• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.1
• /
• pp.59-67
• /
• 2016

A novel instrumentation amplifier (IA) using fully-differential linear operational transconductance amplifier (FLOTA) for electronic measurement systems with low cost, wideband, and gain control with wide range is designed. The IA consists of a FLOTA, two resistor, and an operational amplifier(op-amp). The principal of the operating is that the difference of two input voltages applied into FLOTA converts into two same difference currents, and then these current drive resistor of (+) terminal and feedback resistor of op-amp to obtain output voltage. To verify operating principal of the IA, we designed the FLOTA and realized the IA used commercial op-amp LF356. Simulation results show that the FLOTA has linearity error of 0.1% and offset current of 2.1uA at input dynamic range ${\pm}3.0V$. The IA had wide gain range from -20dB to 60dB by variation of only one resistor and -3dB frequency for the 60dB was 10MHz. The proposed IA also has merits without matching of external resistor and controllable offset voltage using the other resistor. The power dissipation of the IA is 105mW at supply voltage of ${\pm}5V$.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.45 no.1
• /
• pp.64-70
• /
• 2008

The H.264 standard is widely used due to the high compression rate and quality. The deblocking filter of the H.264 standard improves the quality of images by eliminating blocking artifacts of pictures, and it requires a lot of computation. We propose a new hardware architecture for the deblocking filter with pipelined architecture, 1-D filters which support both horizontal and vertical filtering and efficient memory management. Four memory blocks are configured for the efficient storage and access of the current macroblock and adjacent referenced sub-macroblocks, and the pixel data from the motion compensation unit can be transferred without waiting during the computation cycles of the deblocking filter. The number of computation cycles and the hardware area are reduced using the proposed architecture, and the performance of the H.264 decoder is improved. We design the deblocking filter using Verilog-HDL and implement using an FPGA. The designed deblocking filter can be used for decoding HD quality images at 77 MHz.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.2
• /
• pp.327-334
• /
• 2016

In this paper, we propose a hardware architecture of transform and quantization for high-perfornamce HEVC(High Efficiency VIdeo Coding) encoder. HEVC transform decides the transform mode by comparing RDCost to search for the best mode of them. But, RDCost is computed using the bit-rate and distortion which is computed by transform, quantization, de-quantization, and inverse transform. Due to the many calculations and encoding time, it is hard to process high resolution and high definition image in real-time. This paper proposes the method of transform mode decision by comparing sum of coefficient after transform only. We use BD-PSNR and BD-Bitrate which is performance indicator. Based on the experimental result, We confirmed that the decision of transform mode can process images with no significant change in the image quality. We reduced hardware area by assigning different values at the same output according to the transform mode and overlapping coefficient multiplied as much as possible. Also, we raise performance by implementing sequential pipeline operation. In view of the larger process that we used compared with the process of reference paper, Our design has reduced by half the hardware area and has increased performance 2.3 times.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.45 no.5
• /
• pp.192-200
• /
• 2008

Multimodal biometrics is a method for personal authentication and verification using more than two types of biometrics data. RBF based score-level fusion uses pattern recognition algorithm for multimodal biometrics, seeking the optimal decision boundary to classify score feature vectors each of which consists of matching scores obtained from several unimodal biometrics system for each sample. In this case, all matching scores are assumed to have the same reliability. However, in recent research it is reported that the quality of input sample affects the result of biometrics. Currently the matching scores having low reliability caused by low quality of samples are not currently considered for pattern recognition modelling in multimodal biometrics. To solve this problem, in this paper, we proposed the RBF based score-level fusion approach which employs quality information of input biometrics data to adjust decision boundary. As a result the proposed method with Qualify information showed better recognition performance than both the unimodal biometrics and the usual RBF based score-level fusion without using quality information.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.4 s.95
• /
• pp.380-388
• /
• 2005

This paper presents analysis results of the effects of RF filter characteristics on the system performance of impulse radio. The impulse radio system transmits modulated pulses having very short time duration and information can be extracted in receiver side based on cross-correlation between received and transmitted pulses. Accordingly, the pulse distortion due to in-band group delay variation can cause serious system performance degradation. In general, RF bandpass filters inevitably cause group delay difference to the signal passing through the filter which is proportional to its skirt characteristic due to its resonance phenomenon. For time as well as frequency domain analysis, small signal scattering parameter $S_{21}$ and its Fourier transform are used to characterize output pulse waveform under the condition that the input and output ports are matched. The output pulse waveform of the filter is predicted based on convolution integral between input pulse and filter transfer function, and resulting BER performances in the BPM and PPM based impulse radio system are calculated.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.12 no.1
• /
• pp.1-10
• /
• 2001

