• Journal of Advanced Marine Engineering and Technology
• /
• 제25권5호
• /
• pp.1037-1049
• /
• 2001

Considerable interest has evolved in the flow of non-Newtonian fluids in channels of noncircular cross section in compact heat exchanges. Analytical solution was developed for prediction of the flow rate and maximum velocity in steady laminar flow of any incompressible, time-independent non-Newtonian fluids in straight closed and open channels of arbitrary, but axially unchanging cross section. The geometric parameters and function of shear describing the behavior of the fluid model were evaluated for fluid flow among a bundle of rods arranged in triangular and square array. Numerical values of dimensionless maximum velocities, mean velocities, pressure-drop-flow parameters and friction factors were evaluated as a function of porosity and pitch-to-radius ratio.

• 한국전자파학회지:전자파기술
• /
• 제2권3호
• /
• pp.60-66
• /
• 1991

본 논문에서는 효율적인 전자파 차례를 위하여 일정한 두께를 가지고 있는 완전도체의 평판에 원형이나 사각형 모양의 개구면이 삼각형이나 사각형 격자 모양으로 배열되어 있을 때, 이 평판에 수직으로 입사되는 평면파에 대하여 Floquet mode를 이용하여 각 개구면 모양 및 크기에 따라 반사계수 및 투과계수로 나타내어 투과전력을 구함으로써 각 개구면의 모양이나 크기에 따른 전자파 차례효과를 조사하였다.

• 한국전자파학회:학술대회논문집
• /
• 한국전자파학회 2005년도 종합학술발표회 논문집 Vol.15 No.1
• /
• pp.289-292
• /
• 2005

Two planar inverted-F antenna (PIFA) arrays are proposed as an alternative model to generate input and radiation characteristics of two orthogonal oriented circular loops, which has polarization diversity, but inherent mechanical instability of two orthogonal loops, in particular, in installation and operation conditions. Two $1\times2$ PIFA sub-arrays are orthogonally placed on a ground plane and two different feeding networks are applied to control horizontal and vertical radiation current flows for each sub-array, respectively. Equivalence of scattering parameters and radiation patterns between two antennas are validated by the available commercial simulator.

• 한국조명전기설비학회:학술대회논문집
• /
• 한국조명전기설비학회 2001년도 학술대회논문집
• /
• pp.129-132
• /
• 2001

LED는 오랫동안 가전제품이나 각종 기계의 표시소자로 사용되어 왔으나, 최근 LED가 고취도화 되면서 LED를 이용한 조명제품 개발이 활발하게 이루어지고 있다. 본 논문에서는 RGB LED를 이용한 LED 전구를 설계하기 위해 광학설계 프로그램 LightTools을 이용하였다. RGB LED의 비율과 배치에 따른 태양광과 비슷한 백색광을 얻기 위해 RGB LED의 비율을 R:G:B=1:1.5:3, 하여 CIE 색좌표 x:y=0.342: 0.291, 색온도 5100[K]의 값을 얻었다. RGB LED의 대칭, 원형, 간격별 배열에 따른 배치를 통하여 색좌표 x:y= 0.337: 0.297인 백색광을 얻었다. 이 같은 결론을 바탕으로 RGB LED전구를 설계하였다.

• 한국전자파학회:학술대회논문집
• /
• 한국전자파학회 2000년도 종합학술발표회 논문집 Vol.10 No.1
• /
• pp.345-349
• /
• 2000

A microstrip polarized 8${\times}$2 linear phased array antenna with four 4-bit phase shifters is designed at 10 GHz. The 180$^{\circ}$and 90$^{\circ}$ sections of the phase shifter are of the switched line type, and the rests are of the loaded line type. A 2${\times}$2 sequential sub-array is adopted for a broad axial ratio bandwidth. The construction of the array antenna is of the tile type placing the phase shifters on the same layer containing the feed network. The element spacing is chosen to be 0.45λ$\sub$0/ to exclude the grating lobe. Measurement results show a gain 9.69 dB at broadside and 8.3 dB at the beam-tilt angle of 16$^{\circ}$ by imposing a progressive phase of 90$^{\circ}$.

• 한국전자파학회:학술대회논문집
• /
• 한국전자파학회 2002년도 종합학술발표회 논문집 Vol.12 No.1
• /
• pp.290-292
• /
• 2002

In this paper, we present a simple design method and measurement results for circular loop antenna arrays, which can be used for LS band operation, such as access point antennas in the wireless LAN system. It has been shown that the input impedance of a circular loop can be adjusted near 100 $\Omega$ using a short stub. The length of the stub can be immediately determined in the work place through the measurement of S11 with a network analyzer. Fabricated arrays show high antenna gains as much as 12.4㏈i and 15.1 ㏈i at the center frequency of 2.45 ㎓ for 4${\times}$l and 4${\times}$2 array, respectively. These types of loop arrays can be fabricated at a low cost.

• 설비공학논문집
• /
• 제9권3호
• /
• pp.259-267
• /
• 1997

Average heat transfer coefficients and friction coefficients have been measured from staggered short pin-fin arrays to investigate the effect of fin shapes. Flow entering into the test section is a fully developed duct flow and the Reynolds number ranges from 5,000 to 25,000 based on fin diameter and average approaching velocity. The fin has three different shapes; uniform-diameter circular fin, two stepped-diameter circular fins. Average heat transfer rates change slightly with the fin shapes. However, friction loss(pressure loss) for the stepped-diameter fins is significantly less than that for the uniform-diameter fin. This results indicate that the stepped-diameter fin arrays in duct flow enhance heat transfer rates largely based on unit pumping power.

• 대한설비공학회:학술대회논문집
• /
• 대한설비공학회 2009년도 하계학술발표대회 논문집
• /
• pp.1129-1134
• /
• 2009

A numerical study has been conducted to investigate the effect of tube arrangement on the heat transfer and the pressure loss for cross flow heat exchangers. By defining a transverse deviation factor, ${\varepsilon}_t=l_T/S_T$, the flow pattern and the heat transfer characteristics are compared for selected ${\varepsilon}_t$ values of 0.0(in-lined), 0.1, 0.2, 0.3, 0.4, 0.5(staggered) by using a commercial software. Computational domain includes 1 pitch in the transverse direction and 5 pitches in the flow direction with due periodic boundary conditions.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2000년도 춘계학술대회논문집
• /
• pp.319-324
• /
• 2000

Sound insulation effect of periodically arranged circular rods is studied by numerical method (BEM) and model experiment in anechoic room. Five different cylinder groups of diameter from 48 mm to 27 mm are arranged, where each group consists of 5 rows of identical rods and area ratio is kept almost the same as 60%. Comparisons of results by BEM and experiment show the band gap frequency ranges are qualitatively in agreement, while experiments gives higher attenuations. Frequency shifted attenuations (BEM results) by first group (${\phi}$48), third group (${\phi}$34) and fifth group (${\phi}$27) show that attenuation curves are in reasonable agreements for both plane wave and point source.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2006년도 심포지엄 논문집 정보 및 제어부문
• /
• pp.348-350
• /
• 2006

Currently the indication method of the traffic signal light which is established in our country displays each "red, yellow, green" using the brightness LED signal light. In this paper, one LED circular arrangement replaces the Current indication method of the traffic signal light using two color LED. Also the blinking signal function of present time uses the MCU of AVR series and it is embodied with magnification and abridgment of the circular arrangement for recognizing easily far away. The signal light indication method which is proposed will be able to substitute the signal light of 3 colors with 1 signal light with economic profit presented the reform measure of energy efficiency improvement together.