• 자원리싸이클링
• /
• 제11권5호
• /
• pp.21-23
• /
• 2002

A new process based on the co-precipitation method was developed fer removing harmful impurities during Mn-Zn ferrite production such as $SiO_2$ and P from waste pickle liquor. By this process a final result of less than 100 ppm of $SiO_2$ and less than 10 ppm of P content in the ferric oxide is easily attained. Though Ca cannot be removed by this process, water rinsing of the ferric oxide is effective fer reducing Ca content to less than 100 pm. For further purification, the origins of each impurity must be investigated and then taken away.

• 마이크로전자및패키징학회지
• /
• 제11권2호
• /
• pp.29-35
• /
• 2004

65 nm급 게이트 유전체로의 $HfO_2$의 적용을 위해 hydrogen-terminate된 Si 기판과 ECR $N_2$ plasma를 이용하여 SiNx를 형성한 기판 위에 MOCVD를 이용하여 $HfO_2$를 증착하였다. $450^{\circ}C$에서 증착시킨 박막의 경우 낮은 carbon 불순물을 가지며 비정질 matrix에 국부적인 결정화와 가장 적은 계면층이 형성되었으며 이 계면층은 Hf-silicate임을 알 수 있었다. 또한 $900^{\circ}C$, 30초간 $N_2$분위기에서 RTA 결과 $HfO_2/Si$의 single layer capacitor의 경우 계면층의 증가로 인해 EOT가 열처리전(2.6nm)보다 약 1 nm 증가하였다. 그러나 $HfO_2/SiNx/Si$ stack capacitor의 경우 SiNx 계면층은 열처리후에도 일정하게 유지되었으며 $HfO_2$ 박막의 결정화로 열처리전(2.7nm)보다 0.3nm의 EOT 감소를 나타내었으며 열처리후에도 $4.8{\times}10^{-6}A/cm^2$의 매우 우수한 누설전류 특성을 가짐을 알 수 있었다.

• 전자공학회논문지A
• /
• 제33A권3호
• /
• pp.126-134
• /
• 1996

Tungsten silicide films were deposited on the phosphorus-doped poly-Si/SiO$_{2}$/Si-substrates by LPCVD (low pressue chemical vapor deposition). The formation and various properties of tungsten silicide processed by furnace annealing in N$_{2}$ ambient were evaluated by using XRD. AFM, 4-point probe and SEM. And the redistribution of phosphorus atoms has been observed by SIMS. The crystal structure of the as-deposited tungsten silicide films were transformed from the hexagonal to the tetragonal structure upon annealing at 550.deg. C. The surface roughness of tungsten polycide films were found to very smoothly upon annelaing at 850.deg. C and low phosphorus concentration in polysilicon layer. The sheet resistance of tungsten polycide low phosphorus concentration in polysilicon layer. The sheet resistance of tungsten polycide films are measured to be 2.4 .ohm./ㅁafter furnace annealing at 1100.deg. C, 30min. It was found that the sheet resistance of tungsten polycide films upon annealing above 1050.deg. C were independant on the phosphorus concentration of polysilicon layer and furnace annealing times. An out-diffusion of phosphorus impurity through tungsten silicide film after annealing in $O_{2}$ ambient revealed a remarkably low content of dopant by oxide capping.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1998년도 추계학술대회 논문집
• /
• pp.339-342
• /
• 1998

Ferroelectric L $a_2$ $Ti_2$ $O_{7}$(LTO) thin films were prepared by chemical solution deposition processes. Acetylacetone was used as chelating agent and nitric acid was added in the stock solution to control hydrolysis and condensation reaction rate. The LTO thin films were spin-coated on Pt/Ti/ $SiO_2$/(100)Si and Pt/Zr $O_2$/ $SiO_2$/(100)Si substrates. After multiple coating, dried thin films were heat-treated for decomposition of residual organics and crystallization. The role of acetylacetone in Ti iso-propoxide stabilization by possibly substituting $O^{i}$Pr ligand was studied by H-NMR. B site-rich impurity phase, i.e. L $a_4$ $Ti_{9}$ $O_{24}$, was found after annealing, where its appearance was dependent on process temperature indicating the possible reaction with substrate. Dielectric and other relevant electrical properties were measured and the results were compared between modified sol-gel and MOD processes.s.s.

