• Journal of Institute of Control, Robotics and Systems
• /
• v.6 no.11
• /
• pp.963-967
• /
• 2000

This paper deals with a sliding mode control with uncertainty adaptation for the robust stabilization of input-delay systems with unknown uncertainties. A sliding surface including a state predictor is employed to compensate for the effect of the input delay. The proposed method does not need a priori knowledge of upper bounds on the norm of uncertainties, but estimates those upper bounds by adaptation laws based on the sliding surface. Then, a robust control law with the uncertainty adaptation is derived to ensure the existence of the sliding mode. A numerical example is given to illustrate the design procedure.

• Journal of Institute of Control, Robotics and Systems
• /
• v.14 no.8
• /
• pp.792-799
• /
• 2008

Motion estimation is crucial in a remote control for its convenience or accuracy. Time delays, however, can occur in the problem because data communication is required through a network. In this paper, state estimation problem with uncertain time delayed measurements is addressed. In dynamic system with noise, after taking measurements, it often requires some time until that is available in the filter algorithm. Standard filters not considering this time delays cannot be used since the current measurement is related with a past state. These delayed measurements are solved with augmented extended Kalman filter, and the uncertainty of delayed time is also resolved based on an explicit formulation. The proposed method is analyzed and verified by simulations.

• Proceedings of the IEEK Conference
• /
• 2009.05a
• /
• pp.19-21
• /
• 2009

The reflectometry for locating the fault at a cable is the same as a problem estimating the time delay between the incident and the reflected signals. In this paper, we propose a method for estimating the time delay between the two signals. The proposed method is based on the modeling of the Gaussian enveloped linear chirp signal in the Gaussian noise environment. The phase and the instantaneous frequency of the received signal are estimated by linear Kalman filtering. From the estimated instantaneous frequency, we can measure the time interval between the center frequencies of the incident and the reflected signals. The time interval is the same as the time delay between the incident and the reflected signals. In a simulation assuming that the cable has open fault at the end of the cable, the proposed method showed a good result in estimating the time delay.

• Journal of Institute of Control, Robotics and Systems
• /
• v.4 no.5
• /
• pp.630-635
• /
• 1998

The objective of this paper is to propose a new efficient technique for the estimation of time-delay parameters using wavelet theory and third-order cumulants, yielding good performance even in the case of low SNR. In particular, band-limited non-Gaussian signals with non-zero skewness and spatially correlated Gaussian noises are considered here. The approach is based on the fact that the effects of spatially correlated Gaussian noises on time-delay estimation can be reduced by using the projection sequences (based on the redundant wavelet decomposition) of given measurements in the higher-order cumulant domain. Finally, the performance of the proposed approach is demonstrated using simulations.

• Proceedings of the KIEE Conference
• /
• 2002.07d
• /
• pp.2114-2116
• /
• 2002

본 논문은 개선된 Complex 방법을 이용한 하이브리드 퍼지 PID 제어기의 최적 자동동조 알고리즘을 제안한다. 제어응답은 퍼지제어기의 환산계수 값에 의해 여러 종류, 여러 형태로 변화하기 때문에 해당하는 제어계의 평가 기준을 만족하도록 제어 파라미터 값을 정하는 것이 중요하다. PID 파라미터 조정법에는 많은 방법이 제안되어 왔었다. 대표적인 예로서 Ziegler-Nichols, Cohen-Coon, Chien-Hrones-Reswick(CHR) 등에 의해 제안된 방법들이 있다. 본 논문에서는 개선된 Complex 방법을 이용한 강력한 자동동조 알고리즘이 하이브리드 퍼지 PID 제어기의 성능을 자동적으로 개선하기 위해 사용된다. 이 알고리즘은 하이브리드 퍼지 PID 파라미터와 환산계수를 제어출력 변화율과 제한조건에 따라 자동으로 추정한다. 지연시간을 갖는 1계, 2계 공정에 적용하고. 공정출력 기준치는 단위 입력으로 한다. 제어 결과의 성능평가를 위해 ITAE(Integral of Time multiplied by the Absolute value of Error)가 사용되며, 또한 제어기의 오버슈트도 토의된다.

