• Journal of the Korean Magnetics Society
• /
• v.23 no.2
• /
• pp.49-53
• /
• 2013

A current sensor is one of important component which is used for the electrical current measurement during charge and discharge of the battery, and monitoring system of the motor controller in the electric and hybrid vehicle. In this study, we have developed an open loop type current sensor using GaAs Hall sensor and magnetic core has an air gap. The Hall sensor detect magnetic field produced by the current to be measured. The 3 mm air gap core was made by HGO electrical steel sheets after slitting, winding, annealing, molding, and cutting. Developed current sensor shows 0.03 % linearity within DC current range from -400 A to +400 A. Operating temperature range was extended to the range of $-40{\sim}105^{\circ}C$ using temperature compensating electronic circuit. To Improve frequency bandwidth limit due to the air flux of PCB (Printed Circuit Board) and Hall sensor, We employed an air flux compensating loop near Hall sensor or on PCB. Frequency bandwidth of the sensor was 100 kHz when we applied sine wave current of $40A{\cdot}turn$ in the frequency range from 100 Hz to 100 kHz. For the dynamic response time measurement, 5 kHz square wave current of $40A{\cdot}turn$ was applied to the sensor. Response time was calculated time reach to 90 % of saturation value and smaller than $2{\mu}s$.

• The KIPS Transactions:PartB
• /
• v.15B no.6
• /
• pp.575-584
• /
• 2008

According to the network condition, the communication network overload could be occurred when media transmitting. Many researches are being carried out to lessen the network overload, such as the filtering, load distributing, frame dropping and many other methods. Among these methods, one of effective method is frame dropping that reduces specified video frames for bandwidth diminution. B frames are dropped and then I, P frames are dropped according to dependency among the frames in frame dropping. This paper proposes a scheme for protecting copyrights by encryption, when we apply frame dropping to reduce bandwidth of media following MPEG-4 file format. We designed two kinds of frame dropping: first one stores and then sends the dropped files and the other drops frames in real-time when transmitting. We designed three kinds of encryption methods in which DES algorithm is used to encrypt MPEG-4 data: macro block encryption in I-VOP, macro block and motion vector encryption in P-VOP, and macro block and motion vector encryption in I, P-VOP. Based on these three methods, we implemented a digital right management solution for MPEG-4 data streaming. We compared the results of dropping, encryption, decryption and quality of video sequences to select an optimal method, and there is no noticeable difference between the video sequences recovered after frame dropping and the ones recovered without frame dropping. The best performance in encryption and decryption of frames was obtained when we apply the macro block and motion vector encryption in I, P-VOP.

• The KIPS Transactions:PartA
• /
• v.15A no.4
• /
• pp.227-238
• /
• 2008

Recently, as network environment has broadened, the demands on VOD have been increased. The VOD services can be categorized into two types, RVOD and NVOD. Practical VOD services adopt one of them exclusively. Since a method using only one of RVOD and NVOD is not able to deal with frequently variable demand of clients, it leads to a result of overload on a server and a waste of server bandwidth. The efficiency of the network resource usage becomes lower. Hence this paper presents a study on the protocol for efficient VOD services. We propose a new protocol appliable for the existing VOD service algorithm, analyze its performance through simulation, and developed server/client systems applying the new protocol. We propose a mode switching protocol combined with protocols used in RVOD and NVOD. The proposed protocol is not able only to control both RVOD and NVOD but also to change the mode between RVOD and NVOD. As a result of using the proposed protocol to meet frequently variable demand, server bandwidth can be used efficiently. Especially, it can be applied to the existing VOD service algorithms. Therefore, we expect that the proposed protocol in this paper will be widely used in emerging VOD markets.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.5 s.347
• /
• pp.84-93
• /
• 2006

Ethernet-PON is an emerging access network technology that provides a low-cost method of deploying optical access lines between OLT and ONUs. It has a point-to-multipoint and multipoint-to-point architecture in downstream and upstream direction, respectively. Therefore, downstream packets are broadcast from an OLT toward all ONUs sithout collision. On the other hand, since alt ONUs share a common channel, the collision may be occurred for the upstream transmission. Therefore, earlier efforts on Ethernet-PON have been concentrated on an upstream MAC protocol to avoid collision. But it is needed to control downstream traffic in practical access network, where the network provider limits available bandwidth according to the number of users. In this paper, we propose a traffic control scheme for supporting the fairness of the downstream bandwidth. The objective of this algorithm is to guarantee the fairness of ONUs while maintaining good performance. In order to do this, we define the service probability that considers the past traffic information for downstream, the number of tokens and the relative size of negotiated bandwidth. We develop the simulation model for Ethernet-PON to evaluate the rate-limiting algorithm by using AWESIM. Some results are evaluated and analyzed in terms of defined fairness factor, delay and dropping rate under various scenario.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.10
• /
• pp.188-198
• /
• 2013

Maximally flat (MAXFLAT) half-band filters usually have wider transition band than other filters. This is due to the fact that the maximum possible number of zeros at $z={\pm}1$ is imposed, which leaves no degree of freedom, and thus no independent parameters for direct control of the frequency response. This paper describes a novel method for the design of FIR halfband filters with an explicit control of the transition-band width. The proposed method is based on a generalized Lagrange halfband polynomial (g-LHBP) with coefficients parametizing a 0-th coefficient $h_0$, and allows the frequency response of this filter type to be controllable by adjusting $h_0$. Then, $h_0$ is modeled as a steepness parameter of the transition band and this is accomplished through theoretically analyzing a polynomial recurrence relation of the g-LHBP. This method also provides explicit formulas for direct computation of design parameters related to choosing a desired filter characteristic (by trade-off between the transition-band sharpness and passband & stopband flatness). The examples are shown to provide a complete and accurate solution for the design of such filters with relatively sharper transition-band steepness than MAXFLAT half-band filters.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.9
• /
• pp.987-994
• /
• 2010

