• Transactions of the Society of Information Storage Systems
• /
• v.1 no.2
• /
• pp.155-160
• /
• 2005

In this paper, the channel decoder promising reliable data retrieving in noisy holographic channel has been developed for holographic WORM(write once read many) system. It covers various DSP(digital signal processing) blocks, such as align mark detector, adaptive channel equalizer, modulation decoder and ECC(error correction code) decoder. The specific schemes of DSP are designed to reduce the effect of noises in holographic WORM(H-WORM) system, particularly in prototype of DAEWOO electronics(DEPROTO). For real time data retrieving, the channel decoder is redesigned for FPGA(field programmable gate array) based hardware, where DSP blocks calculate in parallel sense with memory buffers between blocks and controllers for driving peripherals of FPGA. As an input source of the experiments, MPEG2 TS(transport stream) data was used and recorded to DEPROTO system. During retrieving, the CCD(charge coupled device), capturing device of DEPROTO, detects retrieved images and transmits signals of them to the FPGA of hardware channel decoder. Finally, the output data stream of the channel decoder was transferred to the MPEG decoding board for monitoring video signals. The experimental results showed the error corrected BER(bit error rate) of less than $10^{-9}$, from the raw BER of DEPROTO, about $10^{-3}$. With the developed hardware channel decoder, the real-time video demonstration was possible during the experiments. The operating clock of the FPGA was 60 MHz, of which speed was capable of decoding up to 120 mega channel bits per sec.

• Korean Journal of Veterinary Research
• /
• v.44 no.3
• /
• pp.441-448
• /
• 2004

DNase activity in Haemonchus contortus reproductive tissue was characterized and compared to that in whole worm. DNase activity in reproductive tissue was detected throughout pHs 4-10 with high activity under acidic conditions. The activity was not inhibited by 10 mM EDTA at pH 5.0, but largely inhibited by pH 7.0. The activity produced DNA fragments with mixtures of 3'-hydroxyls (OH) and 3'- phosphates (P) at each pH. Three distinct DNase activities were identified and had $M_rs$ of 34, 36 and 38.5 kDa in zymograms, which were distinguished according to pH requirement and sensitivity to EDTA. Among them, the 36 kDa reproductive tissue DNase had predominant activity at pH 5.0, but very weak at pH 7.0, and this activity was not inhibited by EDTA at pH 5.0. These characteristics of the 36 kDa reproductive tissue DNase resemble those of classic acidic DNases. In contrast, 36 kDa whole worm DNase activity had high activity at both pH 5.0 and 7.0. While the 36 kDa DNase activity at pH 5.0 was similar in both reproductive tissue and whole worm samples, the activity at pH 7.0 was predominantly detected in whole worm sample. This suggests that the 36 kDa whole worm DNase at pH 5.0 differs from that at pH 7.0. Thus, results indicate that the EDTA-insensitive 36 kDa DNase at pH 5.0 is specific for H. contortus reproductive tissue.

• Advances in Traditional Medicine
• /
• v.6 no.2
• /
• pp.144-156
• /
• 2006

The effect of aqueous and alcoholic extracts of the fruit, leaf and stem of Melia azedarach Linn. (Meliaceae) on the spontaneous movements of both the whole worm and the nerve-muscle (n.m.) preparation of Setaria (S.) cervi and on the survival of microfilariae in vitro was studied. Alcoholic extracts of fruit, leaf and stem caused inhibition of the spontaneous movements of the whole worm and the n.m. preparation of S. cervi, while only aqueous extract of fruit caused inhibition of the spontaneous movements of the whole worm and the n.m. preparation of S. cervi. The initial stimulatory effect was not observed by the aqueous and alcoholic extracts of fruit on n.m. preparation. The concentrations required to inhibit the movements of the whole worm and n.m. preparation for alcoholic extracts of fruit, leaf and stem were 250, $40\;{\mu}g/ml$; 280, $40\;{\mu}g/ml$ and 270, $25\;{\mu}g/ml$ respectively, whereas an aqueous extract of fruit caused inhibition of whole worm and n.m. preparation at $200\;{\mu}g/ml$ and $40\;{\mu}g/ml$ respectively. Alcoholic extracts of the fruit, leaf and stem and aqueous extract of the fruit of M. azedarach caused concentration related inhibition on the survival of microfilariae (m.f.) of S. cervi. The $LC_{50}$ and $LC_{90}$ as observed after 6 h were found to be 5, 15, 10, 20 ng/ml and 10, 25, 20 and 35 ng/ml, respectively. This work was conducted in view of the exploration of potential antifilarial herbal drug.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.1C
• /
• pp.67-77
• /
• 2007

Virus throttling technique, one of many early worm detection techniques, detects Internet worm propagation by limiting connect requests within a certain ratio. The typical virus throttling controls the period of rate limiter autonomically by utilizing weighted average delay queue length to reduce connection delay time without hanving a large effect on worm detection time. In the existing virus throttling research, a minimum period of variable rate limiter is fired and a turning point which is a point that the period of rate limiter has been being decreased and starts to be increased is also fixed. However, these two performance factors have different effects on worm detection time and connection delay. In this paper, we analyze the effect of minimum period and turning point of variable rate limiter, and then propose an algorithm which determines values of performance factors by referencing current traffic pattern. Through deep experiments, it is verified that the proposed technique is more efficient in respect of reducing worm detection time and connection delay than the existing virus throttling which fixed the performance factors.

