• Phonetics and Speech Sciences
• /
• v.9 no.3
• /
• pp.85-91
• /
• 2017

The present study aimed to investigate the changes of acoustic parameters of the aspirated voice in stroke patients. The eighty-eight subjects diagnosed with cerebro-vascular accident were divided into 32 penetration/aspiration (P/A) and 56 Non-P/A groups according to the videofluroscopic swallowing study (VFSS) results, and 26 control subjects participated. All subjects preformed VFSS and vowel /a/ was recorded three times pre- and post VFSS. Since the variation in the acoustic parameters within a single phonation has been observed, we proposed a delta formula for the acoustic parameters which can reflect the temporal changes of the each parameter in an utterance. We measured from the voice data eight acoustic parameters: fundamental frequency (F0), standard deviation of F0 (F0_SD), Jitter, relative average perturbation (RAP), Shimmer, amplitude perturbation quotient (APQ), harmonic to noise ration (HNR), noise to harmonic ratio (NHR). Then we found parameters which show the meaningful biggest temporal change in an utterance using the suggested delta parameter. Among them, the deltas of shimmer and APQ were significantly different pre- and post VFSS. These deltas of the P/A and the control group were increased after VFSS, while those of the Non-P/A group was descended. The variation patterns of the P/A and the control group were similar but the change width of the P/A group was larger. The large variations in an aspirated phonation of the P/A group are thought to be caused by irregular changes in air resistance due to residual food on the vocal cords.

• Journal of the Korean Academy of Clinical Electrophysiology
• /
• v.8 no.1
• /
• pp.51-56
• /
• 2010

Purpose : This study identifies the effect of ankle-taping on limb asymmetry, postural sway and lumbar flexibility. Ankle-taping was applied for participants of this study and the results were compared to the control group. Methods : This study targets 46 adults, in which 25 composed the test group and 21 composed the control group. All participants were interviewed. For the test group, inflexible tapes of 5mm width were applied as designed by Danaka Nobudaka while the tapes for the control group were arranged in a symmetric direction to the direction of the test group. Postural balance was measured using Mediance (Human Tech Inc, Korea) and to identify lumbar flexibility, the trunk flexion is targeted. Results : 1. The postural inclination of both the groups decreased, but a statistically significant difference is not found (p>0.05). 2. Both the groups increased, but no statistically significant difference is found (p>0.05). 3. Both the groups increased, and a statistically significant change is found (p<0.05). Conclusion : As demonstrated in the results above, ankle taping is effective for lumbar flexibility as well as stability of ankle joints regardless of the direction of taping. It also suggests that ankle taping is helpful for health management of athletes and the public. However, as the results are limited in that they were obtained 10 minutes after taping, it is hoped that further studies will follow.

• Journal of IKEEE
• /
• v.19 no.1
• /
• pp.118-123
• /
• 2015

According to the recent report, solar street lamp connected to a non Maximum Power Point Tracking(MPPT) charger, can lead to a system-wide decline in power output with as much as 30%. This paper proposes the charge controller with direct duty ration control for 250W solar street lamp in order to improve the efficiency of photovoltaic from these output power reduction. This paper covers the Pulse Width Modulation(PWM) controller and power conversion topology and analyze the MPPT method for charge controller. The power conversion part consists of push pull converter based on PWM controller using 8bit MCU in order to have lower manufacturing cost. The PWM controller with direct duty ratio control algorithm is constantly tracking the maximum power point of photovoltaic module and increases energy output power. The test results shows 97.1~97.4% MPPT efficiency and the experimental hardware is implemented based on the solar simulator condition for 241W. Thus, the implemented charge controller shows its feasibility for the real application, especially under solar street lamp.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.29 no.4
• /
• pp.250-254
• /
• 2016

Currently, power conversion system which converts AC to DC Power is applied in domestic urban railway. The diode rectifier is used in most of them. However the diode rectifier can not control the output voltage and can not regenerate power as well. On the other hand, PWM (pulse width modulation) converter using IGBT (isolated gate bipolar transistor) can control output voltage, allowing it to reduce the output voltage drop. Moreover the Bi-directional conduction regenerates power which does not require additional device for power regeneration control. This paper compared the simulation results for the DC power supply system on both the diode rectifier and the PWM converter. Under the same load condition, simulation circuit for each power supply system was constructed with the PSIM (performance simulation and modeling tool) software. The load condition was set according to the resistance value of the currently operating impedance of light rail line, and the line impedance was set according to the distance of each substations. The train was set using a passive resistor. PI (proportional integral) controller was applied to regulate the output voltage. PSIM simulation was conducted to verify that the PWM Converter was more efficient than the diode rectifier in DC Traction power supply system.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.13 no.6
• /
• pp.453-460
• /
• 2008

This paper proposes a new multi-output LLC resonant converter by using single control IC, which has the tight-regulated dual output voltage without additional power devices and controller. The proposed converter has master and slave outputs, of which regulations are achieved by the PWM(pulse width modulation) and PFM(pulse frequency modulation), respectively. Different from the conventional dual-output LLC resonant converter, the proposed converter has no additional post-regulators like a boost converter. Therefore, it features a low cost, small size, and high efficiency. To confirm the validity and prove the superiority of proposed converter, simulated and experimental results on a 50" FHD PDP power set prototype are presented.

