현재의 가축분뇨처리 형태와 축종별 적용대상은 표 3과 같이 분류되며, 축분 퇴비화 뇨오수 정화방식의 고액분리 형태에서 분뇨혼합물의 동시처리 즉, 깔감축사(소, 돼지), 슬러리 발효 퇴비화를 통한 무방류 시스템으로 변화되는 추세이다. 이러한 현상은 최근의 방류수질 규제강화에 따른 무방류화 저비용 단순화를 지향하고 있으며, 무방류화의 가장 큰 걸림돌은 톱밥과 같은 수분조절재 부족이라 할 수 있다. 현재 이용되고 있는 주요 시스템별 개선안은 다음과 같다. $\square$ 주요 처리 시스템 적용의 문제제기 $\circ$ 축분발효시설 - 톱밥 등 부자재 무이용을 위한 축분의 예비 건조시설 이용 - 교반식 발효기의 악취확산방지를 위하여 밀폐형 하우스 및 강제환기 장치 설치에 의한 악취 포집 및 탈취 - 중소규모 발효시설 개발 $\circ$ 화력건조 - 예비건조를 통한 톱밥, 연료비용 절감 - 악취방치 장치부착 의무화 $\circ$ 활성오니 정화시설 - 시설 운전관리 단순화 - 1차 고액분리를 통한 유입수 오염부하량 감소 및 균일화 $\circ$ 깔감축사 - 경제적으로 흡수를 극대화할 수 있는 수분조절재의 조합비 결정 및 혼합물을 깔감으로 재이용 기술개발 $\circ$ 슬러리 발효퇴비화 시설 - 톱밥 등 수분조절재 사용량 절감기술 - 증발량 극대화 기술개발 및 소요에너지 최소화기술개발 우리나라는 사계절이 뚜렷하여 외기상에 따라 편차가 심하며, 고밀도 사육 및 지역적 편중성, 경지면적 협소, 고비용 시장구조 등의 축산환경을 고려한다면 근원적으로 가축분뇨문제 해결한다는 것은 결코 쉬운 일이 아니다. 이는 저공해 사료개발에서부터 분뇨가 발생단계에서 분리, 수거할 수 있는 수거시설, 고효율 분뇨처리시스템의 정립, 액비 및 퇴비의 가공, 토양환원되었을 때 작물생장장애, 액비, 퇴비의 유통, 가축분뇨처리 정책 및 규제법 등의 각 분야에서 복합적 노력이 필요하다.

This study was conducted to derive optimal design floods by generalized gamma distribution model of the annual maximum series at eight watersheds along Geum, Yeongsan and Seomjin river systems. Design floods obtained by different methods for evaluation of parameters and for plotting positions in the generalized gamma distribution model were compared by the relative mean errors and graphical fit along with 95% confidence limits plotted on gamma probability paper. The results were analyzed and summarized as follows. 1. Basic statistics and parameters were calculated by the generalized gamma distribution model using different methods for parameters. 2. Design floods according to the return periods were obtained by different methods for evaluation of parameters and for plotting positions in the generalized gamma distribution model. 3. It was found that design floods derived by sundry averages method for parameters and Cunnane method for plotting position in the generalized gamma distribution are much closer to those of the observed data in comparison with those obtained by the other methods for parameters and for plotting positions from the viewpoint of relative mean errors. 4. Reliability of design floods derived by sundry averages method in the generalized gamma distribution was acknowledged within 95% confidence interval.

The optimal reservoir storage capacity is needed to be determined at the stage of reservoir planning. The reservoir storage capacity should be based on water balance between demand and supply, and meet the water deficity during the growing season. However, the optimal reservoir storage capacity should be determined considering benefit-cost analysis for the project. In this study, Two models are developed. The one is the RSOM(Reservoir Storage Optimization Model), that is consisted by three submodels, MROPER (Modified Reservoir OPERation model), RESICO(REservoir SIze and the construction COst computation) model. And the other is the BECA(BEnefit-Cost Anaysis) model. For model application, three districts, Chungha, Ipsil and Edong were selected. The relative difference of B/C ratio between project planning data and estimation by RSOM is 17.9, 15.0 and 7.3% respectively, which may be applicable for water resources development feasibility planning.