In this paper, a multistage parallel interference canceller (MPIC) and a partial multistage parallel interference canceller (PMPIC) are employed as a technique for improving the performance of the asynchronous DS-CDMA systems. The degree of the effect of the timing errors and phase errors on the interference cancellation capability of two types of cancellers is theoretically analyzed and the computer simulation is performed to confirm the analytical results. From the results, the large performance improvement is obtained by employing MPIC and PMPIC with perfect synchronization over the conventional matched filter, and the performance improvement obtained by MPIC and PMPIC is very close to each other as the number of the stage of MPIC and PMPIC increases. When the timing errors and phase errors are considered (in the case of imperfect synchronization), the performance improvement reduces as the performance degradation at the first stage (no cancellation) has a bad effect on the decision statistics at each stage. However MPIC and PMPIC have the strong interference cancellation capability in spite of imperfect synchronization as the number of the stage increases. An interference canceller, which has the strong interference cancellation capability as well as lower complexity for the implementation, is needed for practical systems with timing errors and phase errors because the perfect synchronization is impossible. Therefore, the excellent tradeoff between complexity and performance offered by PMPIC makes it an attractive approach for practical systems.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.13 no.5
• /
• pp.338-343
• /
• 2020

In this paper, it was shown that the decoding method of Hamming codes using soft values can be applied to molecular communication channels. A soft value criterion that can be used for decoding of Hamming codes for a molecular communication channel was proposed, and it has been shown through simulation that the decoding method using these values can improve reliability even in the molecular communication channel. A diffusion-based molecular communication channel was assumed, and information symbols were transmitted using BCSK modulation. After demodulating the number of molecules absorbed by the receiver at each symbol interval with an appropriate threshold, the number of molecules is no longer used. In this paper, the BER performance of the decoder was improved by utilizing information on the number of molecules that are no longer used as soft values in the decoding process. Simulation was performed to confirm the improvement in BER performance. When the number of molecules per bit is 600, the error rate of the Hamming code (15,11) was improved about 5.0×10^-3 to the error rate of the BCSK system without the Hamming code. It can be seen that the error rate of (15,11) Hamming code with the soft values was improved to the same extent. In the case of (7,4) Hamming code, the result is similar to that of (15,11) Hamming code. Therefore, it can be seen that the BER performance of the Hamming code can be greatly improved even in the molecular communication channel by using the difference between the number of molecules absorbed by the receiver and the threshold value as a soft value.

• Journal of KIISE:Information Networking
• /
• v.30 no.4
• /
• pp.535-544
• /
• 2003

Integrated services networks should guarantee end-to-end delay bounds for real-time applications to provide high quality services. A real-time scheduler is installed on all the output ports to provide such guaranteed service. However, scheduling algorithms studied so far have problems with either network utilization or scalability. Here, network utilization indicates how many real-time sessions can be admitted. In this paper, we propose service curve allocation schemes that result in both high network utilization and scalability in a service curve algorithm. In service curve algorithm, an adopted service curve allocation scheme determines both network utilization and scalability. Contrary to the common belief, we have proved that only a part of a service curve is used to compute deadlines, not the entire curve. From this fact, we propose service curve allocation schemes that result in a constant time for computing deadlines. We through a simulation study that our proposed schemes can achieve better network utilizations than Generalized processor Sharing (GPS) algorithms including the multirate algorithm. To our knowledge, the service curve algorithm adopting our schemes can achieve the widest network utilization among existing scheduling algorithms that have the same scalability.

• Journal of the Korean Institute of Gas
• /
• v.12 no.2
• /
• pp.38-41
• /
• 2008

In this research, we propose a new method for tracking the release rate using the concentration data obtained from the sensor. We used a sensor network that has already been set surrounding the area where hazardous gas releases can occur. From the real-time sensor data, we detected and analyzed releases of harmful materials and their concentrations. Based on the results, the release rate is estimated using the neural network. This model consists of 14 input variables (sensor data, material properties, process information, meteorological conditions) and one output (release rate). The dispersion model then performs the simulation of the expected dispersion consequence by combining the sensor data, GIS data and the diagnostic result of the source term. The result of this study will improve the safety-concerns of residents living next to storage facilities containing hazardous materials by providing the enhanced emergency response plan and monitoring system for toxic gas releases.

• Korean Journal of Applied Biomechanics
• /
• v.18 no.3
• /
• pp.83-92
• /
• 2008

Y. W. KIM, Y. J. KIM, Mechanical Properties of Unilateral & Bilateral Movements in Isokinetic Knee Extension and Flexion. Korean Journal of Sport Biomechanics, Vol. 18, No. 3, pp. 83-92, 2008. The purpose of this study was to examine the mechanical properties and patterns of bilateral and unilateral movement under varying velocities and movement patterns. The unilateral and bilateral isokinetic knee extension and flexion were taken for three speeds of 13 healthy male subjects. Although there was bilateral facilitation at the speed of $450^{\circ}$/s for the bilateral movement of knee extension, as a whole there was less resultant torque and power of bilateral movement than summed unilateral under knee flexion and extension of 3 velocity condition. There was significant correlations between bilateral deficits within individuals observed for an the same movement($120^{\circ}-240^{\circ}$ flexion, $120-240^{\circ}$ extension, $240^{\circ}-450^{\circ}$ extension), which means that same agonist was recruited. On the contrary, although there was a tendency of a similar pattern of the individuals bilateral deficit according to the varying velocities, there was not a significant correlations between bilateral deficits of flexion and extension within individual, which means that different agonist was recruited. With the analyses of this results the individuals neuromuscular characteristics and the effecting factors for bilateral movement can be speculated upon.