• Land and Housing Review
• /
• v.5 no.1
• /
• pp.35-40
• /
• 2014

Site coefficient and amplification factor of current domestic Seismic Design Code (KBC-2009) have no consideration for the domestic ground condition in which the base rock is normally placed within 30m form the surface. Accordingly, in this study dynamic centrifugal test and analysis for pile foundation into sand and upper structure were achieved. and the response spectrums of free surface and basement were compared with each other. Within the period 1 sec., the measured spectral acceleration of free surface and basement was bigger than the design spectral acceleration of SC and SD site. However the measured spectral acceleration of free surface and basement for the period over 1.5 sec. was smaller than the design spectral acceleration of SC site. There was no severe difference of spectral acceleration according to the upper structure, embedded depth of foundation and free surface conditions. Consequently, normal domestic apartment housing for the period range over 1.5sec. could be design more economically applying these test result.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.8 no.3
• /
• pp.33-42
• /
• 2004

While transforming the inelastic system into the equivalent elastic one gives an advantage of simpler analysis, the actual inelastic behavior of the system is hardly modeled in the capacity spectrum method (CSM). Therefore, the accuracy of CSM depends on the precise estimation of equivalent period and damping ratio as well as the modification of the elastic response spectrum and the corresponding demand spectrum. In this paper, the effect of demand spectrums on the accuracy of CSM is evaluated. First, the response reduction factors provided in ATC-40 and Euro Code are evaluated. Numerical analysis results indicated that the acceleration responses obtained using the factor of Euro Code are closer to the actual response than those obtained using the factors of ATC-40. Next, the accuracy of CSM is evaluated constructing the demand spectrum using the absolute acceleration responses and pseudo acceleration responses. The results obtained using the absolute acceleration responses were found to be generally larger than those obtained using the pseudo ones. Since CSM often underestimates the response, the use of absolute acceleration response gives the response relatively closer to the exact ones. However, the difference becomes negligible as the hardening ratio and the yield strength ratio become larger.

• Land and Housing Review
• /
• v.5 no.2
• /
• pp.115-120
• /
• 2014

Site coefficient and amplification factor of current domestic Seismic Design Code (KBC-2009) have no consideration for the domestic ground condition in which the base rock is normally placed within 30m form the surface. Accordingly, in this study dynamic centrifugal test and analysis for pile foundation into clay were achieved. and the response spectrums of free surface and basement were compared with each other. Within the period 1sec., the measured spectral acceleration of free surface and basement was bigger than the design spectral acceleration of SC and SD site. However the measured spectral acceleration of free surface and basement for the period over 1.5sec. was smaller than the design spectral acceleration of SC site. There was no severe difference of spectral acceleration according to the upper structure, embedded depth of foundation and free surface conditions. Consequently, normal domestic apartment housing for the period range over 1.5sec. could be design more economically applying these test result.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.4 no.1
• /
• pp.63-76
• /
• 2000

구조물-지반 상호작용에서 알려진 것처럼 구조물 지진응답은 구조물하부 지반조거에 따라 영향을 받는데 UBC-97을 포함한 여러내진설계규준에서 지반사태 영향을 반영하고 있다 이 연구에서는 기초크기 기초밑 지반깊이, 입력지진 작용점 및 기초 근입깊이 등의 영향을 살펴보고 깊은 지반 위에 세워진 구조물의 평균응답스펙트럼을 UBC-97 탄성응답스펙트럼과 비교하기 위해 구조물-지반 상호작용을 고려한 지진해석을 가상 3차원 유한요소법과 부구조물법을 이용하여 1952년 Taft와 1940년 El Centro 지진기록을 주파수영역에서 수행하였다 연구결과에 의하면 기초크기는 구조물 응답에 별 영향이 없고 기초저면 지반깊이는 구조물체계의 고유주기와 최대가속도를 변경시켰다 또 입력지진의 합리적 작용점은 기초저면이라는 것이 확인되었으며 깊은 지반위에 놓인 기초의 근입은 저주기영역에서 구조물 응답을 상당히 줄어들게 하였다 한편 30m 깊은 지반위에 세워진 구조물의 평균가속도와 UBC-97 가속도를 비교한 결과 UBC-97 탄성응답스펙트럼에 의한 구조물 내진설계가 안전하지 못할 수도 있으므로 UBC-97 지진계수의 할증이 필요하다.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.35 no.3
• /
• pp.289-297
• /
• 2011

The explicit finite element method is an essential tool for solving large problems with severe nonlinear characteristics, but its results can be difficult to interpret. In particular, it can be impossible to evaluate its acceleration responses because of severe discontinuity, extreme noise or aliasing. We suggest a new post-processing method for transient responses and their response spectra. We propose smoothing methods using a Gaussian kernel without in depth knowledge of the complex frequency characteristics; such methods are successfully used in the filtering of digital signals. This smoothing can be done by measuring the velocity results and monitoring the response spectra. Gaussian kernel smoothing gives a better smoothness and representation of the peak values than other approaches do. The floor response spectra can be derived using smoothed accelerations for the design.

