• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.9C
• /
• pp.1316-1322
• /
• 2004

Recently, the UWB (ultra wide-band) wireless communication technology, which provides high data transmission and is capable of linearly trading between throughput and signal-to-noise ratio (SNR), has drawn much attention for short-range wireless networks. Fully exploiting its notable features and minimizing its interference to coexisting other systems require the knowledge of SNR's at receivers In this paper, we propose an algorithm for estimating the pulse energy to noise ratio Ep/No of UWB signal with utilization of outputs from a correlator at a receiver, and evaluate the performance of the proposed algorithm through computer simulation. According to simulation results, the maximum standard deviation is about 1 13 dB with a block size of 500. Except for Ep/No=O and 2 dB cases with a block size of 500, no errors greater than 3 dB were observed in all the remaining experiments. Generally speaking, it improves as the true Ep/No, increases and as the block size increases A notable feature of the proposed algorithm is that it does not reduce the effective throughput because the estimation process does not require sending additional training signal of any specific format.

• Steel and Composite Structures
• /
• v.46 no.3
• /
• pp.403-416
• /
• 2023

This paper summarised and re-examined the theoretical basis of the commonly used design rule developed by Cochrane in the 1920s to consider staggered bolt holes in tension members, i.e., the s²/4g rule. The rule was derived assuming that the term two times the bolt hole diameter (2d₀) in Cochrane's original equation could be neglected, and assuming a value of 0.5 for the fractional deduction of a staggered hole in assessing the net section area. Although the s²/4g rule generally provides good predictions of the staggered net section area, the above-mentioned assumptions used in developing the rule are doubtful, in particular for a connection with a small gauge-to-bolt-hole diameter (g/d₀) ratio. It was found that the omission of 2d₀ in Cochrane's original equation appreciably overestimates the net section area of a staggered bolted connection with a small g/d₀ ratio. However, the assumed value of 0.5 for the fractional deduction of a staggered hole underestimates the staggered net section area for small g/d₀ ratios. To improve the applicability of the above two assumptions, a modified design equation, which covers a full range of g/d₀ ratio, was proposed to accurately predict the staggered net section area and was validated by the existing test data from the literature and numerical data derived from this study. Finally, a reliability analysis of the test and numerical data was conducted, and the results showed that the reliability of the modified design equation for evaluating the net section resistance of staggered bolted connections can be achieved with the partial factor of 1.25.

• Journal of Bio-Environment Control
• /
• v.12 no.4
• /
• pp.240-244
• /
• 2003

The purpose of this study was to investigate a proper $Ca^{2+}\;:\;K^+$ ratio in nutrient solution to produce marjoram and oregano by hydroponics. Two herbs were grown for 40 days with the $Ca^{2+}\;:\;K^+$ ratio of 3.5;13, 4.5:11(standard herb's nutrient solution), 5.5:9 and 6.5:7mM${\cdot}L^{-1}$ of herb's nutrient solution developed by European Vegetable R &D Center, Belgium. The ratio of 5.5:9, and 6.5:7 mM${\cdot}L^{-1}$ showed better results in growth of marjoram than other treatments. Vitamin C contents and amounts of esential oil were the highest in the ratio of 5.5:9 and 6.5:7, respectively. Inoregano, the growth and vitamin C contents were the highest in the ratio of 5.5:9 and 6.5:7 mM${\cdot}L^{-1}$, respectively. The content (%) and amount (mg/plant) of essential oil were the highest in the ratio of 6.5:7mM${\cdot}L^{-1}$. These results indicated that 5.5:9 and 6.5:7 mM${\cdot}L^{-1}$were proper $Ca^{2+}\;:\;K^+$ ratio of nutrient solution of marjoram and oregano, respectively, by hydropoinics.

• Food Science and Preservation
• /
• v.21 no.3
• /
• pp.388-395
• /
• 2014

Six types of mixed cereals powder were prepared using different mixing ratios of barley, proso millet, sorghum, and adlay, and their nutritional components and functionalities were analyzed. The mixed cereals powders contained high levels of crude protein. The free amino acid and mineral contents of Sample E were the highest among all the samples. Fructose, glucose, sucrose, and maltose were detected as the four major free sugars in all the mixed cereals powders, and Sample D had the highest amount of reducing sugar among all the samples. The total polyphenol and total flavonoid contents of Sample F were significantly higher than those of the other samples. Sample C showed the highest level of DPPH radical scavenging activity and reducing power. As for the ABTS radical scavenging activity, the $IC_{50}$ of Sample D was the lowest among all the samples, but did not significantly differ from that of Sample C. Therefore, we suggest 2:2:1:1 (in Sample D) as the best mixing ratio of barley, proso millet, sorghum, and adlay to produce a mixed cereals powder with excellent nutritional value and antioxidant activities.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.16 no.2
• /
• pp.1-7
• /
• 1988

Predicting treeform should be very important, eventhough it is difficult, step for landscape designers. This study was carried out to develop a method to classify the treeforms of landscape plants by numerical data. Twenty five treeforms are selected to be compared with 41 Zelkova serrata MAKINO, 26 Pinus strobus L., and 44 Magnolia denudata DESROUX. Statistical judgement was made by using X$^2$-Test. The results are summerized as follows. 1. Zelkova serrata was classified as B3 or C3. This species showed a tendency of changing from A type to B or C type, and the CL/CH ratio(canopy length/canopy height) is thought to be increased as aged. 2. pinus strobus was classified as D4-D5 and the CL/CH ratio tends to be increased as aged. 3. Magnolia denudata was classified as D4 and the change by aging was not observed clearly.

