min;Kim, Seung Hoon;Cho, Sang Bock;Park, Sung Min
    • Journal of the Institute of Electronics and Information Engineers
    • /
    • v.50 no.12
    • /
    • pp.40-48
    • /
    • 2013
  • This paper presents multi-channel transimpedance amplifier(TIA) arrays in short-range LADAR systems for unmanned vehicles, by using a 0.18um CMOS technology. Two $4{\times}4$ channel TIA arrays including a voltage-mode INV-TIA and a current-mode CG-TIA are introduced. First, the INV-TIA consists of a inverter stage with a feedback resistor and a CML output buffer with virtual ground so as to achieve low noise, low power, easy current control for gain and impedance. Second, the CG-TIA utilizes a bias from on-chip bandgap reference and exploits a source-follower for high-frequency peaking, yielding 1.26 times smaller chip area per channel than INV-TIA. Post-layout simulations demonstrate that the INV-TIA achieves 57.5-dB${\Omega}$ transimpedance gain, 340-MHz bandwidth, 3.7-pA/sqrt(Hz) average noise current spectral density, and 2.84mW power dissipation, whereas the CG-TIA obtains 54.5-dB${\Omega}$ transimpedance gain, 360-MHz bandwidth, 9.17-pA/sqrt(Hz) average noise current spectral density, and 4.24mW power dissipation. Yet, the pulse simulations reveal that the CG-TIA array shows better output pulses in the range of 200-500-Mb/s operations.

Channel Variation Tracking based Effective Preferred BS Selection Scheme of Idle Mode Mobile device for Mobile WiMAX System (Mobile WiMAX시스템에서 채널품질 변동추적을 이용한 유휴모드 이동단말의 효율적인 선호기지국 선택 방안)

  • Lee, Kang-Gyu;Youn, Hee-Yong
    • The KIPS Transactions:PartC
    • /
    • v.17C no.6
    • /
    • pp.471-484
    • /
    • 2010
  • In the wireless communication systems, the power consumption of a mobile device is very important issue due to its battery limitations. Hence most of the standards for wireless networks including a mobile WiMAX system are supporting their own power saving mode in way that a mobile device is able to reduce its energy usage while in the mode. However, those standards just define the arrangement of special time intervals, called a paging listening interval, during which the device needs to receive the paging-related control messages, and they do not specify how to effectively reduce the power in many different network environments. This means the amount of power spent by the device is very dependent on the implementations of individual device-vendors, and undesirable paging loss may happen according to the channel conditions. To reduce unnecessary power usage and the risk of paging loss, this paper proposes the effective frequency/BS selection algorithm applicable to a mobile device operating in the power saving mode, which serves the device with better BS based on the tracking for channel variation. This algorithm consists of the channel estimation phase during each paging listening interval, the tracking phase for the measured results, the frequency reselection phase based on the tracking activity, and the preferred BS reselection phase. Thus the proposed method can improve the paging performance while the device is moving in the network. Also the simulation result shows that the presented scheme is superior to other candidates in energy efficiency due to the channel-adaptive frequency/BS selection.

A Study on Mobile Antenna System Design with Tri-band Operation for Broadband Satellite Communications and DBS Reception (광대역 위성 통신/방송용 삼중 대역 이동형 안테나 시스템 설계에 관한 연구)

  • Eom Soon-Young;Jung Young-Bae;Son Seong-Ho;Yun Jae-Seung;Jeon Soon-Ick
    • The Journal of Korean Institute of Electromagnetic Engineering and Science
    • /
    • v.17 no.5 s.108
    • /
    • pp.461-475
    • /
    • 2006
  • In this paper, it is described about the tri-band mobile antenna system design to provide broadband multimedia and direct broadcasting services using goo-stationary Koreasat 3, simultaneously operated in Ka/K/Ku band. The radiating part of the antenna system with a fan beam characteristic in the elevation plane is composed of the quasi-offset dual shaped reflector and the tri-band feeder. The tri-band feeder is also composed of the Ka/K dual band feeder with the protruding dielectric rod, the circular polarizer, the ortho-mode transducer and the circular-polarized Ku band feed array. Especially, the Ka/K dual band circular polarizer was realized firstly using the comb-type structure. For fast satellite-tracking on the movement, the Ku band feed array has the structure of the $2{\times}2$ active phased array which can make electrical beams. And, the circular-polarized characteristic in the feed array was improved by $90^{\circ}$ rotating arrangement of four radiating elements polarized circularly by a $90^{\circ}$ hybrid coupler, respectively. Four beam forming channels to make electrical beams at Ku band are divided into the main beam channel and the tracking beam channel in the output, and noise temperature characteristics of each channel were analyzed on the basis of the contributions of internal sub_units. From the fabricated antenna system, the output power at $P_{1dBc}$ of Ka_Tx channel was measured more than 34.1 dBm and the measured noise figures of K/Ku_Rx channels were less than 2.4 dB and 1.5 dB, respectively, over the operating band. The radiation patterns with co- and cross-polarization in the tri-band were measured using a near-field measurement in the anechoic chamber. Especially, Ku radiation patterns were measured after correcting each initial phase of active channels with partial radiation patterns obtained from the independent excitation of each channel. The antenna gains measured in Ka/K/Ku band of the antenna system were more than 39.6 dBi, 37.5 dBi, 29.6 dBi, respectively. And, the antenna system showed good system performances such as Ka_Tx EIRP more than 43.7 dBW and K/Ku_Rx G/T more than 13.2 dB/K and 7.12 dB/K, respectively.