• Journal of The Korean Society of Integrative Medicine
• /
• v.8 no.2
• /
• pp.97-107
• /
• 2020

Purpose : The purpose of this study is to investigate the effect of squat exercise using a ball on the gap between knees and Q angle of a subject with a genu-varum, and to prove the effect, to provide a clinical basis for developing into a knee correction exercise program. Methods : As a result of posture measurement through GPS, 26 female with genu-varum with a knee length of 5 cm or more were studied. The group was randomly assigned to 13 squat exercise group using ball (experimental group) and 13 general squat exercise groups (control group). The experimental group placed the ball between both knees in a position where the distance between both feet was slightly wider than the shoulder width on a flat support surface, and fixed the ball, and then squat with the start signal. The control group squats without a ball. Each group performed three sets of exercise three times a week for six weeks. Before their exercise, after three and six weeks, EMG, GPS, digital goniometer measurement, the vastus medialis (VM), the vastus lateralis (VL), and the Q-angle were measured in the squat exercise posture. EMG was measured in squat exercise posture. Results : The distance between the knees was reduced. EMG is activated in group A, the group B experimental results showed the high activity of the VL. Q-angle had increased. But the experimental group increased more than the control group. Conclusion : We have confirmed through our experiments that the distance interval between the knees during squat exercises using a ball can be reduced. Furthermore, it would also be helpful to ensure the treatment of genu-varum.

• Korean Journal of Environmental Agriculture
• /
• v.27 no.4
• /
• pp.356-361
• /
• 2008

Chrysanthemum indicum L. (Gamgug) has been examined to study their flowering habits, yields and bioactive compounds under different planting densities and mowing dates. The planting density experiment revealed a significantly increasing stem diameter, number of flowers and branches with decreasing plant density in the $100\;cm{\times}30\;cm$ and $130\;cm{\times}30\;cm$ treatments as compared to $70\;cm{\times}30\;cm$ treatments, but not plant height, leaf and flower width. On the other hand, the mowing date experiment showed that growth characteristics of plants were similar to the control plants (not mowing) and June 20 treatment, but July 20 treatments had significantly smaller than the control. The weights (g $plant^{-1}$) of dry flowers were affected by the planting density and mowing date. The flower yield of $586\;kg\;ha^{-1}$ obtained at $100\;cm{\times}30\;cm$ density was 11% and 22% higher than that of $120\;cm{\times}30\;cm$ and $70\;cm{\times}30\;cm$ treatments, respectively. The yield of dry flowers in the control and June 20 mowing date ranged $495-508\;kg\;ha^{-1}$, which is 40-42% higher than the yield in the July 20 treatments. The amount of essential oil (g $plant^{-1}$) in medically valuable flowerheads of C. indicum L. was statistically different between mowing dates but not among planting densities. The study showed that planting density and the mowing date could increase yields of flowerheads. An optimum planting density of $100\;cm{\times}30\;cm$ and mowing date of on or before June 20 is recommended for C. indicum L.

• Journal of Life Science
• /
• v.15 no.3 s.70
• /
• pp.499-504
• /
• 2005

This experiment was conducted to identify the effect of several plant growth retardants on growth of Sedirea japonica seedlings cultured in vitro and their changes of invertase activities. When seedlings of Sedirea japonica were treated with ancymidol and paclobutrazol, as the concentrations were increased, leaf length was gradually shortened and leaf width became wider than that of control. On the other hand, root length was shorter, but the number of root and the root's diameters were greatly increased, compared with control. In 0.05mg/L uniconazole, growth of leaf and root were enhanced, compared with the control and higher concentrations of uniconazole. As concentration of each growth retardants was increased, leaf shape became round and smaller. Both soluble acid invertase activity and soluble alkaline invertase activity in leaf were decreased in higher concentrations of each growth retardant, but those of the root were contrary to those of the leaf. To confirm the estimated invertase activities, starch content of leaf was higher in low concentration treatments in each growth retardant, but in the root was contrary to content that of the leaf.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.18 no.6
• /
• pp.139-146
• /
• 2014

Recently, in field of bridge construction, modular technology has been studied to reduce construction period, traffic impact and environmental impact. This study is a part of research related to the modular bridges. The aim of the study is to analyze the structural behavior and evaluate a serviceability for transverse connection of modular slab bridge. A total of four specimens were fabricated. including a control beam for finding the maximum load by static test. And one control beam and two segmental beams were fabricated for cyclic loading test. As the test result, the beams that were introduced 100% of the design prestressing force showed a smaller maximum deflection, residual deflection and crack width than the control beam. The beam for serviceability evaluation was satisfied with structural serviceability limits of the deflection and crack.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.06a
• /
• pp.512-513
• /
• 2008

The study examined what effects 100kHz PWM LED light irradiation causes to bone marrow cells of SD-Rat when LED characterized cheap and safe is used onto the light therapy by replacing the low 1evel laser. We developed the equipment palpating cell proliferation using a high brightness LED. This equipment was fabricated using a micro-controller and a high brightness LED, and designed to enable us to control light irradiation time, intensity, frequency and so on. Especially, to control the light irradiation frequency, FPGA was used, and to control the change of output value, TLC5941 was used. Consequent1y, the current value could be controlled by the change of 1eve1 in Continue Wave(CW) and Pulse Width Modulation(PWM), and the output of a high brightness LED could be controlled stage by stage. MTT assay method was chosen to verify the cell increase of two groups and the effect of irradiation on cell proliferation was examined by measuring 590nm transmittance of ELISA reader. As a result, the cell increase of Rat bone marrow cells was verified in 100kHz PWM LED light irradiation group as compared to non-irradiation group.