• Journal of the Mineralogical Society of Korea
• /
• v.15 no.2
• /
• pp.104-113
• /
• 2002

The sorption of Cd$^{2+}$ on calcite was studied in aqueous solutions of several electrolytes. The Cd$^{2+}$ concentration, 10$^{-8}$ M, was kept well below saturation with respect to CdCO$_3$(s). Sorption behavior of Cd$^{2+}$ in different ionic strengths of NaClO$_4$solutions shows that sorption is independent of ionic strength. This result suggests that Cd$^{2+}$ sorption on calcite surface is of a specific nature, and adsorption is controlled by an inner-sphere type of surface complex. Two stages in the sorption behavior could be identified: an initial rapid uptake, followed by slower uptake reaching a maximum steady state by 145 hrs. No evidence was observed for surface precipitation, although it can not be entirely ruled out. Desorption of Cd$^{2+}$ from the calcite surface after resuspension into Cd-free solution is initially very rapid, but depends partly on the previous sorption history. Desorption behavior of Cd$^{2+}$ show that an initial rapid desorption followed either by slow uptake reaching a maximum, as in the adsorption experiments, or slowing desorption to reach a steady state minimum. This irreversible behavior of Cd$^{2+}$ sorption and desorption may act as one of the controls for regulating the mobility of dissolved Cd$^{2+}$ natural aqueous systems. Calculated adsorption partition coefficients suggest that overall sorption and desorption process in the concentration range are controlled by d single mechanism.ingle mechanism.

• Journal of Korean Society of Water and Wastewater
• /
• v.18 no.5
• /
• pp.573-579
• /
• 2004

Electroflotation, which is used as an alternative to sedimentation, is a separation treatment process that uses small bubbles to remove low-density particulates. Making allowances for recent collision efficiency diagram based on trajectory analysis, it is necessary to tailor zeta potential of bubbles that collide with negatively charged particles. In this paper, the study was performed to investigate the effects of magnesium and aluminium ions on zeta potential of bubbles. And, it was studied to find out factors which could affect the positively charged bubbles. Consequently, zeta potential of bubbles increased both with higher concentration of metal ions and in the acidic pH value. And, a probable principle that explained the procedure of charge reversal could be a combined mechanism with both specific adsorption of hydroxylated species and laying down of hydroxide precipitate. It also depended on the metal ion concentration in the solution to display its capacity to control the bubble surface.

• Proceedings of the KAIS Fall Conference
• /
• 2012.05b
• /
• pp.537-540
• /
• 2012

기존 2차 전지 내부저항 측정 또는 잔존 용량 측정 등의 2차전지의 수명을 예측 방법들이 있으나 이 방법은 여러 가지 사용 환경에 따른 측정 오류 발생으로 의해 잔존 수명 예측을 정확하게 판단하기는 어려운 실정이다. 따라서 본 논문은 2치전지의 전해액 비중을 이용한 수명 예측 알고리즘을 개발하고 LabVIEW프로그램을 활용한 2차 전지 상태 감시와 잔존 수명을 예측하는 프로그램을 제작하여, 2차 전지의 상태와 교체 시점에 대한 신뢰도를 높일 수 있는 방안을 제시하고자 한다.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2003.06a
• /
• pp.682-685
• /
• 2003

In this paper, we propose the method to measure the Young's modulus of carbon nano tube which was manufactured by chemical vapor deposition. We also made the tungsten tip by electrochemical etching process and the carbon nano tube which was detangled through ultra-sonication with isopropyl alcohol was attached to the tungsten tip. This tip which was composed of tungsten tip and carbon nano tube can be used in Young's modulus measurement by applying DC voltage with counter electrode. The attachment process and measurement of the deflection of carbon nano tube was done under optical microscope.

