• 한국전기전자재료학회논문지
• /
• 제22권2호
• /
• pp.101-106
• /
• 2009

In this paper, Thin films of $HfO_2$/Hf were deposited on p-type wafer by Atomic Layer Deposition (ALD). We studied the electrical and material characteristics of $HfO_2$/Hf/Si MOS capacitor depending on thickness of Hf metal layer. $HfO_2$ films were deposited using TEMAH and $O_3$ at $350^{\circ}C$. Samples were then annealed using furnace heating to $500^{\circ}C$. Round-type MOS capacitors have been fabricated on Si substrates with $2000\;{\AA}$-thick Pt top electrodes. The composition rate of the dielectric material was analyzed using TEM (Transmission Electron Microscopy), XRD (X-ray Diffraction) and XPS (X-ray Photoelectron Spectroscopy). Also the capacitance-voltage (C-V), conductance-voltage (G-V), and current-voltage (I-V) characteristics were measured. We calculated the density of oxide trap charges and interface trap charges in our MOS device. At the interface between $HfO_2$ and Si, both Hf-Si and Hf-Si-O bonds were observed, instead of Si-O bond. The sandwiched Hf metal layer suppressed the growing of $SiO_x$ layer so that $HfSi_xO_y$ layer was achieved. And finally, the generation of both oxide trap charge and interface trap charge in $HfO_2$ film was reduced effectively by using Hf metal layer.

• 한국전기전자재료학회논문지
• /
• 제11권1호
• /
• pp.33-40
• /
• 1998

The composite SiO$_2$/Si$_3$N$_4$/SiO$_2$(ONO) film formed by oxidation on nitride film has been widely studied as DRAM stacked capacitor multi-dielectric films. Load lock(L/L) LPCVD system by HF cleaning is used to improve electrical capacitance and to scale down of effective thickness for memory device, but is brings a new problem. Nitride film deposited using HF cleaning shows selective deposition on poly silicon and oxide regions of capacitor. This problem is avoidable by carpeting chemical oxide using $H_2O$$_2$cleaning before nitride deposition. In this paper, we study the limit of nitride thickness for abnormal oxidation and the initial deposition time for nitride deposition dependent on underlayer materials. We proposed an advanced fabrication process for stacked capacitor in order to avoid selective deposition problem and show the usefulness of nitride deposition using L/L LPCVD system by $H_2O$$_2$cleaning. The natural oxide thickness on polysilicon monitor after HF and $H_2O$$_2$cleaning are measured 3~4$\AA$, respectively. Two substrate materials have the different initial nitride deposition times. The initial deposition time for polysilicon is nearly zero, but initial deposition time for oxide is about 60seconds. However the deposition rate is constant after initial deposition time. The limit of nitride thickness for abnormal oxidation under the HF and $H_2O$$_2$cleaning method are 60$\AA$, 48$\AA$, respectively. The results obtained in this study are useful for developing ultra thin nitride fabrication of ONO scaling and for avoiding abnormal oxidation in stacked capacitor application.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2007년도 추계학술대회 논문집
• /
• pp.9-10
• /
• 2007

In this paper, Thin films of $HfO_2$/Hf were deposited on p-type wafer by Atomic Layer Deposition(ALD). And we studied the electrical characterization of $HfO_2$/Hf/Si MOS capacitor depending on thickness of Hf metal layer. $HfO_2$ films were deposited using TEMAH and $O_3\;at\;350^{\circ}C$. Samples were then annealed using furnace heating to $500^{\circ}C$. The MOS capacitor of round-type was fabricated on Si substrates. Through TEM(Transmission Electron Microscope), XRD(X-ray Diffraction), capacitance-voltage(C-V) and current-voltage(I-V) analysis, the role of thin Hf metal layer for the better $HfO_2$/Si interface property was investigated.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2002년도 추계학술대회 논문집 Vol.15
• /
• pp.163-166
• /
• 2002

We investigated structural and electrical properties of Metal-Oxide-Semiconductor(MOS) structure using Hafnium $oxide(HfO_{2})$ as high-k gate dielectric material. $HfO_{2}$ films are ultrathin gate dielectric material witch have a thickness less than 2.0nm， so it is spotlighted to be substituted $SiO_{2}$ as gate dielectric material. In this paper We have grown $HfO_{2}$ films with pt electrode on P-type Silicon substrate by RF magnetron sputtering system using $HfO_{2}$ target and oserved the property of semiconductor-oxide interface. Using pt electrode, it is necessary to be annealed at ${300^{\circ}C}$. This process is to increase an adhesion ratio between $HfO_{2}$ films with pt electrode. In film deposition process, the deposition time of $HfO_{2}$ films is an important parameter. Structura1 properties are invetigated by AES depth profile, and electrical properties by Capacitance-Voltage characteristic. Interface trap density are measured to observe the interface between $HfO_{2}$ with Si using High-frequency(1MHz) C-V and Quasi - static C-V characteristic.

• 마이크로전자및패키징학회지
• /
• 제11권2호
• /
• pp.29-35
• /
• 2004

65 nm급 게이트 유전체로의 $HfO_2$의 적용을 위해 hydrogen-terminate된 Si 기판과 ECR $N_2$ plasma를 이용하여 SiNx를 형성한 기판 위에 MOCVD를 이용하여 $HfO_2$를 증착하였다. $450^{\circ}C$에서 증착시킨 박막의 경우 낮은 carbon 불순물을 가지며 비정질 matrix에 국부적인 결정화와 가장 적은 계면층이 형성되었으며 이 계면층은 Hf-silicate임을 알 수 있었다. 또한 $900^{\circ}C$, 30초간 $N_2$분위기에서 RTA 결과 $HfO_2/Si$의 single layer capacitor의 경우 계면층의 증가로 인해 EOT가 열처리전(2.6nm)보다 약 1 nm 증가하였다. 그러나 $HfO_2/SiNx/Si$ stack capacitor의 경우 SiNx 계면층은 열처리후에도 일정하게 유지되었으며 $HfO_2$ 박막의 결정화로 열처리전(2.7nm)보다 0.3nm의 EOT 감소를 나타내었으며 열처리후에도 $4.8{\times}10^{-6}A/cm^2$의 매우 우수한 누설전류 특성을 가짐을 알 수 있었다.

