• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.12 no.1
• /
• pp.364-370
• /
• 2011

The Hilbert transform performs a role to transform band pass signals into low pass signals in wireless communication systems. The operation of Hilbert transform is based on a convolution process which is required adding and multiplying calculations. When the Hilbert transform is designed and hardware-implemented at gate level, the adding and multiplying operation requires a high power consumption and a occupation of wide area on a chip. So the results of adding and multiplying operation cause to degrade the performance of implemented system. In this paper, the new Hilbert transformer is proposed, which has a low hardware complexity by application of MAG(Minimum Adder Graph) algorithm. The proposed Hilbert transformer was simulated in ISE environment of Xilinx and showed the reduction of hardware complexity comparing with the number of gate in the conventional Hilbert transformer.

• Journal of Advanced Navigation Technology
• /
• v.13 no.3
• /
• pp.327-336
• /
• 2009

This paper analysis the STDMA protocol in aviation wireless data communications and carry out the performance analysis with simulation. The STDMA protocol that is currently being used in VDL Mode-4 has TDMA system characteristics, which provides time-division into several slots per one frame. The results of modeled STDMA protocol's data channel analysis show approximate 0.7 channel throughput at the transmission probabilities 0.045, 0.2, and 0.3 in the aspects of channel throughput. The delay time are 2.32434sec, 2.0293sec, and 2.12128sec respectively. These results shows the good stability in spite of variable transmission probabilities. Consequently, it is expected that STDMA protocol would be used properly for domestic communication demands and supervision system improvement by means of applying this to point-to-point communication and data/location broadcasting as a fundamental technology in CNS/ATM.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2007.06a
• /
• pp.205-208
• /
• 2007

Due to the development and wide use of digital multimedia broadcasting (DMB) and Wireless Broadband Internet (WiBro), the digital contents industry using images has been progressed. Therefore, the image processing has been applied in a variety of fields and in order to transmit and conserve accurate information, the degradation phenomenon for images should be removed. As a representative cause of the degradation phenonenon, noise has become known and Gaussian noise occurs in the process of transmission. Diverse researches for Gaussian noise removal have been implemented and a great number of algorithms have been proposed until now. In this paper, for mage restoration an algorithm using the adaptive threshold value is proposed in Gaussian noise environment and the threshold value is established by using the histogram of edge image. And from simulation results, the noise removal performance of the proposed method is proven using mean square error (MSE) and peak signal to noise ratio (PSNR).

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.12B
• /
• pp.1058-1067
• /
• 2006

In this paper, we propose a inband/outband broadcast method for hidden incumbent system detection of medium access control layer for wireless regional area network systems using cognitive radio technology. Through some extra channels that are not currently used, a short message is broadcasted. The message allows CPE detecting an appearance of incumbent system to send sensing report to CR BS. For the hidden incumbent system report message, the BS needs a process or method for allocation of upstream resource to CPEs. And transmitting multiple out-band signals has a possibility to collide with out-band signals of other co-located WRAN BSs. To avoid out-band signal collision, BSs randomly select it out-band signal broadcasting time within the pre-defined explicit out-band signaling, period. And fractional Bandwidth Usage allows WRAN BSs to efficiently use bandwidth.

• Journal of Communications and Networks
• /
• v.11 no.1
• /
• pp.84-93
• /
• 2009

This paper focuses on message complexity performance analysis of mobile ad hoc network (MANET) address autoconfiguration protocols (AAPs) in reference to link errors generated by mobile wireless nodes. An enhancement was made using a proposed retransmission limit, S, to be computed for error recovery (based on the link error probability), to measure message complexity of AAPs in reference to the link error probability, $P_e$. The control procedures for the retransmission limit have been included for each of the AAPs. Retransmission limit control is critical for efficient energy consumption of MANET nodes operating on limited portable energy. O-notation has been applied to analyze the upper bound of the number of messages generated by a MANET group of nodes. The AAPs investigated in this paper are strong duplicate address detection (DAD), weak DAD with proactive routing protocol (WDP), weak DAD with on-demand routing protocol (WDO), and MANETConf. Each AAP reacts different to link errors, as each AAP has different operational procedures. The required number of broadcasting, unicasting, relaying, and received messages of the nodes participating in a single-node joining procedure is investigated to asymptotically calculate the message complexity of each AAP. Computer simulation was conducted and the results have been analyzed to verify the theoretical message complexity bounds derived. The message complexity of WDP was lowest, closely followed byWDO, based on the simulation results and analysis of the message complexity under nominal situations. The message complexity of MANETConf was higher than WDO, and strong DAD resulted to be most complex among the four AAPs.