• Journal of the Korean Society of Industry Convergence
• /
• v.24 no.5
• /
• pp.589-596
• /
• 2021

In this study, the optimum gating system was designed, and the two zinc alloy worm gears were manufactured in single process by applying a symmetrical gating system with 2 runners. The SRG ratio is set to 1 : 0.9 : 0.6, and the cross-sectional shapes such as sprue, runner and gate are designed. In order to determine whether the design of the gating system is appropriate, casting analysis was carried out. It takes 4.380 s to charge the casting 100%, 0.55 to 0.6 m/s at the gates and solidification begins after the casting is fully charged. The amount of air entrapment is 2% in the left gear and 6% in the right gear. Hot spots occurred in the center hole of the gear, and pores were found to occur around the upper part of the hole. Therefore, the design of the casting method is suitable for worm gears. CT analysis showed that all parts of worm gear were distributed with fine pores and some coarse pores were distributed around the central hole of worm gear. The yield strength and tensile strength were 220 MPa, 285 MPa, and the elongation rate was 8%. Vickers hardness is 82 HV.

• Journal of the Korean Association of Oral and Maxillofacial Surgeons
• /
• v.42 no.2
• /
• pp.67-76
• /
• 2016

Dracunculiasis, otherwise known as guinea worm disease (GWD), is caused by infection with the nematode Dracunculus medinensis. This nematode is transmitted to humans exclusively via contaminated drinking water. The transmitting vectors are Cyclops copepods (water fleas), which are tiny free-swimming crustaceans usually found abundantly in freshwater ponds. Humans can acquire GWD by drinking water that contains vectors infected with guinea worm larvae. This disease is prevalent in some of the most deprived areas of the world, and no vaccine or medicine is currently available. International efforts to eradicate dracunculiasis began in the early 1980s. Most dentists and maxillofacial surgeons have neglected this kind of parasite infection. However, when performing charitable work in developing countries near the tropic lines or other regions where GWD is endemic, it is important to consider GWD in cases of swelling or tumors of unknown origin. This paper reviews the pathogenesis, epidemiology, clinical criteria, diagnostic criteria, treatment, and prevention of dracunculiasis. It also summarizes important factors for maxillofacial surgeons to consider.

• Proceedings of the KIEE Conference
• /
• 2004.11c
• /
• pp.184-186
• /
• 2004

This paper is about vision system that exhibits automatic examination of the conditions of shaft's worm. The system is composed of three part : image acquisition, vision algorithm, and user interface. The image acquisition part is composed of motor control, illumination and optics. The vision algorithm examines the parts by labeling algorithm using shaft image. User interface is divided into two parts, user interface for feature registering with control value settings and user interface for examination operation. The automatic inspection system of this research is a tool for final examination of shaft worm. This tool can be practically used in production lines with simple adjustments.

• Journal of Power System Engineering
• /
• v.20 no.1
• /
• pp.57-62
• /
• 2016

In this study, design the core part of the driving of the robot. The power of the driving is window motor for automobiles obtained by using a method of directly to the motor shaft of the worm gear type. The decelerator consists of a worm gear to receive power from the motor shaft, Helical gear contact to worm gear, a pinion gear to be connected in line with the helical gear, and an output shaft to be engaged to the pinion gear. Drive system by using the power from the motor shaft based on the deceleration gear designed by the gear ratio set by the gear teeth increases the torque.

• International Journal of Control, Automation, and Systems
• /
• v.4 no.1
• /
• pp.87-95
• /
• 2006

The outlet feeder pipe thinning in a PHWR (Pressurized Heavy Water Reactor) is caused by a high pressure steam flow inside the pipe, which is a well known degradation mechanism called a FAC (Flow Assisted Corrosion). In order to monitor the degradation, the thickness of the outlet bends close to the exit of the pressure tube should be measured and analyzed at every official overhaul. This paper describes a mobile feeder pipe inspection robot that can minimize the irradiation dose to human workers by automating the measurement process. The robot can move by itself on the feeder pipe by using an inch worm mechanism, which is constructed by two gripper bodies that can fix the robot body on to the pipe, one extendable and contractible actuator, and a rotation actuator connected to the two gripper bodies to move forward and backward, and to rotate in a circumferential direction.

• 제어로봇시스템학회:학술대회논문집
• /
• 2005.06a
• /
• pp.346-351
• /
• 2005

The outlet feeder pipe thinning in a PHWR (Pressurized Heavy Water Reactor) is caused by high pressure steam flow inside the pipe, which is a well known degradation mechanism called FAC (Flow Assisted Corrosion). In order to monitor the degradation, the thickness of the outlet bends closed to the exit of the pressure tube should be measured and analyzed at every official overhaul. This paper develops a mobile feeder pipe inspection robot that can minimize the irradiation dose of human workers by automating the measurement process. The robot can move by itself on the feeder pipe by using an inch worm mechanism, which is constructed by two gripper bodies that can fix the robot body on the pipe, one extendable and contractable actuator, and a rotation actuator connected the two gripper bodies to move forward and backward, and to rotate in the circumferential direction