• Journal of the Korean Geotechnical Society
• /
• v.36 no.6
• /
• pp.17-34
• /
• 2020

In response spectrum analysis of pile-supported structure, an amplified seismic wave should be used as the input ground acceleration through the site-response analysis. However, each design standard uses different input ground acceleration criteria, which leads to confusion in determining the appropriate input ground acceleration. In this study, the ground accelerations were calculated through dynamic centrifuge model test, and the response spectrum analysis was performed using the calculated ground acceleration. Then, the moments derived from the test and analysis were compared, and a method for determining the appropriate input ground acceleration in response spectrum analysis was presented. Comparison of the experimental and simulated results reveals that modeling of the ground using elastic springs allows proper simulation of the natural period of the structure, and the use of a seismic wave that is amplified at the ground surface as the input ground acceleration provided the most accurate results for the response analysis of pile-supported structures in sands.

• Journal of the Korean earth science society
• /
• v.28 no.2
• /
• pp.179-186
• /
• 2007

The response spectrum is one of the important basic materials for the aseismic design. Numerous strong ground motions based on the seismic source characteristics for the earthquakes occurring in the Korean Peninsula were simulated to obtain the response spectra by using the computer program, SMSIM, developed by Boore (2005). Through the extensive review of other study outcomes, the input data for the simulation such as seismic source and attenuation characteristics were selected. The spectra obtained from the simulated ground motions were normalized to 1.0 g of zero period acceleration and compared with the standard response spectrum proposed by the U.S. Atomic Energy Commission (AEC, 1973). In this study, we found that the spectral values for the response spectra appeared to be larger than those of the standard spectrum in the frequency band above roughly 10 Hz. The variation of resulting response spectra was evaluated with the variable stress drops. It was shown that the spectral amplitude of the spectrum for the larger stress drop denotes higher value in the low frequency range.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.3 no.1
• /
• pp.21-28
• /
• 1999

The objective of the study is to develop attenuation equations of the ground motions in the southern part of the Korean peninsula. The earthquake source characteristics and the medium properties were estimated from available instrumental earthquake records and used as input parameters. The peak ground accelerations(PGA) and pseudo-velocity response spectra(PSV) were simulated by the random vibration theory. The attenuation equations for the PGA and PSV were constructed in terms of local magnitudes and hypocentral distances.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.44 no.4
• /
• pp.503-512
• /
• 2024

In the seismic design standard, input waves for different levels of seismic performance are proposed in the form of design response spectra. At the time of establishing these standards, measured records of significant earthquakes that occurred domestically, such as the 2016 Gyeongju earthquake and the 2017 Pohang earthquake, were not included. Additionally, for the ground response analysis, shear wave velocities representing ground amplification characteristics were derived from the results of standard penetration tests (N-values) and applied in empirical formulas. This approach may not adequately capture sufficient information about the characteristics of domestic ground properties. Therefore, in this study, seismic records from the Gyeongju and Pohang earthquakes were modified to adjust the bedrock standard design response spectra. Ground response analyses were conducted using shear wave velocity profiles obtained from borehole tests in the Sejong City area. The shape of the response spectrum and ground amplification coefficient obtained from the ground response analysis were then compared with those from existing studies and seismic design standard.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.10 no.2 s.48
• /
• pp.63-71
• /
• 2006

In the companion paper (II, Development of Site Classification System), new size classification system based on site periods $(T_G)$ was recommended for legions of shallow bedrock depth in Korea. Despite the site classification method was improved, the response spectrum would be required to be modified by adjusting the integration interval to calculate the site coefficients because the response spectra did not match well the average spectral accelerations obtained by site response analyses in the range of long periods. In this paper, new response spectra for each site categories were determined by adjusting the integration interval of long period site coefficient $F_v\;from\;0.4{\sim}2.0\;to\;0.4{\sim}1.5$ second. It matched well the average spectral accelerations and new response spectrum, and it was also improved compared to the current she classification system.