• 한국재료학회지
• /
• 제17권5호
• /
• pp.263-267
• /
• 2007

Hafnium oxide $(HfO_2)$ films were deposited on Si(100) substrates by remote plasma-enhanced atomic layer deposition (PEALD) method at $250^{\circ}C$ using TEMAH [tetrakis(ethylmethylamino)hafnium] and $O_2$ plasma. $(HfO_2)$ films showed a relatively low carbon contamination of about 3 at %. As-deposited and annealed $(HfO_2)$ films showed amorphous and randomly oriented polycrystalline structure. respectively. The interfacial layer of $(HfO_2)$ films deposited using remote PEALD was Hf silicate and its thickness increased with increasing annealing temperature. The hysteresis of $(HfO_2)$ films became lower and the flat band voltages shifted towards the positive direction after annealing. Post-annealing process significantly changed the physical, chemical, and electrical properties of $(HfO_2)$ films. $(HfO_2)$ films deposited by remote PEALD using TEMAH and $O_2$ plasma showed generally improved film qualities compare to those of the films deposited by conventional ALD.

• 대한금속재료학회지
• /
• 제48권3호
• /
• pp.256-261
• /
• 2010

In this work, high-k dielectric stacks of $HfO_2$ and $HfO_2$/$Al_2O_3$/$HfO_2$ (HAH) were deposited on $SiO_2/Si$ substrates by atomic layer deposition as charge trapping layers in charge trapping devices. The structural stability and the charge trapping characteristics of such stacks were investigated using Metal-Alumina-Hafnia-Oxide-Silicon (MAHOS) structure. The surface roughness of $HfO_2$ was stable up to 11 nm with the insertion of 0.2 nm thick $Al_2O_3$. The effect of the thickness of the HAH stack and the thickness of intermediate $Al_2O_3$ on charge trapping characteristics were investigated for MAHOS structure under various gate bias pulse with duration of 100 ms. The threshold voltage shift after programming and erase showed that the memory window was increased with increasing bias on gate. However, the programming window was independent of the thickness of HAH charge trapping layers. When the thickness of $Al_2O_3$insertion increased from 0.2 nm to 1 nm, the erase window was decreased without change in the programming window.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제5권2호
• /
• pp.120-126
• /
• 2005

We have proposed a characteristic method to estimate real composition when multi component oxide films are deposited by ALD. Final atomic concentration ratio was theoretically calculated from the film densities and growth rates for $HfO_2$ and $Al_2O_3$ using ALD processed HfxAhOz mms.W e have transformed initial source feeding ratio during deposition to fins] atomic ratio in $Hf_xAl_yO_z$ films through thickness factors ($R_{HFO_2}$ ami $R_{Al_2O_3}$) ami concentration factor(C) defined in our experiments. Initial source feeding ratio could be transformed into the thickness ratio by each thickness factor. Final atomic ratio was calculated from thickness ratio by concentration factor. It has been successfully confirmed that the predicted atomic ratio was in good agreement with the actual measured value by ICP-MS analysis.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2009년도 하계학술대회 논문집
• /
• pp.133-133
• /
• 2009

It is desirable to choose a high-k material having a large band offset with the tunneling oxide and a deep trapping level for use as the charge trapping layer to achieve high PIE (Programming/erasing) speeds and good reliability, respectively. In this paper, charge trapping and tunneling characteristics of high-k hafnium oxide ($HfO_2$) layer with various thicknesses were investigated for applications of tunnel barrier engineered nonvolatile memory. A critical thickness of $HfO_2$ layer for suppressing the charge trapping and enhancing the tunneling sensitivity of tunnel barrier were developed. Also, the charge trap centroid and charge trap density were extracted by constant current stress (CCS) method. As a result, the optimization of $HfO_2$ thickness considerably improved the performances of non-volatile memory(NVM).

• 한국자기학회지
• /
• 제10권4호
• /
• pp.165-170
• /
• 2000

Fe-Hf-N 연자성 박막의 물리적, 자기적 특성에 미치는 열처리 영향에 대하여 고찰하였다. Fe-Hf-N 연자성 박막을 질소분위기에서 열처리 할 경우 표면에 Fe$_2$O$_3$-Fe$_3$O$_4$으로 구성된 산화층이 생성되었고, 이 산화층 아래 Fe-Hf-O-N층이 생성되었다. 열처리 온도의 증가에 따라 Fe$_2$O$_3$-Fe$_3$O$_4$ 산화층과 Fe-Hf-O-N 층의 두께가 증가하였고, Fe$_2$O$_3$-Fe$_3$O$_4$산화층을 제외한 박막의 두께는 열처리전과 같았다. 열처리한 박막에서 표면에 생성된 Fe$_2$O$_3$-Fe$_3$O$_4$산화층의 두께를 제외하고 계산한 박막의 연자기 특성은 열처리 전의 연자기 특성에 비해 약간 떨어지는 것으로 나타났다. 그러므로, Fe-Hf-O-N층은 박막 전체의 연자기 특성을 크게 떨어뜨리지 않으며, 열처리 후 박막 전체의 연자기 특성은 Fe-Hf-O-N과 Fe-Hf-N의 다층막의 연자기 특성을 나타내는 것으로 생각된다.