• The Journal of Engineering Geology
• /
• v.29 no.3
• /
• pp.265-277
• /
• 2019

Changes in the amount, intensity, frequency, and type of precipitation, in conjunction with global warming and climate change, critically impact groundwater recharge and associated groundwater level fluctuations. Monthly gravity levels by the Gravity Recovery and Climate Experiment (GRACE) are acquired to monitor total water storage changes at regional and global scales. However, there are inherent difficulties in quantitatively relating the GRACE observations to groundwater level data due to the difficulties in spatially representing groundwater levels. Here three local interpolation methods (kriging, inverse distance weighted, and natural neighbor) were implemented to estimate the areal distribution of groundwater recharge changes in South Korea during the 2002-2016 period. The interpolated monthly groundwater recharge changes are compared with the GRACE-derived groundwater storage changes. There is a weak decrease in the groundwater recharge changes over time in both the GRACE observations and groundwater measurements, with the rate of groundwater recharge change exhibiting mean and median values of -0.01 and -0.02 cm/month, respectively.

• Journal of the Korean Geotechnical Society
• /
• v.38 no.3
• /
• pp.35-42
• /
• 2022

The N-value from the Standard Penetration Test (SPT), which is one of the representative in-situ test, is an important index that provides basic geological information and the depth of the bearing layer for the design of geotechnical structures. In the aspect of time and cost-effectiveness, there is a need to carry out a representative sampling test. However, the various variability and uncertainty are existing in the soil layer, so it is difficult to grasp the characteristics of the entire field from the limited test results. Thus the spatial interpolation techniques such as Kriging and IDW (inverse distance weighted) have been used for predicting unknown point from existing data. Recently, in order to increase the accuracy of interpolation results, studies that combine the geotechnics and deep learning method have been conducted. In this study, based on the SPT results of about 22,000 holes of ground survey, a comparative study was conducted to predict the depth of the bearing layer using deep learning methods and IDW. The average error among the prediction results of the bearing layer of each analysis model was 3.01 m for IDW, 3.22 m and 2.46 m for fully connected network and PointNet, respectively. The standard deviation was 3.99 for IDW, 3.95 and 3.54 for fully connected network and PointNet. As a result, the point net deep learing algorithm showed improved results compared to IDW and other deep learning method.

• Korean Journal of Remote Sensing
• /
• v.33 no.5_2
• /
• pp.661-676
• /
• 2017

This study suggests a new method not only to produce the 1 km-resolution seasonal prediction but also to improve the seasonal prediction skill of temperature over South Korea. This method consists of four stages of experiments. The first stage, EXP1, is a low-resolution seasonal prediction of temperature obtained from Pusan National University Coupled General Circulation Model, and EXP2 is to produce 1 km-resolution seasonal prediction of temperature over South Korea by applying statistical downscaling to the results of EXP1. EXP3 is a seasonal prediction which considers the effect of temperature changes according to the altitude on the result of EXP2. Here, we use altitude information from ASTER GDEM, satellite observation. EXP4 is a bias corrected seasonal prediction using genetic algorithm in EXP3. EXP1 and EXP2 show poorer prediction skill than other experiments because the topographical characteristic of South Korea is not considered at all. Especially, the prediction skills of two experiments are lower at the high altitude observation site. On the other hand, EXP3 and EXP4 applying the high resolution elevation data based on remote sensing have higher prediction skill than other experiments by effectively reflecting the topographical characteristics such as temperature decrease as altitude increases. In addition, EXP4 reduced the systematic bias of seasonal prediction using genetic algorithm shows the superior performance for temporal variability such as temporal correlation, normalized standard deviation, hit rate and false alarm rate. It means that the method proposed in this study can produces high-resolution and high-quality seasonal prediction effectively.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.23 no.4
• /
• pp.366-373
• /
• 2021

