• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.36S no.4
• /
• pp.23-31
• /
• 1999

본 논문에서는 Ka 밴드 위성시스템에서 가장 큰 신호감쇠 요인으로 작용하는 강우효과를 분석하고 그 보상 방안으로서 계층형 8-PSK 변조방식을 제안하였다. 동기복조를 가정한 이론적인 BER 성능과 국내 강우 데이터에 근거한 예상되는 수신신호 품질을 분석하고 기존의 계층형 16-QAM 변조방식과 제안한 계층형 8-PSK 변조방식간의 성능을 비교하였다. 강우강도 및 강우감쇠는 대수정규 분포함수를 이용하여 추정하고 수신신호 품질은 서비스 중단 확률, 평균 수신 SNR에 대해 분석하였다. 결론적으로 제안한 계층형 8-PSK 변조방식은 기존의 계층형 16-QAM 변조방식과 비교해서 전반적으로 매우 우수한 성능을 가짐을 확인하였다.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.12
• /
• pp.3063-3068
• /
• 2014

Since the RCS(Radar Cross Section) of target is important factor to determine radar performance, it is important to locate radar where large RCS is observed. However, the distance between the target and the radar is an important factor of the received power, as well as RCS. In this paper, it is calculated that received power from ballistic missile to radar based on different observed position and it is studied that to place radar for high detection efficiency.

• Journal of Broadcast Engineering
• /
• v.13 no.4
• /
• pp.463-478
• /
• 2008

A Distributed Translator Network(DTxR) is a cost-effective and frequency-effective method which can use existing transmission utilities and can be constructed in a shorter time as compared with Multiple Frequency Network(MFN) or Single Frequency Network(SFN) using On Channel Repeater(OCR). In order to verify the feasibility of DTxR, this field test was done in 30 points of north-west area in Seoul using 3rd, 5th, and 6th generation DIV receivers. Electric field strength, noise margin and ease of reception were measured and subjective evaluation of video quality was done in these points during the field test. With the test result, an improvement of receiving quality was obtained and an ease of reception was increased in case of the 5th. and 6th. receiver. From the results, we conclude that DTxR is a feasible method in DIV networks.

• Tunnel and Underground Space
• /
• v.33 no.5
• /
• pp.425-434
• /
• 2023

To measure the wear amount of the TBM disk cutter in real time, it is important not only to automate the measurement using sensors, but also to stably transmit the measured data to the information processing system. In this study, we investigated the viability of utilizing Bluetooth Low Energy (BLE) technology to wirelessly transmit sensor data from the TBM cutter head to a receiver located at the chamber's rear. Through laboratory experiments, we analyzed the Received Signal Strength Index (RSSI) of the receiver considering various signal strength of the transmitter, separation distances between the transmitter and receiver and chamber fill materials. Our results demonstrate that wireless data transmission is feasible across all tested conditions when the transmitter signal strength is 0 dBm or higher.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.7 no.6
• /
• pp.1146-1152
• /
• 2003

Satellite television receiving antenna is required for watching TV on the vehicles, ship and car. Recently TV is not only facility as getting information but one of utility in our life. In Korea, already on the service multi-channel satellite TV using excellent visibility and sound, and there are many users using now by fixing antenna. On this thesis, developed ship's satellite TV receiving antenna, the azimuth controlling is adopted azimuth information using gyro sensor and differential of receiving signal strength algorithm, and elevation controlling used gimbals. The result of this research is successfully implemented Korean satellite tracking antenna as performance until ${\pm}$30 degree roll and pitch of ship motion.

• Journal of Broadcast Engineering
• /
• v.14 no.4
• /
• pp.518-536
• /
• 2009

To verify the performance of a Distributed Translator Network(DTxR) system in the real world conditions, 5 legacy DTV broadcasting repeater sites were implemented with 5 DTxR systems and field-tested by the DTV field test truck. The 4 DTV broadcasting repeater sites are selected in congested areas where their service areas are overlapped and the 5th site is deviated from the other sites to examine the effect of long-delayed multipath signals. First of all, we checked the receiving signal of the main station that used as a transmitting signal in 5 DTxR systems on the pre-selected 60 test points and tested every case of a DTxR system's on & off except 1 repeater site due to the already built-in DTV repeater system. The test items are received signal electric field strength, noise margin, ease of reception and subjective evaluation of the picture quality for received signals. We used 3rd, 5th, and 6th generation DTV receivers to examine the differences of the receivability by each generation of DTV receivers. Reviewing the test results, we conclude that the DTxR system can be adopted in the current DTV Repeater sites and it could improve the quality and receivability of the main signals by extending the service areas and enhancing the signal levels in the shadow areas without using the extra broadcasting channels.

• Journal of Broadcast Engineering
• /
• v.10 no.2
• /
• pp.221-237
• /
• 2005

This paper presents and analyzes field test results of Equalization Digital On-Channel Repeater (EDOCR) using ATSC(Advanced Television Systems Committee) terrestrial digital TV broadcasting system. In the field test, according to EDOCR On/Off, types of antennas and receivers we measured reception possibility, C/N(Carrier to Noise Ratio), reception power, noise and input margin at each test point. By the field test results, the reception rate of the receiver manufactured in 2004 was $33\%$ when EDOCR is off and directional antenna is used. However, the reception rate was $100\%$ when EDOCR is on. In addition, the noise margin, which determines reception quality was increased at least 6 dB, so that it is capable of constructing SFN(Single Frequency Network) using the EDOCR.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2008.05a
• /
• pp.473-476
• /
• 2008

USN(Ubiquotous Sensor Network) has been applied to various fields of industries such as logistics, environment management, traffic management, as well as IT industries including home network and telematics. Among the important techniques required to implement aforementioned applications, location management scheme is essential. In this paper, we proposed and implemented a new location measurement scheme based on RSSI of sensor node for campus car location management.

• Journal of the Korea Society of Computer and Information
• /
• v.13 no.4
• /
• pp.151-159
• /
• 2008

Mobile broadband wireless network is emerging as one of the hottest research areas due to technical advances, and the demands of users who wish to enjoy the same network experience on the move. In this paper, we investigate the handover process at the medium access control (MAC) layer in an IEEE 802.16e-based system. In particular, we identify problems concerned with the scan initiation Process called cell reselection and propose a received signal strength (RSS) estimation scheme to dynamically trigger a scanning process. We show how the RSS estimation scheme can timely initiate a scanning process by anticipating RSS values considering scan duration required.

• Proceedings of the Korean Society of Computer Information Conference
• /
• 2019.01a
• /
• pp.95-97
• /
• 2019

본 논문에서는 ZigBee 기반의 WSN과 노드 연결을 위한 새로운 기법을 제안한다. 이 기법은 통신 노드 간에 격리된 노드의 수를 최소화하기 위해 수신신호강도(RSSI) 샘플에 적용된 딕슨 테스트(Dixon's test)를 사용하여 ZigBee 기반의 WSN을 위한 새로운 노드 연결 구조로써 특이점(outlier)을 제거하여 적은 수의 RSSI 값으로도 정확한 노드 연결이 가능하다. 본 논문에서는 시뮬레이션을 통하여 제안하는 기법이 기존의 RSSI 기반의 기법보다 더 높은 정확도를 유지하면서 처리 시간은 줄어든 것을 증명하였다.