• 한국전기전자재료학회논문지
• /
• 제21권2호
• /
• pp.111-117
• /
• 2008

We have studied surface roughness, contamination of impurity, bonding with some gas element, reflectance and zeta potential on masks to be generated or changed during photolithography/dry or wet etching process. Mask surface roughness was not changed after photolithography/dry etching process. But surface roughness was changed on some area under MoSi film of Cr/MoSi/Qz. There was not detected any impurity on mask surface after plasma dry etching process. Reflectance of mask was increased after variable plasma etching treatment, especially when mask was treated with plasma including $O_2$ gas. Blank mask was positively charged when the mask was treated with Cr plasma etching gas($Cl_2:250$ sccm/He:20 $sccm/O_2:29$ seem, source power:100 W/bias power:20 W, 300 sec). But this positive charge was changed to negative charge when the mask was treated with $CF_4$ gas for MoSi plasma etching, resulting better wet cleaning. There was appeared with negative charge on MoSi/Qz mask treated with Cr plasma etching process condition, and this mask was measured with more negative after SC-1 wet cleaning process, resulting better wet cleaning. This mask was charged with positive after treatment with $O_2$ plasma again, resulting bad wet cleaning condition.

• 한국진공학회지
• /
• 제13권1호
• /
• pp.22-28
• /
• 2004

본 논문은 탄탈 박막의 증착시 음의 기판 바이어스에 의한 탄탈 박막내의 불순물 농도변화에 대해서 고찰하였다. 탄탈 박막은 실리콘 기판 위에 이온빔 증착장비를 이용하여 기판 바이어스를 걸지 않은 경우와 -125 V의 기판 바이어스를 건 상태에서 증착하였다. 탄탈 박막내의 불순물 농도를 관찰하기 위해서 이차이온 질량분석기(secondary ion mass spectrometry)를 이용하였다. 세슘 클러스터 이온에 의한 깊이분석에서, -125 V의 기판 바이어스를 걸어줌으로써 산소, 탄소, 그리고 실리콘 불순물의 농도가 기판 바이어스를 걸지 않은 경우에 비해 상당히 감소한 것을 알 수 있었다. 또한, 세슘 이온빔과 산소 이온빔을 이용한 전체 불순물의 농도분포에서도, 음의 기판 바이어스가 박막 증착시 각각의 불순물 농도에 영향을 준다는 결과를 얻었고 이에 대한 고찰을 하였다.

• 한국진공학회지
• /
• 제1권3호
• /
• pp.376-381
• /
• 1992

Tungsten silicide films were deposited on the highly phosphorus-doped poly Si/SiO2/Si substrates by Low Pressure Chemical Vapor Deposition. They were heat treated in different conditions. XTEM, SIMS and high frequency C-V analysis were conducted for characterization. It can be concluded that outdiffusion of phosphours impurity throught the silicide films lead to its depletion in the poly-Si gate region near the gate oxide, resulting in loss of capacitance and increase of effective gate oxide thickness.

• 한국세라믹학회지
• /
• 제54권4호
• /
• pp.298-302
• /
• 2017

To investigate the influence of alkaline impurity K content on bubbles of quartz glass, samples were prepared based on $SiO_2$ sand with differing amounts of potassium hydroxide solution added by electric fusion. Bubble properties such as number, diameter and bubble fraction were determined using a stereoscopic microscope. The results of the observations indicated that an alkaline impurity content of 100 ppm had a good effect on bubble decline in quartz glass. The effect on OH was investigated by FTIR(Fourier transform infrared spectroscopy).

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2007년도 7th International Meeting on Information Display 제7권2호
• /
• pp.1298-1300
• /
• 2007

The interface between SiNx and ZnO was investigated with Near Edge X-ray Absorption Fine Structure (NEXAFS) for ZnO based thin film transistor (TFT) applications. Impurity species were interstitial $N_2$ molecules at the SiNx / ZnO interface. The evolution of $N_2$ is decreased with increasing of anneal temperature.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1998년도 추계학술대회 논문집
• /
• pp.335-338
• /
• 1998

Ferroelectric Sr$_2$(Nb,Ta)$_2$O$_{7}$ (SNTO) thin films were prepared by chemical solution deposition processes. SNTO thin films were spin-coated on Pt/Ti/SiO$_2$/(100)Si substrates. After multiple coating, dried thin films were heat-treated for decomposition of residual organics and crystallization. B site-rich impurity phase, i.e. [Sr(Nb,Ta)$_2$O$_{6}$], was found after annealing, where its appearance was dependent on process temperature indicating the possible reaction with substrate. Dielectric and other relevant electrical properties were measured and the results showed a little possibility in ferroelectric gate random access memory devices.s.s.