• The Journal of the Acoustical Society of Korea
• /
• v.37 no.6
• /
• pp.412-421
• /
• 2018

The Line array sonar consisting of several hydrophones increases array gain and improves the performance for detecting the direction of the target compared to single hydrophone. However, line array sonar produces the bearing error that makes it difficult to determine the bearing of incoming source signal due to the relation between bearing angle of target and vertical angle of multipath signals. Vertical angles of multipath are varied with the geometry of receiver and target and various underwater environments, therefore it is necessary to consider the bearing error to estimate accurately the bearing of the target. In this study, acoustic modelling was performed to understand the effect of multipath signals on the target signal. The errors of bearing angle estimated from the bottom bounced signals are calculated with several environment. In addition, the expected bearing line, as a function of source-receiver range, compensated for the bearing error is predicted from the estimated bearing angle.

• The Journal of the Acoustical Society of Korea
• /
• v.32 no.4
• /
• pp.308-316
• /
• 2013

A set of experiments (Shallow Water 2006, SW06) was carried out in shallow water near the New Jersey shelf break in summer 2006. Significant fluctuations in direct and surface reflected arrivals were observed from the chirp data (1100~2900 Hz) measured on a vertical line array. This paper presents a geoacoustic inverssion technique for short-range acoustic data with fluctuating arrivals and inversion results of experimental data. In order to reduce effects of random sea surface on the inversion, the acoustic energy back-propagated from the array to the source through direct and bottom-reflected paths is defined as the objective function. A multi-step inversion scheme is applied to the data using VFSR (Very Fast Simulated Reannealing) optimization technique. The inversion results show a source depth oscillation period equal to the measured ocean surface wave period. The inverted bottom sound speed is 1645 m/s and is similar to that estimated by other work at the same site.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.6 no.2
• /
• pp.55-64
• /
• 2003

Underwater acoustic noise measurement is an essential element for vulnerability assessment of modern naval platforms. But during the last few decades environmental conditions have drastically changed due to the gradually increasing sea ambient noise level and decreasing submarine radiated noise level. A real-time underwater acoustic measurement system with vertical line array is designed for the quiet submarine radiated noise assessment in challenging environment. This system has a constant directivity index in measurement frequency range and accurate tracking capability for the transmission loss compensation and navigation aids inside the submarine. This system has been validated at sea and used several times for the submarine noise measurement.

• The Journal of the Acoustical Society of Korea
• /
• v.20 no.5
• /
• pp.92-99
• /
• 2001

To measure temporal variability of long- range transmission in northern part of the East Sea of Korea, low frequency acoustic sources were deployed on the continental shelf 0.4km south of Cape Shultz near the port of Vladivostok during October 1999. The transmissions of the phase modulated signals were recorded by VLA moored on the northern slope of Ulleung-do. The measured signals were processed for the acoustic arrivals and their variability in time. The temporal signal processing involves pulse compression of the phase-encoded signal, time spread and temporal coherence processing. Variability of the ocean sound speed field in time scales of short period seems to be dominated by random fluctuations caused by sound speed perturbation due to the vertical displacements associated with internal waves.

• Proceedings of the Acoustical Society of Korea Conference
• /
• spring
• /
• pp.249-252
• /
• 2000

본 논문에서는 수중음향측정을 위한 수직선배열측정 체계 설계 개념을 연구한다. 본 연구에서는 수직선배열 측정체계를 이용한 음향측정 시 고려해야 할 설계 기법들을 고찰하고, 측정 주파수 대역에서 지향지수가 균일하게 유지되는 비선형 센서배열 설계 알고리즘과 피측정 음원의 위치추정을 위한 음향학적 능/수동 추적 알고리즘을 제안한다 제안 알고리즘의 유용성은 시뮬레이션과 해상시험으로 확인한다.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.22 no.4
• /
• pp.85-92
• /
• 2008

Occurring forest fire or burning bushes beneath overhead transmission lines have caused breakdown disturbances of the system in many countries. In this study, experiments for flashover characteristics in the simulated condition of vertical power lines were conducted so as to investigate the reduction in insulation strength caused by combustion flame. As the results of an experimental investigation, it is demonstrated that flame can reduce breakdown voltages of the model lines according to height(h) of flame. The breakdown voltages were decreased with decreasing the height(h) of flame it can be seen that the average reduction of flashover levels, in comparison with the no-flame case, are 46.2[%] for h=9[cm] and 62.5[%] for h=3[cm] when ac voltage is applied.

