• Journal of Korean Ophthalmic Optics Society
• /
• v.4 no.2
• /
• pp.141-146
• /
• 1999

We measured and analyzed thermoluminescence spectra of $LaAlO_3$, single crystal by 3 dimensional data for temperature, wavelength and luminescence intensity. $LaAlO_3$, has used as the substrates of YBCO(superconductor) or semiconductors. We could determined the energy of recombination center, that is impossible through analysis of glow curve data. We could obtained the energy through analysis of the spectrum data at peak temperature by Franck-Condon model. The total glow curve was deconvoluted to three glow curves by curve fitting method. The activation energies were 0.54eV, 0.91eV and 1.02eV respectively. The energies of recombination centers were determined with 2.04eV and 2.75eV from the analysis of luminescence intensity data for wavelength.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.12 no.6
• /
• pp.2815-2822
• /
• 2011

Clustering method in wireless sensor networks is the technique that forms the cluster to aggregate the data and transmit them at the same time that they can use the energy efficiently. In this paper, I propose the hierarchical unequal clustering method using cluster group model. This divides the entire network into two layers. The data aggregated from layer 2 consisted of cluster group is sent to layer 1, after re-aggregation the total data is sent to base station. This method decreases whole energy consumption by using cluster group model with multi-hop communication architecture. Hot spot problem can be solved by establishing unequal cluster. I also show that proposed hierarchical unequal clustering method is better than previous clustering method at the point of network energy efficiency.

• Journal of Korea Multimedia Society
• /
• v.14 no.11
• /
• pp.1431-1437
• /
• 2011

This paper proposes a novel watermarking algorithm that protects digital copyrights and is robust to attacks. Watermarks are embedded in the subband including the significant part of the signal such as a pitch. Generally, the subband containing the pitch has the biggest energy. In order to find this subband, wavelet packet transform is used to decompose the subbands and their energy are calculated. The signal of the selected subbands is transformed in frequency domain using FFT. The watermarks are embedded using QIM for samples higher than a certain threshold. The blind detection uses the Euclidean distance. The proposed method shows less than 5% BER in the audio watermark benchmarking.

• The KIPS Transactions:PartC
• /
• v.13C no.6 s.109
• /
• pp.741-748
• /
• 2006

Due to the continuous development of sensor technology, Wireless Sensor Networks are rapidly growing and are expected to be applied to various applications. One of the most important factors in Wireless Sensor Networks is energy-efficient management of network resources. For this purpose, a lot of researches have been ongoing in the development of energy-efficient routing protocol. In this paper, a cluster head selection algorithm considering node density in addition to the cluster head selection algorithm of LEACH-C is proposed and simulated. This algorithm gives nearly the same computational speed compared to that of LEACH-C and shows improvement of network lifetime about 11% better than LEACH-C. The simulation result shows that consideration of density as well as distance between nodes in cluster head selection can be more energy-efficient than considering only the distance between nodes as LEACH-C in energy usage of Wireless Sensor Networks.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2011.05a
• /
• pp.62.2-62.2
• /
• 2011

산업화 이후, 석탄 석유를 중심으로 한 화석연료가 이산화탄소를 대량으로 배출하며 지구 온난화를 야기함에 따라, 기존의 화석연료를 대체할 청정하고 무한 재생 가능한 대체에너지로 가장 큰 기대를 받고 있는 것은 태양에너지이며, 이에 보조를 맞춰 태양광발전에 대한 연구개발이 국내외적으로 활발히 진행되고 있는 실정이다. 태양 전지는 빛 에너지를 직접 전기 에너지로 바꿔주는 소자로, 셀의 효율을 높이기 위해서는 최대한 많은 빛을 흡수시킬 수 있는 것이 중요하다. 빛의 반사를 줄이는 방법에는 texturing과 antireflecting coating이 있다. Antireflecting coating은 반도체와 공기의 중간 굴절율을 갖는 박막을 증착하여 측면 반사를 감소시킴으로서 빛의 손실을 감소시키는 역할을 한다. 과거에 반사방지막으로 가장 많이 사용되었던 물질은 SiO로써 굴절률은 1.8~1.9로서 최소의 반사율은 1% 미만이지만, 가시광선영역에서의 흡수에 의한 손실이 생기므로, SiNx가 대체 물질로 제안되었다. SiNx의 경우 굴절률이 약 1.5로서 Si에 쉽게 형성시킬 수 있고, texturing된 Si 표면에 적합하며 반사율을 10%에서 2%로 줄일 수 있는 장점을 가지고 있다. 따라서 본 연구에서는 high power, high frequency PECVD 방법으로 $SiH_4$와 $NH_3$ gas의 비율, $N_2$ carrier gas 등 공정 변수를 변화시켜 증착한 SiNx 박막의 결정학적 특성을 X-ray diffraction 분석과 XPS (X-ray photoelectron spectroscopy)를 통해 화학적 결합을 확인하였고, 이를 FT-IR (Fourier Transform-Infrared spectroscopy)를 통해 관찰한 결과와 연관시켜 분석하였다. 굴절율의 경우 ellipsometer를 이용하여 측정하였으며 위의 측정을 통하여 SiNx박막의 반사 방지막으로써의 가능성을 확인 하였다.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.1A
• /
• pp.23-29
• /
• 2006

