• 한국분무공학회지
• /
• 제29권3호
• /
• pp.134-139
• /
• 2024

An experimental study was conducted on the film boiling of nanofluid droplets at a surface temperature range of 300 to 500℃. The nanofluid was made by mixing pure water with copper oxide powder of diameter of 80 nm. The initial volume of the nanofluid droplet ranged from about 21 to 44 ㎕, and the volume, base diameter, and time were measured during the evaporation process. It was found that nanofluid droplets evaporate faster as the surface temperature increases. Also experimental results showed the droplets evaporate quickly at the beginning of evaporation, but as the volume of the droplets decreases, the evaporation rate gradually slows down, and this trend becomes stronger as the surface temperature increases. In addition, the evaporation rate of nanofluid droplets was slightly faster than that of pure water droplets, this was believed to be because the contact area of nanofluid droplets increased.

• Journal of Microbiology and Biotechnology
• /
• 제23권3호
• /
• pp.335-342
• /
• 2013

In this study, we compared the performance of two control systems, fuzzy logic control (FLC) and conventional control (CC). The control systems were applied for controlling temperature and substrate moisture content in a solidstate fermentation for the biosynthesis of amylase and protease enzymes by Aspergillus oryzae. The fermentation process was achieved in a 200 L rotating drum bioreactor. Three factors affecting temperature and moisture content in the solid-state fermentation were considered. They were inlet air velocity, speed of the rotating drum bioreactor, and spray water addition. The fuzzy logic control system was designed using four input variables: air velocity, substrate temperature, fermentation time, and rotation speed. The temperature was controlled by two variables, inlet air velocity and rotational speed of bioreactor, while the moisture content was controlled by spray water. Experimental results confirmed that the FLC system could effectively control the temperature and moisture content of substrate better than the CC system, resulting in an increased enzyme production by A. oryzae. Thus, the fuzzy logic control is a promising control system that can be applied for enhanced production of enzymes in solidstate fermentation.

• 한국분무공학회지
• /
• 제26권3호
• /
• pp.127-134
• /
• 2021

Fire sprinkler initial spray was analyzed by Large eddy simulation (LES) and Volume of Fluid (VoF) integrated method. The IsoAdvector geometric VoF was used to identify the liquid-gas interface clearly even with the large Courant-Friedrichs-Lewy number. To reduce the computational costs, sector meshes and Adaptive Mesh Refinement up to level 3 were used. Base mesh size was 1 mm, which is roughly equivalent to the initial sprinkler droplet. Top surface radius of boss and deflector size were modified to investigate the effects of sprinkler head design on primary breakup process. When top surface radius of boss was increased, vertical liquid sheet was formed. This phenomenon reduced the sheet breakup radius, sheet thickness and velocity. Due to reduced liquid sheet thickness, a large amount of ligaments was created from the liquid sheet. As a result, there was a dramatic decrease in volume per surface area, indicating an increase in breakup process. Spray pattern viewed in radial direction also changed when top surface radius of boss increased. When top surface radius of boss was increased, a T-shaped pattern was observed while a V-shaped pattern was observed in all other cases. When the deflector size increases, the spray pattern remains V-shaped, even if the top surface radius of boss increased. Further studies on promoting atomization of the water supplied to the lower part of the sprinkler head in the T-shape pattern should be conducted.