In this paper, a simple and effective active load-pull method is proposed, and the method to improve the efficiency of X-band power amplifier using harmonic control circuit is presented. The proposed active load-pull system mainly consists of directional coupler, phase shifter, short circuit, and power amplifier, and allows a user to access reflection coefficients near the edge of the Smith chart($\Gamma$=1) easily. The device used in this paper is Mitsubishi's GaAs FET MGF1801, and the operating frequency of the power amplifier is 9 GHz, The amplifier had output power of 21.65 dBm and drain efficiency of 24.9 % at class-A, and had output power of 21.46 dBm and drain efficiency of 53.3 % at class-AB. Harmonic control circuit is designed only second and third harmonic components because of the bandwidth limitation of the microwave components. The drain efficiency is improved as much as 6.4 % compared with class-AB power amplifier.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.28 no.10
• /
• pp.769-778
• /
• 2017

In this paper, a self-interference signal cancellation(SIC) circult for In-band Full-Duplex has been developed and tested in RF/analog region. By use of this SIC circuit, a FM two-way radio has been developed working at FRS(Family Radio Service) band. The two-way radio device is transmitting the FM modulated signal and demodulating the wanted FM signal at the same time. A circulator is used to enable a single antenna to transmit and receive simuultaenously. The receiver circuit needs to cancel out the self-interference signal due to the transmit signal. A vector modulator(VM) is used to control the phase and magnitude of the esitmated signal. And in-phase and quadrature correlators are used to figure out the optimal coefficients of the VM to remove the self-interference signal according to the change of channel environment. In this work, SA58646 has been used as the FM transceiver, and the system is tested with a frequency of 465 MHz and a bandwidth of 12.5 kHz FM signal. The output power is 17.2 dBm at the antenna port, and the self intererence signal level is measured -49.2 dBm at the receiver end. Therefore the SIC level is measured by 66.4 dB.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37C no.11
• /
• pp.1138-1147
• /
• 2012

In this paper, an efficient power control based MF-TDMA resource allocation scheme is proposed for next generation military satellite communication systems. The proposed scheme has the flexibility is used to support heterogeneous terminals with differ in transmission capabilities. The method can be divided into two parts : burst size calculation and burst structure determination. At first, we estimate the link budget taken into account a dynamic satellite link state variation. Then, applicable ACM level and burst size is chosen. In burst structure determination phase, we reorganize the burst structure in time-frequency domain by controlling limited power, bandwidth, time resources. In particular, we compensate the power spectral density among different terminals to integrate them in same transponder, Furthermore, we increase the packing efficiency by controlling the ACM level of the burst in applicable power spectral density range. Simulation results show that the method increase the spectral efficiency and burst packing efficiency. In addition, slot allocation rejection ratio is successfully reduced.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.9 s.339
• /
• pp.85-96
• /
• 2005

A ' Virtual Private Network (YPN) over Internet' has the benefits of being cost-effective and flexible. However, given the increasing demands for high bandwidth Internet and for reliable services in a 'VPN over Intemet,' an IP/GMPLS over DWDM backbone network is regarded as a very favorable approach for the future 'Optical VPN (OVPN)' due to the benefits of transparency and high data rate. Nevertheless, OVPN still has survivability issues such that a temporary fault can lose a large amount of data in seconds, moreover unauthorized physical attack can also be made on purpose to eavesdrop the network through physical components. Also, logical attacks can manipulate or stop the operation of GMPLS control messages and menace the network survivability of OVPN. Thus, network survivability in OVPN (i.e. fault/attack tolerant recovery mechanism considering physical structure and optical components, and secured transmission of GMPLS control messages) is rising as a critical issue. In this Paper, we propose a new path establishment scheme under shared risk link group (SRLG) constraint for physical network survivability. And we also suggest a new logical survivability management mechanism by extending resource reservation protocol-traffic engineering extension (RSVP-TE+) and link management protocol (LMP). Finally, according to the results of our simulation, the proposed algorithms are revealed more effective in the view point of survivability.

• The KIPS Transactions:PartC
• /
• v.15C no.4
• /
• pp.297-302
• /
• 2008

In case of display a lot of information from mobile devices, those systems are being developed that display the information from mobile devices on remote devices such as TV using the mobile devices as remote controllers because it is difficult to display a lot of information on mobile devices due to their limited bandwidth and small screen sizes. A lot of cost is required to design and develop interfaces for these systems corresponding to each of remote display devices. In this paper, a mobile environment based remote display system for displays at real times is proposed for continuous monitoring of status data for unique 'Mote IDs'. Also, remote data are collected and monitored through sensor network devices such as ZigbeX by applying status perception based remote displays at real times through processing ubiquitous computing environment data, and remote display applications at real times are implemented through PDA wireless mobiles. The system proposed in this paper consists of a PDA for remote display and control, mote embedded applications programming for data collections and radio frequency, server modules to analyze and process collected data and virtual prototyping for monitoring and controls by virtual machines. The result of the implementations indicates that this system not only provides a good mobility from a human oriented viewpoint and a good usability of accesses to information but also transmits data efficiently.