• 한국해양학회지
• /
• v.24 no.1
• /
• pp.52-61
• /
• 1989

The daily net primary production by phytoplankton and ammonium excretion by macrozooplankton (> $350{\mu}m$) were measured to understand the nitrogenous nutrient dynamics in the southern part of the East Sea of Korea. At most of the staions, water columns were well stratified and strongly developed pycnoclines and matching nutriclines could be found near the 20-60m. Total chlorophyll ranged between $1.22-3.24{\mu}g$ ChI/l and nano-fractions of chlorophyll ranged from 43.2 to 99.6% in the surface layer. The daily net primary production by phytoplankton ranged from 0.75 to 2.04 gC/$m^2$/d and averaged to be 1.5 gC/$m^2$/d. 1t is evidenced that the primary production and chlorophyll content are relatively high in frontal waters where the North Korean Cold Water meets with the East Korean Warm Water. The turnover time of nitrate in the euphotic zone ranged from 0.2 day to 1.6 day and averaged to be 0.8 day. The N:P ratio of the study area shows on the average 13.4 which indicates nitrogenous nutrient to be the limiting factor for phytoplankton growth. Ammonium excretion by macrowoplankton averaged out to 1.3mg at-N/$m^2$/d, and contributed 7.3% of daily total nitrogen requirement by phytoplankton in this area. Calculation of upward flux of nitrate to the surface mixed layer from the lower layer approximates 7% of nitrogen requirement by phytoplankton.

• Animal cells and systems
• /
• v.6 no.1
• /
• pp.19-22
• /
• 2002

Life table studies were conducted in the laboratory for the eulophid gregarious pupal parasitoid, Tetrastichus sp., on Hyphantria cunea Drury at a constant temperature of 28.2$\pm$2$^{\circ}C$, 50-60% RH to evaluate their impact on the host and their potential biological control. Development of immature stage took 20.1$\pm$2.7 d: adult females lived for 23.2$\pm$2.2 (range, 16-27)d and produced a mean of 53.6$\pm$26.6 adult progeny per female, with a sex ratio of 1: 9.5 (M:F). The intrinsic rate of natural increase (r$_{m}$) was 0.178/ female/day; the net reproductive rate (R$_{o}$), 46.74; the capacity for increase (r$_{c}$) 0.177; the finite rate of increase (λ) 1.19/female/day; thus each female contributed 46.74 individuals to the population in a mean generation time of 21.6 d. Biological factors in determining the life history trait variation of the parasitoid were discussed.d.d.d.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.12 no.1
• /
• pp.37-43
• /
• 2001

In this paper, we designed a linear power amplifier considering its delay characteristics fur wideband operation. The power amplifier has the gain of 37 dB and is designed in 3-stage typ with 1W output power. The error amplifier has the gain of 55 dB and is designed in 4-stage typ. And directional coupler and power divider are designed. Vector modulator is used to adjust magnitude and phase of signal. A linear power amplifier, that is assembled with each modules, is designed considering the delay characteristics for 2.11~2.2 GHz. Its C/I3 ratio has been improved by B5 dB for bandwidth of 30 MHz.

• Journal of Biosystems Engineering
• /
• v.27 no.3
• /
• pp.219-226
• /
• 2002

Desorption equilibrium moisture contents of oak mushroom were measured by the static method using salt solutions at flour temperature levels of 35$\^{C}$, 45$\^{C}$, 55$\^{C}$ and 6$\^{C}$ and five relative humidity levels in the range from 11.0% to 90.8%. EMC data were fitted to the modified Henderson, Chung-Pfost, modified Halsey and modified Oswin models using nonlinear regression analysis. Drying tests far oak mushroom were conducted in an experimental dryer equipped with air conditioning unit. The drying test were performed in triplicate at flour air temperatures of 35$\^{C}$, 45$\^{C}$, 55$\^{C}$ and 65$\^{C}$ and three relative humidities of 30%, 50% and 70% respectively. Measured moisture ratio data were fitted to the selected four drying models(Lewis, Page, simplified diffusion and Thompson models) using stepwise multiple regression analysis. The results of comparing root mean square errors for EMC models showed that modified Halsey was the best model, and modified Oswin models could be available far oak mushroom. The results of comparing coefficients of determination and root mean square errors of moisture ratio for four drying models showed that Page model were found to fit adequately to all drying test data with a coefficient of determination of 0.9990 and root mean square error of moisture ratio of 0.00739.

• Journal of the Korean Society of Safety
• /
• v.9 no.4
• /
• pp.29-41
• /
• 1994

High temperature tensiles tests, steady state creep tests, internal stress tests and creep rupture tests using Al 7075 alloy were performed over the temperature range of 9$0^{\circ}C$~50$0^{\circ}C$ and stress range of 0.64~17.2(kgf/$\textrm{mm}^2$) in order to investigate the creep behavior and predict creep rupture life From the apparent activation energy Qc and the applied stress exponent n measured, at the temperature range of 9$0^{\circ}C$~l2$0^{\circ}C$, the creep deformation seemed to be controlled by cross slip. On the other hand at the temperature of 20$0^{\circ}C$~23$0^{\circ}C$ the creep deformation seemed to be controlled by dislocation climb but at 47$0^{\circ}C$~50$0^{\circ}C$, by diffusion creep. And the rupture life(t$_{f}$) might be represented by anthermal process attributed to the difference of the applied stress dependence of Internal stress and the ratio of the Internal stress to the applied stress, the thermal activated process attributied to the temperature dependence of the internal stress. Also the ratio between stress dependence of primary creep rate and that of minimum creep rate was measured 0.46, the minimum creep rate is expected to be appromately obtained from master creep curve including the relationship primary creep rate and minumum creep rate. Finally the relationship new rupture parameter and logarithmic stress was represented with including the ratio between the dependence of primary creep rate and that of minimum creep rate, using the new rupture parameter the rupture life predition is exactly expected.d.