• Journal of the Korean Chemical Society
• /
• v.30 no.2
• /
• pp.224-230
• /
• 1986

Dodecyltrimethylammonium bromide (DTAB) was examined as a counter-ion in the separation of aromatic sulfonic acids on alkylmodified silica (ODS) column by reversed-phase ion-pair chromatography. The capacity factor of acids was investigated and separation was attempted. The capacity factor of samples was influenced by the several factors such as a concentration of counter-ion, concentration of methanol, kinds and concentration of electrolyte in mobile phase as well as kinds and position of functional group in samples. Some mixtures of samples were able to be separated under optimum condition.

• Proceedings of the KSME Conference
• /
• 2003.11a
• /
• pp.1888-1891
• /
• 2003

In this paper, we proposed a new method to control the length of carbon nano tube in the single CNT probe. A single CNT probe was composed of a tungsten tip made by the electrochemical etching and carbon nano tube which was grown by CVD and prepared through the sonication. The two components were attached with the carbon tape. Since the length of CNT can not be controlled during the manufacturing, the post process is needed to shorten the CNT. In this paper, we proposed the method of electrochemical process. The process was done under the optical microscope and the results were checked by SEM. The diameter of the carbon nano tube used in this paper was about 130nm because the above process had to be done with the optical microscope. Using the method proposed in this paper, we can control the length of the nano tube tip.

• Proceedings of the KSME Conference
• /
• 2004.04a
• /
• pp.1126-1129
• /
• 2004

Because of the various length condition of carbon nanotube, it is very confined the application area of the single CNT tip. In this paper, it was proposed the cutting technique of single CNT tip and the relationship between the etched volume and the amount of the applied charge. It is possible to control the length of single CNT tip arbitrary using this technique. The etched volume and length in the single CNT tip can be predicted with the amount of the applied charge. It is very easy to make a single CNT tip with proper length using this technique and to make nanotweezer that was composed two single CNT tips.

• Transactions of the Korean hydrogen and new energy society
• /
• v.32 no.6
• /
• pp.497-505
• /
• 2021

Water management is essential to improve the performance of proton exchange membrane fuel cells. This study targets to understand the characteristics of water concentration in proton exchange membrane fuel cells at a dynamic load variable environment. The fuel cell model was developed to simulate nonlinear water transport in membrane by the MATLAB/Simulink^® (MathWorks, Natick, MA, USA) platform, and it calculates water content in membrane, ionic conductivity, and predicts fuel cell performance through one-dimensional analysis.

• Applied Chemistry for Engineering
• /
• v.8 no.2
• /
• pp.161-171
• /
• 1997

Anodic regeneration of PCB enchant and cathodic deposition of copper using electrochemical method has been studied. Cu(I)/Cu(II) concentration ratio as a function of Cu(I) oxidation at the anode was measured from the potential difference between platinum and Ag/AgCl/4M KCl electrodes. Chlorine gas evolution was minimized by maintaining Cu(I) concentration above a specific concentration and using non-porous graphite electrode. Dendritic copper deposition was observed at the cathode and the optimum conditions for Cu deposition was identified as the current density of $360mA/cm^2$, and copper concentration of 12 g/l. Titanium was the most effective cathode material which showed a higher current efficiency and copper recovery. The current efficiency decreased with increasing temperature, but the highest power efficiency was achieved at $50^{\circ}C$.

• Journal of the Korean Magnetics Society
• /
• v.19 no.4
• /
• pp.138-141
• /
• 2009

We studied the effects of Saccharin on the properties of electroplated Ni-Fe Permalloy thin films. When 0 to 1 ${\mu}mol/L$ of Saccharin was added to the plating electrolyte, the grain sizes of the deposits are found to decrease, which reduces the surface roughness and the coercivity and increases the permeability and magnetoimpedance. The reduction in the grain sizes is strongly correlated with increases in the incremental permeability and the magnetoimpedance. We demonstrated that Saccharine is a useful additive for the electrodeposition of soft Permalloy thin films and that the softness can be adjusted by varying the concentration of Saccharin.