• Journal of Adhesion and Interface
• /
• v.8 no.3
• /
• pp.9-15
• /
• 2007

The interfacial evaluation of surface modified Jute fiber/polypropylene (PP) composites before and after hydration was investigated using micromechanical test and dynamic contact angle measurement. The IFSS of alkaline and silane-treated Jute fiber/PP composites increased, whereas after hydration, the IFSS of the untreated, alkaline- and silane-treated Jute fibers/PP composites decreased due to swelled fibrils by water infiltration. The interfacial adhesion of silane treated fiber/PP composites was higher than alkaline-treated or the untreated cases. The surface energies of Jute fiber treated under various conditions were obtained using dynamic contact angle measurement. Especially after hydration, the thermodynamic work of adhesion was calculated by considering water interlayer, which indicated the stability of IFSS between silane treated Jute fiber and PP matrix showing better than others.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.28 no.4A
• /
• pp.573-580
• /
• 2008

In this paper, we estimated the effect of the siliceous filler's particle size on the performance of Ultra High Performance Concrete (UHPC). Filler's particle diameters considered in this paper were about 2, 4, 8, 14, $26{\mu}m$ and the performance was evaluated by testing fluidity in fresh concrete, compressive strength, ultimate strain, elastic modulus and flexural strength in hardened concrete. We also carried out XRD and MIP tests to analyze the relationship between the mechanical properties and microstructure. Test results showed that the smaller filler's particle size improves flowability and strength properties. MIP results revealed that the smaller size of filler decreased the porosity and thus increased the strength of UHPC. From XRD analysis, we could find out there were little influence of filler's particle size on chemical reactivity in UHPC.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.48 no.4
• /
• pp.102-107
• /
• 2011

In this paper, a microfluidic array biochip for simultaneously detecting multiple antigen-antibody bindings was designed and implemented. The biochip has the single channel in which microreaction chambers are serially connected, and the antibody-coated microbeads are packed in each microreaction chamber. In addition, the weir structure was fabricated in the microchannel using the gray-scale photolithography in order to trap the microbeads in the microreaction chamber. Three kinds of antibodies were chosen, and the antibodies were immobilized onto the microbeads by the streptavidin-biotin conjugation. In the experiment, as the fluorescence-labeled antigens were injected into the microchannel, the antigen-antibody bindings were completed in 10 minutes. When the solution with multiple antigens was injected into the microchannel, it was observed that the fluorescence intensity increased in only the corresponding microreaction chambers with few non-specific binding. The microfluidic array biochip implemented in this study provides, even with the consumption of tiny amount of sample and fast reaction time to simultaneously detect multiple immunoreactions.

• Journal of the Korean Wood Science and Technology
• /
• v.42 no.3
• /
• pp.346-355
• /
• 2014

Confocal reflection microscopy (CRM) was utilized to create 3-dimensional images of bordered pits and cell wall in the tracheid of Korean red pine (Pinus densiflora). Ultrastructures of torus, margo, and pit border were clearly observable in the CRM micrograph. Micrograph of cross-field pit revealed the connecting and supporting structure between tracheid and ray parenchyma cell. The CRM micrographs enabled to investigate detailed structures of tracheid cell wall such as S1, S2, S3 layers, transition layers between these layers, and microfibril (MF) orientation in S3 and S2 layers as well as complicated distribution of MF orientation around bordered pits. Not only concentric MF orientation of border thickening in the pit border was observed, but also changes in MF orientation from the cell wall to the border. From the experimental results, the CRM was thought to be a versatile microtechnique to investigate detailed structures of cell wall and bordered pit in the tracheid and cross-field pit between tracheid and ray parenchyma cell.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.26 no.6
• /
• pp.112-119
• /
• 2022

Recently, as carbon neutrality has been important factor in the construction industry, many studies have been conducted on the high-volume fly ash concrete. High volume fly ash concrete(HVFC) is usually made by replacing more than 50% of cement with fly ash. However, HVFC has a disadvantage of low compressive strength in early age. To overcome this shortcoming of HVFC, improve this, interest in techonolgy using nanomaterials is increasing. Nano silica is expected to improve the early age strength of HVFC as a pozzolanic material. This study investigated the effect of nano silica on the early hydration reaction and microstructure of HVFC. The early hydration reaction of HFVC was analyzed through setting time, isothermal calorimeter, compressive strength and thermal weight analysis. In addition, the microstructure of HVFC was measured by mercury intrusion porosimetry. From the test results, it was confirmed that nano silica increased the early age strength and improve the microstructure of HVFC.