• Journal of Information Processing Systems
• /
• v.7 no.2
• /
• pp.221-240
• /
• 2011

Vehicular networks are a promising application of mobile ad hoc networks. In this paper, we introduce an efficient broadcast technique, called CB-S (Cell Broadcast for Streets), for vehicular networks with occlusions such as skyscrapers. In this environment, the road network is fragmented into cells such that nodes in a cell can communicate with any node within a two cell distance. Each mobile node is equipped with a GPS (Global Positioning System) unit and a map of the cells. The cell map has information about the cells including their identifier and the coordinates of the upper-right and lower-left corner of each cell. CB-S has the following desirable property. Broadcast of a message is performed by rebroadcasting the message from every other cell in the terrain. This characteristic allows CB-S to achieve an efficient performance. Our simulation results indicate that messages always reach all nodes in the wireless network. This perfect coverage is achieved with minimal overhead. That is, CB-S uses a low number of nodes to disseminate the data packets as quickly as probabilistically possible. This efficiency gives it the advantage of low delay. To show these benefits, we give simulations results to compare CB-S with four other broadcast techniques. In practice, CB-S can be used for information dissemination, or to reduce the high cost of destination discovery in routing protocols. By also specify the radius of affected zone, CB-S is also more efficient when broadcast to a subset of the nodes is desirable.

• KSCI Review
• /
• v.14 no.2
• /
• pp.165-174
• /
• 2006

This paper is a matter of remote control apparatus and display remote control system comprising the same. The remote controller is a wireless remote pointing device that is included a function of mouse and a function of remote controller for VOD etc. It is assembled a sending signal part to communicate with display device, a image sensor part to capture a seen of front view and a main body. Also, it includes a control part that analyzes the captured image, calculates a relative moving factor that main body is moved by user, and then controls the mouse cursor on the display device. The remote control apparatus is able to capture a seen of front view, to analyze the captured image, and to move a mouse cursor point on the display device as much as it calculated relative moving factor. Therefor it brings down the cost of production by a product design that is increased user satisfaction. And it, using the patent and the new product design, will make an epoch in development of the remote control system for Ubiquitous broadcasting industry.

• International Commerce and Information Review
• /
• v.12 no.3
• /
• pp.55-78
• /
• 2010

This study analyses recent development of digital contents industry. The purpose of this study is to show how the convergence phenomenon is occurring in the digital contents industry. Furthermore, this study examines the influence of digital convergence on the digital contents industry. The characteristics of the digital contents industry falls roughly into three features. To begin with, technical aspect of the industrial feature is that digitalized contents can be used in various digital devices, namely OSMU(One Source Multi Use). The second feature is related to protection of copyright against illegal file sharing and downloading. One final point is that platform for distribution channels has been universal by digital convergence. To sum up, the notable feature of digital contents industry is high value-added. Also, digital contents industry is composed of users, digital device, network, and universal contents. Users are the key component of digital contents industry, who is distinguished from consumers. Digital devices such as mobile phone, PDA can play all kinds of digital contents and make users communicate in two-ways. Portable devices also allow the users to consume digital contents at any place. Digital contents can be distributed by both wire and wireless networks. And most of transactions can be made through networks. There are three key issues about digital convergence. Entry barriers for market become lowered; the age of contents users is changed from old generation to young generation. And the form of contents devices is changing rapidly. Traditional contents field such as movie, music, broadcasting, publishing, animations are combined into one digital contents territory. As a result, this paper suggests that digital convergence phenomenon will be accelerating for the future. According to the result of this study, the advent of digital convergence and e-Commerce will have significant influence on trade of digital contents.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.1
• /
• pp.38-46
• /
• 2011

In this paper, we propose a calculation methodology of the service distance to assure the satisfactory quality of service for analogue and digital TV receivers. Using the field strength formulation for TV receiver based upon Rec. ITU-R P.1546, computational results are presented and discussed for both systems, and some important factors are reviewed in terms of the equivalent level of service, which must be kept due to ATV to DTV conversion. The presented method provides the predicted values of field strength at receiver areas to check whether transmission quality can be satisfied or not, and it can be also used for obtaining the protection ratio or separated distance from co-channel or adjacent interference signal.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.9 s.351
• /
• pp.60-68
• /
• 2006

Using the wireless communication among unacquainted vehicles, an intelligent vehicle safety system can be constructed to exchange vehicle safety-related information, such as urgency stop, traffic accident and road obstacles. In the majority of vehicle safety applications, vehicle safety messages are propagated in the form of broadcast. However, this approach causes some effectiveness and performance problems with massive radio collision, multi-hop propagation. This paper presents a priority based relay node selection method for propagating vehicle safety messages of traffic accident protection system. With this method, vehicle safety messages are relayed by a node that locates in proper distance out of the nodes that are included in the radio transmission range. By decreasing the number of duplicated messages, the packet overhead is lessened while the communication performance is raised. The proposed method was proven to be better than other schemes through network simulations.