• Journal of Advanced Navigation Technology
• /
• v.16 no.1
• /
• pp.96-102
• /
• 2012

The goal of mobile internet system is to provide a high-data-rate, low-latency and optimized packet radio access technology supporting flexible bandwidth deployments. Therefore, network architecture is designed with the goal to support packet-switched traffic with seamless mobility, quality of service and minimal latency. An important requirement for the mobile internet system is improved cell-edge BER performance and data throughput. This is to provide some level of service consistency in terms of geographical coverage as well as in terms of available data throughput within the communication coverage area. In a cellular system, however, the signal to interference plus noise power ratio gap between cell-center and cell-edge users can be of the order of 20 [dB]. The disparity can be even higher in a communication coverage limited cellular system. This leads to vastly lower data throughputs for the cell-edge users relative to cell-center users creating a large QoS gap. This paper proposes a analytical approach that tries to reduce inter-cell interference, and shows the SIR and BER performance according to the OFDM system parameters in mobile Internet environment.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.5 no.5
• /
• pp.977-984
• /
• 2001

In this paper, Genetic-Fuzzy Algorithm for Inverted Pendulum is presented. This Algorithms is combine Fuzzy logic with the Genetic Algorithm. The Fuzzy Logic Controller is only designed to two inputs and one output. After Fuzzy control rules are determined, Genetic Algorithm is applied to tune the membership functions of these rules. To measure of performance of the designed Genetic-Fuzzy controller, Computer simulation is applied to Inverted Pendulum system. In the simulation, In the case of f[0.3, 0.3] Fuzzy controller is measured that maximum undershoot is $-5.0 \times 10^{-2}[rad]$, maximum undershoot is $3.92\times10^{-2}[rad]$ individually however, Designed algorithm is zero. The Steady state time is approximated that Fuzzy controller is 2.12[sec] and designed algorithm is 1.32[sec]. The result of simulation, Resigned algorithm is showed it's efficient and effectiveness for Inverted Pendulum system.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.10
• /
• pp.6969-6976
• /
• 2015

As new technologies are advancing and development paradigms are changing, software development process and development methods are evolving progressively. As a result, because the number of developing and managing processes and methodologies are increasing as a project in companies, effective management methods are needed. Especially, because companies should apply optimized methodology according to project's size and characteristics, customization technique of methodology is required urgently. In this paper, we propose a meta-model based methodology framework which can integrate and manage methodologies being developed progressively. Applying proposed methodology framework, a company is able to manage as well as develop optimized methodology easily as a project. Especially, because a proposed methodology framework is developed by meta-model, adding or extending new methodology elements can be realized simply as well as method elements are reused easily in case of customization of methodology as a project.

• The Journal of the Korea Contents Association
• /
• v.15 no.12
• /
• pp.525-533
• /
• 2015

The evolution of spectrum sharing technology enables the creation of many business scenarios and business models such as TV white space service. Business models considering spectrum sharing should guarantee economic feasibility for service providers and increasing benefit for service users. In addition, new business models should contribute to economic activation in the wireless telecommunication service industry. It is therefore necessary to design quantitative evaluation methods for selection of the best business models. The methods should reflect the various points of view of valuation. Our research addresses evaluation method for business models considering spectrum sharing. We define evaluation indicators to reflect the distinct characteristics of spectrum sharing. Also, we adopt analytic hierarchy process(AHP) to derive the weights of each indicator to evaluate business models considering spectrum sharing.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.38 no.5
• /
• pp.489-495
• /
• 2014

A micro-genetic algorithm (MGA) is one of the improved forms of a genetic algorithm. It is used to reduce the number of iterations and the computing resources required by using small populations. The efficiency of MGAs has been proved through many problems, especially problems with 3-5 design variables. This study proposes an optimization algorithm based on the sequential design of experiments (SDOE) and an MGA. In a previous study, the authors used the SDOE technique to reduce trial-and-error in the conventional approximate optimization method by using the statistical design of experiments (DOE) and response surface method (RSM) systematically. The proposed algorithm has been applied to various mathematical examples and a structural problem.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.8
• /
• pp.5260-5266
• /
• 2015