Water level of irrigation reservoir during the flood season could be kept to a certain level, so called, flood control level by releasing the flood inflow in advance in order to reduce the peak discharge of next coming flood and the damage of inundation. Concept of restriction intensity of water supply was introduced to evaluate the influence of flood control volume on the irrigation water supply. Restriction intensity can be calculated by multiplying the ratio of restriction to the days of restriction which are obtained from the operation rule curve and daily water level of irrigation reservoir and it has the dimension of % day. The method of restriction intensity was applied to the Yedang irrigation reservoir with the observed data of 30 years to review whether the present flood control volume is reasonable or not, and suggest the optimal flood control volume, if possible.

Location patterns of protected horticulture were analyzed using a multiple correspondence analysis(MCA). The analysis could be used in evaluating location suitability of protected horticulture. The location factors of the protected horticulture for MCA include land category, size of protected horticulture, land slope, topography, effictive soil depth, irrigation and drainage condition, distance from roads, and so forth. The results showed that there were three different location patterns of protected horticulture. The first pattern was characterized by their nearness to villages. The facilities of this pattern were mainly located near to residential area. The second pattern was of those found in plain area. The facilities of this pattern were large in scale and located in paddy field far from residential area. The facilities of the last pattern were small in scale and located on nonpaddy fields. They were mostly found in hilly or mountainous area.

Large amount of sludge have been generating in the process of water and wastewater treatment in urban area, and it has been making many environmental problems. Currently almost of sludge is landfilled, and since sludge is difficult to handle and dehydrate, the permeated water from the filled-in ground contaminate the surrounding soil and groundwater which may cause serious environmental and sociological problems. The organic component in sludge can be almost removed through the heat treatment process, and the final product is called artificial soil or artificial media according to the temperature control. To produce artificial media using sludge, chabazite and lime were used as an additive, and the mixture of sludge & additives was thermally treated in the firing kiln at about 800~1, 100。C for about fifteen minutes. The physical and chemical characteristics of the produced artificial media were analyzed, and it showed that it can be used as an artificial media for plant production or soil conditioner for farmland. The concentrations of the toxic heavy metals in the artificial media were lower than the soil quality standard for farmland. The characteristics of produced artificial media, using the mixture of sludge and additives through the heat treatment, is similar to the natural chabazite and soil. The analyzed result of the mineral composition of artificial media showed that it has a characteristics similar to natural stable soil, so the produced artificial media may be applied to farmland or water culture without causing adverse effect. Therefore this study showed that the above process can be a feasible alternative for sludge treatment.

Measurement of electrical resistivity in soils has been used for many years with purpose of estimating in situ porosity or density. Recently electrical resistivity has also been used as an indicator of soil contaimination. This paper presents the result of laboratory experiment to investigate the resistivity variation in contaminated sandy soils. The results can be used with the Cone Penetrometer Test (CPT) result to analyse ground condition. In the experiment, the water content and leachate concentration of soils were controlled by groundwater and leachate, and then the resistivity measurement was made with 'STING-R1' by Advanced Geosciences Inc. In the case of using groundwater, the resistivity was in the range of over 1000${\omega}{\cdot}m$, but in the case of using polluted water by leachate, the resistivity decreased significantly down to 10~ 100${\omega}{\cdot}m$ for the same moisture content. Also the resistivity varied according to the degree of saturatrion. Therefore, if soil is contaminated by leachate, the CPT with electrical resistivity sensor might be used to investigate the contamination status and plume migration. But exact component of leachate and the pollutant concentration are still hard to identify.

