• Economic and Environmental Geology
• /
• v.49 no.4
• /
• pp.269-280
• /
• 2016

I presented three vector crustal magnetic anomaly components and six gradients by using spherical Slepian functions over the cap area of $20^{\circ}$ of radius centered on the South Pole. The Swarm mission, launched by European Space Agency(ESA) in November of 2013, was planned to put three satellites into the low-Earth orbits, two in parallel in East-West direction and one in cross-over of the higher altitude. This orbit configuration will make the gradient measurements possible in North-South direction, vertical direction, as well as E-W direction. The gravity satellites, such as GRACE and GOCE, have already implemented their gradient measurements for recovering the accurate gravity of the Earth and its temporal variation due to mass changes on the subsurface. However, the magnetic gradients have little been applied since Swarm launched. A localized magnetic modeling method is useful in taking an account for a region where data availability was limited or of interest was special. In particular, computation to get the localized solutions is much more efficient and it has an advantage of presenting high frequency anomaly features with numbers of solutions fewer than the global ones. Besides, these localized basis functions that were done by a linear transformation of the spherical harmonic functions, are orthogonal so that they can be used for power spectrum analysis by transforming the global spherical harmonic coefficients. I anticipate in scientific and technical progress in the localized modeling with the gradient measurements from Swarm and here will do discussion on the results of the localized solution to represent the three vector and six gradient anomalies over the Antarctic area from the synthetic data derived from a global solution of the spherical harmonics for the crustal magnetic anomalies of Swarm measurements.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2015.05a
• /
• pp.471-471
• /
• 2015

토양내의 수분흐름을 이해하는 것은 토양수분의 시공간적 분포변화와 유출기작을 규명하는데 매우 중요하다. 본 연구에서는 설마천유역의 작은 사면에서의 장력측정 시스템을 구축하여, 3차원의 흐름방향에 대해 잠재적 흐름구배를 평가하고자 하였다. 또한 흐름구배를 평가하기 위한 일반적 산술적 계산방법인 평균적 흐름구배와 측정시스템의 구조적 영향 및 흐름구배의 공간적 평가 기준을 고려한 계산방법론을 개발하여 비교 평하였다. 3차원의 흐름방향은 사면의 지표경사를 기준으로 x, y, z축을 기준으로 하여, 각 축 방향에 해당하는 흐름구배 값과 흐름방향을 각각 계산하였다. 그 결과, 강우사상에 따른 토양내의 장력변화는 매우 민감하게 변화하였으며, 이에 따른 각 흐름구배 값과 흐름방향의 반응이 빠르게 반응을 하였다. 특히, 습윤, 건조기간동안의 흐름구배의 발달 및 방향이 바뀌는 천이되는 상태인 흐름 굽힘 현상(flow Bending)을 확인하였다.

• Journal of Wetlands Research
• /
• v.20 no.1
• /
• pp.27-34
• /
• 2018

Reproductive phenology and physiological responses of Epilobium hirsutum L. to moisture content and nutrient content of soil were analysed in order to obtain basic data for effective conservation and restoration. Epilobium hirsutum L. is a perennial plant. But Epilobium hirsutum L. grew reproductively in all moisture and nutrient gradients. Flower bud, flowers and peduncle were respectively ripened in earlier under highest moisture condition and highest nutrient condition. And, number of flowers and peduncle were more quickly increased under highest moisture condition and highest nutrient condition. Chlorophyll content was high under highest moisture condition and higher middle moisture condition. However, we found no significant difference of chlorophyll content regard to nutrient gradients. There was no difference in minimum chlorophyll fluorescence among all moisture and nutrient gradients. The photochemical efficiency values of PS II were 0.75 in all moisture gradients, and it was 0.78 in highest nutrient gradient. The chlorophyll content of Epilobium hirsutum L. increased as the moisture content increased, and the Fv/Fm value increased as the organic matter increased. Our results showed that high moisture and nutrient content of soil advance their breeding season and promote reproductive growth. It might be important basic informations for the maintenance of population and the management of habitat of Epilobium hirsutum L. an endangered plant species.

• Journal of the Korean Geophysical Society
• /
• v.2 no.1
• /
• pp.57-64
• /
• 1999

To effectively identify near-surface faults with vertical slips from seismic refraction data, the GRM interpretation technique is tested and investigated in terms of various parameters through computer modeling. A characteristic change in shape of the velocity-analysis function near faults is noticed, and a new strategy of `Slope Variation Indicator (SVI)' is developed and tested in this study. The SVI is defined as a first horizontal derivative of the difference of velocity analysis functions for a large XY value and a small one, respectively. As the dip of refractor decreases and as the difference in XY value increases, the peak value of SVI increases and its duration decreases. Consequently, the SVI indicates accurately the location of buried fault in the test models. The SVI is believed to be an efficient tool in seismic refraction method to investigate location and distribution of shallowly buried faults.

