In this paper, the etching of Au films using photoresist masks on Si substrates was investigated using a capacitively coupled plasma etch reactor. The advantages of plasma etch techniques over current methods for Au metalization include the ability to simplify the metalization process flow with respect to resist lift-off schemes, and the ability to cleanly remove etched material without sidewall redeposition, as is seen in ion milling. The etch properties were measured for different gas mixing ratios of CF4/Ar, and chamber pressures while the other conditions were fixed. According to statistical design of experiment (DOE), etching process of Au films was characterized and also 20 samples were fabricated followed by measuring etch rate, selectivity and etch profile. There is a chemical reaction between CF4 and Au. Au- F is hard to remove from the surface because of its high melting point. The etching products can be sputtered by Ar ion bombardment.

In this paper, p-n junction formation using screen-printed metalization and co-firing is used to fabricate high-efficiency solar cells on single- crystalline silicon substrates. In order to form high-quality contacts, co-firing of a screen-printed Ag grid on the front and Al on the back surface field is implemented. These contacts require low contact resistance, high conductivity, and good adhesion to achieve high efficiency. Before co-firing, a statistically designed experiment is conducted. After the experiment, a neural network (NN) trained by the error back-propagation algorithm is employed to model the crucial relationships between several input factors and solar cell efficiency. The trained NN model is also used to optimize the beltline furnace process through genetic algorithms.

In this paper, we have investigated the characteristics of the magnetic abrasive using sludge on polishing of internal finishing of seamless stainless steel tube applying magnetic abrasive polishing. Either green carborundum(GC) grain was used to resin sludge at a low temperature, and the sludge of magnetic abrasive powder was synthesized and crushed into 200 meshes. Surface roughness was measured before and after polishing, and more than 38% of improvement of surface roughness was achieved when grain was used under a specific condition. Even though some degree of surface roughness due to deeper scratches still exist, but the result showed a prospective magnetic abrasive polishing using sludge with green carborundum grains.

Several research projects funded by National GIS Master Plan have started to produce several outcomes that need to be applied in the real world situation. To make the project results more useful and to improve upon the current results, it is necessary to integrate the project outcomes produced under various circumstances into a consistent and coherent structure.

The use of a low-frequency cave radio can also verify survey accuracy. A receiving unit on the surface can pinpoint the depth and location of a transmitter in a cave passage by measurement of the geometry of its radio waves. A survey over the surface from the receiver back to the cave entrance forms an artificial loop with the underground survey, whose loop-closure error can then be determined. In the past, caves were reluctant to redraw complex cave maps after detecting survey errors. Today, computer cartography can automatically redraw cave maps after data has been corrected.