• Structural Engineering and Mechanics
• /
• v.57 no.6
• /
• pp.1085-1105
• /
• 2016

The drainage problem in bifurcations causes pecuniary losses when hydropower stations are undergoing periodic overhaul. A new design philosophy for Y-typed bifurcations that are flat-bottomed is proposed. The bottoms of all pipe sections are located at the same level, making drainage due to gravity possible and shortening the draining time. All fundamental curves were determined, and contrastive analysis with a crescent-rib reinforced bifurcation in an actual project was conducted. Feasibility demonstrations were researched including structural characteristics based on finite element modeling and hydraulic characteristics based on computational fluid dynamics. The new bifurcation provided a well-balanced shape and reasonable stress state. It did not worsen the flow characteristics, and the head loss was considered acceptable. The proposed Y-typed bifurcation was shown to be suitable for pumped storage power stations.

• Journal of Korea Water Resources Association
• /
• v.53 no.10
• /
• pp.861-870
• /
• 2020

As the flow velocity and Reynolds number increase in rockfill porous media, the flow deviates from Darcy conditions. In this study, the permeability tests of rock column specimen and laboratory gabion weir model were carried out to investigate a head loss behaviour of flow through rockfill deposition in small river artificial recharge. Through column test, the nonlinear relationships between flow velocity and hydraulic gradient and coefficients were determined and the correlation formula of hydraulic mean radius and coefficients was proposed. The flow velocities and discharges in voids estimated by proposed equations were well matched with the measured values of laboratory gabion weir model.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.14 no.1
• /
• pp.251-258
• /
• 1990

Optimal design of heat exchanger for closed CO$_{2}$ gas turbine plant of three processes selected from the result of cycle analysis have been discussed previously paper(I) has been carried out under specified inlet and outlet conditions. Independent variables such as number of parallel connection, tube diameter, shell side and tube side pressure loss as well as dependent variables such as shell diameter, number of tubes, number of serial connections were all characterized according to the standardization or so. Search method was used to construct a computer simulation together with the calculation of heat transfer rate by logarithmic mean temperature difference method. Strength analysis of major parts was carried to examine their dimensions satisfying heat transfer and pressure loss requirements.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.37 no.9
• /
• pp.1117-1125
• /
• 2013

A finite element based approach that can be used to investigate the plane-view shape and crop loss of a material during plate rolling is presented. We employed a three-dimensional finite element model to continuously simulate the shape change of the head and tail of a plate as the number of rolling passes increases. The main feature of the proposed model lies in the fact that the multistage rolling can be simulated without a break because the rolling direction of the material is reversibly controlled as the roll gap sequentially decreases. The material constants required in the finite element analysis were experimentally obtained by hot tensile tests. We also performed a pilot hot plate rolling test to verify the usefulness of the proposed finite element model. Results reveal that the computed plane-view shapes as well as crop losses by the proposed finite element model were in good agreement with the measured ones. The crop losses predicted by the proposed model were within 5% of those measured from the pilot hot plate rolling test.

• Journal of Veterinary Clinics
• /
• v.38 no.6
• /
• pp.299-304
• /
• 2021

A 3-year-old female Connemara pony was referred to Jeju National University Equine Hospital because of weight loss and prolonged anorexia. On admission, heart and respiratory rates were slightly elevated while body temperature was within the normal range. The color of the conjunctival and oral mucosa was yellowish pink. The blood chemistry results showed that total bilirubin, aspartate aminotransferase, and gamma-glutamyl transferase levels were remarkably elevated while blood urea nitrogen was within the reference range. Transcutaneous abdominal ultrasound revealed an enlarged right lobe of the liver with prominently increased parenchymal echogenicity, reduced hepatic vessels, and rounded caudal border. The pony was tentatively diagnosed with chronic hepatitis and icterus; rest and supportive treatments were provided. Clinical signs aggravated on day 2 with hind quarter paresis and cranial nerve signs such as circling, drooping, jerking, and head pressing against walls. Recumbency and generalized ataxia (grade 5/5) were shown on day 3. Plasma ammonia concentration on day 3 was as high as 656 µmol/L. Necropsy and histopathologic examinations strongly supported a diagnosis of hepatic encephalopathy. This case of hepatic encephalopathy exhibited rapid progress from low to terminal grade within 4 days in a Connemara pony. The results provide well-established clinical and pathological data for future application.

• The Journal of Engineering Geology
• /
• v.34 no.2
• /
• pp.217-228
• /
• 2024

During deep drilling, confined aquifers can present various challenges such as the inability to remove cuttings, rapid groundwater influx, and mud loss. Particularly in flowing well conditions, it is essential to apply the suitable mud density since the aquifer can generates an overpressurized condition. This paper proposes a method for determining the suitable mud density while drilling (SMD) through confined aquifers using mud window analysis and applies it to a case study. The minimum mud density at each depth, which represents the lower limit of the mud window, is determined by the equivalent mud density pore pressure gradient (or by adding a trip margin) at that depth. The pore pressure gradient of a confined aquifer can be calculated using the piezometric level or well head pressure of the aquifer. As the borehole reaches the confined aquifer, there is a significant increase in pore pressure gradient, which gradually decreases with increasing depth. The SMD to prevent a kick can be determined as the maximum value among the minimum mud densities in the open hole section. After entering the confined aquifer, SMD is maintained as the minimum mud density at the top of the aquifer during the drilling of the open hole section. Additionally, appropriate casing installation can reduce the SMD, minimizing the risk of mud loss or invasion into the highly permeable aquifer.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.8
• /
• pp.709-716
• /
• 2016

In this paper, A duplexer module with temperature-insensitive electrical characteristics was proposed for remote wireless communication system. Duplexer modules are required to have performances of low insertion loss, high isolation between transmitted band and received band, harmonic suppression as well as high power durability in the system for transmitting guided information to missile flying a free space on the ground. The proposed duplexer module are consist of transmission bandpass filter and receiving bandpass filter which are connected to common antenna port, planar coupler for output power monitoring and low pass filter for harmonic attenuation of power amplifier and coaxial cavity resonator. The material and dimensions of the resonator are determined for minimum frequency shift by temperature variation using 3D EM simulation. The measured results of the prototype showed a good agreement with the simulation results, and it should be well applied not only for guided weapon systems but also for any other communication systems such as remote radio head.