• Proceedings of the Acoustical Society of Korea Conference
• /
• 1998.06c
• /
• pp.235-238
• /
• 1998

파이프의 양 끝단에 심한 온도구배가 형성될 때 음향이 발생한다는 사실은 이미 알려진 사실이다. 본 연구는 열구동식 열음향냉동기를 구현하기 위해서 1단계로 열원에 의한 음향발생을 달성하고자 했다. 이를 위해 1/4 파장의 열음향 발생장치를 설계 및 제작하여 실험에 사용하였다. 열음향 발생기는 직경 3cm, 길이 16cm의 공명관에 가열부, 박판집적체, 고온부 및 저온부의 열교환기로 구성되며 발생음의 기본주파수는 520Hz로 설계하였다. 고온부를 38$0^{\circ}C$로 가열한 결과 열음향발생기의 개구부로부터 1m 떨어진 곳에서 최초 음압측정값이 약 112dB, 음향출력으로 약 1와트에 해당하는 값을 얻었다. 박판집적체에 급격한 온도구배가 형성되면서 주변의 기체가 자발적인 진동을 하여 형성된 음향동력중 일부는 공명관 벽에 흡수되고 일부는 열교환기에서 점성에 의해 소산된다. 따라서 실제로 음향으로 변하는 부분은 이들을 감한 부분인데 실험결과 약 53%의 음향 생성효율을 달성했으며 이는 스위프트 등이 얻었던 결과보다 우수하다.

• International Journal of Highway Engineering
• /
• v.8 no.1 s.27
• /
• pp.25-32
• /
• 2006

Behavior of concrete pavement due to temperature gradient was investigated for 48 hours at test road using Falling Weight Deflectometer. The deflections at slab center changed similarly to those of ambient temperature and temperature gradients in the slab. And rapid variations in the deflections were observed between 8 to 12 in the morning. However, dynamic modulus of subgrade reaction and joint deflections showed reverse trends to the ambient temperature and temperature gradients. The dynamic modulus of subgrade reaction was significantly affected by temperature gradient when its value got higher. Backcalculated elastic moduli were obtained using AREA method and Method of Equivalent Thickness. The trends of the backcalculated elastic modulus were similar to those of dynamic modulus of subgrade reaction. Measured load transfer efficiencies showed maximum peak in the morning due to dowel locking. However, additional effort is necessary to verify the result.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.18 no.1
• /
• pp.47-53
• /
• 1982

An analysis of convection, in a fully developed laminar steady flow through the vertical square duct under the condition of variational symmetric heat flux, is considered. Finite element solution algorithm by Galerkin's method with triangular elements and linear interpolation polynominals for the temperature and velocity profiles are derived for the vertical square duct. The comparison of temperature distribution due to variational symmetric heat flux in the duct were made with available the other data when the condition of peripheral heat flux were uniform and zero. Numerical values for the dimensionless temperatures and Nusselt numbers at selected Rayleigh numbers and pressure gradient parameters were obtained at a few nodal points for the vertical square ducts and effects of corner in the duct were investigated.

• International Journal of Highway Engineering
• /
• v.10 no.2
• /
• pp.145-157
• /
• 2008

Load transfer efficiency (LTE) reflects the structural performance of doweled and undoweled joints of Jointed Concrete Pavement (JCP). A 3-dimensional (3-D) model of JCP was built using ABAQUS software in this study. Three concrete slabs were placed on bonded sublayers composed of a base and subgrade. Spring elements were used to connect the adjacent slabs at joints. Different spring constants were input to the model to simulate different joint stiffness of the concrete pavement. The LTE of the joint increased with an increase of the spring constant. The effects of material properties and geometric shape on the behavior of JCP were analyzed using different elastic modulus and thickness of the slab and base in the modeling. The results showed the elastic modulus of the subgrade affected the behavior of the slab and LTE more than that of the base and the thickness of the slab and base. The effects of a negative temperature gradient on the behavior of the slab and LTE were more than that of positive and zero temperature gradients. Joints with low stiffness were more sensitive to the temperature gradient of the slab.

• Membrane Journal
• /
• v.12 no.2
• /
• pp.90-96
• /
• 2002

A novel methodology on the calculations of osmotic pressure and gradient diffusion coefficient has been provided ill the present study, by applying a succinct numerical analysis on the experimental results. Although both the osmotic pressure and the gradient diffusion coefficient represent a fundamental characteristic in related membrane filtrations such as microfiltration and ultrafiltration, neither theoretical analysis nor experiments can readily determine them. The osmotic pressure of colloidal suspension has been successfully determined from a relationship between the data of the time-dependent permeate flux, their numerical accumulations, and their numerical derivatives. It is obvious that the osmotic pressure is gradually increased, as the particle concentration increases. The thermodynamic coefficient was calculated from the numerical differentiation of the correlation equation of osmotic pressure, and the hydrodynamic coefficient was evaluated from the previously developed relation for an ordered system. Finally, the estimated gradient diffusion coefficient, which entirely depends on the particle concentration, was compared to the previous results obtained from the statistical mechanical simulations.

• The Korean Journal of Food And Nutrition
• /
• v.4 no.2
• /
• pp.155-160
• /
• 1991

Authrobacter sp. L-3이 생성하는 glucose isomerase를 DEAE-cellulose column chromatography법으로 2단계 NaCl농도 구배로 용출함으로서 순수분리하였다. 이것이 SDS-acrylamide gel electrophoresis상에서 단일띠를 보임으로서 매우 잘 분리되었음을 알 수 있었다. Glucose isomerase의 Km값과 Vmax값이 각각 0.175M, 0.29로 얻어졌다. 한편, SDS-acrylamide gel electrophoresis와 Sephadex-G10050에 의한 gel filtration으로부터 분자량이 각각 42,000과 180,000으로 얻어져, 이 효소는 분자량이 42,500인 4개의 subunit로 구성되었음을 알 수 있었다.