Compressibility and permeability properties are the most important input parameters necessary to assess the suitability of core materials in seepage control system construction. To achieve this objective, an experimental investigation was conducted in the laboratory. For the bentonite-soil/sand mixes, consolidation and permeability tests were carried out in the conventional consolidation cell, 6Omm in diameter and 2Omm in height, was modified to perform a falling head type permeability test. From the results, the normalized relationship with respect to void ratio at liquid-limit state $(e_L)$, and the changes of compressibility and permeability for various bentonite-soil/sand mixes were presented. This approach will be helpful in proportioning mixes and predicting corresponding changes in engineering behavior. And it is possible to proportion a mix to arrive at the required compressibility without affecting the permeability.

The finite element analysis program should be prepared to deal with many of newly arising engineering problems. The sequential structured programming technique does not make a finite element method so flexible. So far, the object oriented programming technique was studied as an alternative programming paradigm. However, most of the research were in the state of the evaluation of the possibility and the applicability of the object oriented method for a finite element program. In this study, a practical object oriented finite element analysis program, OOFE_ JAVA was developed and the result of the analysis on a rectangular clamped plate was shown. The objects which compose the OOFE_JAVA were applied to several engineering problem without any modification and it was concluded that the object oriented technique was appropriate for the development of a complex and large engineering system. And a virtual machine which Java language is using can be loaded on any kinds of computer which has java interpreter regardless of the platform on which the OOFE_JAVA was developed.

Since a structure carries out its given functions and purposes while it is always resisting against the external load, the capacity of the resistance in the structure within the range that will not collapse the structure itself becomes the important factor in the design of the structures. Therefore, many suggestions were proposed and noted for determining method of the collapse load. Some of the methods from the suggestions have been commonly used due to the considerations on their distinctive advantages such as the compactness of the conceptions and the convenience in the computation. However, in case when the variation becomes huge in the materials and load, the results would carry(have or contain) many uncertain elements. On the other hand, load incremental method which regards the characteristics of the probability must be more attainable method even though it might complicate the calculation. This study intends to develop a finite element model that uses the probabilistic load incremental method to estimate the collapse load, and also to compare the result of the analysis with the linear load incremental method and Turkstra's Rule.

The aims of this study are to evaluate the application on the stress-strain behavior of granite Soil using Lade's double work hardening constitutive model based on the theories of elasticity and plasticity. From two different sites of construction work, two disturbed and compacted weathered granite samples which are different in partical size and degree of weathering respectively were obtained. The specimen employed were sampled at Iksan and Pochon in order to predict the constitutive model. Using the computer program based on the regression analysis, 11 soil parameters for the model were determined from the simple tests such as an isotropic compression-expansion test and a series of drained conventional triaxial tests. In conclusion, it is shown that Lade's double work hardening model gives the good applicability for processing of stress-strain, work-hardening, work-softening and soil dilatancy. Therefore, this model in its present form is applicable to the compacted decomposed granite soil.

This study was initiated to investigate the applicability of the dredged soil from agricultural reservoirs on the crop cultivation. Four reservoirs were selected for this experiment, and properties of the dredged soils were analyzed physically and chemically. Soil textures were sandy loam(SL), silty loam(SiL), gravelly loam(GL), graveHy silty loam(GSiL), respectively. General chemical components, organic matter contents, main cations, heavy metals, etc. showed no adverse effects on crop growth. Tomato, cucumber, radish, Chinese cabbage were cultivated during 8 months period, in the soil treated with fertilizer and compost(Tmt.1), fertilizer(Tmt.2), compost(Tmt.3) and none (Tmt.4). Data for plant height, root zone depth and crop yield were collected and analyzed, and the yield for most crops showed increase as Tmt.1 >Tmt.2>Tmt.3>Tmt.4 by fertilizing methods, and as GL>GSiL>SL>SiL by soil textures. From the results, the crop cultivation using dredged soil was considered to be effective, due to its soil texture, organic matter content and fertilization.