• Journal of Magnetics
• /
• 제12권1호
• /
• pp.27-30
• /
• 2007

Experimental evidence suggests that spin pinning conditions for standing spin mode in polycrystalline $Ni_{84}Fe_{16}$ alloy film, is confirmed using the four categories of Camley et al. and the value of q$\bot$ for the pinning conditions, this was achieved by performing Brillouin light scattering measurements. The value of q$\bot$ was observed, in order to increase at a rate of $\pi$/2 with an increasing mode number. With this condition, the coexistence of standing spin wave modes was shown, with intermediate pinning, in addition to free and strong pinning. The values for spin-wave-stiffness constant ($D_B$), g-factor (g), and surface magnetization (4$\pi$M) of the Permalloy film were obtained from the results of BLS, and determined to be $D_B=1.85{\pm}0.05Oecm^2$, $g=2.11{\pm}0.02$, and 4$\pi$M=8.7 kG, respectively.

• Steel and Composite Structures
• /
• 제32권2호
• /
• pp.199-212
• /
• 2019

This paper presents an investigation on seismic behavior of out-of-code Q690 circular high-strength concrete-filled thin-walled steel tubular (HCFTST) columns made up of high-strength (HS) steel tubes (yield strength $f_y{\geq}690MPa$). Eight Q690 circular HCFTST columns with various diameter-to-thickness (D/t) ratios, concrete cylinder compressive strengths ($f_c$) and axial compression ratios (n) were tested under the constant axial loading and reversed cyclic lateral loading. The obtained lateral load-displacement hysteretic curves, energy dissipation, skeleton curves and ductility, and stiffness degradation were analyzed in detail to reflect the influences of tested parameters. Subsequently, a simplified shear strength model was derived and validated by the test results. Finally, a finite element analysis (FEA) model incorporating a stress triaxiality dependent fracture criterion was established to simulate the seismic behavior. The systematic investigation indicates the following: compared to the D/t ratio and axial compression ratio, improving the concrete compressive strength (e.g., the HS thin-walled steel tube filled with HS concrete) had a slight influence on the ductility but an obvious enhancement of energy dissipation and peak load; the simplified shear strength model based on truss mechanism accurately predicted the shear-resisting capacity; and the established FEA model incorporating steel fracture criterion simulated well the seismic behavior (e.g., hysteretic curve, local buckling and fracture), which can be applied to the seismic analysis and design of Q690 circular HCFTST columns.

• 대한수학회보
• /
• 제25권2호
• /
• pp.175-178
• /
• 1988

Let .SIGMA. be a smooth compact manifold without boundary having the same homotopy type as a sphere, which is called a homotopy sphere. Supose a group G acts smoothly on .SIGMA. with the fixed point set .SIGMA.$^{G}$ consists of two isolated fixed points p and q. In this case, tangent spaces $T_{p}$ .SIGMA. and $T_{q}$ .SIGMA. at isolated fixed points, as isotropy representations of G are called Smith equivalent. Moreover .SIGMA. is called a supporting homotopy sphere of Smith equivalent representations $T_{p}$ .SIGMA. and $T_{q}$ .SIGMA.. The study on Smith equivalence has rich history, and for this we refer the reader to [P] or [Su]. The following question of pp.A.Smith [S] motivates the study on Smith equivalence.e.

• East Asian mathematical journal
• /
• 제25권4호
• /
• pp.527-532
• /
• 2009

In this paper, we study the following extended generalized variational inequality problem, introduced by Noor (for short, EGVI) : Given a closed convex subset K in q-uniformly smooth Banach space B, three nonlinear mappings T : $K\;{\rightarrow}\;B^*$, g : $K\;{\rightarrow}\;K$, h : $K\;{\rightarrow}\;K$ and a vector ${\xi}\;{\in}\;B^*$, find $x\;{\in}\;K$, $h(x)\;{\in}\;K$ such that $\xi$, g(y)-h(x)> $\geq$ 0, for all $y\;{\in}\;K$, $g(y)\;{\in}\;K$. [see [2]: M. Aslam Noor, Extended general variational inequalities, Appl. Math. Lett. 22 (2009) 182-186.] By using sunny nonexpansive retraction $Q_K$ and the well-known Banach's fixed point principle, we prove existence results for solutions of (EGVI). Our results extend some recent results from the literature.

• 한국해양바이오학회지
• /
• 제2권3호
• /
• pp.198-200
• /
• 2007

Cultivation of a $Q_{10}$-producing photosynthetic bacterium, Rhodobacter sphaeroids, was carried out in a 1-L flask to characterize its cellular growth reaction. The result of experiment showed that dissolve oxygen in the broth was depleted within 7 h. ORP decreased with decrease of DO, and recovered somewhat with increase of pH. The growth of R. spahaeroids reached at late-log phase in 140 h of reaction. The final pH and dry-cell weight were 7.62 and 2.2 mg/mL, respectively. The $Q_{10}$ content in the final broth was 2.35 mg/g dry cell weight, which was higher than that obtained in tube culture.

• 한국식품영양학회지
• /
• 제34권5호
• /
• pp.430-440
• /
• 2021

This study was conducted to investigate the intake status of beverages and water in Korean adults using data from the 8th National Health and Nutrition Examination Survey. The 'total water' intake was 2,250.6 g for men and 1,871.2 g for women. Men and women consumed an average of 314.9 g of 'total beverages', of which 'coffee' was the largest at 107.5 g, followed by 'others'(65.4 g), 'milk' (44.8 g), 'soda' (44.1 g), 'teas' (20.9 g), and 'fruits and vegetables' (18.5 g). The intake of 'plain water' was 1,059.9 g, and the intake of 'water from food' consumed was 547.3 g. The 'total water' intake decreased with increasing age in males and females (p<0.001). Both men and women showed a tendency toward increased 'total water' intake as income levels increased. 'Plain water' intake accounted for 51.4% of the 'total water' intake in males and females. The intake of all nutrients significantly increased from the Q1 group to the Q4 group by quartile ranges of total water intake. The results of this study showed that the intake of healthy water should be considered, and care and educational programs are needed, especially for older people, to ensure adequate water intake.

