• Journal of Power System Engineering
• /
• v.4 no.3
• /
• pp.55-61
• /
• 2000

In this study, a new design of an one-body type of an unbalanced-fixed- displacement type vane pump combined with an induction type electric motor was suggested. By the application of the new design scheme, it was possible to reduce the number of parts of the pump system and to cut down the volume of power package than that of already-used products. The case in this study enabled efficient heat transfer and electricity insulation of hydraulic fluid. Thus oil moves through the inside of the package for cooling and returns to the reservoir. Because of this design, it was difficult to measure the shaft-input torque. Therefore the package overall efficiency in the paper was evaluated with a ratio of hydraulic power and electric power.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.52 no.1
• /
• pp.28-34
• /
• 2003

In this paper, a predistortion linearizer using series diode is proposed for linearizing the power amplifier in microwave radio systems. The power amplifier should be operated near saturation region to achieve high efficiency. But at this region, amplitude and phase distortions of the amplifier remarkably increase with the increase of input power and cause a significant adjacent channel interference. The linearizer is composed of a series diode with a parallel capacitor, which provides positive amplitude and negative phase deviations with the increasing input power. This type of linearizer using the nonlinearity of diode has improved the C/I(Carrier to Intermodulation Distortion) ratio well. By applying this linearizer to two-tone 880MHz power amplifier, adjacent channel leakage power is improved up to 5dBm.

• Journal of the Korean Society for Heat Treatment
• /
• v.15 no.3
• /
• pp.113-117
• /
• 2002

Fatigue characteristics of ferroelectric $Pb(Zr,Ti)O_3$ (PZT) based capacitors through donor doping is reported in this paper. La substitution up to 10% were carried out to study systematically the fatigue behaviors of epitaxial ferroelectric capacitors grown on Si using $(Ti_{0.9}Al_{0.1})N/Pt$ conducting barrier composite. Ferroelectric capacitors substituted with 10% La show sufficient low voltage switched polarization and fatigue free performance. Systematic decrease in the tetragonality of the ferroelectric phase (i.e., c/a ratio) results in the corresponding reduction in coercive voltage, sufficient remnant polarization at 1.5-3V, and good fatigue property.

• Asian-Australasian Journal of Animal Sciences
• /
• v.11 no.3
• /
• pp.268-271
• /
• 1998

Twenty crossbred calves of $88{\pm}5.5kg$ initial live weight and 3-4 month of age were divided into two groups and fed wheat straw and concentrate to support a 500 g daily gain in body weight. Calves in the experimental group (YC) were given a daily dose of 10 ml yeast cell suspension (YC) containing live cells $(5{\times}10^9 cells/ml)$ of Saccharomyces cerevisiae ITCCF 2094. After a growth study of 122 days metabolism trials were conducted. The calves in the YC group recorded a daily weigt gain of $492{\pm}27.8g$ as compared to $476{\pm}20.1g$ in control group. There were no significant differences in feed intake, nutrient digestibility, feed/gain ratio and nitrogen retention between the YC supplemented and control groups.

• Communications of the Korean Mathematical Society
• /
• v.35 no.3
• /
• pp.967-977
• /
• 2020

In this article, we find the necessary and sufficient condition for a proper biharmonic Frenet curve in the Lorentzian Sasakian space forms 𝓜³₁(H) except the case constant curvature -1. Next, we find that for a slant curve in a 3-dimensional Sasakian Lorentzian manifold, its ratio of "geodesic curvature" and "geodesic torsion -1" is a constant. We show that a proper biharmonic Frenet curve is a slant pseudo-helix with 𝜅² - 𝜏² = -1 + 𝜀₁(H + 1)𝜂(B)² in the Lorentzian Sasakian space forms x1D4DC³₁(H) except the case constant curvature -1. As example, we classify proper biharmonic Frenet curves in 3-dimensional Lorentzian Heisenberg space, that is a slant pseudo-helix.

• Wind and Structures
• /
• v.4 no.1
• /
• pp.63-72
• /
• 2001

This paper presents results of a study on wind loads and wind induced dynamic response of bridge jointed twin-towered buildings. Utilizing the high-frequency force balance technique, the drag and moment coefficients measured in wind tunnel tests, and the maximum acceleration rms values on the top floor of towers, are analyzed to examine the influence of building's plan shapes and of intervals between towers. The alongwind, acrosswind and torsional modal force spectra are investigated for generic bridge jointed twin-towered building models which cover twin squares, twin rhombuses, twin triangles, twin triangles with sharp corners cut off, twin rectangles and individual rectangle with the same outline aspect ratio as the twin rectangles. The analysis of the statistical correlation among three components of the aerodynamic force corroborated that the correlation between acrosswind and torsional forces is significant for bridge jointed twin-towered buildings.

• Computers and Concrete
• /
• v.17 no.2
• /
• pp.227-240
• /
• 2016

An analytical study was conducted to investigate the effect of the shape and spacing of modified inclined studs used as shear connector between concrete and steel plate on the cyclic behavior of steel plate concrete (SC) shear wall. 9 different analysis cases were adopted to determine the optimized shape and spacing of stud. As the results, the skeleton curves were obtained from the load-displacement hysteresis curves, and the ultimate and yielding strengths were increased as the spacing of studs decrease. In addition, the strength of inclined studs is shown to be bigger compared to that of conventional studs. The damping ratios increased as the decrease of stiffness ratio. Finally, with decreasing the spacing distance of studs, the cumulative dissipated energy was increased and the seismic performance was improved.

• Computers and Concrete
• /
• v.18 no.1
• /
• pp.139-154
• /
• 2016

Since the concrete strength around the reinforcement rebar affects the tension stiffening, the tension stiffening effect of ultra high performance concrete on the concrete members reinforced by steel rebar is examined by testing the specimens with circular cross section with the length 850 mm reinforced by a steel rebar at the center of a specimen's cross section in this research. Conducting a tensile test on the specimens, the cracking behavior is evaluated and a curve with an exponential descending branch is obtained to explain the post-cracking zone. In addition, this paper proposes an equation for this branch and parameters of equation is obtained based on the ratio of cover thickness to rebar diameter (c/d) and reinforcement percentage (${\rho}$).

• Steel and Composite Structures
• /
• v.15 no.5
• /
• pp.507-518
• /
• 2013

The seismic performance of six types of weak-axis steel moment connections was investigated through cyclic testing of six full-scale specimens. These weak-axis moment connections were the column-tree type, WUF-B type, FF-W type, WFP type, BFP-B type and DST type weak-axis connections. The testing results showed that each of these weak-axis connection types achieved excellent seismic performance, except the WFP and the WUF-B types. The WFP and WUF-B connections displayed poor seismic performance because a fracture appeared prematurely at the weld joint due to stress concentrations. The column-tree type connection showed the best seismic behavior such that the story drift ratio could reach 5%.

• Proceedings of the KOSOMBE Conference
• /
• v.1992 no.05
• /
• pp.64-67
• /
• 1992

To improve signal-to-noise ratio in sodium image, short echo time (2-3 ms) and long data acquisition (10-20 ms) protocols are used. Sodium in biological specimens demonstrates a bi-exponential decay of transverse magnetization and the fast decaying component of the sodium signal results in the reconstruction of images which are blurred significantly. The spatially-dependent nature of the blurs are due mainly to the presence of short local transverse relaxation values (0.7-3 ms) of sodium in tissue. We present an algorithm that corrects for object-dependent blurs due to fast-decaying T2 and improves the computational behavior of the algorithm by incorporating a relaxation parameter into the iterative process.