• Journal of Chest Surgery
• /
• v.36 no.11
• /
• pp.799-811
• /
• 2003

Background: The aim of this study is to define the cardioprotective effects (hemodynamic, cytochemical and ultrastructural of the newly developed Histidine-Tryptophan-Ketoglutarate (HTK) cardioplegia compared to DelNido cardioplegia. Material and Method: Seventy-nine isolated rat hearts were divided into three groups on the basis of techniques of cardioplegia infusion. Twenty-eight hearts (Group 1) were flushed with cold DelNido cardioplegia with every 40 minutes for 2 hours. Twenty-seven hearts (Group 2) were flushed with cold HTK cardioplegia for once during the 2 hours. Twenty-four hearts (Group 3) were flushed with cold HTK cardioplegia with every 40 minutes for 2 hours. Heart rate, left ventricular developed pressure (LVDP), changes of + dp/dt max, coronary flow, and rate-pressure product value were measured at pre-ischemic, post-reperfusion 15 minutes, 30 minutes, and 45 minutes for hemodynamic study. Aspartate aminotransferase (AST), lactate dehydrogenase (LD), creatine kinase (CK), CK-MB, troponin-I, myoglobin, and lactate were measured at pre-ischemic and post-reperfusion 45 minutes for cytochemical parameters. Mitochondrial scores were counted in 3 cases from each group for ultrastructural assessment. Result: In hemodynamic study, there were no significant differences among group 1, group 2, and group 3. However, the decrease values of heart rate in group 2 and 3 exhibited significantly lower values than in group 1. In cytochemical study, there were no significant differences among group 1, group 2, and group 3. However, the increase values of lactate in group 2 and 3 exhibited significantly lower values than in group 1. In ultrastructural assessment, the mean myocardial mitochondria scores in group 1, group 2, and group 3 were 2.14$\pm$0.10, 1.52$\pm$0.57, and 2.10$\pm$0.16. Conclusion: HTK solution provides adequate myocardial protection with some advantages over DelNido solution in isolated rat hearts.

• The Journal of the Acoustical Society of Korea
• /
• v.42 no.1
• /
• pp.7-15
• /
• 2023

Recently, as interest in air quality in vehicles increases, the use of fine dust detection sensors for air quality measurement is becoming common. An axial-flow fan is inserted in the fine dust sensor installed in the air conditioning system in the vehicle to prevent dust from sinking directly on the sensor. When the sensor operates, the flow noise caused by the rotation of the axial-flow fan acts as a major noise source of the fine dust sensor. flow noise is recognized as one of the product competitiveness of fine dust sensors. In this study, the noise was gradually reduced at the same flow rate by improving the flow performance of the small axial flow fan. First, a virtual fan performance tester consisting of about 20 million grids was developed to analyze the aerodynamic performance of the target small axial-flow fan. In addition, the flow field was simulated by using compressible Large Eddy Simulation for direct computation of flow noise as well as high-accurate prediction of flow rate. The validity of numerical method are confirmed through the comparison of predicted results with experimental ones. After the effects of pitch angle on flow performance were analyzed using the verified numerical method, the pitch angle was determined to maximize the flow rate. It was found that the flow rate was increased by 8.1 % and noise was reduced by 0.8 dBA when the axial-flow fan with the optimum pitch angle was used.

• Journal of Life Science
• /
• v.33 no.5
• /
• pp.429-435
• /
• 2023

Epidemiological studies suggest that maternal infection, maternal stress, and environmental risk factors during pregnancy increase the risk of brain development abnormalities associated with cognitive impairment in the offspring and increase susceptibility to schizophrenia and autism spectrum disorder. Several animal models have demonstrated that maternal immune activation (MIA) is sufficient to induce abnormal brain development and behavioral defects in the fetus. When polyinosine:polycytodylic acid (poly I:C) or lipopolysaccharide (LPS), which is commonly used in maternal immune activation animal models, was introduced into a pregnant dam, an increase in pro-inflammatory cytokines and microglial activity was observed in the offspring's brain. Microglia are brain-resident immune cells that play a mediating role in the central nervous system, and they are responsible for various functions, such as phagocytosis, synapse formation and branching, and angiogenesis. Several studies have reported that microglia are activated in MIA offspring and influence offspring behavior through interactions with various cytokines. In addition, it has been reported that they play an important role in brain circuits through interactions with neurons and astrocytes. However, there is controversy concerning whether microglia are essential to brain development or lead to behavioral defects, and the exact mechanism remains unknown. Therefore, for the potential diagnosis and treatment of brain developmental disorders, a functional study of microglia should be conducted using MIA animal models.

• The Journal of Engineering Geology
• /
• v.33 no.4
• /
• pp.701-716
• /
• 2023

Microplastics (<5 mm diameter) in aquatic environments adsorb heavy metals, potentially exposing humans to their toxic effects via food chains. We investigated factors influencing the adsorption of heavy metals on microplastics in aquatic environments, examining their adsorption processes and mechanisms. Adsorption characteristics vary with polymer type, crystallinity, particle size, and environmental conditions (pH, temperature, weathering), and the adsorption capacity for heavy metals increases with weathering and reduction in polymer particle size. However, correlations between environment temperature, polymer crystallinity, and adsorption capacity for heavy metals could not be confirmed. The adsorption behavior of heavy metals can be explained in terms of physicochemical adsorption processes and evaluated through adsorption kinetics and isothermal studies, with multiple mechanisms usually being involved. An understanding of the adsorption of heavy metals by microplastics should aid evaluation of the potential risks of microplastics in aquatic environments.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.31 no.9
• /
• pp.18-25
• /
• 2003

In this paper, thermal conductivities of carbon-phenolic 8-harness satin weave composite, ACP302, were measured and predicted. In the analysis, the satin weave unit cell was identified and modeled discretely by 3-dimensional finite elements, considering the interlaced fiber tow architecture microscopically. At the unit cell boundary, the corresponding periodic boundary conditions were applied. The results were analyzed to investigate the effect of microstructural parameters such as stacking phase shifts, waviness ratio, and fiber volume fraction. The conductivities were also obtained by experiments and compared with the numerical results.