• Applied Biological Chemistry
• /
• v.41 no.6
• /
• pp.431-436
• /
• 1998

The optimum ohmic heating condition of apple juice was investigated with model solution. The temperature rise of model solution was found to be $7.8,\;21.0,\;47.4^{\circ}C/min$ when the distances between electrodes were 29, 22, and 17mm, respectively. The heating rate increased proportionally with the numbers of electrode pairs, 1 to 3 and highly dependent on applied voltage. The heating rate was not affected by the frequencies ranged from 60 Hz to 60 KHz and the wave form of applied alternating electric current. The apple juices prepared by ohmic heating sterilization revealed similar physicochemical properties to that by commercial sterilization.

• Membrane Journal
• /
• v.14 no.1
• /
• pp.75-84
• /
• 2004

In this study, we present a noble study far membrane transport models using chlorine resistance of polyamide RO membranes. Membrane transport mechanism is investigated by the comparison of membrane permeation performance under the continuous and Intermittent operation modes with mixed feed solution containing NaOCl and NaCl. Analysis of permeation performance indicates that solution-diffusion model and preferential adsorption-capillary flow model are relatively efficient according to operation mode. Under the continuous flow state, mass transfer depends on preferential adsorption-capillary flow model rather than solution-diffusion model. On the other hand, it prefers solution-diffusion model to preferential adsorption-capillary flow model under the stationary state. SEM images of NaOCl treated membrane surfaces strongly support these conclusions. These surface images reveal that NaOCl treated membrane in continuous operation mode exhibits ridge and valley structure in some fraction of the surface area, whereas that in intermittent operation mode shows surface degradation entirely.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.26 no.1
• /
• pp.8-13
• /
• 2016

A top-seeded solution growth (TSSG) is a method of growing SiC single crystal from the Si melt dissolved the carbon. In this study, multiphysics modeling was conducted using COMSOL Multiphysics, a commercialized finite element analysis package, to get analytic results about electromagnetic analysis, heat transfer and fluid flow in the Si melt. Experimental results showed good agreements with simulation data, which supports the validity of the simulation model. Based on the understanding about solution growth of SiC and our set-up, crystal growth was conducted on off-axis 4H-SiC seed crystal in the temperature range of $1600{\sim}1800^{\circ}C$. The grown layer showed good crystal quality confirmed with optical microscopy and high resolution X-ray diffraction, which also demonstrates the effectiveness of the multiphysics model to find a process condition of solution growth of SiC single crystal.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.20 no.6
• /
• pp.572-581
• /
• 1991

For the development of a model to predict absorbed salt quantity in radish during salting, absorbed salt quantity and water content change in radish by the hour were measured at 5%, 10%, 15% brine concentration and $10^{\circ}C,\;20^{\circ}C,\;30^{\circ}C$ respectively. Absorbed salt quantity in radish by the time showed logarithmic function, absorbed salt quantity by brine concentration and temperature showed linear relation. A model to predict absorbed salt quantity in radish at each time, brine concentration and temperature was calculated by the regression program of SPSS. Apparent diffusivity of salt in radish was calculated from appropriated diffusion equation solution of Fick's second law using computer simulation. Salt diffusivity in radish increased as brine concentration increased and the effect of temperature could by expressed by Arrhenius equation. A model equation which could predict salt diffusivity was developed by regression analysis. To specify relation between salt quantity which absorbed into radish and water content which removed out of it, Flux ratio(${\Delta}W/{\Delta}S$) was calcuated. The values showed that the removed water content was greater than the absorbed salt quantity.

• The Korean Journal of Rheology
• /
• v.1 no.1
• /
• pp.54-62
• /
• 1989

준희박과 농축용액에서 약간의 유연성을 갖는 강성막대형 고분자의 회전확산계수와 zero shear rate 점도를 예측하기 위해 한정된 강성 사슬모델이 제시되었다. 본 연구에서는 이제시된 모델을 분자량 분포를 갖는 다분산계로 확장시켰다. 분자들의 분자량 분포 (MW/Mn) 와 분포 함수를 알수 없기 때문에 해당분자에 가장 적당한 분자량 분포와 함수를 취하였다. 만약 이것들을 알고 있다면 제시된 모델로 회전확산계수와 zero shear rate 점도 등과 같은 인자들을예측할수 있었다. 단분산계의 경우와 같이 다분산계에서도 회전확산계수 의 평균분자 윤곽길이 의존도는 L-7 에 비례하는 것으로 나타났다. Doi와 Edwards 의 튜브 모델에 의한 L-9 과 다른 이유는 분자들의 거동을 관찰하기 위해 임의로 선정된 하나의 막 대형 고분자운동을 제약하는 정도가 심하지 않았으며 따라서 제약 완화시간도 훨씬 짧았기 때문이다. 더구나 점도와 회전 확산계수와 단분산계에서는 정성적으로 일치한데 제약 완화 시간도 훨씬 짧았기 때문이다. 더구나 점도와 회전적인 일치를 나타내었다. 이 모델로 기준 으로 하여 분자들의 길이와 종류에 관계없이 하나의 master curve를 그릴수 있었다.