• The Plant Pathology Journal
• /
• 제24권3호
• /
• pp.283-288
• /
• 2008

Plant leaf surface is an important niche for diverse epiphytic microbes, including bacteria and fungi. Plant leaf surface plays a critical frontline defense against pathogen infections. The objective of our study was to evaluate the effectiveness of a starch-based super-absorbent polymer(SAP) combination, which enhances water potential and nutrient availability to plant leaves. We evaluated the effect of SAP on the maintenance of bacterial populations. In order to monitor bacterial populations in situ, a SAP mixture containing Pseudomonas syringae pv. tabaci that expressed recombinant green fluorescent protein(GFPuv) was spray-challenged onto whole leaves of Nicotiana benthamiana. The SAP combination treatment enhanced bacterial robustness, as indicated by disease severity and incidence. Unexpectedly, bacterial numbers were not significantly different between leaves treated with the SAP combination and those treated with water alone. Furthermore, young leaves treated with the SAP combination had more severe symptoms and a greater number of bacterial spots caused by primary and secondary infections compared to young leaves treated with the water control. In contrast, bacterial cell numbers did not statistically differ between the two groups, which indicated that measurement of viable GFP-based bacterial spots may provide a more sensitive methodology for assessing virulence of bacterial pathogens than methods that require dilution plating following maceration of bacterial-inoculated leaf tissue. Our study suggests that the SAP combination successfully increased bacterial aggressiveness, which could either be used to promote the ability of biological agents to control weedy plants or increase the robustness of saprophytic epiphytes against competition from potentially harmful microbes.

• Environmental Engineering Research
• /
• 제20권2호
• /
• pp.171-174
• /
• 2015

This study investigates the possibility of applying food waste leachate to a municipal solid waste incinerator in order to effectively dispose of the material and to reduce the environmental impact. The spray positions and the quantity of the food waste leachate in municipal solid waste incinerator were adjusted to examine the stability of the process and the environmental effect. The rear of the first combustion chamber was found to be the desirable location for an environmental perspective in this study. At a food waste leachate injection rate of $2m^3/h$, the concentration of the emitted NOx decreased from 130 ppm to 40 ppm. The consumption of ammonia water was reduced by about 36% after adding the food waste leachate. The inclusion of the food waste leachate to the municipal incinerator also increased the amount of steam that was produced. The results of this research indicated that a positive outcome can be expected in terms of diversifying the treatment options for food waste leachate. The results also provide guidance for institutional framework to manage the incineration of the food waste leachate.

• 한국분무공학회지
• /
• 제27권1호
• /
• pp.11-17
• /
• 2022

In upcoming Post Stage-V and Tier 5 regulations of construction machineries, nitrogen oxide (NOx) emissions are strictly limited in cold start conditions. In response to this, a method of improving NOx conversion efficiency has been applied by installing an electric heating catalyst (EHC) in front of conventional urea-SCR systems so that the evaporation and thermal decomposition of urea-water solution can be promoted in cold start conditions. In this strategy, the evaporation and thermal decomposition of urea-water solution and corresponding NOx conversion efficiency are governed by temperature conditions inside the EHC. Therefore, characterizing the temperature distribution in the EHC under various operating conditions is crucial for the optimized operation and control of the EHC in Urea-SCR systems. In this study, a 1-D modeling analysis was performed to predict the heater surface temperature distribution in EHC under various operating conditions. The reliability of prediction results was verified by comparing them with measurement results obtained using an infrared (IR) camera. Based on 1-D analysis results, the effects of various EHC operation parameters on the heater surface temperature distribution were analyzed and discussed.

• 한국농공학회논문집
• /
• 제62권4호
• /
• pp.87-97
• /
• 2020

The livestock infections had been happened seasonally, but they have gradually changed to be irrelevant to seasons and have an aspect to rapidly spread after outbreak. Especially in Korea, proactive disinfection measures are very important because the livestock farms are located densely so high as to accelerate the spread of disease between farms. livestock disease outbreaks like HPAI and FMD occurred with high probability due to vehicles visiting the farms, this study is to evaluate the efficiency of livestock vehicle disinfection systems by investigating the disinfectant coverage according to the type of vehicle disinfection system and the type of vehicle quantitatively. In field experiments, water-sensitive papers (WSPs) were attached to 21 locations on the surface of four vehicles (sedan, SUV, truck, and feed transport), respectively, and exposed to disinfectants while the vehicle was sprayed in two vehicle disinfection systems (tunnel type and simplified type). The WSPs were scanned and image-processed to calculate the disinfectant coverage. The results showed that the tunnel-type vehicle disinfection system had a better disinfection performance with an average coverage of 90.27% for all vehicles compared to 32.62% of the simplified type system. The problem of the simplified system was a wide coefficient of variation (1.05-1.31) of the disinfectant coverage between 21 locations indicating a need for further improvement of nozzle location and arrangement.