• Korean Security Journal
• /
• no.41
• /
• pp.67-96
• /
• 2014

Today each country in the world goes beyond the narrow concept of national security that was limited to national defense and ideology and are entering multi-dimensional global system mainly based on economic profits. Nevertheless, conflicts between nations due to religious and ideological reasons have brought unprecedentedly intense disputes Security services for head of states have been an important national mission in every era and society. However, they are becoming a main target for assassination and attacks by terrorists. Attacks on the head of state and other VIPs can cause aftermath ranging from war to conflict situation, political crisis, and economic loss. Therefore this study aims to draw insights by comparing protective security units of Korea, the U.S., and Japan which have different legal basis and sociocultural characteristics. Especially in South Korea, which faces difficult diplomatic stance due to the tension with North Korea and relationship with other countries such as the U.S., China, and Russia as well as polarization between classes, generations, regions, and ideologies, cohesion among members of society has weakened and hatred toward the head of state has been brought, which emphasizes the important of national security services. Therefore the study of protective security units and its operation by comparison between neighboring countries will be able to bring insights on the promotion of the security service.

• Journal of Environmental Impact Assessment
• /
• v.22 no.3
• /
• pp.241-254
• /
• 2013

The nutria(Myocastor coypus) that is originated from South America is a representative Invasive alien species in Korea. invasive alien species is one of the biggest causes for the loss of biodiversity and it may threaten the conservation and function of ecology as well as the welfare of mankind. Intense habitation has been made around the Nakdong River basin area that this study has analyzed the habitat density of nutria for the subject of 3 survey sites in the Nakdong River basin area. As a result of survey on habitation density in 2011 and 2012, under St.1 it was shown $2.01{\pm}0.21$/ha in 2011 and $0.69{\pm}0.55$/ha in 2012. Under St.2, it was shown $0.91{\pm}0.37$/ha in 2011 and $0.55{\pm}0.39$/ha in 2012. Under St.3, it was shown $5.31{\pm}0.72$/ha in 2011 and $3.99{\pm}2.31$/ha in 2012. The wet survey areas of St.1 and St.3 had shown relatively high habitation density compared to St. 2, the river survey area, and the average annual habitation density of the survey area was $2.74{\pm}2.29$/ha in 2011 and $1.74{\pm}1.18$/ha in 2012 that it has shown slightly reducing trend. As a result of measuring the morphology by capturing the habitation individuals, the average body length of adults is $92.23{\pm}9.41cm$, the length from the head to body for $53.90{\pm}5.15cm$, tail length for $38.33{\pm}4.83cm$, hind foot length for $13.82{\pm}1.00cm$, front foot length for $6.02{\pm}0.56cm$, and weight for $5.48{\pm}1.08kg$. As a result of comparing the types between genders, male showed a slightly higher figure in all parts compared to female and it showed significantly difference in total body length, head-body length, front foot length and total weight. As a result of analysis for each head-body length, other measured parts, weight and relativity for each measured part, all bodily part is shown to have the higher volume of correlations. The condition index of individuals in the survey area was shown in the average of $35.67{\pm}4.78$ with female for an average of $36.60{\pm}5.19$ and male for an average of $34.73{\pm}4.34$. The winter temperature in the southern area of Korea is considered for not greatly impacting on the habitation and development of nutria that, if there is no artificial control, it is considered to have certain concern of showing drastic breeding and territory expansion for the habitation group.

• Asian Pacific Journal of Cancer Prevention
• /
• v.13 no.6
• /
• pp.2629-2633
• /
• 2012

Background: Raw betel nut (RBN) chewing is an important contributing factor for esophageal squamous cell carcinoma (ESCC), although associated genomic changes remain unclear. One difficulty in assessing the effects of exclusively RBN induced genetic alterations has been that earlier studies were performed with samples of patients commonly using tobacco and alcohol, in addition to betel-quid. Both CDKN2A (at 9p21) and Rb1 gene (at 13q14.2) are regarded as tumor suppressors involved in the development of ESCC. Therefore, the present study aimed to verify the RBN's ability to induce ESCC and assess the involvement of CDKN2A and Rb1 genes. Methods: A panel of dinucelotide polymorphic markers were chosen for loss of heterozygosity studies in 93 samples of which 34 were collected from patients with only RBN-chewing habit. Promoter hypermethylation was also investigated. Results: Loss in microsatellite markers D9S1748 and D9S1749, located close to exon $1{\beta}$ of CDKN2A/ARF gene at 9p21, was noted in 40% ESCC samples with the habit of RBN-chewing alone. Involvement of a novel site in the 9p23 region was also observed. Promoter hypermethylation of CDKN2A gene in the samples with the habit of only RBN-chewing alone was significantly higher (p=0.01) than Rb1 gene, also from the samples having the habit of use both RBN and tobacco (p=0.047). Conclusions: The data indicate that the disruption of 9p21 where CDKN2A gene resides, is the most frequent critical genetic event in RBN-associated carcinogenesis. The involvement of 9p23 as well as 13q14.2 could be required in later stages in RBN-mediated carcinogenesis.