• Korean Journal of Optics and Photonics
• /
• v.26 no.5
• /
• pp.269-274
• /
• 2015

In this paper we design the optical system for an integrated two-channel TO-type optical transmitter to apply the HDMI interface using the code V simulator. The proposed integrated two-channel optical transmitter has two VCSELs attached in parallel on an 8-pin TO-CAN package, on top of which is a lens filter block ($1mm{\times}2mm{\times}4mm$) composed of hemispherical lenses and WDM filters. Considering two-channel transmitters manufactured with wavelength combinations of 1060nm/1270nm and 1330nm/1550nm, we obtain the optimum value of the diameter of the hemispherical lens as 0.6 mm for both combinations, and the distances L between the lens filter block and ball lens as 1.7 mm and 2.0 mm for the 1060nm/1270nm and 1330nm/1550nm wavelength combinations, respectively. At this time, the focal length f0 of the lens filter blocks for wavelengths of 1060, 1270, 1330, and 1550 nm are 0.351, 0.354, 0.355, and 0.359 mm, respectively, and the focal lengths F of light passing through the lens filter block and ball lens are 0.62 mm for 1060nm/1270nm and 0.60-0.66 mm for 1330nm/1550nm wavelength combinations.

• Journal of Korea Multimedia Society
• /
• v.14 no.6
• /
• pp.752-758
• /
• 2011

In this paper, we perform a research on a message delivery link based on visible light communication using illumination light-emitting diodes (LEDs) for car-to-car communications and the link transmission success probability is analyzed for the link. The message delivery system is modeled and the signal-to-noise ratio is calculated from the received optical power. Then, the link transmission probability is estimated from the calculated bit error rates (BERs). The message delivery system has optical links from an LED transmitter near the rear lamp of a car ahead to a receiver near the headlamp of a car behind, whose positions are assumed to follow the normal Gaussian distribution. The link transmission success probability is calculated considering the physical characteristics of the optical link. The car positions are generated according to the normal distribution and the bit error rates are calculated for all links. The link transmission success probability is defined. For the unoptimized optical car-to-car message delivery links, it is shown that the link transmission success probability is larger than 0.9 with the transmitted optical power of 400 mW and the semi-angle at half power of 30 degree.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.44 no.11
• /
• pp.36-42
• /
• 2007

In this paper, we have studied temperature compensation architecture for a bust mode optical transmitter to convert the electric burst mode date signal to a optical one through the laser diode. In order to get stable high speed data transmission, we used digital sampling technique with a microprocessor for the temperature compensation of the laser diode, not the previous real time analog technique. Though the digital automatic power control circuit should be complemented the previous analog one with accuracy and effectiveness. So the digital technique will be more effective in further future in development for the over Gb/s transmitting speed.

• Proceedings of the IEEK Conference
• /
• 1999.11a
• /
• pp.909-912
• /
• 1999

This paper describes realized APC and pre-equalizer circuit, and their operation principle and test results. In analog optical transmitter, constant lasing power control, free of signal clipping and linearity are important considerations. We examined pre-equalizer and APC(Automatic Power Control) circuit to improve the analog optical transmitter performance.

• Proceedings of the IEEK Conference
• /
• 1999.11a
• /
• pp.301-304
• /
• 1999

밀리미터파 대역의 아날로그 광전송을 위한 진행파형 (travel ing wave, TW) 전계흡수 광변조기 (electroabsorption modulator, EAM)와 광수신기의 설계에 대해 발표하고자 한다. TW EAM 및 TW 광수신기의 일반적인 형태인 ridge-type의 co-planar waveguide (CPW)구조에서의 마이크로파의 전송특성을 3차원 FDTD로 분석하여 광파와 전파의 속도 정합 등을 이루는 최적화 구조를 설계하였다. TW EAM의 경우 광세기 변조의 비선형 응답특성에 있어서 마이크로파 손실과 소자길이가 RF 신호의 혼변조 왜곡 (intermodulation distortion)과 SFDR (spurious free dynamic range)성능에 미치는 영향도 이론적으로 조사하였다. TW PIN 광수신기의 경우 광파와 마이크로파의 속도정합의 영향과 이전에는 고려되지 않았던 photo-generated 전송자의 진성 영역에서의 transit time이 광수신기의 밴드 폭에 미치는 영향을 분석하여 최적화 설계하였다.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.21 no.3
• /
• pp.795-806
• /
• 1996