• Membrane Journal
• /
• v.11 no.4
• /
• pp.161-169
• /
• 2001

Single and mixed particle suspensions of kaolin, bentonite, starch and PMMA were carried out using a dead-end Amicon fi1tration cell with microfilteration membranes. The experimental data of permeate fluxes were fitted by the constant pressure fi1tration models in order to investigate fouling steps. In 0.1 wt% mixed solution of equal amount of kaolin and starch, the permeation flux was about 30% lower than the average of each particle flux. However, the permeation flux for kaolin/PMMA mixed solution was about 10% higher than the average of each particle flux. In the cases of bentonite and PMMA or starch mired solution, the improvement effect on permeation flux was weaken than that of kaolin mixed solution. Also, the membrane fouling resistance for mixed particle solution of equal amount of kaolin and starch was minimum at 0.05 wt% particle concentration.

• KSBB Journal
• /
• v.26 no.1
• /
• pp.13-18
• /
• 2011

In this study, precipitation process was developed for the recovery of the lactic acid from calcium lactate fermentation broth. Calcium lactate yield was improved by decreasing the solubility of calcium lactate through the addition of ethanol (25%, v/v) as a co-precipitant. The optimal lime type, lime concentration, stirrer speed, precipitation time, temperature, and solvent amount for $Ca(LA)_2$ precipitation were CaO, 0.0175 g/mL, 220 rpm, 24 h, $5^{\circ}C$, ethanol 25% (v/v), respectively. Lactic acid was easily and efficiently recovered from precipitated $Ca(LA)_2$ by adding sulfuric acid ($Ca(LA)_2/H_2SO_4$ molar ratio=1:1). In the model solution of organic acids and fermentation broth, the overall yields of recovered lactic acid were 62% and 55%, respectively, under the aforementioned optimal conditions.

• The Korean Journal of Rheology
• /
• v.7 no.3
• /
• pp.211-224
• /
• 1995

묽은 고분자 용액의선형 점탄성과 완화시간 스펙트럼에 대하여 비드수, 유체역학적 상호작용, 배제 부피와 비선형 스프링들의 영향을 비드-스프링 모델을 통하여 연구하였다. Fixman의 모델을 개량하였고, 비선형 스프링개념을 도입한후 선형점탄성에 관한 식들을 유 도하였다. 그중에서 주로 복고 점도의 크기와 위상차에 대한 BSM 파라미터들의 영향을 살 펴보았다. 실험데이터에서 진동수에 따른 위상차의 평평한 부분의 길이로부터 비드수를 Mark-Houwink 식의 지수 값으로부터 유체역학적 상호작용 파라미터를 그리고 fitting 파라 미터로써 배제 부피 파라미터와 비선형 스프링 파라미터의 함수형태로 표현되는 동적 확장 파라미터를 결정할수 있었다. 또한 광산란 실험등으로부터 배제 부피 파라미터를 결정하게 된다면 이로부터 비선형 스프링 파라미터도 결정할수 있음을 알수 있었다. 한편 불연속적인 현태인 BSM의 완화시간 스펙트럼에 미치는 BSM 파라미터들의 영향을 분석함으로써 각 파람터의 효과와 차이점을 분명히 알수 있었다. 본논문에서는 BSM에 비드수, 유체역학적 상호작용 배제 부피 그리고 비선형 스프링 효과를 동시에 적용하는 방법을 제시하였으며 이 방법을 통하여 묽은 고분자 용액의 선형 점탄성 실험 데이터를 정량적으로 설명할 수 있었다.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 1998.06a
• /
• pp.3-7
• /
• 1998

본 연구에서는 광산 인근 토양에서 산성비를 비롯한 침출수에 의한 지하 환경 오염 메카니즘을 검토하고, 오염 방지 및 교정과 대안의 효과를 정량화 하기 위한 방안을 고찰하였다. 이를 위하여 중금속인 비소의 오염도가 높은 토양을 대상으로 인위적 산성용액에 의한 비소의 용출을 실험적으로 검토하였다. 한편, 산성 침출오염수에 의한 지하 환경의 오염을 방지하기 위하여 석회석을 활용한 토양의 안정화방법의 효과를 살펴보았다. 오염된 시료토양에 포함된 비소는 pH 1 이하의 강산성 용액일수록 격렬히 용출되었으며, pH 값이 낮아질 수록 최대 용출량은 증가되는 것으로 나타났다. 석회석에 의한 토양 안정화방안은 매우 효과적이었으며, 석회석에 의한 산성용액의 중화반응 특성식은 미반응 핵 모델중에서 화학반응이 속도지배인 특성식에 잘 부합되는 것으로 보여진다.

• Korean Journal of Crystallography
• /
• v.14 no.1
• /
• pp.35-38
• /
• 2003

A simple multistep-concentration setting in capillaries was used to control the water-evaporation rate in vapor-diffusion protein crystallization. In the method used, a variety of evaporation rate curves were obtained by using the secondary precipitant solution referred to as “regulatory solution”, which is not directly exposed to the protein solution. The curves were applied to the crystallization of lysozyme as a model protein. The results clearly showed that crystal growth is dependent on the evaporation rate. Especially, the decoupling curves in which precipitant concentration in protein solutions increases to a certain point and then decreases to the equilibrium concentration gave the best crystals.