• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.44 no.6 s.360
• /
• pp.60-68
• /
• 2007

A technique is presented to extract differential second harmonic output from common source nodes of a cross-coupled P-& N-FET oscillator. Provided the impedances at the common source nodes are optimized and the fundamental swing at the VCO core stays in a proper mode, it is found that the amplitude and phase errors can be kept within $0{\sim}1.6dB$ and $+2.2^{\circ}{\sim}-5.6^{\circ}$, respectively, over all process/temperature/voltage corners. Moreover, an impedance-tuning circuit is proposed to compensate any unexpectedly high errors on the differential signal output. A Prototype 5-GHz VCO with a 2.5-Hz LC resonator is implemented in $0.18-{\mu}m$ CMOS. The error signal between the differential outputs has been measured to be as low as -70 dBm with the aid of the tuning circuit. It implies the push-push outputs are satisfactorily differential with the amplitude and phase errors well less than 0.34 dB and $1^{\circ}$, respectively.

• Journal of the Korean Society for Railway
• /
• v.13 no.6
• /
• pp.559-564
• /
• 2010

This paper proposes an advanced filter design to improve power quality of a head electric power (HEP) as a power conversion unit in centralized-power type electric railway vehicle. First of all, we have measured waveform of output power of transformer connected HEP to design the filter. Throughout experiment and simulation results, it is estimated that switching technique used HEP is advanced selected harmonic elimination PWM (SHEPWM) and the applied switching frequency is about 300Hz. In this paper, a filter to improve power quality considering estimated parameters is designed. As a result, the reduction of the magnitude of the overall harmonic is achieved and confirmed through simulations.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.30 no.4
• /
• pp.307-313
• /
• 2019

The traveling wave tube amplifier (TWTA), which can be applied to the Ka-band millimeter-wave multi-mode seeker, consists of an high voltage power supply(HVPS), a grid modulator, a command and control, and an RF assembly. We designed a power supply that generates a -17.9 kV high voltage by synchronizing the pulse repetition frequency(PRF) and power supply switching frequency(i.e. synchronization frequency), and a high-speed grid-switching modulator for RF pulse modulation. The TWTA, which is fabricated through miniaturization with a volume of 3.18 L, has high pulse switching characteristics of up to 18.5 ns. The maximum rise/fall time of the grid on/bias signal and peak power is more than 564.9 W. Moreover, an excellent spurious performance of -68.4 dBc or less was confirmed within the range of PRF and PRF/2.

• Proceedings of the KIEE Conference
• /
• 2004.07c
• /
• pp.2064-2066
• /
• 2004

본 논문에서는 새로운 개념인 능동 고조파 결합을 이용한 4위상 전압제어 발진기를 설계, 제작하였다. 4위상 출력 특성을 얻기 위하여 각각의 차동 VCO의 가상 접지(Virtual Ground)면을 본 논문에 제시된 능동 고조파 결합 회로(Active super harmonic coupling)을 이용하여 결합시키는 방법을 적용하였다. 제안된 구조는 다음과 같은 장점을 가지고 있다. 결합구조를 갖는 트랜지스터에 부가적인 전류소비를 줄일 수 있으며, layout상에서 문제되었던 대칭구조를 개선할 수 있다. 또한 기존에 발표되었던 방법인 passive transformer를 이용한 고조파 결합 보다 회로 크기를 줄일 수 있다. 측정결과 출력 전력 -12dBm, -117dBc/Hz @1-MHz 이하의 위상잡음 특성, 2.66GHz${\sim}$2.91GHz의 250 MHz 주파수 가변, 25dB이하의 2차고조파 억압, 7 mA 의 전류 소모(buffer amp. 포함되지 않음)를 가졌다.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.18 no.9
• /
• pp.68-75
• /
• 2017

This paper presents the experimental and theoretical results of the dynamic responses of a pendular energy extractor in a two-dimensional wave channel. By adopting a wave maker with varying wave height and period, the dynamic responses of the pendular buoy were experimentally obtained. Furthermore, with the aid of the co-simulation of moving particle analysis and rigid dynamic analysis, the dynamic responses of the pendular system were evaluated. In order to validate the feasibility of the proposed wave power generator, the force tuning of the pendular system with restoring energy was carried out. The results provide proof of concept data for the development and design of a commercial model for horizontal wave power generators in the shoreline area.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.4 no.3
• /
• pp.183-189
• /
• 2009

