Applied Chemistry for Engineering (공업화학)

The Korean Society of Industrial and Engineering Chemistry (한국공업화학회)
권호 표지

Synthesis of ITO Nano-Particles by SAS Method and Preparation for Conductive PET Film with Multi-Layers

SAS법을 이용한 ITO 나노입자의 합성과 적층 도포된 PET 도전필름의 제조

  • Yun, Sang-Ho (Department of Chemical Engineering, Sungkyunkwan University) ;
  • Kim, Moon-Sun (Department of Chemical Engineering, Sungkyunkwan University) ;
  • Lee, Hee-Dai (Department of Chemical Engineering, Sungkyunkwan University) ;
  • Kim, Chul Kyung (Department of Design and Material, Mokwon University)
  • 윤상호 (성균관대학교 화학공학과) ;
  • 김문선 (성균관대학교 화학공학과) ;
  • 이희대 (성균관대학교 화학공학과) ;
  • 김철경 (목원대학교 디자인소재학과)
  • Received : 2007.08.23
  • Accepted : 2007.11.24
  • Published : 2008.02.10
Download PDF
⟨ Previous Next ⟩

Abstract

The multi-layer PET film of ITO/ATO was prepared by a wet coating method to obtain the transparent film with a high conductance at low cost. ITO nano-particles were synthesized by a SAS method at 15 MPa and $50^{\circ}C$, where optimized rate of In/Sn was 65. Average diameter and resistivity of ITO obtained from SAS are $15{\pm}2nm$ and $4{\times}10^4{\Omega}{\cdot}cm$. Coating solution was prepared at pH 10. Roughness (Ra), resistivity, and transmissivity of ATO film on PET are 9 nm, $5.5{\times}10^6{\Omega}{\cdot}cm$, and 91%. The multi-layered film of ITO/ATO was obtained by solution including 0.1, 0.5, 1.0, and 2.0 ITO wt% on ATO layer. Roughness (Ra) of multi-layered film with 0.1, 0.5, 1.0, and 2.0 ITO wt% is 4, 10, 12, and 16 nm, respectively. Corresponding resistivity with an increasing ITO concentration is $3.7{\times}10^6$, $2.4{\times}10^6$, $8{\times}10^5$, and $2{\times}10^5{\Omega}{\cdot}cm$. Transmissivity of ITO/ATO film decreases as 89, 88, 86, and 82% with an increasing ITO concentration as 0.1, 0.5, 1.0, and 2.0 wt%.

저렴한 비용으로 도전성 투명 필름을 제조하기 위해 PET 필름 위에 습식 도포법으로 ITO/ATO 막을 적층시켰다. 압력 15 MPa, 온도 $50^{\circ}C$의 SAS 합성 조건으로 ITO를 합성하였으며 ITO의 최적 조성비(In/Sn)는 65, 합성된 ITO의 평균입경은 $15{\pm}2nm$, 표면저항 값은 $4{\times}10^4{\Omega}{\cdot}cm$였다. 도포액은 pH 10에서 제조하였으며 ATO 막의 표면조도(Ra), 표면저항 값, 빛투과율은 각각 9 nm, $5.5{\times}10^6{\Omega}{\cdot}cm$, 91%였다. 일차 도포된 ATO 막 위에 0.1, 0.5, 1.0, 2.0 ITO wt% 첨가한 도포액으로 ITO 막을 적층 제조하였으며, ITO/ATO 적층 필름의 표면조도는 4, 10, 12, 16 nm이였으며 표면저항 값은 각각 $3.7{\times}10^6$, $2.4{\times}10^6$, $8{\times}10^5$, $2{\times}10^5{\Omega}{\cdot}cm$로 측정되었다. 적층 필름의 빛투과율은 각각 89, 88, 86, 82%이였으며 ITO 농도가 높아질수록 빛투과율은 낮아졌다.