• Proceedings of the KIEE Conference
• /
• 2005.11b
• /
• pp.83-86
• /
• 2005

최근 가공 송전선로 건설에 대한 인근 지역주민들의 반대에 부딪쳐, 불가피하게 가옥이 밀집된 주거지역을 우회하거나 토지 활용도가 낮은 산악지를 이용하여 선로를 건설하는 경우가 대부분이다. 이와 같이 경과지의 제한성으로 인해 때때로 국지적인 기상현상 발생 우려가 있는 지역에 불가피하게 송전선로를 건설하는 경우가 있으며, 이상기상 현상이 발생하는 11월말에서 3월초 사이에 경기북부 지역의 국지성 돌풍에 의해 갤로핑(Galloping)현상이 종종 발생되었다 갤로핑은 바람으로 인해 전력선이 횡진과 출렁임이 발생되는 현상을 말한다. 송전선로의 지지물에는 주로 철탑이 사용되고, 전력선은 ACSR 410mm 복도체가 주로 사용된다. 송전선로는 경제성과 계통의 안전성을 고려하여 수직배열로 2회선용 표준철탑을 사용한다. 갤로핑 현상은 바람에 의해 전력설에 심한 진동을 일으켜, 수직 배열된 전력선 상간 단락 또는 전력선과 가공지선간의 지락으로 고장전류가 생기고, 고장전류에 의한 보호계전기 동작으로 선로가 트립(Trip)되며, 이로 인한 전력공급 중단이 발생된다. 또한 전력선의 기계적인 진동에 의하여 전력선의 단선 또는 지지물의 파손으로 영구고장을 일으킬 수도 있다. 본 논문에서는 경기북부지역의 산악지에 설치된 154kV 송전선로에서 산비탈면을 타고 오르는 상승 바람에 의한 갤로핑 사례를 국내 최초로 현장에서 촬영한 동영상 자료를 토대로 소개하고, 갤로핑 발생시 송전선로에 미친 영향 등 검토 결과를 설명하였다. 전력선에 생긴 아크 흔적을 토대로 전력선간의 단락이 발생했던 지점을 실제로 관측할 수 있었다. 최근 갤로핑으로 인한 상간 단락 고상 방지론 목적으로 개발된 폴리머 상간스페이서(Interphase spacer)의 시공 사례를 소개하고, 현재까지 상간스페이서가 설치된 송전선로의 점검 결과를 소개하고자 한다.

• Proceedings of the KIEE Conference
• /
• 2008.07a
• /
• pp.426-427
• /
• 2008

전력의 안정적 공급, 공급 신뢰도 향상 및 도심지 인구밀집 지역의 전력공급 및 미화 등의 축면에서 송전분야에서의 지중화는 필수적이며 지속적으로 증가추세에 있다. 그러나 제한적인 지중공간을 활용함에 따른 여러 문제가 발생하고 있다. 지중선로 고장상황으로 1선 지락, 2선지락, 선간단락, 3상단락 등의 사고가 있으며 이러한 고장상황에서 발생하는 고장전류에 의한 열거동은 지중선로에 악영향을 준다. 그러므로 각 고장상황에 따른 지중선로의 영향에 대한 세부적인 검토가 필요하다. 본 논문에서는 각 고장상황에 따른 검토조건으로 1회선과 2회 선일 경우와 상배열이 정삼각배열, 수평/수직배열, 직각배열일 경우를 선정하여 지중선로에 미치는 영향을 EMTP, IDEARS, MARC를 활용하여 분석하였다.

• Polymer(Korea)
• /
• v.30 no.4
• /
• pp.362-366
• /
• 2006

It was found by polarized FTIR spectroscopic studies that pentacene molecules are arranged with their molecular axes perpendicular to the substrate surface when pentacene films are deposited on a polyimide alignment layer. The ring plane in a pentacene molecule is arranged parallel to the rubbing direction of the polyimide alignment film while no specific arrangement of vertically deposited pentacene molecules was found for the film without rubbing. The pentacene band at $1296cm^{-1}$ which has a transition dipole moment parallel to the ring plane is much stronger in a polarized IR spectrum of parallel to the rubbing direction, whereas the band at $908cm^{-1}$ whose transition dipole align normal to the ring plane shows much stronger intensity in a spectrum of perpendicular to the rubbing direction. These findings indicate that orientation of polyimide chains affects the arrangement of pentacene molecules when they are deposited on a polyimide alignment film.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.9 no.6
• /
• pp.580-584
• /
• 1999

The synthesis and characterization of intercalated compound of decansulfonate into hydrated nickel is presented. The compound shows a layered structure as determined by high temperature powder X-ray diffraction (HTXRD). The layer distance of the product is increased from 24.7 $\AA$ to 30.5 $\AA$ by increasing the temperature which is in turn accomplished by changing the structure of the intercalated nickel compound. From the X-ray diffraction data and the decanesulfonate size, the orientation of the decanesulfonate onto the nickel layer is determined. The molecular axis of the decanesulfonate with bilayer structure is tilted to the perpendicular of the nickel layer.