In this paper, we propose RF front-end architecture using hybrid conversion method to receive broadband signal. The validity is verified by design, fabrication and experiment. The proposed RF front-end architecture due to up-conversion block improves the deficiency of performance deterioration to be generated through harmonic signal and image signal conversion in the conventional RF front-end, and improves the deficiency of the complexity that is from to adopt a multiple local oscillators for the generation of wideband LO signal in the conventional RF front-end by applying the principle that tuning bandwidth is multiplied at sub-harmonic mixer. Manufactured circuits satisfy the deduced design specification and target standard with gain above 80 dB, noise figure below 6.0 dB and IIP3 performance above -5.0 dBm for the condition of the minimum gain in RF front-end.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.4 s.346
• /
• pp.75-80
• /
• 2006

This paper has proposed a novel dual band transmitter module which can be operating either as an amplifier or as a frequency multiplier according to the input frequency. A conventional dual band transmitter consists of separate amplifiers operating at each frequency band, but the proposed dual band module operates as an amplifier for the IEEE 802.11b/g signal, and as a frequency doubler for the IEEE 802.11a signal according to input frequency and bias voltage. In this paper, we have obtained sharp stop band characteristics by using microstrip DGS(Defected Ground Structure) to suppress the fundamental frequency of the frequency doubler as well as the second harmonic of the amplifier. From measurement result, second harmonic suppression is below -59dBc in the amplifier mode, and fundamental suppression is below -35dBc in the frequency doubler mode. And the designed module has 17.8dBm output P1dB at 2.4GHz and 10.1dBm power for 5.8GHz output, and the output power in the two modes are 0.8dB and 2.8dB larger than the module with ${\lambda}g/4$ reflector, respectively.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.37 no.3
• /
• pp.248-254
• /
• 2009

The use of evolutionary algorithm is limited in the field of aerodynamics, mainly because the population-based search algorithm requires excessive CPU time. In this paper a coupling method with adaptive range genetic algorithm for floating point and back-propagation neural network is proposed to efficiently obtain a converged solution. As a result, it is shown that a reduction of 14% and 33% respectively in wave drag and its consumed time can be achieved by the new method.

• Journal of The Korean Society of Grassland and Forage Science
• /
• v.34 no.2
• /
• pp.81-86
• /
• 2014

This study was conducted to evaluate the effect of different seeding dates on agronomic characteristics, forage quality, dry matter (DM) and dry matter digestible (DDM) yields of sudangrass hybrid (Sorghum bicolor(L.) Moench) and oat (Avena sativaL.) at Seongju in Kyeongbuk from 2012 to 2013. The experiment was arranged in randomized complete block design with three replications. Sudangrass was seeded five times seeding dates of 10 days interval ranging from $1^{th}$ August to $10^{th}$ September in 2012 and 2013. Oat was seeded three times seeding dates of 10 days interval ranging from $20^{th}$ August to $10^{th}$ September in 2013. Sudangrass was harvested on $26^{th}$ October, 2012 and $2^{nd}$ November, 2013. Plant length and DM content decreased with delaying seeing date. The DM and DDM yields of sudangrass were higher (P<0.05) in first seeding date than all other seeding dates and decreased with delaying seeding dates (P<0.05). The DM and DDM yields of oat were higher (P<0.05) in first and second seeding dates than third seeding date. The results of this study indicated that early seeding of sudangrass would be a recommended than late seeding after $20^{th}$ of August, and late seeding of oat after $30^{th}$ August would be recommened for DM and DDM yields in the Southern Korea.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.8 no.3
• /
• pp.554-562
• /
• 2004

It was recommended for all ship engaged in international voyages to carry the Satellite Emergency position Indicating Radio Beacon according to Global Maritime Distress ＆ Safety System but also it is tending to be diffused to require the satellite EPIRB installed in small vessel such as a fishery boat by domestic regulations of each countries. Otherwise the domestic regulation can't evaluate exactly the compatibility with the satellite system and the performance of the equipment itself required by international regulation. And even if it is required the performing of the performance inspection in accordance with international regulation, it is difficult to grasp the characteristics of equipment by a generalized measuring equipment. Hence this study performed the measurement for the matters related with an wave forms, modulation characteristics, frequency and the power, etc through the design and implementation of the test bench capable of ensuring most of test items regulated by international regulation. Through this study, it has been paved the way being capable of preparation of the standard regarding to transmission repetition period, phase variation and frequency stability related with the system compatibility and in conclusion, it is enable to improve the performance of a main distress communication equipment directly connected with the life of a survivor.