This study attempted to establish a field data-based write analysis standard by analyzing field observation data, which is non-linear data of southern garlic. Five regions, including Goheung, Namhae, Sinan, Changnyeong, and Haenam, were selected for analysis. Observation values for each observation station were extracted from the temperature data of farmland in the region through inverse distance weighted. Southern-type garlic production and temperature data were collected for 10 years, from 2010 to 2019. Local regression analysis (Kernel) of the obtained data was performed, and growth temperatures were analyzed, such as 0.8 (18.781℃), 0.9 (18.930℃), 1.0 (19.542℃), 1.1 (20.165℃), and 1.2 (21.042℃) depending on the bandwidth. The analyzed optimum temperature and the grown temperature (4℃/25℃) were applied to extract the growth temperature for each temperature by using the temperature response model analysis. Regression analysis and correlation analysis were performed between the analyzed growth temperature and production data. The coefficient of determination(R²) was analyzed as 0.325 to 0.438, and in the correlation analysis, the correlation coefficient of 0.57 to 0.66 was analyzed at the significance probability 0.001 level. Overall, as the bandwidth increased, the coefficient of determination was higher. However, in all analyses except bandwidth 1.0, it was analyzed that all variables were not used due to bias. The purpose of this study is to accommodate all data through non-linear data. It was analyzed that bandwidth 1.0 with a high coefficient of determination while accepting modeling as a whole is the most suitable.

• Journal of Korea Water Resources Association
• /
• v.50 no.7
• /
• pp.455-465
• /
• 2017

Understanding of the two-dimensional velocity field is crucial in terms of analyzing various hydrodynamic and fluvial processes in the riverine environments. Until recently, many numerical models have played major roles of providing such velocity field instead of in-situ flow measurements, because there were limitations in instruments and methodologies suitable for efficiently measuring in the broad range of river reaches. In the last decades, however, the advent of modernized instrumentations started to revolutionize the flow measurements. Among others, acoustic Doppler current profilers (ADCPs) became very promising especially for accurately assessing streamflow discharge, and they are also able to provide the detailed velocity field very efficiently. Thus it became possible to capture the velocity field only with field observations. Since most of ADCPs measurements have been mostly conducted in the cross-sectional lines despite their capabilities, it is still required to apply appropriate interpolation methods to obtain dense velocity field as likely as results from numerical simulations. However, anisotropic nature of the meandering river channel could have brought in the difficulties for applying simple spatial interpolation methods for handling dynamic flow velocity vector, since the flow direction continuously changes over the curvature of the channel shape. Without considering anisotropic characteristics in terms of the meandering, therefore, conventional interpolation methods such as IDW and Kriging possibly lead to erroneous results, when they dealt with velocity vectors in the meandering channel. Based on the consecutive ADCP cross-sectional measurements in the meandering river channel. For this purpose, the geographic coordinate with the measured ADCP velocity was converted from the conventional Cartesian coordinate (x, y) to a curvilinear coordinate (s, n). The results from application of A-VIM showed significant improvement in accuracy as much as 41.5% in RMSE.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.23 no.2
• /
• pp.1-20
• /
• 2020

The purpose of this study was to analyze the distribution characteristics of spatial and temporal PM_2.5 in urban areas of Changwon-si, and to identify the causes of PM_2.5 by comparing the characteristics of land-use, and to suggest the direction of reduction measures. As the basic data, the every hour average from September 2017 to August 2018 of Airpro data, which has measurement points in kindergartens, elementary schools, and some middle and high schools in Changwon-si was used. Also, by using IDW method among spatial interpolation methods of GIS, monthly and time-slot distribution maps were constructed, and based on this, spatial and temporal PM_2.5 distribution characteristics were confirmed. First, to verify the accuracy of the Airpro data, the correlation with AirKorea data managed by the Ministry of Environment was confirmed. As a result of the analysis, R² was 0.75~0.86, showing a very high correlation and the data was judged that it was suitable for the study. In the monthly analysis, January was the highest year, and August was the lowest. As a result of analysis by time-slot, The clock-in time at 06-09 was the highest, and the activity time at 09-18 was the lowest. By administrative district, Sangnam-dong, Happo-dong, and Myeonggok-dong were the most severe regions of PM_2.5 and Hoeseong-dong was the lowest. As a result of analyzing the land-use characteristics by administrative area, it was confirmed that the ratio of traffic area and commercial area is high in the serious area of PM_2.5. In conclusion, the results of this study will be used as basic data to grasp the characteristics of PM_2.5 distribution in Changwon-si. Also, it is thought that the severe regions and the direction of establishing reduction measures derived from this study can be used to prepare more effective policies than before.