• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.4C
• /
• pp.321-329
• /
• 2008

H.264/AVC video coding standard enables a considerably higher improvement in coding efficiency compared with previous standards such as MPEG-2, H.263 and MPEG-4. To achieve this, for each macro-block in H.264/AVC, Rate-Distortion Optimization (RDO) technique is employed to select the best motion vector, reference frame, and macro-block mode. As a result, computational complexity is increased significantly whereas RDO achieve higher improvement. This paper presents fast intra mode selection algorithm based on constraints of frequency characteristics which are derived from intra coding modes of H.264/AVC. First of all, we observe the features of each intra mode through the frequency analysis of image. And then proposed Frequency Error Costs (FECs) are calculated to select the best mode which has minimum cost. Computational complexity is considerably reduced because rate-distortion costs only calculate the candidate modes which are set of best mode and its neighbouring two modes. Experimental results show that proposed algorithm reduces the complexity dramatically maintaining the rate-distortion performance compared with H.264/AVC reference software.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.10 no.6
• /
• pp.113-123
• /
• 2006

As Cable-stayed bridges were constructed to the long span, they have become bigger and had weaknesses to vibration induced by earthquake, wind and vehicle loads. Structural damages induced by these loads affect the characteristic of vibration modes of structure. Damage detection of cable-stayed bridges by using existing safety diagnosis is difficult to detect the characteristic change of overall structural action. Also it requires very much time and cost. So in this study, the investigation of characteristic change of structural action and the detection of structural damages is analyzed by using characteristic properties of vibration mode before and after structural damage.

• Proceedings of the KIEE Conference
• /
• 2015.07a
• /
• pp.1256-1256
• /
• 2015

방열판과 같이 전류나 전압원에 연결된 도체의 구조물은 유기된 전류에 의해 전파를 방사하게 된다. 이때의 전류 분포는 도체 구조물의 형상과 주파수에 따른 전류 분포를 갖게 되는데, 이는 모드의 특성 해석을 통하여 분석할 수 있다. 원치 않는 전파의 방사를 이 특성 모드 해석을 통하여 분석하고, 이를 통해서 효율적인 접지 위치를 선정 후 최적의 저항을 사용하여 원치 않는 전파의 방사가 최소가 되도록 한다.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.14 no.2
• /
• pp.75-84
• /
• 2010

An in-cabinet response spectrum should be generated to perform the seismic qualification of devices and instruments mounted inside safety-related electrical equipment installed in nuclear power plants. The response spectrum is available by obtaining accurate seismic responses at the device mounting location of the cabinet. The dynamic behavior of most of electrical equipment may not be easily analyzed due to their complex mass and stiffness distributions. Considering these facts, this study proposes a procedure to estimate the seismic responses of a structure by a combination of a test and subsequent analysis. This technique firstly constructs the modal equations of the structure by using the experiment modal parameters obtained from the impact test. Then the seismic responses of the structure may be calculated by a mode superposition method. A simple steel frame structure was fabricated as a specimen for the validation of the proposed method. The seismic responses of the specimen were estimated by using the proposed technique and compared with the measurements obtained from the shaking table tests. The study results show that it is possible to accurately estimate the seismic response of the structure by using the experimental modal parameters obtained from the impact test.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.17 no.4
• /
• pp.389-403
• /
• 2004

This study presents the structural model modification based on the modal data such as natural frequencies and mode shapes. Preliminary structural model can be obtained using design drawings and field measurement, and therefore the deteriorated stiffness of a structure and the effect of the boundary conditions are difficult to be evaluated in preliminary analysis model, and the preliminary model can be modified using structural response data including static and/or dynamic characteristics. In this study, the structural model is modified based on the structural modal data using genetic algorithm. Modal testing were carried out for Imjin River Bridge and Hangjoo Bridge, the modal properties were estimated using modal identification techniques, and finally the structural models were updated using genetic algorithm. The modified structural model could give us more reliable structural analysis results and therefore those can be used for structural performance evaluation such as load carrying capacity and seismic capacity.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.48 no.7
• /
• pp.28-34
• /
• 2011

Radiation characteristics of a dual-mode inductor loaded patch antenna using zeroth order resonance and half wavelength resonance are investigated. The isolation between two radiation patterns from the two different modes is improved by increasing the forward radiation and decreasing the horizontal radiation of half wavelength resonance mode. The frequency difference between the two resonant frequencies increases as the dielectric constant of the antenna substrate decreases and the operating frequency increases.