A structure which transmits and receives 3 subscribers packet data through an optical splitter node in an optical subscriber network of PON wave suggested and realized. All the functions which are necessary to use PON structure such as 155.52Mb/s multiplexer/demultiplexer of down-stream signal, 25.92Mb/s multiplexer/demultiplexer of up-stream signal, frame synchronizer, and phase aligner for aligning phase of the clock and received data have been integrated within 2 ICs using CMOS technonology. TDMAtechnology was suggested for up-stream transmission. In the optical up-stream transmission of the urst signals transmissionquality degradataion by APC and AGC of optical tranceiver was observed. By compensating the degradation, more than 17dB of link budget which is enough to satisfy 11.2dBthat is required in SWAN of PON architecture has been obtained with optical transceiver whose power and sensitivity are -17dBm and -34dBm respectively.

• 한국정보통신설비학회:학술대회논문집
• /
• 2004.08a
• /
• pp.46-49
• /
• 2004

레이저 다이오드 (LD)의 광 직접 변조시 광자와 전자의 동역학에 의하여 입출력 관계가 결정된다. 이는 LD의 직접 변조 시 대역폭을 제한하는 요소로 작용한다. 높은 대역폭을 가지는 광송신기 설계를 위하여 LD의 등가회로 분석은 필수적이다. LD의 등가회로는 E/O response를 이용하여 소신호 분석을 통해 얻을 수 있으며, E/O response는 rate equation을 이용하여, 구할 수 있다. LD의 등가회로는 직렬 저항값, 기생 커패시턴스, 외부 회로와의 연결을 위한 와이어에 기인하는 인덕턴스 성분 등으로 구성된다. 본 논문에서는, rate equation을 사용하여 계산된 결과를 이용하여, LD의 등가회로를 도출하였다.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.9 no.6
• /
• pp.1346-1355
• /
• 2005

Recently, the development of passive optical networks (PON) for FTTH (Fiber-To-The-Home) have been actively conducted. In PON, a burst-mode transceiver is one of key modules. In this paper, we have made the protype module of a 155.52 Mpbs optical burst-mode transceiver with commercially available chips and then have measured the performance. Also, a new method of burst-mode clock recovery have been proposed. The burst-mode clock recovery implemented by using CPLD(Complex Programmable Logic Device) has coupled with the above burst-mode transceiver and has been tasted.

• Journal of Korea Society of Industrial Information Systems
• /
• v.11 no.3
• /
• pp.82-89
• /
• 2006

Optical transmission system related to network infra of ubiquitous is a essential bridge technique between metro network and access point. So, it is need to develop this technique. In this paper, we develop 1Gbps SNMP optical transmitter/receiver system based on 1 core ring-type WDM PON. The developed system can reduce number of optic fiber and doesn't need extra transmitter/receiver. Also, this system can extend nodes owing to many node per wavelength, acts rapidly against security cutting, and acts independent of protocols.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.32A no.11
• /
• pp.86-93
• /
• 1995

An optical transmitter was designed and implemented using a commercially available LiNbO$_{3}$ Mach-Zehnder modulator and the power amplifiers. We have adopted a new method to stabilize the bias voltage of the modulator using the second order harmonic component of the dithering signal. This technique has been applied successfully to the 2.5 Gbit/s external modulator for more than 6 hours without bit error rate degradaton. We demonstrated a repeaterless transmission of a 2.5 Gbit/s signal over 150 km nondispersion-shifted fiber using the transmitter. The receiver sensitivity was -34.5 dBm at 10$_{-10}$ bit error rate. No appreciable BER degradation due to fiber dispersion were observed after transmission.