• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.5
• /
• pp.1231-1239
• /
• 2010

The aim of this study was developing the non-invasive focused magnetic stimulation system(NI_FMSS) that can stimulates acupoints which are small parts and knotted muscular tissues. To evaluate pain treatment effect of the NI_FMSS, we caused muscle fatigue to 25 subjects in biceps of the arm. Then, we stimulated acupoints(trigger points) HT2 using low frequency stimulator(10 subjects) and NI_FMSS(10 subjects). The other 5 subjects had not been stimulated. We analyzed muscle fatigue recovery with median frequency, RMS and median power in frequency domain for 5 days. We checked the magnetic stimulation effect on acupoint by evaluation of muscle fatigue recovery. Therefore, we identified that the NI_FMSS was more efficient system to relieve muscle pain than electric-stimulation system.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.15 no.1
• /
• pp.235-242
• /
• 2011

The control performance in active structural control system can be drastically deteriorated when the modeling errors and the uncertainties existing in the disturbances are disregarded in the designing stage. It can even throw the control system into an unstable phase, resulting in out of control against the seismic excitations. The purpose of the study is to investigate the control effectiveness of a non-linear control system called sliding mode controller(SMC) in cooperation with a Tuned Mass Damper subjected to the three seismic excitations selected from the FFT analysis. Even though the transient performance such as settling time and overshoot were deteriorated, the robustness against the system stability was appeared from SMC when the structural masses and stiffness perturbed within the range of ${\pm}30%$. SMC is a feasible technique for active structural control in cooperation with TMD against seismic disturbances, exhibiting robustness in perturbation of system stiffness and mass as well as uncertainties of the disturbances.

• Journal of Animal Science and Technology
• /
• v.50 no.3
• /
• pp.401-406
• /
• 2008

This study was conducted to clarify the characteristics of estrus-related vocalization of sows after artificial insemination. Vocalization of sows in artificial insemination day, and 3 days and 50 days after artificial insemination, were recorded 3 hours per day from September 2006 to March 2007 using the MD Recorder(Marantz PMD-650) and microphone(RF Condesner MIC, MKH 416P48). The shapes of spectrum and spectrogram of vocalization were different in each period after artificial insemination. There were significant differences in frequency and intensity, but not in duration of vocalization. The fact that signal may give a reliable indication of the signaller's needs has suggested that in some circumstances they can provide information on animal welfare.

• The Journal of the Korea Contents Association
• /
• v.8 no.2
• /
• pp.74-82
• /
• 2008

This paper investigates chrominance reconstruction methods that reconstruct subsampled chrominance information efficiently using the correlation between luminance and chrominance components in the decompression process of compressed images, and analyzes drawbacks involved in the adaptive-weighted 2-dimensional linear interpolation among the methods, which shows higher efficiency in the view of computational complexity than other methods. To improve the drawback that the spatial frequency distribution is not considered for the decompressed image and to support the application on a low-performance system in behalf of 2-dimensional linear interpolation, this paper proposes the multi-mode reconstruction method which uses three reconstruction methods having different computational complexity from each other according to the degree of edge response of luminance component. The performance evaluation on a development platform for embedded systems showed that the proposed reconstruction method supports the similar level of image quality for decompressed images while reducing the overall computation time for chrominance reconstruction in comparison with the 2-dimensional linear interpolation.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.16 no.5
• /
• pp.511-520
• /
• 2011

Nowadays, industry of smart grid is important for practical use of the renewable energy. In this situation, it is important to use the energy storage to make more stable and efficient renewable energy sources. The power conditioning systems consist in a boost converter which makes renewable energy source connected with the grid-connected inverter and the charger/discharger which takes the energy transfer between the boost converter and an energy storage. The effects on the controller design of each converter must be investigated to avoid the instability of the entire system. small-signal modelling of the boost converter and charger/discharger have been done and a controller design example is also presented. In this paper, effects on the controller design of the boost converter and the charger/discharger are investigated according to the existence of the parasitic resistance of the boost converter. In conclusion, the parasitic resistance of the inductor should be considered from the aspect of both the frequency domain analysis and time domain simulation using both MATLAB and PSIM.