• Proceedings of the Optical Society of Korea Conference
• /
• 2000.08a
• /
• pp.82-83
• /
• 2000

굴절율이 외부보다 큰 실린더 (cylinder)나 스피어 (sphere)는 경계면에서의 전반사에 의해 손실이 매우 적은 high-Q 공진기가 될 수 있음이 잘 알려져 있다. 크기가 수 십 $mu extrm{m}$ 되는 실린더나 스피어에서의 공명모드는 편광(TM, TE), 모드 수 (mode number) n, 모드 순서 (mode order) l에 의해 정의되고 WGM (whispering gallery mode)라고도 불리워진다$^{(1)}$ . 모드 수n 이 클수록 모드 순서 l이 작을수록 공명모드의 Q 값은 큰 경향을 가진다. 액체 방울이나 액체 제트와 같이 열적 섭동에 민감한 마이크로 공진기 (micro-cavity)의 경우 Q값이 $10^{7}$ 정도로 제약되나, 실리카 마이크로 스피어 (micro-sphere)와 같은 고체 구에서 측정된 Q값은 약 $101^{10}$ 정도로 손실이 매우 적은 공진기가 될 수 있다$^{(2)}$ . 이와 같은 마이크로 공진기 특성을 이용하여 다양한 형태의 마이크로 공진기 레이저 대한 연구가 진행되어 왔다. 색소가 첨가된 고체구, 액체 방울, 액체 제트 등에서 기본적인 실험이 이루어졌고 반도체마이크로 스피어 구조에서 WGM 레이저$^{(3)}$ , polymer disc laser$^{(4)}$ , 광양자테 (photonic quantum ring)$^{(5)}$ 특성 연구 등이 실용가능성을 목표로 진행되고 있다. (중략)

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.10 no.6
• /
• pp.296-307
• /
• 1985

The reults of the interlaboratory measurement comparison of the multimode and single mode fiber papameters are reported. 7 multi-mode fiber spools and 4 single mode spools are used and 5 independent domestic organizations (ETRI & 4 optical fiber manufacturing companies) are participated in the comparison study. Our results are compared with those of the comparison studies conducted in the foreign countries.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2020.11a
• /
• pp.434-437
• /
• 2020

블록암호는 정해진 길이의 평문을 암호화하는 암호 알고리즘으로 정해진 길이보다 더 긴 평문을 암호화하기 위해 다양한 운용모드가 제안되었다. 그 중에서 카운터 모드는 블록암호를 스트림암호 형태로 바꿔주는 모드로, 평문 대신 고정 값인 논스와 블록의 순번인 카운터를 입력 값으로 사용한다. 카운터 모드는 논스 값이 고정이기 때문에 암호 연산 중에 논스가 사용되는 부분의 다른 변수가 모두 고정 값이라면 결과가 항상 동일하다는 특성이 있다. 본 논문에서는 전술한 특성을 사용하여 카운터 모드 최적 구현을 한 블록암호에 대해 정리하며, 각각의 성능을 비교해볼 것이다. 개략적으로 AES 기존 구현물보다 약 16% ~ 32% 정도의 성능 향상을 보이고 CHAM은 약 10% ~ 13% 정도의 성능 향상을 보였다.

• Journal of Convergence for Information Technology
• /
• v.12 no.3
• /
• pp.151-157
• /
• 2022

The purpose of this study was to investigate the frequency characteristics of forced vibration considering the vehicle progress. And the vibration characteristics in frequency domain that occur, when vehicle passes the bump, were analyzed. The responses such as displacement, velocity and acceleration were obtained through numerical analysis, and FFT processing was performed to analyze the frequency response function(FRF) characteristics. In particular, the location of vehicle eigenmodes and external excitation modes was clearly shown and analyzed. In the forced vibration model by external force, the behavior of the eigenmode in power spectrum and real and imaginary parts were also analyzed. The mode characteristics were also analyzed in each FRF. It was approximated by assuming total excitation force by considering the exciting frequency using impulse and sine wave forces, which can give the amplitude and frequencies. The response characteristics of forced oscillations having different mass, damping and stiffness have been systematically discussed.