MAC Layer of IEEE 802.11 Wireless LAN (IEEE 802.11 무선 근거리통신망의 MAC계층)

  • Park, Yeong-Mi;Jeong, Hui-Chang
    • Electronics and Telecommunications Trends
    • /
    • v.11 no.4 s.42
    • /
    • pp.89-101
    • /
    • 1996
  • 본 논문은 IEEE 802.11 프로토콜 구성과 무선 근거리 통신망의 매체접근제어(Media Access Control: MAC), 공유자원인 무선채널을 액세스하기 위하여 사용하는 대표적인 MAC방식을 분류하여 설명하였고, MAC의 핵심이 되는 매체접근제어 프로토콜인 DFWMAC(Distributed Foundation Wireless MAC)의 핵심기능에 대하여 소개한다.

Heat Transfer by Heat Generation in Electrochemical Reaction of PEMFC (고분자 전해질 연료전지에서 전기화학반응 열생성에 의한 열전달특성)

  • Han, Sang-Seok;Lee, Pil-Hyong;Lee, Jae-Young;Park, Chang-Soo;Hwang, Sang-Soon
    • Journal of the Korean Electrochemical Society
    • /
    • v.11 no.4
    • /
    • pp.273-283
    • /
    • 2008
  • GDL(Gas Diffusion Layer) is one of the main components of PEM fuel cell. It transports reactants from the channel to the catalyst and removes reaction products from the catalyst to the channels in the flow filed plate. It is known that higher permeability of GDL can make it possible to enhance the gas transport through GDL, leading to better performance. And MEA's temperature is determined by gas and heat transport. In this paper, three dimensional numerical simulation of PEM fuel cell of parallel channel and serpentine channel by the permeability of GDL is presented to analysis heat and mass transfer characteristics using a FLUENT modified to include the electrochemical behavior. Results show that in the case of parallel channel, performance variation with change of permeability of GDL was not so much. This is thought because mass transfer is carried out by diffusion mechanism in parallel channel. Also, in the case of serpentine channel, higher GDL permeability resulted in better performance of PEM fuel cell because of convection flow though GDL. And mass transfer process is changed from convection to diffusion when the permeability becomes low.

Could Cable Local Channels Be an Alternative to Strengthen Broadcast Locality? Exploring the Possibility of Linking Local Terrestrial and Cable Local Channels (케이블 지역채널은 방송 지역성 강화의 대안일 수 있을까? 지역 지상파와 케이블 지역채널 간 접목 가능성 탐색)

  • Kim, Jaeyoung
    • Korean journal of communication and information
    • /
    • v.84
    • /
    • pp.7-27
    • /
    • 2017
  • This study explores the possibility of maximizing locality through synergy between local terrestrial broadcasters and cable local channels. To this end, it examines the significance of the concept of locality in the changing environment represented by the 4th Industrial Revolution. It also analyzes the existing situation of broadcasting locality and the terrain of existing studies concerning cable local channels. Based on the reviews, the study searches for the connection points between local terrestrial and cable channels, which are still heterogeneous operators. The difference in the size of broadcast region and the programming time constitutes the optimum condition. As a result of this, the study discusses the issue of appropriateness and feasibility of bundling the local terrestrial and pay-TV channels in the same legal system. By doing so, it reveals the biggest obstacle in institutionalizing the cable channel into the public category is the emotional rejection towards cable TV. In order to overcome this problem, the study suggests to abolish both the current policy guideline characterized as the same service, same regulation principle and the abolition of local business right of cable TV. It also proposes to allow news commentary function of cable local channels and strengthen cable TV's own capabilities.

  • PDF

On the Performance Analysis of Coherent Bandwidth in Underwater Channel Environments Using Beamforming Technologies Based on the Use of Measurement Data (측정 데이터를 이용한 빔형성기의 적용에 의한 수중 채널 환경에서의 상관 대역폭 분석)

  • Kim, Min-Sang;Cho, Dae-Young;Kim, Kye-Won;Lee, Tae-Seok;Park, Jong-Won;Lim, Yong-Gon;Ko, Hak-Lim
    • Journal of the Institute of Convergence Signal Processing
    • /
    • v.15 no.4
    • /
    • pp.162-168
    • /
    • 2014
  • The OFDM system have been widely studied for the purpose of increasing data rate with more reliable communications in underwater channel environments. And it is possible only when the sub-carrier's bandwidth is smaller than the coherence bandwidth of channel in the underwater OFDM communication system. However, the size of the FFT for the OFDM system will be increased because the coherence bandwidth is as small as several tens of Hz in real underwater channel environments. Also, It is necessary to add a CP having a length longer than the rms delay spread of a channel. So the complexity of the system is increased and the data efficiency is reduced. Therefore, in this paper, we have studied the increase of the coherence bandwidth by adapting the beamforming technologies. To do this, we have collected data from real underwater channel environments and analyzed the coherence bandwidth when adapting the beamforming technologies. Analyzing the experimental data show that the coherence bandwidth by the beamforming technologies in underwater channel environments was greatly increased compared to that of a single sensor.