In wireless sensor networks(WSNs), it is crucial to maintain network connectivity as long as possible since nodes are battery-powered and unchange-able. We propose a new routing protocol called Energy Aware Source Routing(EASR) which can be efficient in respect of network lifetime and long-term connectivity. Our protocol is multipath source routing, only one path will be selected at the same time and each path has probability to be selected like as Energy Aware Routing(EAR) protocol. The route discovery procedure of EASR protocol is reformed from the route discovery procedure of Split Multipath Routing(SMR) protocol. However, there is the difference between SMR and EASR. In EASR, we define an overhearing ratio in order to reduce energy waste due to overhearing effect among each selected path. Thus, we can establish energy efficient multiple paths by making use of overhearing ratio. The simulation results are also demonstrated that our scheme increases in network lifetimes, and achieves reasonable packet latency time.

• Journal of the Korea Society for Simulation
• /
• v.16 no.2
• /
• pp.55-64
• /
• 2007

The sensor nodes on the sensor network transmit the reply for the queries of ADV(Advertisement) message from sink node, and the sink node presents the received information to users. To find the relevant sensor nodes, routing algorithms disseminates ADV messages to the whole network. Thus not only the relevant sensor nodes but also the irrelevant ones consume considerable amount of energy. To alleviate such kind of energy consumption, this thesis proposes a new routing algorithm and coins it Directed Messaging. It propagates ADV message only to the limited direction and changes the direction until the requested sensor node is found. In this way, Directed Messaging reduces unnecessary energy consumption and enhance the efficiency of the networks. Performance of the Directed Messaging algorithm is evaluated through simulation and compared with Directed Diffusion algorithm. Simulation results show that it has better performance than Directed Diffusion.

• 한국신재생에너지학회:학술대회논문집
• /
• 2007.11a
• /
• pp.485-488
• /
• 2007

Riverbank filtration is a kind of artificial aquifer recharge for the fresh water supply. By construction of several production wells penetrating the riverbank, surface water withdrawn from the river would pass riverbed. This extracted water is well known to be cooler than surface water in summer and warmer than surface water in winter, showing more constant water temperature. This characteristic of extracted water is applied to geothermal energy utilization. Prediction of the annual temperature variation of filtrated water is the major concern in this study. In Daesan-myeon, Changwon-si, Gyeongsangnam-do, South Korea, riverbank filtration facility has been on its operation for municipal water supply and thermal energy utilization since 2006. Appropriate hydraulic and thermal properties were estimated for flow and heat transfer modeling with given pumping rate and location. With the calibrated material properties and boundary conditions, we numerically reproduced measured head and temperature variation with acceptable error range. In the numerical simulation, the change of saturation ratio and river stage caused by rainfall was calculated and the resulting variation of thermal capacity and thermal conductivity was considered. Simulated temperature profiles can be used to assess the possible efficiency of geothermal energy utilization using riverbank filtration facility. Influence of pumping rate, pumping location on the extracted water temperature will be studied.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.8 no.5
• /
• pp.137-147
• /
• 2008

Recently, Power and thermal management are becoming major concerns in computer system design. The energy efficiency is an important attribute of the mobile and embedded systems. Today's powerful mobile processors needs more energy and longer battery life. Many research has been focused to reduce energy consumption for the mobile processors.In this paper, performance monitoring system for the Power-management techniques is implemented for Intel's XScale microarchitecture-based Marvell PXA320 processor on Windows CE platform. It also provides software interface for changing DVFS configuration. Performance and power consumption are measured for benchmark programs through performance counter value and voltage/current measurements on LabVIEW platform. By using the developed monitoring system, it is possible for dynamic power management to track processor's workload and to determine the actual power consumption.

• Journal of Environmental Policy
• /
• v.10 no.1
• /
• pp.93-127
• /
• 2011

Investment on technology to obtain green energy is prevailing all over the world. The technology development project is more likely to involve multiple sub-projects, each of which is related to develop elementary technology when the project is larger and nation-wide. However, the methodologies identifying optimal combination of elementary technologies among the candidates have been very few. Hence, the purpose of this paper is to propose a novel methodology which provides an optimal combination of green energy technologies. To do so, to-be developed technologies are clustered with multiple categories. Among the technologies, based on Delphi method, the experts select a representative technology, which is indispensible to the green energy system and has the highest connectivity with other elementary technologies. Then the methodology selects an elementary technology from each technology category based on two metrics: Relatedness with representative technology and project risk. To show the feasibility of the proposed methodology, we applied the methodology to an actual windmill development project.