• 한국환경보건학회지
• /
• 제42권4호
• /
• pp.266-273
• /
• 2016

Objectives: This study evaluated the virucidal efficacy against avian influenza virus (AIV) of a disinfectant spray containing 0.25% grapefruit seed extract, 0.2% citric acid, 0.0625% malic acid and 0.0125% benzalkonium chloride. Methods: The disinfectant spray was diluted several times with hard water (HW) and organic matter (OM). Two point five mL of each diluent was added into each test tube, and 2.5 mL of AIV suspension was inserted into each test tube. After 30 minutes of virus-disinfectant contact reaction at $4^{\circ}C$, 2.5 mL of 10% inactivated fetal bovine serum was added into each test tube to neutralize the sanitizer efficacy. The neutralized solutions were serial 10-fold dilutions with phosphate buffer solution, and 0.2 mL of the diluents was injected into the allantoic cavity of five ten-day-old-chickens per dilution time. After incubation of the embryos for five days, the viability of the AIV was examined by hemagglutination titer. The valid dilution of the disinfectant spray was estimated according to the dilution time that the virus titer was inactivated more than $10^4$ 50% egg-infective dose (EID50)/mL compared with pathogen control. Results: In HW and OM conditions, the valid dilutions of the disinfectant spray against AIV were seven- and three-fold dilutions, respectively. The AIV titer of the pathogen control was more than 6.1 log10EID50/mL, and there was no embryonic toxicity. Conclusion: The present study showed that this disinfectant spray has effective virucidal activity against AIV.

• 한국식품위생안전성학회지
• /
• 제31권4호
• /
• pp.299-303
• /
• 2016

살모넬라증과 부루셀라증은 가축 및 사람에 심각한 피해를 유발하는 질병으로, 축산업과 식품산업에 많은 경제적 손실을 초래하고 있다. 본 연구에서는, 자몽종자추출물, 구연산, 사과산 그리고 염화벤잘코늄을 주성분으로 하는 스프레이형 소독제의 Salmonella Typhimurium과 Brucella ovis에 대한 효력시험을 수행하였다. 살균효력시험은 배지희석법에 따라 수행하였으며, 스프레이형 소독제와 시험 세균들을 처리조건에 따라 경수와 유기물로 희석하여 반응을 시켰다. 유기물 조건에서, Salmonella Typhimurium과 Brucella ovis에 대한 스프레이형 소독제의 살균력은 경수조건에서의 살균력과 비교하여 낮게 나타났는데, 이는 유기물들에 의한 소독제의 살균 유효성분에 대한 저해작용에 따른 것으로 사료된다. 스프레이형 소독제는 Salmonella Typhimurium과 Brucella ovis와 같은 인수공통전염병 유발 병원균들에 대해 살균효과를 나타내어, 살모넬라증과 브루셀라증과 같은 세균성 질병의 확산을 제어하는데 효과적으로 이용될 수 있을 것으로 사료된다.

• 한국분무공학회지
• /
• 제21권2호
• /
• pp.111-115
• /
• 2016

This paper experimentally reports the effect of suspension stability on the thermal conductivity of water-based Au nanofluids. For this purpose, the water-based Au nanofluids are prepared by the one-step method called electro-chemical method with volume fraction of 0.0005%. The thermal conductivity of water-based Au nanofluids is measured from $22^{\circ}C$ to $42^{\circ}C$ using the transient hot wire method. To quantify the suspension stability of Au nanofluids, the suspension stability of nanofluids is evaluated using the in-house developed laser scattering system at a fixed wavelength of 632.8nm with the elapsed time. Based on the experimental results, the both thermal conductivity and suspension stability of water-based Au nanofluids are gradually decreased according to the time. These results experimentally show that the suspension stability of water-based Au nanofluids is the one of the important factor of thermal conductivity.