• Journal of the Korea Society for Simulation
• /
• v.13 no.2
• /
• pp.1-12
• /
• 2004

This paper estimated the arrival angle and electric wave delay time using the space method law and the directions of arrival (DOA) estimation algorithm in case of signal correlation. Space method law is the method used to repress cross correlation before applying the weight value to the receiving signal. The values of the diagonal elements in the correlation matrix were averaged to replace as the diagonal elements value. In the area of wireless communication or mobile communication, there are high correlations in case of low delay time difference in multiple waves. This causes the quality of the communication to drop due to interference with the desired signal elements. This paper estimated the arrival angle and electric wave delay time using the space method law and the MUSIC algorithm. With the arrival angle algorithm, the arrival angle cannot be estimated below 5 in case of signal correlations because the angle resolution capacity decreases accordingly. The super resolution capacity was estimated to determine the arrival angle below 5 in this paper. In addition, the proposed algorithm estimated the short delay time difference to be below 20ns.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.24 no.1
• /
• pp.52-59
• /
• 1987

A new on-line estimation algorithm for a time varying time delay is proposed. This algorithm is based on the concept of minimization of prediction error. As only the parameters directly related to the poles and zeros of the process are estimated in the algorithm, persistently exciting condition for the convergence of parameters can be less restrictive. Under some assumptions which is necessary in adaptive control, it is shown that this algorithm estimates time varying time delay accurately. In view of computational burden, this algorithm needs far less amount of calculations than other methods. The larger the time delay is, the more effective this algorithm is . Computer simulation shows good properties of the algorithm. This algorithm can be used effectively in adaptive control of large dead time processes.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2020.06a
• /
• pp.319-319
• /
• 2020

최근 데이터 과학의 획기적인 발전 덕분에 딥러닝 (Deep Learning) 알고리즘이 개발되어 다양한 분야에 널리 적용되고 있다. 본 연구에서는 인공신경망 중 하나인 LSTM(Long-Short Term Memory) 네트워크를 사용하여 댐 유입량을 예측하였다. 구체적인 내용으로, (1) LSTM에 필요한 입력 데이터를 효율적으로 사전 처리하는 방법, (2) LSTM의 하이퍼 매개변수를 결정하는 방법 및 (3) 다양한 손실 함수(Loss function)를 선택하고 그 영향을 평가하는 방법 등을 다루었다. 제안된 LSTM 모델은 강우량(R), 댐유입량(Q) 기온(T), 기저유량(BF) 등을 포함한 다양한 입력 변수들의 함수로 가정하였으며, CCF(Cross Correlations), ACF(Autocorrelations) 및 PACF(Partial Autocorrelations) 등의 기법을 사용하여 입력 변수를 결정하였다. 다양한 sequence length를 갖는 (즉 t, t-1, … t-n의 시간 지연을 갖는) 입력 변수를 적용하여 데이터 학습에 최적의 시퀀스 길이를 결정하였다. LSTM 네트워크 모델을 적용하여 2014년부터 2020년까지 한강 유역 9개의 댐 유입량을 추정하였다. 본 연구로부터 댐 유입량을 예측하는 것은 홍수 및 가뭄 통제를 위한 필수 요건들 중 하나이며 수자원 계획 및 관리에 도움이 될 것이다.

• Journal of Advanced Navigation Technology
• /
• v.14 no.5
• /
• pp.625-631
• /
• 2010

In this paper, robustness performance of SNUR message is compared with those of existing ones, RTCM(Radio Technical Commission for Maritime Services) v2 MT(Message Type) 18/19 and MT 20/21 under a poor broadcast condition such as temporary data loss or disconnection We defined the temp oral data loss as 2 second delay and reconnection after disconnection as 7 second latency, and then evaluated its robustness for each latency case by double differentiating the observables. Our result shows that SNUR protocol method can reduce the latency error of the existing RTCM messages by 30~60%. Moreover, a rover using SNUR message, whose latency error is bounded within 1/4 L1 wave length, can figure out its own fixed position continuously in spite of 7 second disconnection, while the other using RTCM message, whose error is larger than half wave length, cannot keep its previous fixed solution.

• Journal of the Korean Society for Railway
• /
• v.18 no.4
• /
• pp.374-390
• /
• 2015

This research shows the relationship between the number of trains and the probability of trains with arrival delay and suggests way to estimate the benefits of improved punctuality in a bottleneck section of the Gyeongbu Line. The arrival delays of high-speed and conventional trains were estimated using the train operation data of KORAIL. Linear regression models for the probability of trains with arrival delay by train type are presented in this paper. The probabilities of trains with arrival delay were more affected by the number of conventional trains than by the number of high-speed rail trains. For the empirical analysis, a project for increasing the capacity in the Seoul~Geumcheongu office section was tested. The benefits of the improved punctuality were estimated to be 4.2~4.5 billion Korean won every year. This research has some limitations but it can help evaluate more precisely the feasibility of the project of increasing the capacity in bottleneck sections.