• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.24 no.6B
• /
• pp.1015-1023
• /
• 1999

We propose nonlinear processing schemes for robust acquisition of direct-sequence spread spectrum (DS/SS) signals in wideband pulse jamming. To mitigate the interference effect due to impulse-like wideband jamming signals, the received signal is preprocessed by using the median filter, a simple order statistic filter Since only parts of the PN sequence are used for rapid acquisition, it is indispensable for analytic design of an acquisition scheme to have an appropriate model of the partial PN signal. The partial correlation of the median filtered PN signal is approximated by a two-piecewise linear model using an approximate upper bound. The acquisition performance of the proposed schemes is compared to that of other schemes. Finally, the analytic design is verified by computer simulation.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.3 no.2
• /
• pp.305-311
• /
• 1999

In this paper, it is designed a new type single layer patch antenna which is printed on a very thin film and separated from the ground-plane by foam with a low permitivity of 1.06 and a high thickness of around quarter wavelength. It allows the use of three-dimensional transition, from one level to another, so that its bandwidth can be enhanced by wideband impedance matching. The radiation pattern, return loss, and VSWR of the antenna are calculated using "IE3D" simulation package, and compared with the experimental results. Experimental results show that the bandwidth is about 65% of center frequency 6.8 GHz, return loss and VSWR are in a fairly good agreement with the calculations.culations.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.14 no.5
• /
• pp.549-560
• /
• 1989

In this paper, the method of determining the initial weighting vlaues fuctioning as a filter under the Directional Constrained Minimization of Power(DCMP) algorithm is presented. By analyzing the sideband beamformer with the Finite Impulse Response (FIR) filter concepts, the constraints of any desired directions are obtained and the initial weighing values with fast adaptation time are formulated from those constraints. By applying this proposed initial weighting values to the DCMP and the spatial averaging processor, the interference of a desired direction and the coherent noises are eliminated at the same time. The improvement of this method compared with the existing algorithm is confirmed by computer simulation.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.6A
• /
• pp.677-682
• /
• 2004

In this paper, A novel spatial power combiner with wideband printed dipole antennas and balanced amplifier is proposed. The wideband spatial power combiner is proposed to improve power capability and bandwidth by using balanced amplifier and wideband printed dipole antenna, respectively, The proposed 4${\times}$1 spatial power combiner with those components has the characteristics that the 3-dB bandwidth is 1.02 GHz (17 ％), and the effective isotropic power gain (EIPG) is 24.04 dB at 6 GHz. Also, power combining efficiency is 68.69％.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.6A
• /
• pp.833-838
• /
• 2000

In this paper, a novel type of wideband single-patch microstrip antenna using the reactive-loading technique is presented. We demonstrated that, by inserting stubs at both of the radiating edges, the frequencies of the two resonant modes are closely spaced to form a wide operating bandwidth. Segmentation technique and cavity model are used to analyze the antenna characteristics and experimental data are show to be in good agreement with the calculated results. With the proposed structure, the measured antenna bandwidth of 230MHz is obtained, which is almost 2.65 times larger than that of an unloaded rectangular patch antenna and fully covers the whole frequency range of 1.885GHz~2.025GHz allocated to IMT-2000.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.19 no.9
• /
• pp.1710-1718
• /
• 1994

In this paper, a broadband tunable YIG(Yittrium Iron Garnet) oscillator is designed and fabricated. To design an YTO(YIG Tuned Oscillator), a suitable YIG resonator is selected according to the design oscillation range and its equivalent R, L, C resonant circuit parameters are obtained through the measurement of its resonance characteristic. Using the equivalent circuit, the wideband topology which suppresses the parasitic oscillation is selected and implemented. The designed circuit is simulated by HBT(Harmoic Balance Technique) using EEsof's jOMEGA. The YTO thus fabricated has the wide oscillation range from 1.4 GHz to 4 GHz, and its linearity is 0.5% in the oscillation range. The phase noise is below 105dBc at 100kHz offset.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.7A
• /
• pp.852-857
• /
• 2004

In this research, we suggested a new PBG cell with wide stopband. In order to improve the characteristics of the insertion loss, return loss, and ripple, we used two overlapped cells. One is small cell which is made in inside and the other is large cell which is made in outside. The inner cell stops the high band and the outer cell stops the low band. As a result, the new PBG cell had a wide stop band. Insertion loss was about 40dB in stopband and the ripple, and the return loss was improved. Also, the passband is broaden by employing new PBG cells.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.10 no.3
• /
• pp.83-89
• /
• 2010

This paper presents the impacts of Ultra Wide-Band(UWB) sensor using frequency of 4.5 GHz on Broadband Wireless communication system which uses frequency of 4.5 GHz. The Minimum Coupling Loss (MCL) method and Spectrum Engineering Advanced Monte Carlo Analysis Tool (SEAMCAT) is used to evaluate the interference effects of UWB sensor on Broadband Wireless communication system, respectively. The minimum protection distance between single UWB sensor and mobile station of Broadband Wireless communication system should be more than 1.2 m to guarantee the co-existence. In case of multiple UWB sensors, UWB transmitting PSD of around -68.5 dBm/MHz below should be required to guarantee interference probability of 5% below for mobile station of Broadband Wireless communication system.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.7 no.6
• /
• pp.1287-1292
• /
• 2012

In this paper, a dual polarization patch antenna operates at the wide bandwidth of 1.525GHz~1.665GHz was designed and fabricated. To obtain the wide bandwidth and high gain, increased height of air floor from GND was applied, and to get wide band axial ratio and high gain, parasitic patch was applied. The simulation and measurement showed good agreements, the VSWR was less than 1.9 at the frequency bandwidth, the return loss was less than -10dB, and the LHCP(Left Hand Circular Polarization) and RHCP(Right Hand Circular Polarization) isolation was less than -13dB at the frequency bandwidth.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2015.10a
• /
• pp.65-67
• /
• 2015

In this paper, small WLAN antenna was designed and investigated. Proposed antenna was configured for microstrip patch antenna ($29mm{\times}29mm$) that was mounted on RF4 dielectric substrate (relative permittivity 4.4, thick 1.6mm, tangent loss 0.025) with $45mm{\times}45mm$. In order to obtain a wide band characteristic, the cutting process was 3.2mm diagonal corners of the patch antenna located on the top of the substrate. Antenna feeding position for 50 ohm impedance matching was decided to be 5.1mm at the central axis in the horizontal direction. As a result, frequency bandwidth satisfying the condition of VSWR<2dB was 2.365-2.45GHz (85MHz, 3.53%) for considering WLAN.