• Proceedings of the Korea Concrete Institute Conference
• /
• 1999.10a
• /
• pp.263-266
• /
• 1999

This study aims to make high performance concrete for normal strength using crushed stone fines to control high strength of the high performance concrete. According to the experimental results, when crushed stone fines are increased every 10%, 15% of compressive strength is decreased, and 5% of drying shrinkage is increased, compared to normal high performance concrete. Also, high performance concrete has been evaluated to have good durability factor more than 100% in the 480cycle of freezing and thawing test, without regard to using AE and crushed stone fines.

• Proceedings of the Korean Geotechical Society Conference
• /
• 1997.10a
• /
• pp.203-210
• /
• 1997

• Proceedings of the Korea Concrete Institute Conference
• /
• 1990.04a
• /
• pp.16-19
• /
• 1990

The effect of superplasticizers on the fluidity performance in fresh concrete and physical properties in hardened concrete have been analyzed and investigated under mix proportions of water cement ratio of 0.4, 0.6, crushed stone aggregates, and addition rates of superplasticizers of 0.0, 0.5, 1.0 and 1.5 in the practical range. It is the aim of this study to provide the fundamental data on the workability improvement and engineering properties of crushed stone concrete using superplasticizers comparing with conventional concrete for the practical use and research data accumulation of superplastized concrete.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1993.10a
• /
• pp.97-102
• /
• 1993

In the country, due to short comings of natural aggregates of good quality, it is common to use crushed stones. However, the investigation has not been done on the chemical reaction of crushed stones. This study tested and analyzed the aggregate chemical reaction by Petrographic Examination(ASTM C 295),Chemical Metho(ASTM C 289) and Mortar-Bar Method (ASTM C 227). As a result, most of test aggregates didn't show any reaction but many have common deleterious mineral. Therefore, there exists the possibility of chemical reaction in petrographic point of view.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1993.10a
• /
• pp.113-117
• /
• 1993

The purpose of this study is to raise the strength of concrete with admixture. The natural zeolites and mud stone, abundant in this country, were used as admixture for high-strengthening of concrete. Proper workability was gained by using the superplasticizer. The optimum replacement ratio of zeolite mud stone was 10% on unit -cement amount. At these optimum replacement ratio, the strength development over the plain concrete was 34% for zeolite and 16% for mud stone. Through this study, we concluded the natural zeolite and mud stone were adequate admixture for the high-strengthening of concrete.

• Proceedings of the KSR Conference
• /
• 1999.05a
• /
• pp.367-374
• /
• 1999

The selection of geogrid types for the use of reinforced rail roadbed is important in the design of railways. Also, the problem of the construction damage on the geogrid during construction is raised by the field engineers. Therefore, laboratory model tests were peformed to investigate the efficiency of the bearing capacity and construction damage. As a result, it was found that the bearing capacity of the rigid geogrid reinforced railroad ballast shows 1.54 times higher than that of the flexible geogrid reinforced case. In addition, there were no noticeable damage during construction.

• Journal of the Korean GEO-environmental Society
• /
• v.7 no.1
• /
• pp.5-18
• /
• 2006

Stone column or granular compaction pile have been used in widely during the several decades as a technique to reinforce soft cohesive soils and increase bearing capacity, accelerate consolidation settlement of the foundation soil. The bearing capacity of the granular compaction pile is governed mainly by the lateral confining pressure mobilized in the native soft soil to restrain bulging collapse of the granular pile. Therefore, the technique becomes unfeasible in soft, compressible clayey soils that do not provide sufficient lateral confinement. This paper presents the main results of numerical study of granular compaction pile which is partly mixed with lean concrete. 3D finite element analyses are performed with composite reinforced foundations by both granular compaction pile and partly mixed granular compaction pile with lean-mixed concrete. Finally, a regression formula for calculating settlement reduction coefficients is proposed in this study by using numerical analysis results and applicability of the proposed method is identified by a series of parametric study about settlement reduction coefficients.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.31 no.4C
• /
• pp.127-136
• /
• 2011

The settlement of a compaction plate resting on the surface of rubble-mound and subjected to a vibrating vertical load can be characterized by a transient amplitude and a plastic settlement. As long as the maximum imposed load does not exceed the bearing capacity of the rubble-mound, plastic settlement will approach an ultimate value and essentially steady-state vibration will ensue. For the settlement behavior by vibro-compaction, most laboratory experiments were conducted on laterally confined samples with loads over the full surface area or on samples placed on a vibrating table. In the field, the loads cover only a small fraction of the surface area. In this study, crushed stones are loaded with the same as field condition. According to the vibro-compaction experiments on crushed stone, it was found that approximately 90% of total settlement occur within 2 minutes and plastic settlement increases with increasing cyclic stress levels including static and dynamic stress. A compaction equation on which the number of load cycles, amplitude of plate, settlement, width of plate, and cyclic stress are related each other is proposed.

• Journal of the Korean Society of Hazard Mitigation
• /
• v.9 no.4
• /
• pp.53-59
• /
• 2009

The purpose of this research is particle shape evaluation of granular soil and aggregate using Digital Image Process(DIP). DIP is very useful to measure the roughness and particle shape of aggregates. Couple of aggregates, like standard sand, two different crushed stones, and two different marine aggregates, have been employed. Shape factor of two different marine aggregates is ranged 0.35 to 0.54. Crushed stone I is that of 0.74 which is highly flat, but standard sand is elongated shape. Especially, two marine aggregate showed a big difference of width and length which meaned a long shape. There is any significant difference of elongation ratio and flakiness for each aggregate with different measuring system, like direct measurement of vernier calipers and DIP method. Within the limited test results, DIP is one of useful to get the particle shape of aggregate with limitation of measuring errors and to apply the particle distribution curve.

• Tunnel and Underground Space
• /
• v.26 no.5
• /
• pp.418-430
• /
• 2016

In this study, experimental study on cement grout materials containing anti-washout admixtures or accelerators in grout column for reinforcement technology in groundwater-saturated mining cavity was conducted. As a result, the cement milk containing anti-washout admixtures was suitable for mixed aggregates, and the cement mortar containing anti-washout admixtures and the cement milk containing accelerators were suitable for crushed stone aggregate in terms of forming grout column. Especially, in the case of crushed stone aggregate injecting the cement milk containing accelerators, the diameter of the grout column was greatest and the void of the crushed stone aggregate was filled with grout materials. Therefore the case of crushed stone aggregate injecting the cement milk containing accelerators is considered for optimal grout materials and aggregate.