• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.11
• /
• pp.753-764
• /
• 2020

In this study, the plastic zone and internal earth pressure of the tunnel were calculated using the following three methods: metal plasticity to analyze the deformation of metal during plastic processing, Terzaghi's earth pressure theory from the geotechnical perspective and modified Terzaghi's earth pressure theory, and slip line theory using Mohr-Coulomb yield conditions. All three methods are two-dimensional mathematical analysis models for analyzing the plane strain conditions of isotropic materials. Using the theory of metallurgical plastics, the plastic zone and the internal earth pressure of the ground were obtained by assuming that the internal pressure acts on the tunnel, so different results were derived that did not match the actual tunnel site, where only gravity was applied. An analysis of the plasticity zone and earth pressure via the slip-line method showed that a failure line is formed in a log-spiral, which was found to be similar to the real failure line by comparing the results of previous studies. The earth pressure was calculated using a theoretical method. Terzaghi's earth pressure was calculated to be larger than the earth pressure considering the dilatancy effect.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2000.11a
• /
• pp.80-80
• /
• 2000

차세대 대화면 평판 디스플레이에서 가장 주목을 받고 있는 디스플레이 소자는 PDP라고 할 수 있다. PDP 패널 제조 공정 기술에서 난해한 공정 중 하나인 투명 유전체 제조 공정은 현재까지 인쇄법에 의한 연구가 주로 진행되어 왔다. 그러나 인쇄법은 여러 번의 인쇄와 건조, 소성이 반복되어야 함으로써 유전체 제조에 있어서 복잡한 제조 공정이므로 대폭 단순화할 필요가 있다. 이에 대한 해결책으로서 제시된 것이 tape casting을 이용한 건식 공정이다. 본 연구에서는 tape casting용 slurry에 포함되는 유기물인 binder, plasticizer, solvent의 변화에 따른 dry film의 특성 및 소성 조건에 따른 유전체 특성에 관하여 조사하였다. PbO-SiO$_2$-B$_2$O$_3$계 유리 분말과 유기 vehicle을 ball mill을 이용하여 분산, 혼합하여 tape casting용 slurry를 제조하고, 이 slurry를 doctor blade법으로 tape를 제조하고 건조한 후 유리기판에 transfer한 후 소성하였다. Slurry의 조건과 소성 조건에 따른 투광성, 표면 조도 및 단면의 미세구조 등 투명 유전체의 특성을 평가하였다.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.29 no.5
• /
• pp.192-202
• /
• 2019

Physicochemical properties and sintering characteristics of pottery stone (Taebaek, Haenam, Aphae, Haengnam) were evaluated as a raw material for porcelain products. Due to acid leaching procedure, the concentration of iron oxide ($Fe_2O_3$) was decreased to < 1.0 wt%, which affects the whiteness of sintered samples. Mean particle size of acid leached samples is $5.7{\sim}10{\mu}m$ with narrow particle size distribution (PSD), which is lower than that of the pristine ($8{\sim}18{\mu}m$) with broad PSD. According to phase analysis by X-ray diffraction, most of pottery stones (PS) have Quartz phase as a main phase with Pyrophyllite as a second phase, however, Haenam PS shows halloysite phase. The absorption rate was in order of Taebaek (A, B, C)~Aphae (A, B) < Taebaek (Special A) < Haengnam < Haenam, and the samples sintered in reductive atmosphere showed lower absorption rate. This result might be due to the concentration of feldspar contained in PS, working as a flux in sintering process. Comparing the color of the sintered samples, the whiteness of refined PS (Taebaek special A, Haenam, Hangnam) is higher than acid leached PS (Taebaek A/B/C, Aphae A/B). The whiteness (L*) for refined PS is 95~97 %, which is higher than acid leached (82~96 %). This might be due to lower iron oxide concentration of the refined PS (0.11~0.58 %) than those of the acid leached PS (0.41~1.91 %) even though most of iron oxide was removed by acid leaching.

• Resources Recycling
• /
• v.19 no.3
• /
• pp.16-23
• /
• 2010

Coal briquette use has dramatically increased because of high oil prices. Hence, it is necessary to develop an environment-friendly recycling technique of the coal briquette ash. The coal briquette ash contains a large amount of an unburned carbon content and a mullite with high thermal property, so it is considered to be used as raw materials of sintered eco-brick. This study aimed to investigate on how the unburned carbon affects properties of the sintered eco-brick. The eco-brick was mixed with the ratio of 50 wt% coal briquette ash having the unburned carbon 10.5 wt% and 50 wt% cullet, then being sintered at $950^{\circ}C$, which of the compressive strength was in line with the first class of the sintered clay brick standard(KS L 4201). In particular, the compressive strength of the sintered eco-brick was equal to the first class of the KS L 4201 despite the increase of mixing ratio for coal briquette ash with 1.0 wt% unburned carbon to 70 wt%.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.33 no.6
• /
• pp.210-215
• /
• 2023

