• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.1
• /
• pp.52-59
• /
• 2009

In modern radars, dynamic range requirements far severed due to high CNR(Clutter-to-Noise Ratio) environment operation scenario. ADC spurious signal restricted the required dynamic range. In this paper, receiver gain of active phased array radar dependent on ADC nonlinear characteristic was analyzed. Within limited scope of ADC SFDR which blocks required system dynamic range, ADC dynamic range reaches trade-off with ADC SNR loss. Comparing antenna stage output noise voltage to that of ADC input, receiver gain was mathematically analyzed. Finally the whole contents were explained from the application example.

• The Journal of the Acoustical Society of Korea
• /
• v.23 no.5
• /
• pp.370-375
• /
• 2004

This paper proposes an algorithm that estimates three dimensional array shape calibration about the bottom-mounted sensor array. under the assumption that the active sources are in the far-field with unknown positions. Under some assumptions. we calculate the sensor positions via an algebraic solutions of a least squares problem that the linear equations are related to the sensor positions and directions or arrival. We give examples of algorithm performance from both computer simulations and sea test. We also illustrate the performance of sensor positions estimation as a function of time delay estimation variance and the distribution of the localizing sources.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.8
• /
• pp.826-831
• /
• 2008

This paper presents hybrid antenna(HA) design based on shaped reflector for mobile satellite communication. HA is composed of a shaped reflector and a feeder having $1{\times}8$ linear phased array, and reflector shaping method is applied for the performance optimization with minimum aperture size. And, in the feeder design, HA has another merit to minimize the manufacturing cost by optimizing the number of element. Proposed HA is designed at Ka-band and can electrically control a beam pattern within ${\pm}3^{\circ}$ in the basic angle of $+45^{\circ}$ in elevation. This antenna is designed to meet ITU-R S.465-5 for beam pattern including side-lobe level.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.6
• /
• pp.574-581
• /
• 2002

Microstrip $8{ imes}2$ sub-array antennas for a extension to active phased array antennas are designed, fabricated and measured for TX/RX dual operation in satellite communication and a reception of satellite broadcasting. For the frequency range from 11.7 to 12.75 GHz for RX and from 14 to 14.5 GHz for TX, two orthogonal linear polarizations of ${pm}45^{\circ}$ are used to transmit and receive simultaneously with one radiator. They adopt dual resonance between two patches for wideband characteristics in RX band and show isolation characteristics over 20 dB. An electrical beam tilt of $30^{\circ}$ is achieved and a tapered power distribution, narrow element spacing are used for the purpose of low side-lobe characteristics.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.1
• /
• pp.130-136
• /
• 2014

This paper reviews the research on silicon based phased array system operating from microwave to millimeter wave frequencies. First, the design of phase shifter using CMOS technology is presented. The passive phase shifter is applied to the transmit/receive module from one to 16 channel in a single chip. The 35 GHz 4-element T/R module consumes less than 200 mW both transmit and receive modes. The architecture can extend to 16-channel operating at 44 GHz, thereby improving transmit power and linearity. The Ku-band 2-antenna 4-element receiver was developed using active phase shifter based on vector sum method. It is important to minimize coupling between beams because the chip contains four independent beams. The method of coupling is presented and verified.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.38 no.1
• /
• pp.34-42
• /
• 2001

The new periodic array structure or frequency selective surface with polarizers characteristic is proposed. The present structure is constructed with two sheets or FSS material, spaced about one-eight wavelength apart, the dipole element orientations of the two sheets being almost perpendicular to each other. The methods of the spectral domain immittance and MoM are used to analyze electromagnetic scattering from this periodic array structure. To confirm the validity of the polrizer's functions or the new periodic array structure, frequency selective surfaces are fabricated, calculated values for the frequency response of the reflection and transmission loss are compared with measured values. Good correspondence has been observed between them. Good axial ratio has been also observed to be achieved in the proposed structure.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.20 no.6
• /
• pp.18-22
• /
• 1983

In this paper, we derive and analyze the peak sidelobe estimator of the planar random array antenna by extending the theory of the linear random array antenna. The computer simula-tions, which are based on Monte Carlo method, are programmed and applied easily to cases where a great number of array elements are involved. The results obtained from the computer simulations show that there is a little difference of the maximum 0.8 dB. Consequently, the peak sidelobe estimator is well consistent with the results of the computer simulations over confidence level 0.5.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.2 no.1
• /
• pp.71-77
• /
• 1998

In this Paper, the training principles and the control method of adaptive array antennas using the LMS and CMA algorithms for the $\pi$/4 QPSK signal is showed and the convergence characteristics, the adaptivity of directional pattern SINR and the replication of desired signal of adaptive arrays are compared and discussed each other. Computer simulation results showed that the SINR of LMS adaptive array was 13.8［dB］, and that of CMA was 12.8［dB］, and also the convergence characteristics of LMS was fast a little than that of CMA. The LMS adaptive array was also performed null point well for the interference signal direction than that of the CMA adaptive array.

• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 2008.10a
• /
• pp.158-161
• /
• 2008

In the line array roll set (LARS) process, the initial plate is progressed into the final shape in a stepwise or pathwise manner according to the basic principle of the incremental forming process. The deformation proceeds simultaneously in the longitudinal and transverse directions. It was found that the curvature level of the formed plates in the previous study was well over the curvature required in shipyards. This fact shows that the LARS method has considerable potential for shipbuilding applications. In this study, several experiments with the LARS system is carried out fur manufacturing of plates with large curvatures. The bulbs at a stem and stern among ship hull plates correspond to these plates. Furthermore, the qualities of formed plates are evaluated according to the types of roll arrangements through experimental and numerical analyses.

• Proceedings of the Acoustical Society of Korea Conference
• /
• spring
• /
• pp.249-252
• /
• 2000

본 논문에서는 수중음향측정을 위한 수직선배열측정 체계 설계 개념을 연구한다. 본 연구에서는 수직선배열 측정체계를 이용한 음향측정 시 고려해야 할 설계 기법들을 고찰하고, 측정 주파수 대역에서 지향지수가 균일하게 유지되는 비선형 센서배열 설계 알고리즘과 피측정 음원의 위치추정을 위한 음향학적 능/수동 추적 알고리즘을 제안한다 제안 알고리즘의 유용성은 시뮬레이션과 해상시험으로 확인한다.