• Journal of KIISE:Information Networking
• /
• v.29 no.2
• /
• pp.129-140
• /
• 2002

In this paper, we consider the problem of packet transmission in a wavelength division multiplexed(WDM) optical network. Our network model assumes that receivers are fixed-tuned and transmitters are tunable such that optical lasers assigned to transmitters have limited access to the network bandwidth: hence each node must be equipped with multiple optical lasers and/or multiple optical filters in order to maintain a single-hop network. We first analyze scheduling all-to-all packet transmissions and present optimum scheduling for all-to-all packet transmissions. We then extend the analysis to the case of arbitrary traffic demands. We show that the scheduling with arbitrary traffic demand is NP-hard. A heuristic algorithm based on list scheduling is presented. The upper bound so obtained is compared with the lower bound and provides performance guarantees with arbitrary demands. The result are applicable to arbitrary tuning delay, arbitrary number of wavelength channels and optical lasers of arbitrary tuning ranges.

• Korean Journal of Remote Sensing
• /
• v.15 no.3
• /
• pp.167-175
• /
• 1999

So far, the remote sensing technology has widely been used in a variety of application areas such as military, medical imaging, environment, geology and so forth. The microwave remote sensing uses the wavelengths ranging from around one centimeter up to a few tens of centimeters and is known to be very effective regardless of the weather conditions and the day/night time as compared with the reflective InfraRed (IR) remote sensing or the thermal IR remote sensing. There are three generic modes of synthetic aperture radar imaging systems depending on its application, that is, stripmap mode, spotlight mode, or inverse mode. In this article we focus on the issue of imaging of flying aircrafts for the inverse mode of a ground - based, fixed radar with moving objects. The imaging of flying aircrafts is considered to be an important step for the automatic target recognition systems, and therefore a great deal of efforts have recently been made on the subject. Here we review the three representative methods including the Fourier transform processing, the time - frequency processing, and the reconstruction from the projection. Some relative merits and drawbacks are also discussed.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.30 no.4
• /
• pp.328-331
• /
• 2019

A linear frequency modulated pulse train waveform can be cost-effective in achieving high range resolution, and thus the synthetic aperture radar may be benefited by using the mixer output of the received signal. However, the image formation process from a mixer output is vulnerable to errors caused by stop-and-go approximation. In this paper, a nadir-looking imaging radar based on time domain correlation is proposed. Furthermore, to prevent the occurrence of ghosting effect in images, antenna placement on a rotating disk is proposed. Simulation results indicate that ghosting effect can be eliminated by employing the proposed antenna placement structure.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.23 no.5
• /
• pp.48-59
• /
• 2019

In recent years, the type of bridge where cables such as suspension bridge and cable-stayed bridge are the main factors in the construction of long-range bridges has been soaring. The effects of cables on these structures are very large, and for structural analysis, it is necessary to study the cable and the structural changes according to the mode characteristics of the cables. In particular, cables are directly connected to camber adjustment, which conveys load effects on girders to tower, and are important components in the overall structure, and since the initial tension on the construction is compared with the tension over time, this study was conducted to help identify the condition of the bridge's aging and abnormalities. Therefore, in this study, the characteristics of the mode from the mode analysis through the impact hammer to the mass of the cable and the change in the length of the cable are analyzed.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.26 no.7
• /
• pp.1026-1031
• /
• 2022

Cognitive Radio Ad-Hoc Networks (CRAHNs) enable to overcome the shortage of frequency resources due to the increase of radio services. In order to avoid interference with the primary user in CRANH, channel sensing to check the idle channel is required, and when the primary user appears, the time delay due to handover should be minimized through fast idle channel selection. In this paper, throughput was improved by reducing the number of channel sensing and preferentially sensing a channel with a high probability of being idle, using reinforcement learning. In addition, we proposed a multi-channel MAC (Medium Access Control) protocol that can minimize the possibility of collision with the primary user by sensing the channel at the time of data transmission without performing periodic sensing. The performance was compared and analyzed through computer simulation.