Combustion and Nano-particulate Emissions Characteristics of a Compression Ignition Engine Fueled with Oxygenated Blending Fuel

압축착화 엔진에서 함산소 혼합연료의 연소 및 미세입자 배출물 특성

  • Published : 2009.09.01

Abstract

An experimental investigation was conducted to analyze the effects of biodiesel-ethanol and biodiesel-diesel blended fuels on the characteristics of combustion and exhaust emissions, and size distributions of particulate matter in a single cylinder diesel engine. The three types of test fuel were biodiesel and two blended fuels which were added ethanol and diesel by 20 % volume based fraction into biodiesel, respectively. In this study, the injection rate, combustion pressure, exhaust emissions and size distributions of particulate matter were measured under various injection timings and injection pressures. The experimental results show that biodiesel-ethanol blended fuel has lengthened ignition delay and low combustion pressure in comparison with those of biodiesel and biodiesel-diesel blended fuel even if all fuels indicated similar trends of injection rate under equal injection pressures. In addition, the ethanol blended fuel significantly reduced nitrogen oxidies (NOx) and soot emissions. And then the size distribution of particulate matters shows that blended fuels restrain the formation of particles which were beyond the range of 150nm comparison with biodiesel fuel.

Keywords

References

  1. H.K. Suh, S.W. Park, S.I. Kwon and C.S. Lee, "Macroscopic Behavior and Atomization Characteristics of Bio-diesel Fuels," Transactions of KSAE, Vol.12, No.6, pp.23-29, 2004
  2. A. Mohammadi, T. Ishiyama, T. Kakuta and S. S. Kee, "Fuel Injection Strategy for Clean Diesel Engine Using Ethanol Blended Diesel Fuel," SAE 2005-01-1725, 2005
  3. S. H. Yoon, M. Y. Kim, S. 1. Kwon, H. S. Jeon and C. S. Lee, "Combustion Characteristics of Biodiesel Fuel Derived from Soybean in a Common-Rail Diesel Engine," Spring Conference Proceedings, Vol.1 , KSAE, pp.1922-1928, 2006
  4. T. Shudo, A. Fujibe, M. Kazahaya, Y. Aoyagi, H. Ishii, Y. Goto and A. Noda, "The Cold Flow Performance and the Combustion Characteristics with Ethanol Blended Biodiesel Fuel," SAE 2005-0-3707,2005
  5. S. H. Park, H. K. Suh, H. J. Kim and C. S. Lee, "Atomization Characteristics of Ethanol-biodiesel Blending Fuel," Spring Conference Proceedings, Vol.1, KSAE, pp.604-610, 2007
  6. S. H. Yoon, J. P. Cha, J. C. Kim and C. S. Lee, "Combustion and Particulate Emissions Characteristics of CI Engine Fueled with Bioethanol Blended Fuel," Spring Conference Proceedings, Vol.1, KSAE, pp. 534-539, 2008
  7. Y. T. Seo, H. K. Suh, S. H. Bang and C. S. Lee, "A Study of the Injection Characteristics of Biodiesel Fuels Injected through Common- rail System," Fall Conference Proceedings, vol.1, KSAE, pp.570-575, 2006
  8. D. B. Kittelson, "Engines and Nanoparticles: A Review," J. Aerosol Sci. Vol.29 No.5/6, pp.575- 588,1998 https://doi.org/10.1016/S0021-8502(97)10037-4