• Journal of Nutrition and Health
• /
• 제38권7호
• /
• pp.578-585
• /
• 2005

Maternal zinc deficiency is relatively common worldwide, but its consequences for pregnancy outcome are not established. The purpose of this study was to examine the effect of zinc status in the second trimester on pregnancy outcome. Subjects were 248 pregnant Korean women (25-28 wk gestation). Cord blood was collected from subgroup of 69 women and pregnancy outcome data were obtained from 185 babies. Anthropometry measurement, dietary intake, and biochemical characteristics of pregnancy and cord serum substances were measured. The subjects were divided into quartiles on the basis of maternal serum Zn concentration; $ZnQ_1$ (< 25 percentile), $ZnQ_2$ ($26\~50$ percentile), $ZnQ_3$ ($51\~75$ percentile), and $ZnQ_4$ ($76\~100$ percentile). Zn groups were compared in terms of various maternal factors, concentrations of cord serum substances, and pregnancy outcome. Maternal serum Zn concentration was $118.4\;{\pm}\;35.5\;{\mu}g/dl$ as mean. Intake of Zn was lower than Korean RDA. The rate of Zn deficiency among all subjects was $8.5\%$. Maternal serum Zn levels belonged to normal range. Cord serum Zn level was about $154.7\%$ of maternal serum level. Intakes of energy, calcium, iron, folic acid, and riboflavin did not meet the Korean RDA for pregnant women by gestational age. The mean birth weight of neonates is 3083 $\pm$ 697 g, of whom $9.1\%$ were of low birth weight (< 2,500 g). Maternal serum Zn level was positively correlated with pre-pregnancy weight, pre-pregnancy body mass index, and vitamin C intake (p < 0.05). $ZnQ_1$ group had significantly lower maternal serum iron concentration and higher cord serum cholesterol than those in other groups. Maternal serum Zn level, cord serum Zn level, and dietary Zn intake were no related to the pregnancy outcome. The birth weight had a correlation with the maternal hemoglobin and albumin concentration. In conclusion, at this study, we could not find the association with maternal Zn status in 2nd trimester and pregnancy outcome.

• 한국생물공학회:학술대회논문집
• /
• 한국생물공학회 2000년도 춘계학술발표대회
• /
• pp.263-266
• /
• 2000

The purified biosurfactant $3.16g/{\ell}$ was obtained after cultivation for 104hr at $25^{\circ}C$ with an optimal agitation speed of 200rpm, an aeration rate of 2vvm in a $14{\ell}$ fermenter containing $5.5{\ell}$ of LB medium and 1%(w/v) olive oil as a carbon source. For the kinetic studies, the optimal substrate concentration was analyzed on different olive oil concentrations(0.1, 0.5, 1.0, 1.5, 2.0%(w/v)) and optimal culture conditions(MLBM, 200rpm, 2vvm at $25^{\circ}C$) in a $14{\ell}$ jar fermenter. The results obtained indicate that $K_s$=0.0086 $g/{\ell}$, $q_s$= 0.664 $g/g{\cdot}h$, $q_p$= $4.2{\times}10^{-3}$ $g/g{\cdot}h$, and ${\mu}_{max}$ was determined as $0.1449h^{-1}$.

• Journal of applied mathematics & informatics
• /
• 제37권3_4호
• /
• pp.163-176
• /
• 2019

Given a distribution of pebbles on the vertices of a connected graph G, a pebbling move is defined as the removal of two pebbles from some vertex and the placement of one of those pebbles at an adjacent vertex. The t-pebbling number, $f_t(G)$, of a connected graph G, is the smallest positive integer such that from every placement of $f_t(G)$ pebbles, t pebbles can be moved to any specified vertex by a sequence of pebbling moves. A graph G has the 2t-pebbling property if for any distribution with more than $2f_t(G)$ - q pebbles, where q is the number of vertices with at least one pebble, it is possible, using the sequence of pebbling moves, to put 2t pebbles on any vertex. In this paper, we determine the t-pebbling number for the middle graph of a complete binary tree $M(B_h)$ and we show that the middle graph of a complete binary tree $M(B_h)$ satisfies the 2t-pebbling property.

• Carbon letters
• /
• 제1권3_4호
• /
• pp.148-153
• /
• 2001

The initial irreversible capacity, $Q_i$, is one of the parameters to express the material balancing of the cathode to anode. We introduced new terms, which are the initial intercalation Ah efficiency (IIE) and the initial irreversible specific capacity at the surface ($Q_{is}$), to express precisely the irreversibility of an electrode/electrolyte system. Two terms depended on kinds of active-materials and compositions of the electrode, but did not change with charging state. MPCF had the highest value of IIE and the lowest value of $Q_{is}$ in 1M $LiPE_6$/EC + DEC (1 : 1 volume ratio) electrolyte. IIE value of $LiCoO_2$ electrode was 97-98%, although the preparation condition of the material and the electrolyte were different. $Q_{is}$ value of $LiCoO_2$ was 0~1 mAh/g. MPCF-$LiCoO_2$ cell system had the lowest of the latent capacity. $Q_{is}$ value increased slightly by adding conductive material. IIE and $Q_{is}$ value varied with the electrolyte. By introducing PC to EC+DEC mixed solvent, IIE values were retained, but $Q_{is}$ increased. In case of addition of MP, IIE value increased and $Q_{is}$ value also increased a little.