Raw mix burnability is an especially crucial factor in cement manufacturing technology, and it depends on the physical, chemical and mineralogical properties of each raw material. In this article, we compared the difference of burnability between the domestic and Japanese fly ash as cement raw materials by using Lafarge and Polysius evaluation method. Regardless of the type or amount of fly ash used, it was found to be more combustible when using fly ash. In both case, burnability improves as the amount of fly ash increases, especially the improvement in bunarbility is remarkable up to 3%. In conclusion, as the amount of fly ash increases within the range allowed by cement quality, burnability of raw materials improves, and thus the fuel cost required for the firing of clinker can also be expected to be reduced.

• Journal of the Korea Concrete Institute
• /
• v.13 no.6
• /
• pp.637-644
• /
• 2001

A regularization method based on the Duvaut-Lions viscoplastic scheme for plastic-damage and continuum damage models, which provides mesh-independent and well-posed solutions in nonlinear earthquake analysis of concrete dams, is presented. A plastic-damage model regularized using the proposed rate-dependent viscosity method and its original rate-independent version are used for the earthquake damage analysis of a concrete dam to analyze the effect of the regualarization and mesh. The computational analysis shows that the regularized plastic-damage model gives well-posed solutions regardless mesh size and arrangement, while the rate-independent counterpart produces mesh-dependent ill-posed results.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.17 no.3
• /
• pp.732-737
• /
• 2016

Using the pyrolyzed carbon black (PCB) from waste tires, the performance of 13 mm dense-graded hot mix asphalt was evaluated. The Marshall mix design was carried out and the measured optimal asphalt content was 5.8%. The impact resonant test was conducted to obtain the elastic modulus and damping ratio of the hot mix asphalt. The elastic modulus of HMA increased with increasing amount of PCB. On the other hand, there was no significant change in the damping ratio. The Marshall mix design, indirect tensile test, permanent deformation test, and program analysis were carried out. The strength ratio of the PCB modified asphalt mixtures was within 10%. More 10% of PCB was not good for the permanent deformation of hot mix asphalt. From the pavement design program, the use of 5% PCB in hot mix asphalt showed a decrease in the top-down crack, bottom-up crack, and permanent deformation. Judging from the limited test and analysis, the use of 5% PCB is good for enhancing the pavement performance.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.15 no.6
• /
• pp.3888-3893
• /
• 2014

The number of waste tires is increasing. One effective recycling method is the pyrolysis of waste tires. Using the pyrolyzed carbon black from waste tires, the characteristics of permanent deformation for PA-13mm porous mixture were evaluated. The confining pressure of 138 kPa and deviatoric stress of 551 kPa were adopted. The testing temperature was $45^{\circ}$ and 50 gyrations of the gyratory compactor was used to simulate the medium traffic level. The mixture modified by 10% PCB showed the largest Marshall Stability of 3.41 kN. The stability of the mixtures with PCB was 50% higher than that of mixture without PCB. The limited laboratory test showed that the use of PCB in a porous pavement decreases the permanent deformation and will be an effective alternative method to reducing the permanent deformation of a porous pavement.

• Journal of the Korean Applied Science and Technology
• /
• v.33 no.1
• /
• pp.129-135
• /
• 2016

CO oxidation was performed with Cu-Mn and Cu-Zn co-precipitated catalysts as differential precipitant, metal ratio and calcination temperature. The effects of differential metal mole ratio and calcination temperature in mixed metal oxide catalyst were investigated with CO oxidation reaction. Physiochemical properties were studied by XRD, $N_2$ sorption and SEM. 2Cu-1Mn with $Na_2CO_3$ catalyst calcined at $270^{\circ}C$ has a large surface area $43m^2/g$ and the best activity for CO oxidation. $Cu_{0.5}Mn_{2.5}O_4$ in XRD peak shows the lower activity than others. The catalytic activity over the catalyst calcined $270^{\circ}C$ displayed the highest conversion, and it was better activity comparing with Pt catalysts CO conversion.

• Journal of the Korean Applied Science and Technology
• /
• v.38 no.6
• /
• pp.1606-1615
• /
• 2021

The purpose of this study is to provide basic data for injury prevention and performance improvement by developing a flywheel training program for handball players. The results of analyzing the effects of the 12-week complex flywheel training program on body composition, physical fitness factors, anaerobic power, and isokinetic muscle function are as follows. There was a significant difference between groups in push-ups. Body fat percentage and anaerobic power showed significant differences in the interaction by period. Long jump, slow jump, grip strength, back muscle strength, anaerobic average power, and isokinetic muscle function tests showed significant differences by period in the left and right flexors. Therefore, it is considered that 12-week flywheel training results can be used as the basic data for injury prevention and improvement of performance in handball players.