Keywords

References

  1. K. L. Chopra, S. Major, and D. K. Pandya, Thin Solid Films, 102, 1 (1983) https://doi.org/10.1016/0040-6090(83)90256-0
  2. Y. H. Kim, Y. S. Kim, and J. B. Gi, J. Ind. Eng. Chem., 10, 739 (2004)
  3. M. Y. Ryu, J. H. Choi, and H. T. Kim, J. Korean Ind. Eng. Chem., 12, 249 (2001)
  4. T. Minami, H. Sonohara, T. Kakumu, and S. Takata, Thin Solid Films, 270, 37 (1995) https://doi.org/10.1016/0040-6090(95)06889-9
  5. W. C. Song, J. of KIEEME, 17, 1277 (2004)
  6. N. S. Murty and S. R. Jawalekar, Thin Solid Films, 108, 277 (1983) https://doi.org/10.1016/0040-6090(83)90075-5
  7. D. F. Lii, J. L. Huang, I. J. Jen, S. S. Lin, and P. Sajgalik, Surf. Coatings Technol, 192, 106 (2005) https://doi.org/10.1016/j.surfcoat.2004.03.025
  8. I. Baia, B. Fernandes, P. Nunes, M. Quintela, and R. Martins., Thin Solid Films, 383, 244 (2001) https://doi.org/10.1016/S0040-6090(00)01589-3
  9. M. Boehme and C. Charton, Surf. Coatings Technol., 200, 932 (2005) https://doi.org/10.1016/j.surfcoat.2005.02.040
  10. J. Lintymer, J. Gavoille, N. Martin, and J. Takadoum, Surf. Coatings Technol., 174, 316 (2003) https://doi.org/10.1016/S0257-8972(03)00413-4
  11. L. J. Meng and F. Placido, Surf. Coatings Technol., 166, 44 (2003) https://doi.org/10.1016/S0257-8972(02)00767-3
  12. J. Sun, B. V. Velamakanni, W. W. Gerberich, and L. F. Francis, J. Colloid Interface Sci, 280, 387 (2004) https://doi.org/10.1016/j.jcis.2004.08.014
  13. B. S Chiou and S. T. Hsieh., Thin Solid Films., 229, 146 (1993) https://doi.org/10.1016/0040-6090(93)90357-U
  14. M. S. Kim, H. D. Lee, and C. K. Kim, J. Ind. Eng. Chem., 12, 430 (2006)
  15. C. Goebbert, R. Nonninger, M. A. Aegertera, and H. Schmidt, Thin Solid Films, 351, 79 (1999) https://doi.org/10.1016/S0040-6090(99)00209-6
  16. P. K. Biswas, A. De, K. Ortner, and S. Korder, Material Letters, 58, 1540 (2004) https://doi.org/10.1016/j.matlet.2003.10.023
  17. E. Reverchon, I. De Marco, G. Caputo, and G. Della Porta, J. Supercrit. Fluids, 26, 1 (2003) https://doi.org/10.1016/S0896-8446(02)00186-9
  18. E. Reverchon, J. Supercrit. Fluids, 15, 1 (1999) https://doi.org/10.1016/S0896-8446(98)00129-6
  19. Y. W. Lee, HWAHAK KONGHAK, 41, 679 (2003)
  20. K. H. Song, C. H. Lee, J. S. Lim, and Y. W. Lee, Korean J. Chem. Eng., 19, 139 (2002) https://doi.org/10.1007/BF02706887
  21. H. Kwak and S. Y. Bae, J. Ind. Eng. Chem., 12, 387 (2006)
  22. L. Hong, J. Guo, Y. Gao, and W. K. Yuan, Ind. Eng. Chem. Res., 39, 4882 (2000) https://doi.org/10.1021/ie000129h
  23. S. D. Yeo, M. S. Kim, and J. C. Lee, J. Supercrit. Fluids, 25, 143 (2003) https://doi.org/10.1016/S0896-8446(02)00094-3
  24. Y. Takahashi, S. Okada, R. B. H. Tahar, K. Nakano, T. Ban, and Y. Ohya, J. Non-Crystalline Solids, 218, 129 (1997) https://doi.org/10.1016/S0022-3093(97)00199-3
  25. H. Bisht, H. T. Eun, A. Mehrtens, and M. A. Aegerter, Thin Solid Films., 351, 109 (1999) https://doi.org/10.1016/S0040-6090(99)00254-0
  26. U. S. Patent 5,602,195 (1997)
  27. C. S. Yang, J. S. Kim, J. W. Choi, M. H. Kwon, Y. J. Kim, J. G. Choi, and G. T. Kim, J. Ind. Eng. Chem, 6, 149 (2000)
  28. M. S. Kim, K. M. Hong, Y. C. Lee, N. K. Kim, and C. K. Kim, Korean J. EHS Assessment, 1, 35 (2003)
  29. H. J. Jeon, M. K. Jeon, M. Kang, S. G. Lee, Y. L. Lee, Y. K. Hong, and B. H. Choi, Materials Letters, 59, 1801 (2005) https://doi.org/10.1016/j.matlet.2005.01.070
  30. C. P. Udawatte and K. Yanagisawa, J. Solid State Chem., 154, 444 (2000) https://doi.org/10.1006/jssc.2000.8863
  31. J. Sun, B. V. Velamakanni, W. W. Gerberich, and L. F. Francis, J. Colloid Interface Sci., 280, 387 (2004) https://doi.org/10.1016/j.jcis.2004.08.014
  32. C. A. Schuh, T. G. Nieh, and T. Yamasaki, T., Scripta Materialia., 46, 735 (2002) https://doi.org/10.1016/S1359-6462(02)00062-3
  33. G. Guzman, B. Dahmani, J. Puetz, and M. A. Aegerter, Thin Solid Films, 502, 281 (2006) https://doi.org/10.1016/j.tsf.2005.07.297