To develop weapon system, Concurrent Spare Parts(CSP) is one of the important somethings in terms of Intergrated Logistics System(ILS). CSP is very important to improve the availability of weapon system, and various research about CSP are performed. However, most of the research does not consider the effects between sub-item's failure and weapon system's multiple function. In other words, if sub-item's failure does not seriously influence weapon system's specific function, the point, not necessarily to replace sub-item, is not considered. Therefore, the method to calculate CSP based on above consideration is written by failure-function matrix in this paper. The study follows the procedure below. First, it's to define the operation and maintenance procedure of weapon system. Second, failure-function matrix is developed. Third, simulation model is desinged by input data. Finally, The quantity of CSP is calculated by simulation and evolution strategy, meta-model. This study suggests new research direction to calculate CSP.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.21 no.5
• /
• pp.8-14
• /
• 2013

In this study, we propose the method of optimally selecting material of front pillar (A-pillar) and package tray for minimizing weight while satisfying vehicle requirements on static stiffness and dynamic stiffness. First, we formulate a material selection optimization problem. Next, we establish the CAE procedure of evaluating static stiffness and dynamic stiffness. Then, to enhance the efficiency of design work, we integrate and automate the established CAE procedure using a commercial process integration and design optimization (PIDO) tool, PIAnO. For effective optimization, we adopt the approach of metamodel based approximate optimization. As a sampling method, an orthogonal array (OA) is used for selecting sampling points. The response values are evaluated at the sampling points and then these response values are used to generate a metamodel of each response using the radial basis function regression (RBFr). Using the RBFr models, optimization is carried out an evolutionary algorithm that can handle discrete design variables. Material optimization result reveals that the weight is reduced by 49.8% while satisfying all the design constraints.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.43 no.1
• /
• pp.72-78
• /
• 2015

Recently, the usage of the satellite is increased more and more in the areas that are communication, weather, marine, optical, radar etc. The functions of the Satellite are evolving from passive transponder to active transponder by the developing of a technology. Advanced countries in satellites install the DCAMP for increase of bandwidth efficiency, improvement of QoS by interference rejection. DCAMP includes many digital components in order to implement functions. Thus, these kinds of active transponders consume much more power compared to passive transponder and then increase the heat. In this paper, we discuss the TVAC test result of DCAMP in EQM(Engineering Qualification Model) level. The paper shows the test results of digital gain control in order to verify DCAMP status under the TVAC test. In addition, the temperature and heat condition of main components from viewpoint of derating will be treated through the official environment test for qualification.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.12B
• /
• pp.1481-1488
• /
• 2011

Recently, Hacking Attacks are appearing as a various Attack techniques with evolution of the Network. and most of the network through a Various Security Systems are responding to an attack. In addition, it should be placed adding the Security Systems to protect the Internal Network's Information assets from External attacks. But, The use of Security Systems inside the network makes a significant impact on Security and Performance, as well as a result causes Economic Additional Costs. Therefore, In this paper, it will be to analyze by associated a case study and experimental results about the Additional Costs Factors(Variable situations difficult to predict and Information Security Recognition levels, Security Systems, Information Asset Assessment). This is expected to serve as a valuable Information for the Reduction of an Costs in a Network deployment and Design in a future.

• Journal of Digital Convergence
• /
• v.9 no.5
• /
• pp.65-75
• /
• 2011

For the latest information and communication technology convergence with related technology to integrate all the systems has been developed in the form. In this era as well as the flow of the healthcare industry in recent years many studies on the development and application has been actively. Health IT in healthcare information systems that integrate information systems that have evolved rapidly in the direction to go, and in the future it is expected to do better acceleration. In this paper, state-led ubiquitous environment for building the hospital application system and IT application services are practical and Free in the integrated health information for the patient care service strengthening to integrated medical information system proposal and design do's and At the same time the establishment of integrated health information systems plans and operational challenges presented.